Passat (B6) :: Evap Flapper Motor Failure And Charcoal Canister Error Code
An MIL light came on the dash the other week while driving. Dealer cleared the error code but next morning it returned. Car is now in the shop to have the flapper motor and canister can replaced. Get it back tomorrow, Got '08 Jetta 2.5 as a loaner. I will run out of warranty in another couple of weeks(48100 mi. on it now).
View 10 RepliesAvalon 2005-12 :: Error Code P0355 Diagnosed
2006 Toyota Avalon 72000 miles
Plugs and coil have been switched between Banks 1,3,5 with 2,4,6 code P0355 shows the same cylinder 5 after the switch. What's the difference between a PCM and ECU and which one do I have.
Avalon 2005-12 :: Check Engine Light On - P0015 Error Code
I have a CEL on my 2007 Avalon so I decided to take it to Autozone to get a scan. Error code P0015 was returned. This code has to do with B Camshaft Position, Timing Over Retarded (Bank 1). I've done a little research and I've read that this could possibly from a dirty screen on the Oil Control Valve, the OCV itself, or the Cam Position Sensor. Before replacing parts, what I would like to do first is to check/clean the screen on the OCV. Secondly, I would like to swap the Cam Position Sensor to a different bank and see if the other bank throws an error. If the other bank throws an error, then I know the sensor is bad and needs to be replaced. With this said, I am having trouble locating the OCV and CPS. Where the valve and sensor is located. A diagram would be useful.
View 14 RepliesAvalon 2005-12 :: P0031 Error Code / Part Number For O2 Sensor?
I have a check engine light come on in my 07 Avalon and had the car scanned. It was throwing error code P0031. I'm gonna go ahead and replace this O2 sensor, however, I'm having a hard time finding the correct part# for this sensor.
View 1 RepliesAvalon 2005-12 :: 2006 - Error Code P0031 / Heated Oxygen Sensor Is Bad
I received error code P0031 on my 06 Avalon the other day. It states that the HO2S (Heated Oxygen Sensor) is bad. Bank 1 Sensor 1. I located the sensor but have a few questions...
Just to give an over view for those that don't know where these are, there are 4 sensors the one in the front on the manifold (upper - B2, S1), (lower - B2, S2) and the rear manifold (upper - B1, S1), (lower - B1, S2).
All of the sensors look the same with 4 wires. what the part number is for the sensor? Also since this is the hardest one to get to, I would like to know where the wire routes to. I found the wire up to the connector on every other sensor except the one I need (B1S1). It looks like it runs towards the top of the engine but from the top I don't see it.
Avalon 2005-12 :: P0351 Error Code - Ignition Coil A Primary / Secondary Circuit Malfunction
The 2005 Avalon has 48K miles and it's been running well without any issues, until today.
Driving in city traffic, max speed is about 30 ml/h, The "Check Engine" light and the "VSC (Vehicle Slip Control) Off" lights came on. I did stop the engine, restarted after couple of minutes and the same lights stayed on. The car ran just fine, no noticeable difference in performance.
With the OBDCOM reader, the Avalon has this code:
P0351 232
P0351 Ignition coil A primary/secondary circuit malfunction
That seems to indicate a malfunction for cylinder A, or #1, ignition coil that has nothing to do with the "VSC" AFAIK. Is this a misread by OBDCOM reader, or the Avalon is confused?
The code had been reset via the OBDCOM reader, the car runs fine, neither of the lights come on now. Should I do something about coil A, or just wait until the code comes back?
Ford - Mustang :: 2005 - Got Error Code P0456 Code / Gas Won't Fill?
My 2005 Mustang w/ 4.6L is giving a P0456 code and also won't let me fill it with gas completely. I think I've narrowed it down to the canister vent or purge valve. Looking for narrowing down which would cause the gas fill issue.
View 7 RepliesSubaru - Forester :: Error Code PO457 - Evaporative Emissions Error
I am getting error code po457 Evaporative emissions error, I am told the canister purge valve could be bad.
View 4 RepliesSanta Fe (CM - 2007-12) :: Error Code P0057 - O2 Sensor Replacement
I need to replace O2 Sensor which is Bank 2 Sensor 2 which needs to be replaced.
Where is this located on a 2009 Hyundai Santa Fe 3.3L
4160 - Transmission :: 2008 - Getting Error P0700 Code Even After Replacement Of Tranny?
4l60. Tranny 08 xpress. I'm getting p0700 code. 2 weeks after first getting code the tranny went out. Replaced tranny but still getting the same code. Should I b worried and how can I fix it.
View 3 RepliesPrius (2004-09) :: 2005 - Getting P0505 Error Code
I have a 2005 Prius with almost 244,000 mile and about a week and a half ago the check engine light came on. I went to an Advanced Auto and had them read the code for me, which came back with a P0505 error code. I have read several things on web that this code is a Idle Air Controller related.
I also have read that this could be to a loose or bad PCV valve, an air leak in the vacuum lines, throttle motor shaft might be binding, or a failed engine ECM.
The car runs and idle just fine, no stalling or a rough idling. The only problem that is obvious is that when the car is warm and I come to a stop or put in park, the motor will not shut off.
Which one of these would cause this to happen? Or could this be due to a MAF sensor that needs cleaned or replaced?
