Prius (Gen 2) :: Control Module Communication Bus Off - Code U0073
This is a 2008 Prius with no check engine light or other operational issues. The car runs fine. When doing a health check with a Techstream scanner (new toy), it shows the code U0073 along with U0123, 124, 126, and 293. Need to further diagnose what may be wrong?
View 7 RepliesAvalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Camry :: O2 Sensor And Error Code P0137
Had my Check Engine light come on so I went by a local AutoZone to see if they could read the code. He said it was P0137, but what his reader can't tell is which one it is.
A co-worker pointed out where it was on my 2006 2.4, but I'm not sure if it's the sensor in the engine bay or the one closest to the catalytic converter. The engine bay looks easy to change out but I'm in no condition to be crawling around underneath.
Which sensor the P0137 is referring to?
Camry :: Error Code P0442, P0442P And P0456P
I've been getting P0442, P0442P and P0456P on my 2005 Camry 4 cylinder standard since about December 2011. For some odd reason, lately P0456P stopped when scanning when the CEL comes on again after erasing the code.
There's no symptoms of any problem so I think it's likely to be some small leak in the evap. Looking at my gas cap, it's a little dirty, but I don't see any cracks or damage, and I always make sure to fasten it on tight.
I have emission test coming up soon. (Actually this happened for 1st time like about 4 years ago when the car was under warranty. The dealer simply said that I didn't fasten on the fuel cap right, and erased the codes and sent me home. After about 4 years, same codes now that the warranty has expired....)
Toyota - Camry :: 1999 - Error Code P1780
I have an automatic 6 cup and get a P1780 error code. Says to check neutral shift sensor, which I replaced. Code came back. Internet search says to try wire loom in trunk, driver side. Opens 2-3' of it and found no frayed or broken wires. All lights work fine. Car shifts fine. No other issues other than check engine light and that code. Where else to check?
View 3 RepliesSanta Fe (CM - 2007-12) :: Invalid VIN Error Code Shown
Check engine light is on, when I went to get my car inspected it was showing an invalid vin code. How do get this off so I can get my emissions done?
2007 Santa Fe SE
Prius (Gen 2) :: 2007 - Error Code P0ac0, P0afa Diagnosed
Car was perfectly fine. Parked it in a parking spot, turned it off for a minute, started it back up, and BAM, Master Indicator Light is illuminated(not blinking), along with check engine light. (yellow, not blinking)
Code reader gives me these two codes: P0ac0 and P0afa
Santa Fe (CM - 2007-12) :: Misfires Along With Error Code P0341 / P2189
I have a 2008 model 2.7 v6 with 80000 Km, and I would like to share my experience with several issues:
- Random misfire: brought the car to Hyundai, very bad response. I bought online the wiring of the spark plugs (according to them that was the reason of the misfire) and they installed it, did not improve. The car was still showing error code after clearing, and the fuel consumption at an average of 23L/100km.
- I then decided to change all the 6 spark plugs, no difference. The workshop told me the coils were in perfect condition. Still having a message like this: "ignition error on 2 or more spark plugs".
- I did a complete cleaning with contact spray of the MAF sensor.
- I bought online a couple of ignition coils, being original Hyundai ones, and changed them. When installing them i realized the existing ones were not original Hyundai and had a small marking, making me think they were recycled or chinese stuff.
- Having done that, the OBDII shown two more error codes: P341: error on camshaft position sensor, P2189: fuel idle (too much air, maybe caused by the first one). Changed both camshaft position sensors and then big change in the behaviour, more response, throttle, better gear switching.
- I so concluded that the 4 remaining coils have to be changed and ordered another time 4 of them online. OBDII showing now only one error code: random misfire. The engine going much better than all i got before.
- I have decided to take advantage of this order and also ordered a new TPS (seeing here that it was a common problem) and a Crankshaft position sensor (in order to prevent any other issue).
- I also changed previously 2 downstream o2 sensors that were giving an error related to emission. Emission here are not strictly controled so it is not a big issue.
My question is, what in all that sensors can more likely make my car burn 23L/100km??? Asian cities are quite similar to american cities, lots of highways. This consumption compared to what you describe is way over the normal one isn't it? I was assuming the ignition problem was the responsible, am i right?
Santa Fe (CM - 2007-12) :: Error Code P0057 - O2 Sensor Replacement
I need to replace O2 Sensor which is Bank 2 Sensor 2 which needs to be replaced.
