Ford Super Duty (1999-2016) :: 1997 - Uphill 4th Gear Very Hard - Clutch Slipping?
I have a 1997 F250 heavy duty 4x4 7.5 efi. I just bought a 2003 weekend worrior weighing 5800lbs dry. When I go up slight hills in 4th gear it seems to work real hard especially on freeways, could my clutch be slipping or am I just at max tow
View 11 RepliesFord Super Duty (1999-2016) :: Loud Clunk Locking Into 3rd As The Gear Engaged
Was pulling passat home 50 miles round trip this saturday and downshifted into 3rd. As the gear engaged it let out a loud clunk locking into 3rd gear. was able to find neutral after a day but slammed into gear just idling. Can find neutral on pattern but not actually get there....also drags right rear tire upon disengaging clutch.
1999&half psd zf6 1 ton single....
Ford Super Duty (1999-2016) :: Super Loud Clunk Noise Come From The Door When Car Turned On
So the other day i opened the door and heard a super loud clunk noise come from the door and when I turned the car on and pulled hte window down it wouldn't go down all the way, only about 75% of the way so I assumed like BMW cars the window motor died but oddly it continued to go up and down just now 100% down.
Then 3 days later when I came to drive the car again the window went down to the 75% mark and now its jammed there with no movement even if I tried to lift the window up myself. Usually a broken motor allows this to happen but since it isn't budging I am wondering if its an electrical issue with the power window button more than the motor?
I say this because when i try to lower the passenger window from the driver side it works than out of no where on the 3rd time it wont move at all than 5 minutes later it will move or if it doesn't move I just go and pull the window down from the passenger side then I come to the driver side and try it and it works again than it'll stop again. So maybe its the power window control buttons on the drivers side that's failing?
Ford Super Duty (1999-2016) :: Steering Wheel Jerk And Loud Clunk Noise
I took my truck to an alignment shop to have him look over my truck to find a steering wheel jerk and a loud clunk noise. He believes it's in the transfer case driveline. Said to remove the driveline then drive it around and see if it goes away, if it does then that's the problem. So to the question, how to properly take this out? Do I need to make marks with a paint pen anywhere to line things back up or does it matter?
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Harsh Shifting / Sluggish / Loss Of Power
I have a question for everyone out there with any insight of the harsh shifting with these trucks. I have a 2003 f250 super duty with the 5.4l and 126,000 miles on it. The problem I'm having is some weird shifting that has been going on over the last six months and I feel like I am just throwing money at this problem. My truck shifts hard from 2nd to 3rd and from 3rd to 4th with the most violent shifts being from 3rd to 4th! Between shifts is where it Is sluggish I mean if I am not on the throttle from those shift points I switch from driving a truck to a geo metro it is night and day with the felling of loss of power!
I have had it scanned at my local ford dealership and had a full diagnostics done and all I got was "it's since truck and a nice bill to come with it" they couldn't find a thing. So far I have all new motorcraft plugs, cops, changed fuel filter, had my catalytic converter checked if it was clogged,run on two different power balance tests! Still nothing! So now I'm lost I have heard things about these trannys and the lock up but I was told this only had to do with overdrive and it wouldn't happen at other gear changes. I still drive it everyday I have just figured out ways to calm it down if I stay off the gas when it's about to shift for a couple seconds then get back on the gas it is like it never happened.
Ford Super Duty (1999-2016) :: 2004 F350 - Loud Clunk Noise In Forward Or Reverse Hi Or Lo When Accelerate
Ive got a 04 f350 that after u shift into 4hi or 4lo when u accelerate it it makes loud clunk noise in fwd or reverse hi or lo. With hubs unlocked it still clunks. Have checked, wheel bearings, axle U-joints, and driveshaft joints all good. So I am thinking I've got issues in t-case. Popped drain plug out and wow that dex merc 4 looks nasty. So thinking I need exploded view of transfer case.
View 4 RepliesFord Super Duty (1999-2016) :: Transmission Slipping In 3rd Gear?
Truck is slipping in/out of gear in 3rd gear. Shut it off and the problem may not come back for several days, but in general it is getting more frequent. No codes are registering for the transmission. Curious the wisdom of performing a simple fluid/filter change vs taking it to the transmission shop. Fluid basically looks/smells good, and is full.
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Clunk In Reverse When Clutch Is Pressed
My issue, just purchased f250, 2004, v 10, manual transmission, state vehicle with 32,000 miles but was a plow vehicle for localRMV lot, that said, great shape and runs strong but I get a clunk and shutter when I am in reverse and only when I push down clutch before stopping. Doesn't do it starting forward or reverse, only reverse and when I push clutch in before stopping. Did have a friend drive and looks like the transfer case is moving, as if mounts or bolts are loose. Does this make sense and could bad slip joints be putting excess torque on ?!?!?
View 4 RepliesFord Super Duty (1999-2016) :: Transmission Slipping In / Out Gear - Code P0705
I recently had a thread going regarding my 1999 F350 2wd auto transmission slipping in/out gear. Tried to follow up on old thread but got confused so I'm trying to start a new one. Basic problem is that truck was slipping in/out of gear. Cleaned the solenoid pack electrical plug (as instructed on previous thread) and the truck didn't act up for 2 weeks. Today it started slipping in/out again and this time it registered a code of P0705.
