Prius (Gen 4) :: Error Code, B1423 Diagnosed
Just used Carista to switch to a single beep when reversing. Whilst I was in the app, just out of curiosity, I checked for error codes. B1423 appeared. I didn't expect to see anything as the car is brand new.
View 8 RepliesAvalon 2005-12 :: Error Code P0355 Diagnosed
2006 Toyota Avalon 72000 miles
Plugs and coil have been switched between Banks 1,3,5 with 2,4,6 code P0355 shows the same cylinder 5 after the switch. What's the difference between a PCM and ECU and which one do I have.
Prius (2004-09) :: CEL With Error Codes P0117 And P1150 Diagnosed
I just bought my 2006 Toyota Prius about a year ago in 2009. About a month or two ago, the check engine light came on and stayed on along with a big red triangular warning light.
I brought the vehicle into my local Toyota dealership so they can diagnose it.They told me that they had 3 or 4 different "codes" coming from the machine when getting the signals from the check engine light. All the codes were related to the cooling system. They said that they felt that there was "debris" clogging the pathway for the coolant flow throughout the engine. They had recommended a "coolant flush" for the hybrid side as well as the mechanical side.
So I had them perform the coolant flushes. After leaving the dealership that 1st time, the check engine light came back on the next day. I called the same dealership and explained it to them. They asked me to bring it in again.
SO I brought it to them a 2nd time. They diagnosed it again. They told me they came up with 2 of the SAME "codes" and 1 that was different, but ALL the codes were STILL related to the cooling system. They explained to me that something was preventing the clear flow of coolant throughout the engine. And since the thermostat was the only major obstacle, they recommended that I replace it. Well, I did. And after I left the dealership that 2nd time, I was praying that this was the last of my Prius issues !
The check engine light came back on the next day. The service person invited me back and did not charge me this time because it was the same issue. I told them that I am not in the business of randomly changing parts on my car unless I am absolutely sure I know exactly what the problem is. HOWEVER, this time they kept my vehicle for a good week or two. Running it through various diagnostics tests overnight here and there.
They finally came out and said that they feel that I have a coolant system leak coming from my engine and that I need to replace my head gasket which is responsible for sealing the engine.
During my 1st visit, the codes were P0117 and P1150
During the 2nd and 3rd visits , in addition to those, there was one additional one that came up that I will post as soon as I find it !
Prius (Gen 1) :: Diagnosed 22 Code - AC Don't Work On Turning Fan Down
My 2003 with 150K miles has had the blinking A/C light problem for the past year or so. I ran the diagnosis, got the 22 code, so it seems the clutch needs to be adjusted or replaced. If I leave the A/C on Max with the fan on at Max, the A/C works fine (for at least as long as my daily commute, about 40 mins). Once I turn the fan down or turn Max off, the lights start blinking within 5-10 minutes and the A/C doesn't work. Is this consistent with the clutch problem?
View 5 RepliesPrius (Gen 2) :: CEL / Red Triangle With Exclamation - Code P0093 Diagnosed
I have around 68k miles on my 2009 Prius and just got a CEL, the Red Triangle with an exclamation point, an intermittently occurring VSC light, and an intermittently occurring yellow circle with an exclamation point on the upper dash display. I also have a car shaped icon with an exclamation point on my main display (ICE?). My scan tool shows P0093 as the only code.
View 19 RepliesPrius (Gen 2) :: Diagnosed Code P1116, Red Triangle And Headlight Icon
I got red triangle and headlight icon on the screen. I hooked OBD and It gave me error code P1116, I checked all my front, back lights are working fine.
View 19 RepliesPrius (2004-09) :: P3009 And Info Code 526 With Warning Lights Diagnosed
I bought an '04 prius about a month ago and it has already been at Toyota for over a week. It get's the red triangle, the yellow brake light, and the hybrid red car on the screen and says Problem! I took it to the dealer and he pulled the codes P3009 and info code 526. When you open the hood, the inverter overflow tank is boiling, so it must be overheating. I have read about the pumps going out and when the engine is cool there is turbulence in the overflow tank.
The guy I bought it from did say he had replaced the water pump recently. Toyota kept it for a week trying to replicate and couldn't, and even had the regional rep look at it.
Tiguan :: Error Codes P1946, 006470 Diagnosed
I have a '10 tiguan awd wolfs. The other day I was stuck in traffic and the temp started to run away. Got home and a few checks. No coolant leaks and the 40A fan fuse is ok.
I did a scan and vcds found this:
006470 - Control Module 1 for Coolant Fan
P1946 - 000 - Defective
From what I've found the new(er) style control module is no longer a small brick; it's located within the main fan motor. I dropped the rad assembly, installed the new one and cleared the dtc code in the engine control module. Immediately the code comes back and the fans never kick on.
Golf IV / Jetta IV :: Error Codes P 1137, P1297, P1171 Diagnosed
So my car has been running a little rough for a while(about 6-8 months now) and the CEL has been going off sporadically. The clutch went out last week and has been replaced fixing a large part of the issue, however the car still feels kind of rough in the 3k rpm range and up. I feel a strong vibration when I step on the throttle and the car hesitates to build power. On cold starts the car also has a rough idle where the rpms are hovering above 1k for a few minutes.
I recently took the car over to AU Tuning where they gave me a free diagnostic(Pacific German was charging me $100 just for a diagnostic!?). They told me the throttle body might need a cleaning but I was better off replacing the whole unit. They also discovered my air intake hose torn near the diverter valve and a 5 bar Fuel Pressure Regulator that was pressed in for added pressure.