Where is this located on a 2009 Hyundai Santa Fe 3.3L
Santa Fe (CM - 2007-12) :: Error Code C1627 - ESP Light Is On And 4WD Blinking
I have an issue in my car (Santa fe 2011) and it occurred since it was new (ODO 3000 KM , ESP light is on and the 4WD Blinking) . the agency could not resolve the issue. and my car up to now been in and out from the workshop for more than 6 times . and more the error code ( C1627 ) that appears in the GDS(Global Diagnostic System) does not exist in the system (troubleshoot manual) .
View 5 RepliesPassat (B6) :: 2007 - Error Code Of P0171 System Too Lean
I have an 07 passat with a 2.0 4 cyl turbo and I have an error code of P0171 system too lean (bank1) but engine seems to run just fine, what this code means, am wondering if it is something I can fix or if it needs to go to the shop??
View 2 RepliesLexus ES 2007-12 :: Got Error Code C1201 / P0057 / P0161
So I just bought a used 2007 ES 350. One week into ownership the check engine light, vehicle stability light (car with swerving tire tracks) and check vsc lights all come on.
I got the codes read and they are C1201 P0057 and P0161.
The last two I believe are oxygen sensors and the first is a vague engine control problem?
The lights come on for a few days, then go away for a few days.
The non-Lexus dealer who sold me the car sent me to a mechanic who says the lights will likely go away all together if we just replace the correct O2 sensors.
The car also vibrates when moderately applying the brakes at speeds higher than 60 mph- is that normal?
Camry :: 2007 XLE V6 - Error P0031
Alright, so I've been battling this for a few hours. I know I need to replace a sensor, and that's about it. The issue, is I don't know if I need to replace an oxygen sensor or an air fuel ratio sensor. I have searched, but I keep finding conflicting information. So which do I need?
View 3 RepliesPassat (B6) :: 2007 - Key Won't Release When Car Turned Off / Steering Lock Error Code
I can't get the key out off the ignition with out playing around with the shifter button and brake pedal, an error talking about a steering column lock shows up some times.
View 3 RepliesLexus ES 2007-12 :: Code P0368 - Camshaft Position Sensor Error
2007 Lexus ES350 with 177k miles. Getting a P0368 (Camshaft Position Sensor B Circuit High Bank 1) Error. I can't seem to find online where this sensor is located at.
View 2 RepliesFord F-150 (2004-2008) :: 2007 - Stumbling And Hesitating A Bit Between 25 - 35 MPH / P0307 Error Code
My 2007 Ford F150 Lariat (5.4L) with 82k miles popped a P0307 (#7 misfire) code one chilly morning. It began stumbing and hesitating a bit between 25-35mph, and each time it occurred, the engine light would flash on and off. Hesitation clears and light goes steady. Cleared the code and didn't see problems again for a month...until the next cold day (freezing temps). Popped again and hesitation returned. Ford dealer wants to change plugs. I've read coils can also cause the issue. Not sure if I can do either myself.
View 4 RepliesCamry - Hybrid :: 2007 - Check VSC System Error
I have a 2007 Camry Hybrid and got the front and rear rotors and pads changed last Friday at a shop. On Monday morning, I drove the car to a Pharmacy drive-thru and briefly stopped it. It would not start a few minutes later and showed - Check VSC System Error. Push it out of the way and then I tried re-starting, and it did. Since then it has happened a couple of times again. A little push and then it restarts. Otherwise, all error lights come on when attempting to start the car. I check the brake fluid- it is at Max or slightly higher. The driving seems ok when it is driving. What could be happening? Is there a reset button or do I have to take it to the dealer to get it scanned? I disconnected the 'positive' terminal of the battery (the negative was hard to reach) but that did not seem to change things.
View 17 RepliesLexus GX 2004-09 :: Reset Error Code On 2007 GX470 Tire Pressure Monitoring System
How to reset and remove the error code on the tire pressure monitoring system?
View 5 RepliesCamry :: 2007 Navigation Screen Error / MAP DVD - Unable To Read Data
My new '07 Camry with 5K miles on it, driving along, minding my own business. The navigation was on as it always is, but not in guidance mode. All of a sudden I notice the screen turn dark and I see this error: "MAP DVD - Unable to read data. Check if map DVD is correct." (see image)
I have never removed the DVD from the drive. It is clean as a whistle. I wasn't on a bumpy road. I tried resetting and cleaning it, but no good.