Phaeton :: Actual Computer Error Code From TPMS (Module Or Sensors?)
I took the car to be inspected today (for extended warranty purposes) and asked for the mechanic to run the car through their code reader and print out all error codes. They did and this is the error code it gave for TPMS (FYI- They couldn't reset the error display either, and I've done the 'learning' procedure several times as suggested in these forums, but it doesn't work and the display eventually shows Tire Monitoring Pressure Fault) NONE of the tires show in the TPMS screen. I have no flats, nails, and all the pressures are up to level.
So here is the actual code from the Phaeton:
CODE001:
01325 Type pressure sporadic monitoring
Open contr.unit-j5-0 circuit 2
So what I am wondering is whether the Module has gone bad or perhaps the sensors? What the above means?
Ford - Explorer :: 2008 - Got Error Code P0401 With CEL?
I have a 2008 Sports Trac, with a 4.0 SOHC engine ... 165k miles. Last week my check engine (CE) light came on and the code is P0401 ... too little flow on the EGR system. I first tried cleaning the existing valve - but CE light still came on. So I replaced the old EGR valve, cleaned the SS tube from the exhaust manifold back to the EGR valve and the CE light is still on. I have not driven the truck since I replaced with the new valve ... only fired her up in the garage. Is this something that could possibly clear up given a couple of miles?
View 6 RepliesFord - Explorer :: 1997 - Airbag Error Code 45
I have a 97 Ford Explorer and the air bag indicator started to flash a code 45. What is this code and what do I need to do to clear this problem?
View 5 RepliesFord - Explorer :: 1993 - Error Code For A Low Voltage MAF Sensor
1993 ford explorer sport... I got an error code for a low voltage MAF sensor. how would i go about fixing it? Do i need to get a new MAF sensor?
View 1 RepliesFord - Explorer :: 1996 - Airbag Error Code B1944
I just pulled error code B1944 from my 96 Explorer. It says
Crash sensor ground
Ckt 1, High res/open
I found the airbag diagnostic module (in passenger cowl area) and checked for loosed wire, nothing found. Where the loose ground wire is located? I checked under the seat (didn't do a through job, but looked).
Ford - Explorer :: Hard Jerk While Changing Into 2nd Gear - Error Code P0715
The other day, my Explorer gave a hard jerk while changing into 2 (maybe 3rd?) gear. Never happened before. I was under 20 MPH & had just stared it. (My speedometer works as do all the dials.) My Check Engine light came on & when I had the code pulled it read quote "P0715."Transmission Speed Sensor circuit condition. Vehicle speed above 15 MPH while transmission output shaft speed below 60 RPM. Possible cause Failed transmission speed sensor or electrical problem"
I got a Transmission Speed Sensor, (which I haven't put in yet), and was told that this would solve the problem. My question is twofold: Is there ANY chance this is a false or misread code and the problem is something else? And could ANOTHER sensor attached to the transmission be the cause? (How many sensors are on the tranny?) All I've read about this problem, say's replacing the Transmission Speed Sensor is preceded by the SPEEDOMETER quitting, but mine works fine.
The truck is a 1997 Explorer 4x4, but I don't use 4x4. In fact I've driven it without the forward drive shaft ever since I had the BW4405 Transfer Case replaced.
Explorer :: 2000 - Pulled Over Error Code PO172
My daughters 2000 explorer has a PO172 code, tune it up,Replaced filters plugs & wires and rear O2 sensors that were damaged. Has 65 psi on fuel rail. Can not find any vacuum leaks. Not sure maybe injectors are dirty.
Also I replaced MAF, now it idles, But it's a rough Idle,Gets worse in gear. She say's on cold start up she can smell a whiff of gas ..
Ford Ranger / B-Series :: 1997 - O2 Heater Circuit Codes For All 3 Sensors
1997 2wd, 4.0 - As you can guess it runs pretty bad at idle. It has O2 heater circuit codes for all 3 sensors. I'm leaning towards the ECM because the 2 heater wires are both hot with the key on. I unplugged the computer and turned the key on and just one wire is hot. Looks like the ecm is supposed to ground the wire to turn the heater on, but it's going hot instead?
View 14 RepliesAvalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Ford F-150 - 1997-2003 :: Vacuum Leak - Error Codes Indicating Bad O2 Sensors
I am having problems with a 2003 Ford F 150 with a 4.2 L V6. The problem is that it is giving me code errors that would indicate bad O2 sensors. I replaced both the upper and lower O2 sensors, and still I get the same codes. I was told by the mechanic with the computer reader that this usually means a bad vacuum seal. He suggested looking for bad hoses, but did not offer much more than that. How to proceed?