Prius (2004-09) :: 2005 - Error Code P0420 / CEL Came On Again?
Just picked up a 2005 with 146k and full Toyota service history, although seems a steering recall was not done. Will run it to the dealer today to check. I need to decide a.s.a.p. if I am keeping the car or not (I know the seller, he will take it back)
Anyway to cut a long story short, two questions.
1) Car had P3190 and P0420 when I got it. Seller reset, drove home and within 5 minutes on the road the CEL was back on. Checked the codes at home and see only a P0420. Much to worry about? Seems this might be big (Cat) or small (O2). Car getting great mileage - 60mpg at 60mph and it seems to be running great. Should I worry or forget about it? Note I am in Florida with no inspections.
Prius (2004-09) :: 2005 - Pulled Over Error Code P0420
So I bought a used 2005 Prius back in August it had 88,000 miles on it and was out of warranty. But I had a full inspection on it and the car was in great shape. Well, after a few months of driving, I got the P0420 error. I took it into my mechanic who cleared the code and told me to call him if it came back on. It came back on, then I cleared it myself, and it came back on again. So it was confirmed that I had a bad catalytic converter.
[URL].......................
Prius (2004-09) :: 2005 - Inverter Dead / No Error Code?
My 2005 died in the middle of the road a few days go. Was just rolling along fine then suddenly out of a stop light, the car stalled and would no longer go back into P, D, or R while the battery still seemed to be working. So had it towed to the dealership to be checked.
View 5 RepliesChrysler - PTCruiser :: 2005 - Getting Engine Error Code P0016?
I just wanted to post this due to the problem I was having with this code. I recently replaced a broken timing belt on my 2005 pt cruiser (non-turbo). Everything went back together, minus the hours trying to get the timing marks lined up by myself. After getting the engine buttoned up, the car would crank and idle, but only after 2000 rpm and the engine code P0016 would show up. I went back into the engine, reset the timing belt, and cranked it before putting everything back together. Worked fine, so buttoned it back up and took it for a test drive.
Bam, same engine code pops up again, only this time the car acted like it wanted to go into limp mode for half a second after driving for a few miles when I was turning around to come back to the house. It straightened up and drove fine. I could drive the car fine even after that, made a few test drives into town. The car would kind of fight limp mode after first cranking the car and accelerating, but then straighten up.
After a couple of months of research and talking to a friend who is a pretty good mechanic, I decided this was an electrical problem. I checked, and sure enough, after looking at the wiring at the cam shaft sensor connector, it was frayed. I spliced it and still had some issues with the code. I had just put a new sensor on it when the belt broke thinking it might be the sensor, so I put the old sensor back on it and now it runs fine, no more light. So, after months of thinking the timing or tone rings might be off, it was just a wiring/sensor issue.
Lexus SC430 :: Code P0440 - Fuel Overfill Check Valve Replacement?
Replace this when they got a code p0440? If so, which way did you go about replacing? if so, did u have to drop the tank or from cutting from underneath the seat? Is this the same location as from the 1st gen is300?
View 12 RepliesAvalon 2005-12 :: P0051 Code - Hidden Sensor Replacement On Firewall Side
So, my '06 XL just popped up a P0051 code, which is the bank 2, sensor 1 (the upstream A/F sensor that you can easily view upon opening the hood in the front exhaust manifold. Easy enough of a replacement on that one, but what about bank 1, sensor 1 (the upstream A/F ratio sensor on the firewall side of the engine)? I changed my oil today and I can access three of the four oxy/A/F sensors, but the upstream rear looks like a bitch! Out of curiosity, I called a local Toyota dealer and they said it would be 300.00 total to replace the hidden sensor on the firewall side. Does this amount seem realistic? I know that there is a TSB for this sensor that states to replace the exhaust manifold/cat assembly. I def. can't afford no 1700.00 crap right now!!
View 3 RepliesAvalon 2005-12 :: Code P0500 - Transmission Speed Sensor Replacement / Location
I have an 08 avalon w/ 281k miles. NEED to replace the transmission speed sensor (P0500 code thrown). Where is it located on the trans and what is the part #? I'm thinking about servicing the trans while I'm there but looks like a lot of "comments" regarding this transmission and the problems with servicing it!?
View 9 RepliesFord Super Duty (1999-2016) :: 2005 F350 Not Starting With P2291 Error Code / ICP Reads 0 While Cranking
2005 F350 crew cab with 6.0 currently cranks but no start with a P2291 error code. Using scanguage 2 it shows icp 0, IPR 67.7, FICM 47.5 while cranking. Disconnected ICP and still no start. removed icp and hooked up air and I do not hear/see any signs of air leaking. When I disconnect the air it then whooshes out. About 2 months ago got a #1 cylinder contribution error code and changed out that injector and it has ran fine up until this issue.
Can this be a IPR? I am leading towards the HPOP, but as it costs a pretty penny would really love to make sure I tried every other avenue.
I have 197K on it, and 2 years ago did a EGR cooler delete. In May this year replaced the oil cooler, and then in August changed out the #1 fuel injector.
Oil cooler screen was broken. Cleaned the entire reservoir out. Could this just be a clogged IPR? or seeing the change while cranking an indication that it is working?