Prius (Gen 2) :: Occasional Clunk Noise When Stepping And Releasing Brake Pedal
I get a clunk noise when stepping on and releasing the brakes occasionally but not always. This occurs even with the engine off and the vehicle stationary. I also hear some other noise like some sort of vacuum servo thing is happening.
View 4 RepliesPrius (2010-12) :: Loud Clunk On Start Up After Releasing Brakes
I have a 2010 prius 2;
This morning after starting the car and releasing the brakes I heard loud clunking sound (seemed like a belt ?) Turned the car off. tried it again exact same thing, turned if off .. opened the hood to see if I can tell where this was coming from.. started the car and the clunking came for <1 sec and went away, car drove fine brakes worked fine..
I read something regarding temp changes we have had some change but not a drastic change, and the car was driven over the weekend.
Accent RB (2012+) :: Creaking Noise On Releasing Clutch Pedal
On releasing the clutch pedal, a creaking noise can be heard, which:
- sounds and feels like a rusty spring being unloaded
- occurs for the entire range of pedal travel, but worse near the bottom
- is louder outside the car than inside
- happens not only when driving, but also when stationary with the engine off
I don't think anything is wrong with the clutch itself, or any bearings, or major components... It just feels like something needs to be lubed. I've lubed the spring above the pedal inside the car, with no real effect.
Ford Excursion :: Loud Roaring Noise When Releasing Gas Pedal Or Stopped
I have a 2000 X 5.4... There is a loud roaring noise when releasing gas pedal or stopped (doesn't matter whether its in park or drive)...noise stops when giving gas...the noise is almost like a bull horn...there are no engine lights on so can't get a code...
View 8 RepliesGolf IV / Jetta IV :: Transmission Knocking When Clutch Pedal Released
I've done a bit of research both here and on other sites. I originally thought that I had a bad flywheel but I'm not convinced. First I'll give a little backstory. I just installed steel shift forks because one broke and got jammed in the gears. None of the gears are damaged and I assumed that when it slammed to halt, the flywheel got messed up. So anyways, the complaint is that when the clutch pedal is released I start to hear a knocking sound which becomes more rapid with RPM. When the pedal is depressed the sound goes away. This sound seems to be coming more from the driver's end of the trans. The car still moves in all gears so I can't imagine that I put it together wrong.
View 6 RepliesGolf/GTI VI :: Manual Transmission - Rattling Noise When Clutch Pedal Is Not Engaged
I currently own an mk6 gti with a manual trans... as of late I've been noticing a rattling noise when the clutch pedal is not engaged.. once engaged the rattling stops completely .. it seems to be getting louder and louder .. I am worried this could eventually turn into something worse than just a rattling noise .. i had a friend mention it could be the "throwout bearing" ..
View 9 RepliesGolf IV / Jetta IV :: Clutch Pedal Is Rock Solid Hard After Transmission Swap
2004 Jetta 1.8 bought mainly as a parts car w /204K miles on it. Ran and drove fine, but the tranny had no 1st gear. Tried all sorts of things other than going inside the transmission and figured it is/was a bent shift fork. Clutch worked perfectly. Had another 02J tranny from 2003 1.8, so we swapped trannys. Could not get any response from the clutch.
Start the car in neutral and it won't disengage enough to shift into gear. Start it in gear with clutch pedal in and it is obviously slipping/burning/chattering. Have bled the slave cylinder to no end, have reverse pressurized it into the reservoir , etc, etc. Made up a block off plate to go over the end of the slave actuator and when the actuator is "blocked" from moving the clutch pedal is rock solid hard. Yet, the clutch acts as if the actuator isn't extending far enough. Have swapped out the original slave cylinder with the one from the '03, no change.
Removed tranny yesterday to check the condition of the throw out bearing and pivot and Pressure plate. All appeared fine. Reinstalled tranny and same issue.
Golf IV / Jetta IV :: Creaking When Pushing In And Releasing The Clutch
I have done some research, but have found no one with the same noise as I am having. My clutch is creaking when pushing in and releasing the clutch. It does not sound like it is coming from the pedal. I have had a new clutch and transmission replace within the past 18 months. Someone mentioned the creak could be "dust on the slave cylinder." What this could be? Should I be worried? It shifts perfectly find and rides fine.
View 3 RepliesBMW - 328 :: 1996 - Loud Clunk / Pop When Clutch Depressed
This is regarding my 96 BMW 328i. It has approximately 177,000 miles on it. Over the past year, I've replaced the cooling system, fuel pump, alternator and trans fluid for kicks. So, I'm understandably frustrated with it. Anyway, to my story:
On my way into work, whenever I pressed in on the clutch, it would make a loud clunk/pop and freak me out. I turned around after 1/4 of the way and swapped cars.
My mechanical skills are maybe 3 on a scale of 1 to 10. I'm not afraid of changing oil, brake pads, transmission fluid, changing an alternator, etc. But I want to have someone to blame for anything that involves anything within the engine block/head/transmission continuum.
I noticed that a heat shield was loose between the driveshaft and the exhaust. I rapped it with a hammer, and the heat shield didn't make a noise anything like I'm hearing. So, it doesn't sound like that's the real culprit here.
