Lexus ES 2007-12 :: Got Error Code C1201 / P0057 / P0161
So I just bought a used 2007 ES 350. One week into ownership the check engine light, vehicle stability light (car with swerving tire tracks) and check vsc lights all come on.
I got the codes read and they are C1201 P0057 and P0161.
The last two I believe are oxygen sensors and the first is a vague engine control problem?
The lights come on for a few days, then go away for a few days.
The non-Lexus dealer who sold me the car sent me to a mechanic who says the lights will likely go away all together if we just replace the correct O2 sensors.
The car also vibrates when moderately applying the brakes at speeds higher than 60 mph- is that normal?
Camry :: 2007 - Engine Code P0057 / VSC Light On
2007 camry 3.5q... I got my engine scanned and the code was p0057. I already replace my two oxygen sensor but the check engine light and check vsc system still on. What will i do?
View 1 RepliesSanta FE SM (2001-06) :: Code P2125 - Throttle Position Sensor Replacement?
Getting code P2125. Read on here to get some electric contact cleaner and see if that works by cleaning the connections.
If I do end up changing out the Throttle Position Sensor, what voltage value do I look for when installing the new one ?
Santa Fe (CM - 2007-12) :: Throttle Position Sensor Replacement?
Replacing the tps themselves? Is it something a newbie at diy car stuff can do? I'm getting codes P2016, P1295 and P161B, and I see no problem with the car except one thing, when the engine is cold the shift from P to D is rough. Is the tps causing this?
View 9 RepliesLexus ES 2007-12 :: Code P0368 - Camshaft Position Sensor Error
2007 Lexus ES350 with 177k miles. Getting a P0368 (Camshaft Position Sensor B Circuit High Bank 1) Error. I can't seem to find online where this sensor is located at.
View 2 RepliesAvalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Santa Fe (CM - 2007-12) :: Invalid VIN Error Code Shown
Check engine light is on, when I went to get my car inspected it was showing an invalid vin code. How do get this off so I can get my emissions done?
2007 Santa Fe SE
Santa Fe (CM - 2007-12) :: Misfires Along With Error Code P0341 / P2189
I have a 2008 model 2.7 v6 with 80000 Km, and I would like to share my experience with several issues:
- Random misfire: brought the car to Hyundai, very bad response. I bought online the wiring of the spark plugs (according to them that was the reason of the misfire) and they installed it, did not improve. The car was still showing error code after clearing, and the fuel consumption at an average of 23L/100km.
- I then decided to change all the 6 spark plugs, no difference. The workshop told me the coils were in perfect condition. Still having a message like this: "ignition error on 2 or more spark plugs".
- I did a complete cleaning with contact spray of the MAF sensor.
- I bought online a couple of ignition coils, being original Hyundai ones, and changed them. When installing them i realized the existing ones were not original Hyundai and had a small marking, making me think they were recycled or chinese stuff.
- Having done that, the OBDII shown two more error codes: P341: error on camshaft position sensor, P2189: fuel idle (too much air, maybe caused by the first one). Changed both camshaft position sensors and then big change in the behaviour, more response, throttle, better gear switching.
- I so concluded that the 4 remaining coils have to be changed and ordered another time 4 of them online. OBDII showing now only one error code: random misfire. The engine going much better than all i got before.
- I have decided to take advantage of this order and also ordered a new TPS (seeing here that it was a common problem) and a Crankshaft position sensor (in order to prevent any other issue).
- I also changed previously 2 downstream o2 sensors that were giving an error related to emission. Emission here are not strictly controled so it is not a big issue.
My question is, what in all that sensors can more likely make my car burn 23L/100km??? Asian cities are quite similar to american cities, lots of highways. This consumption compared to what you describe is way over the normal one isn't it? I was assuming the ignition problem was the responsible, am i right?
Santa Fe (CM - 2007-12) :: Error Code C1627 - ESP Light Is On And 4WD Blinking
I have an issue in my car (Santa fe 2011) and it occurred since it was new (ODO 3000 KM , ESP light is on and the 4WD Blinking) . the agency could not resolve the issue. and my car up to now been in and out from the workshop for more than 6 times . and more the error code ( C1627 ) that appears in the GDS(Global Diagnostic System) does not exist in the system (troubleshoot manual) .
View 5 RepliesSanta Fe (CM - 2007-12) :: 2011 - PO198 Code / Oil Temperature Sensor?
I took my 2011 Santa Fe, 3.5 liter, in for the tail light water thing, and a cracked fitting down near the thermostat (all warranty). I bought a rad flush while they were in there.