View 7 RepliesFord Super Duty (1999-2016) :: Massive Clunk Sound When Shifting From Reverse To Drive Or Vice Versa
I continuously read that people with 6.2 F250s averaging 13 mpg or so in a combination city/highway driving. This 2014 4x4 barely has enough power to move itself (honestly, I'd rather have my Ram 1500 back) and barely gets 10mpg. Basically have to give it about half-pedal to even get up to freeway speed and floor it if i want to pass anything. Is it just that much of a POS or does this not sound right? Other than a massive "clunk" sound when shifting from reverse to drive or vice versa, no indication of any problems.
View 14 RepliesFord Super Duty (1999-2016) :: Clunk When Shifted Into 3rd Gear If Accelerating Hard
Ok so I'm having a problem that seems to have been getting worse. 1999 7.3, auto, 4 door, long bed, 6" lift. When I got the truck a while back I had a slight problem where if I was accelerating hard I would hear a clunk when it shifted into 3rd gear. I'm not hard on the truck that often so it took me a while to realize that the noise was the driveshaft hitting the floorboard right at the joint at the transfer case output.
The carrier bearing was flopping around a bit so I replaced that first. No better... kept driving the truck since it was only a problem while being really hard on it. But it's gotten worse so now when I tow (usually not more than 7-8k lbs) I have a bad vibration on takeoff at low speed. If I try to take off from a stop very hard with any load the driveshaft jumps into the floorboard. So I just replaced the transmission mount and checked the motor mounts, no better. Only thing I can figure at this point is axle wrap...?
Ford Super Duty (1999-2016) :: Grinds Bad Shifting Into 3rd Gear
I have a 99 7.3 F350 with 5 speed manual with over 300,000 miles. Grinds bad shifting into 3rd, and nothing happens in 4th. I think it is a S5-47-ZF. Is a 6 speed manual comparable to bolt up to bell housing?
View 2 RepliesFord Super Duty (1999-2016) :: Transmission Shifting From 3 To 4 Gear Seems To Be A Bit Prolonged
I have a 2012 F-250 ccsb lariat and the shift from 3 to 4 seems to be a bit prolonged as if the converter is slipping and wont go ahead and push it into 4 gear. Also it will want to downshift from 3 to 1 and feels like the car behind nailed you. I have read that the early 2011 had some of this problem and the dealer reflashed the tcm and it did not do much good but as mine being a 2012 mine should have been flashed with the lastest tcm flash from the get go?? Egr fell off and am running Kory Willis tunes through ez lynk so the stealership is probably out of the question. I have also read that changing a couple solenoids( dont remember which ones) will fix the problem.
View 11 RepliesFord Super Duty (1999-2016) :: Transmission Shifting Hard Between 2 And 3 Gear
The tranny is shifting really hard between 2 and 3 if I feather the throttle it can be a little less of a jolt but still enough none the less iv never done a filter and fluid change as I just got it it has 235000 miles 99 v10 super duty 4x4....
View 8 RepliesFord Super Duty (1999-2016) :: Strange Hesitation When Shifting From 1st To 2nd Gear
I bought my 2011 F250 FX4 about 2 months ago. A little about the truck: 6.2 liter gas. XL FX4. Manual 4x4. 6 speed auto. Supercab. Long bed. 42,000 miles. (1,000 of them mine.)
Until yesterday, the truck has performed absolutely flawlessly under all conditions. Then, randomly, I had what felt like a "missed shift" as I was leaving my dog's veteranarian yesterday. I pulled out onto the highway and as the truck attempted to shift into second gear, it didn't "catch" second. The gas just revved up and I had to take my foot off the gas pedal and put it back down to get second gear to engage. Most of my driving is stop and go around town and this has only happened once in probably well over a thousand stop and go situations. Should I be worried or was it just a fluke?
Also, FWIW, I did plenty of stop and go driving today without a single problem.
Ford Super Duty (1999-2016) :: Transmission Stays In 5th When Shifting Into Any Gear Including Reverse
I have a 2000 F-550 w/7.3 and a 6 speed ZF transmission. My problem is that when you go to shift into any gear inc. reverse the transmission stays in 5th gear. I pulled the shifter and tried to do it from top of transmission it still stays in 5th. Any thoughts that I could possibly check?
View 1 RepliesFord Super Duty (1999-2016) :: Loud Thunk / Shudder And No Gear
I just broke my 2000 F350 7.3L 4X4. I never had any shift problems in the 3+ years I've had this truck. 3 days ago, I stood on it to enter the freeway, it dropped into passing gear, then a loud THUNK, a shudder, and no gears whatsoever. I coasted to a stop, checked to make sure the transfer case hadn't jumped to neutral, ran the tranny through all gears, and nothing, truck wouldn't move.
I took the tranny pan off this morning and its clean, just a little fuzzy on the magnet but nothing more than normal for 3 years and 200k miles without service. At this point, I'm thinking its the torque converter let go and won't pump fluid. Tranny Shops only want to sell you the whole assembly, not fix the problem.
Ford Super Duty (1999-2016) :: F250 - Clunk Noise When Turning Right Once In A While
I have a 2004 f250 with some front end troubles. When turning right once in a while it will make a hard CLUNK noise and then trying to drive down the street it drifts over to the left and I pull the wheel back to the right and when I turn the wheel it feels like I like theres something hitting somthing else in the front end. I have checked ball joints and tie rods and they are all nice and tight. Some stuff I have done that probably isn't related to my problem is shocks and sway bar end links. What this could be? Hopefully not the steering box!
View 7 RepliesPassat (B7) :: 2016 - Harsh Shifting Into Second Gear
16 se. When driving slowly, I feel my car shift into second gear, not very smooth, to other gears, it's butter smooth. I mean it's not bad at all but little harsh for a new car. I only have 700 miles on it. Is this kinda normal !?
View 9 Replies