Phaeton :: Loud Bang Or Clunk Underneath The Pedal
2005 V8 Phaeton,82,000 miles.
If I ease on the brakes ,no problem but if I hit the pedal there is a loud bang or clunk from underneath,sometimes front and sometimes in the back. It's as if the wheels stopped but the chassis went forward and back slightly. As long as I put the brakes on gradually there is no problem stopping.
When I come off the Interstate and leave the off ramp, the low side of the front end sounds as if there is no shock absorber ,doesn't matter which side is low,they both do it on the low side.
Intermittent problems.
Steering wheel turns and grinding,groaning noises from under the hood, not all the time.
Going over a speed bump in a parking lot causes the same noise I get exiting the Interstate.
Volvo - 240 :: 1992 - Loud Clunk When Flooring The Gas Pedal
When I 'hit the gas' I hear a loud clunk or short scratching noise (definitely metal) before the engine starts revving up. I've researched the issue a bit but found no concrete answers. Motor mounts, timing, transmission issue? No one thing seems to cause it as far as I can tell.
I got my '92 Volvo 240 Non-Turboalmost a year ago and haven't really thought much of the noise, but I'm coming up on a 500mi trip to Northern California. I want to make sure it's in tip-top shape before I leave. [IMG]
Volvo :: Loud Clunk Noise In Reverse - Roll Back When Press The Pedal
When I put my car (04 s60 2.5t) in reverse it hesitate, then when I press the pedal it roll back with a loud clunk noise. But if I put the car in drive before putting it in reverse everything goes smoothly.
View 2 RepliesElantra GD (2013+) :: Clutch Pedal Is Really Very Loud
I have a 2013 elantra, manual transmission. I have about 17k miles on it and it's 8months old. For some reason my clutch pedal is really loud. At 12k my power steering rack was replaced and I wanted the clutch addressed then but they didn't address it and claimed it was fine. Then at 16k my master cylinder was replaced. Within four hours the sounds came back. They are not addressing what is making the sound properly and claim it is okay to drive on it. My issue is with all of these crazy sounds that don't belong how am I supposed to tell if there is an issue with my clutch.
I drive about 30k a year. There could be damage happening and I will be expected to pay for it because it wasn't addressed because with my clutch making sounds I won't know if there is something abnormal, usually having a sound tells you that. I also get a pull to the side some times and when it happens I feel like I don't have control of my steering for a split second. I have owned two previous hyundai vehicles, and many standard vehicles and never had these sounds from a clutch. Whether it is the bushings or not it shouldn't be making sounds. Engineering should be trying to problem solve this, but instead hyundai hands me back a defective vehicle
Ford Super Duty (1999-2016) :: Clutch Slipping - Harsh Shifting - Loud Clunk Noise Into Gear 2 Then 1
New truck 11000kms ago thats done medium amount of work but nothing heavy or sustained for long periods of time. I get the feeling of clutches slipping especially when truck is cold but also when normal temps. Doesnt make any weird noises or anything. I can really notice the difference in torque if in manual mode being much better, but still not perfect if i stomp on the gas pedal and go through the gears in manual mode will still slip. Also is really harsh shift if i come to a halt in 3rd manual mode with the brake pedal depressed push minus button the truck makes very loud clunk noise into gear 2 then 1. Took it to ford they couldnt find anything ? Thinking of trying another dealer.
View 2 RepliesCorolla / Matrix 2009-13 :: Auto Transmission Has A Loud Clunk When Down Shifting On A Hill
We have a 2009 Matrix, 68000 miles. automatic transmission has a loud clunk when down shifting on a hill. Has only happened a few times and cant seem to make it happen. Am really concerned what this might be.
View 5 RepliesFord Transmission :: 1979 - Installed New Clutch Now Pedal Won't Come All The Way Up?
Just installed new clutch and everything good except pedal doesnt comecall way up now have pull up with foot, ans grabs rt off the floor, i assume just need to adjust? Make adjust rod longer?
View 10 RepliesGolf VI R :: Clunk While Downshifting From 3rd To 2nd After Clutch Replaced
I recently replaced my clutch and I've noticed that occasionally, while downshifting from 3rd to 2nd, I hear a clunk sound that comes from beneath the back seats. Especially if my throttle bliping is not aggressive enough. What this could be?
View 3 RepliesFord Transmission :: 1996 F150 - Pedal Goes Almost To The Floor Before Clutch Engages
1996, f150, 300, 4x4, 5 speed, 296,000 miles... My pedal goes almost to the floor before the clutch engages and about a half inch, maby less, of travel back out the clutch disengages. I think it is about time for a new clutch. My question is what is the best clutch to put in my truck?
while i have the transmission slid back to replace the clutch i am planning on replacing the slave cylinder while im in there as well. Any particular brand better than the next on that item? Are there any other items that I should think about replacing while i have the transmission slid back to do the clutch?
Ford Transmission :: 1995 F150 - Clutch Pedal Losing Pressure?
I have a 1995 F150 with the 4.9L and it has 73000 miles on it. One morning recently (it was about 35 degrees outside) I went to start my truck to let it warm up. When I let off of the clutch it stayed on the floor. I shut it off and drove my car to work instead. I asked around at work and one guy mentioned that it was probably my clutch master cylinder...so that day we replaced it, and bled it until it felt like knew. Since then, we have had to bleed it three more times, because the pedal keeps losing its pressure making it harder to shift. I have inspected around the clutch line and the bellhousing for signs of needing to replace my slave cylinder, but everything looks fine.
View 8 Replies