I picked up the car, drove for 1/2 hour and got a CEL. Plugged in my code reader and got three PO198's, oil temperature sensor. The dealer was closed by then, so I left it in their lot and will call them tomorrow. Their repair performance to date has been poor, and that's being polite. How a rad flush could cause a PO198? Could they have forgot to plug the sensor in? Is it located anywhere near the thermostat housing? Did they not get the air out of the rad, and maybe the engine did get hot?
Santa Fe (CM - 2007-12) :: Code C1209 - Faulty Right Rear Wheel Speed Sensor
My mother in laws 2012 Santa Fe had a number of dash lights on (ABS, hill decent, stability control). I put my scanner on it and came up with fault code C1209 which showed up as a faulty right rear wheel speed sensor. I have replaced this module and then cleared the codes.
However, the dash lights still light up and the vehicle continues to throw the same code. I don't work on Hyundai's very often so I am at a bit of a loss.
Golf VI R :: Getting Error PO140 After Replacement Of O2 Sensor - Fuse?
So, at some point in the past (probably during the winter) the bottom panel on the passenger side of the car was torn off. Either during that incident, or sometime after, the O2 sensor wires were also torn. I have replaced the O2 sensor (and the bottom panel), but I'm still getting a P0140 (O2 Sensor Circuit) error. So, now I'm wondering if the torn wires managed to short circuit, either with themselves or in the rain/snow at some point. What fuse this might be? I haven't pulled the cover off to check yet, just thought I would ask here while I was thinking of it.
View 4 RepliesHyundai - Entourage :: Engine Codes P0057 And P0037 - Downstream Oxygen Sensor
I recently had my Hyundai Entourage (2008) come up with the following engine codes: P0057 and P0037, both related to the downstream oxygen sensors. The generic description of the code is heated oxygen sensor heater control circuit low. As I understand this code, it is signaling that there is too much current passing through the heater circuit. The oxygen sensors test out OK for resistance, around 10 Ohms each and disconnecting them entirely and rerunning the test after driving a few times yields the same code. So I suspect the issue is not with the sensors but either the wiring or the ECU. I'd be a little surprised at a sudden short in the wires for both sensors but I suppose stranger things have happened. Oh and the fuse for the oxygen sensors has not blown. I am correct in reading these codes to mean there is an apparent short? Or are there any other things that could cause this to happen?
View 3 RepliesLexus GX 2004-09 :: Fault Codes P0037 And P0057 - Oxygen Sensor Heater Control Circuit Low
What can be done regarding these faults? P0037 and P0057
Description:
Oxygen Sensor Heater Control Circuit Low (Bank 1, Sensor 2)
Oxygen Sensor Heater Control Circuit Low (Bank 2, Sensor 2)
The catalytic converters have been removed but the fault was present before that anyway. All I want is the VSC function to work again and the lights to go off. I have heard you can put dummy sensors in.
Camry :: O2 Sensor And Error Code P0137
Had my Check Engine light come on so I went by a local AutoZone to see if they could read the code. He said it was P0137, but what his reader can't tell is which one it is.
A co-worker pointed out where it was on my 2006 2.4, but I'm not sure if it's the sensor in the engine bay or the one closest to the catalytic converter. The engine bay looks easy to change out but I'm in no condition to be crawling around underneath.
Which sensor the P0137 is referring to?
Camry :: 2009 V6 Check Engine Code ID P0057
I'm getting code P0057 with my OBD II code reader. This is what shows up..
H025 Heater control circuit low bank 2 sensor 2
Is it the code for the 02 sensor???? 09 Camry V6
Lexus GX 2004-09 :: P0051 Error Code Calling For O2 Sensor
Got the p0051 error code and its calling for a o2 sensor. What brand does lexus use? I rather get one on line but dealer quality.
View 12 RepliesElantra XD (2001-06) :: Camshaft Sensor Error Code After Tune Up
I just had a ton of maintenance done on my 2003 Elantra. Spark plugs & wires, timing belt, drive belts, water pump, replaced coolant and replaced the transmission fluid. The spark plugs are NGK platinum as recommended in my handbook. As soon as the mechanic started the car after the tuneup, the engine light came on with a cam shaft sensor code. He said it went off on its own.
The engine light came back on when I started the car. There's also a major loss of power after coming to a stop. I have to floor it to get it to go anywhere above 20 mph after a stop.
The mechanic said that when he replaced my water pump the liquid splashed all over everything and he thinks he might have gotten something wet that shouldn't have gotten wet and that all will be fine after it dries.
Passat (B5) :: Getting Error Code P3081 - Coolant Temp Sensor?
P3081. What the hell is this code. I think it is a coolant temp. sensor issue.
View 3 Replies