View 2 RepliesFord - Explorer :: Transfer Case Sensors Name?
I just replaced the transfer case BW 4405. And I noticed that the 2 sensors (front drive shaft and rear drive shaft) are bad. What is the name of these two sensors? I'm looking for a brand new ones...
View 13 RepliesFord - Explorer :: ABS Light Still On But Sensors Replaced
I've replaced the rear sensor and the two front ones on my 2002 Ltd, but the lights still on! It's driving me crazy...what now?
View 7 RepliesFord - Explorer :: 1998 V6 - No Data From O2 Sensors
I have a 1998 Ford Explorer 4.0 V6 with 200K miles. I plugged an OBII scanner with live data readings and my o2 sensors never relayed any information (voltage), they all ead -100% and the voltage never changed. Could all four be bad? I left the truck running for 15 minutes with the scanner attached and nothing changed.
BANK 1 SENSOR 1 = -100%
BANK 1 SENSOR 2 = -100%
BANK 2 SENOR 1 = -100%
BANK 2 SENOR 2 = - 100%
Ford - Explorer :: 1998 XLT V8 - CEL Has Been On And Off Sporadically - Both Upper O2 Sensors Are Shot
I have a 1998 Explorer XLT with the 5.0L V8. My check engine light has been on and off sporadically for the past two months. Lately, it has been on more than off. I brought it to a local place to diagnose the problem. Both upper O2 sensors are shot. What kind of difficulty level am I looking at if I tackle this myself?
View 14 RepliesLexus LS 2007+ :: 2014 LS460L - Check Headlight System Error Popped Up
2014 LS460L "Check headlight system" error popped up. Since the RV mirror failed as well apparently the system is not getting the light sensor signal from the mirror and brings up the HL error. Where is the RV mirror fuse? I took off the fuse cover to the left under the steering column but can't find it. It's not practical to unplug and check all 26 fuses, owner manual is useless...
View 6 RepliesSanta FE SM (2001-06) :: Changed Bank2 Sensors But Still Getting P0174 Error
Still getting p0174 error after upsteam downstream, checked everything.
View 1 RepliesFord Excursion :: Started Spattering And P1280 Code Popped Up?
I did a CCV MOD and washed the engine with simple green and a garden hose yesterday, started the truck and it was running fine for about 10 min. After that it started spattering and a P1280 code poped up. Is it related to a wash or ccv? It does not stoll but idles bad, drives fine once i get it over about 5mph.
View 1 RepliesGolf/GTI VII :: System Error - Parking Sensors Beeping And Button Flashing
I am owner of brand new Golf Sportsvan 1.4 92kw petrol, 6 speed manual. Since day two ive been noticeing that something might be wrong with my car. Second day of ownership i was greeted by TPMS, ESC, Auto hold and Stop start system error all at once, and parking sensors were beeping and button was flashing. Ive been reading about it and its not new for MK7 owners as i can understand. But what worries me most is the revs when the engine is cold and i start it up first time. Did a video and uploaded it. [URL] .....
Weird thing is i only get errors when its cold start, i mean for example yesterday and today it was cold here (-5 degrees celcsius) and car started up with no errors, but the revs where bouncing up and down like seen on video. Sometimes i get those 4 errors aswell and rev problem, sometimes only rev problem, but when the engine is at the working temperature i get no errors, no shakey revs.
Otherwise love the car. Solid build quality, Spacious, Like the pyramid gold color, lovely car, beside those gremlins.
Ford - Escort - Code :: 1443 - Service Engine Soon Light Popped Up
Last year my car popped up with the SERVICE ENGINE SOON light. I am cheap so I went out and bought a code reader- code 1443 came up. Online I found this information: 1443-Evaporative Emission Control System - Vacuum System - Purge Control Solenoid or Purge Control Valve fault. I bought something from Ford for $81, erased the code and it came back on a week later. I just kept erasing it. It quit coming back on in November so I figured the bulb had burned out but the Light came on when I started the car. So I just ignored it. Now that the weather has warmed up again the light comes back on with the same code. Other question. Are there any modern cars that are as easy to work on as, say, a 68 Falcon? Or even a 74 Pinto? I don't expect real ease I just want to be able to stick my hand in the engine compartment with a blood sacrifice.
View 1 Replies