Given that I just replaced the clutch, funds are tight and I don't have the money to replace everything right away
I should mention VAG-Com reported the following codes:
P1137 Fuel Trim: Bank 1 - System too Rich,
P1297 Pressure Drop between Turbo and Throttle Valve (check D.V.!)
P1171 Angle Sensor 2 for Throttle Actuator(G188) Implausible Signal
Avalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Passat (B7) :: 2012, 2.5l - Diagnosed CEL With P0106 Code
Had CEL light come on with the code P0106 barometric pressure sensor.
View 2 RepliesPassat (B5) :: Code 17748 And P1340 Diagnosed
I just replaced my timing belt. Checked it at TDC several times, even after releasing the tensioner. Now Im getting a
17748 - Camshaft Position Sensor (G40) / Engine Speed Sensor (G28): Incor. Correlation
P1340 - 001 - Upper Limit Exceeded
Camry :: 2007 SE Getting Error Code U0073
My 2007 Camry SE has an intermittent electrical issue. The problem started yesterday, no accidents of any time ever in the car. 195,000 miles on car.
As I was driving along the speedometer, tachometer, temp gauge all started bouncing. Simultaneously the ABS and Emergency brake light came on. The engine did not change, still drove fine. I got the code U0073. I checked a couple obvious fuses like ABS and Alternator as well as cleaning the contacts on the computer at the actuator. I've also checked my battery terminals -- fine.
I am hoping to narrow something down other than just going straight to replacing that ECU by the actuator. That is an expensive part not to be 100% sure of it, but as it stands now I would almost rather it be something "simple" like that because chasing these electrical phantoms is quite aggravating.
Also all the items I have focused are based off the assumption it is something electrical revolving around the ABS unit. Is it possible the instrument cluster is the culprit, wiring in the harness or a simple fuse related to that panel?
Santa Fe (CM - 2007-12) :: Invalid VIN Error Code Shown
Check engine light is on, when I went to get my car inspected it was showing an invalid vin code. How do get this off so I can get my emissions done?
2007 Santa Fe SE
Santa Fe (CM - 2007-12) :: Misfires Along With Error Code P0341 / P2189
I have a 2008 model 2.7 v6 with 80000 Km, and I would like to share my experience with several issues:
- Random misfire: brought the car to Hyundai, very bad response. I bought online the wiring of the spark plugs (according to them that was the reason of the misfire) and they installed it, did not improve. The car was still showing error code after clearing, and the fuel consumption at an average of 23L/100km.
- I then decided to change all the 6 spark plugs, no difference. The workshop told me the coils were in perfect condition. Still having a message like this: "ignition error on 2 or more spark plugs".
- I did a complete cleaning with contact spray of the MAF sensor.
- I bought online a couple of ignition coils, being original Hyundai ones, and changed them. When installing them i realized the existing ones were not original Hyundai and had a small marking, making me think they were recycled or chinese stuff.
- Having done that, the OBDII shown two more error codes: P341: error on camshaft position sensor, P2189: fuel idle (too much air, maybe caused by the first one). Changed both camshaft position sensors and then big change in the behaviour, more response, throttle, better gear switching.
- I so concluded that the 4 remaining coils have to be changed and ordered another time 4 of them online. OBDII showing now only one error code: random misfire. The engine going much better than all i got before.
- I have decided to take advantage of this order and also ordered a new TPS (seeing here that it was a common problem) and a Crankshaft position sensor (in order to prevent any other issue).
- I also changed previously 2 downstream o2 sensors that were giving an error related to emission. Emission here are not strictly controled so it is not a big issue.
My question is, what in all that sensors can more likely make my car burn 23L/100km??? Asian cities are quite similar to american cities, lots of highways. This consumption compared to what you describe is way over the normal one isn't it? I was assuming the ignition problem was the responsible, am i right?
Santa Fe (CM - 2007-12) :: Error Code P0057 - O2 Sensor Replacement
I need to replace O2 Sensor which is Bank 2 Sensor 2 which needs to be replaced.
Where is this located on a 2009 Hyundai Santa Fe 3.3L
Santa Fe (CM - 2007-12) :: Error Code C1627 - ESP Light Is On And 4WD Blinking
I have an issue in my car (Santa fe 2011) and it occurred since it was new (ODO 3000 KM , ESP light is on and the 4WD Blinking) . the agency could not resolve the issue. and my car up to now been in and out from the workshop for more than 6 times . and more the error code ( C1627 ) that appears in the GDS(Global Diagnostic System) does not exist in the system (troubleshoot manual) .
View 5 RepliesPassat (B6) :: 2007 - Error Code Of P0171 System Too Lean
I have an 07 passat with a 2.0 4 cyl turbo and I have an error code of P0171 system too lean (bank1) but engine seems to run just fine, what this code means, am wondering if it is something I can fix or if it needs to go to the shop??
View 2 RepliesLexus ES 2007-12 :: Got Error Code C1201 / P0057 / P0161
So I just bought a used 2007 ES 350. One week into ownership the check engine light, vehicle stability light (car with swerving tire tracks) and check vsc lights all come on.
I got the codes read and they are C1201 P0057 and P0161.
The last two I believe are oxygen sensors and the first is a vague engine control problem?
The lights come on for a few days, then go away for a few days.
The non-Lexus dealer who sold me the car sent me to a mechanic who says the lights will likely go away all together if we just replace the correct O2 sensors.
The car also vibrates when moderately applying the brakes at speeds higher than 60 mph- is that normal?