Ford - Explorer :: 1998 XLT V8 - CEL Has Been On And Off Sporadically - Both Upper O2 Sensors Are Shot
I have a 1998 Explorer XLT with the 5.0L V8. My check engine light has been on and off sporadically for the past two months. Lately, it has been on more than off. I brought it to a local place to diagnose the problem. Both upper O2 sensors are shot. What kind of difficulty level am I looking at if I tackle this myself?
View 14 RepliesFord - Explorer :: Transfer Case Sensors Name?
I just replaced the transfer case BW 4405. And I noticed that the 2 sensors (front drive shaft and rear drive shaft) are bad. What is the name of these two sensors? I'm looking for a brand new ones...
View 13 RepliesFord - Explorer :: ABS Light Still On But Sensors Replaced
I've replaced the rear sensor and the two front ones on my 2002 Ltd, but the lights still on! It's driving me crazy...what now?
View 7 RepliesFord - Explorer :: Error Code For O2 Sensors Popped Up / Heater Circuits Gone Bad?
I have a '97 XLT, 5.0 and the error code for the O2 sensors has popped up, when checking it shows there isn't voltage for the heater circuits. I see there are 3 different heater circuits, 1ea for the left & right O2 sensors and a common one for the catalytic converter O2 sensors, so I ordered another PCM.
View 14 RepliesSensors :: 1998 Chevy Cheyenne C1500 4.3L V6 - Codes P0420 And P0131
1998 Chevy C1500 4.3L V6 170,000 miles
My truck is stumbling and losing engine power sporadically. When this is happening I can usually drive it if I am real easy on the gas and slowly build up speed but if I mash it the engine will eventually just die completely. It has had this problem off and on for several years and now it's back with a vengeance. It always seemed to happen after a heavy rain but now I'm not sure.
Last week I had a mechanic look at the codes and he cleared them saying that once it happened again the code(s) that showed up would be a good indicator of the actual problem. The codes that were there were for a couple O2 sensors, catalytic converter and loss of vacuum I think. It happened again and his shop was closed so I got it read and cleared somewhere else and it was P0131 bank 1 sensor 1 and since I knew that one had come up before I went ahead and replaced it myself.
The next day the CEL came back on without any noticeable engine trouble. That was yesterday, this morning it rained and the problem is back and I went to get the code read and it was the P0420. There was also C0281 stop lamp circuit something or other that was new.
My gas mileage has stayed pretty good this whole time, always 15+mpg. Just wondering if my catalytic converter probably needs replaced, if I should replace other O2 sensors, or if this all might indicate something else in the engine.
Chevrolet - 3500 :: 1998 - Check Engine Light On / Codes For MAF And MAP Sensors
I have a 1998 chevy 3500 2wd pickup with a 454 engine. The check engine light is on. I have had the codes read and they were for a MAF and MAP sensors. I have replaced both. The check engine light is still on saying that I have a bad MAF sensor. I replaced it again. The check engine light still is on. What else should I look at to fix this problem??
View 19 RepliesToyota - Acceleration - Rav4 - Sensors :: 1998 - At Start Up Accelerator No Longer Has Any Effect?
98 Rav4 (130,000 miles) starts fine, idles fine, runs fine for 30 seconds then the accelerator no longer has any effect. I can put the pedal to the floor, but there is no gas getting to the engine, it will idles but doesn't go. Until it warms up to operating temperature and then it is just fine.
This gets worse the more times I stop for an hour then try to go again - it is better when it is starting from being completely cold.
The check engine light does not come on, two different mechanics have tested it - no codes are produced - the computer thinks everything is just fine. One of the mechanics called his buddies at a Toyota garage in California but none of the 12 mechanics there could figure it out.
Ford - Explorer :: 1998 - Low Beams Went Out
Got a 98 explorer eddie bauer and the low beams went out. A search through the console revealed this explore doesn't have the lamp/light out module. So i guess a multifunction switch would be the next place to go? Fuses look good too btw.
View 3 RepliesFord - Explorer :: 1998 - Blowing Hot Air Even In Max AC?
My 98 Limited started blowing hot air yesterday, even in Max AC. It even blows hot air out the defroster when the climate control is shut off. It started doing this 2 days ago, but I could still get sporadic cold air from Max AC, but now nothing. What could be the problem?
View 8 RepliesFord - Explorer :: 1998 V6 Stuck In 4 Low
Okay here is my issue : I have explorer 98 v6 4.0L 4wd .. I changed my transfer case with the shift motor because the old one was making noise and grind .. I put a good used and tested transfer case but once i started the car to test it I noticed its feels loke stuck in 4 low ..
I parked the car and switched it to 4wd Hi. The light of 4wd hi came ON in the dash. Then I put the shifter in Neutral and moved the switched to 4wd low but the light of 4wd hi stayed ON never seen the 4 low light in the dash. I'm so confused and disappointed now. Even with the old bad transfer case it was fine other than the noise the transfer case making.
Ford - Explorer :: 1998 Not Starting / Only Click When Turn The Key
I was told by the dealership that the battery was bad and needed to be replaced ( which I did) I went out to my car this morning and had the same problem. When I turn the key nothing happens. When I turn the key you hear a click but that is it.
View 3 RepliesFord - Explorer :: 1998 - Won't Shift Into Overdrive / No Reverse Right Away?
Got a call from my little sister about two weeks ago that her Ford Explorer would not drive forward. Checked it out and put it into second to get it home.Last weekend me and my dad changed the filter and fluid and then drove it for a bit. It sounded a little better but still would go into drive or reverse. We shifted into second which we knew worked and then back into reverse immediately and now reverse worked, although sluggish. The same was true for drive. A few days later dad changed a solenoid and now it will go into drive and go up to 15mph, but will not shift from first to overdrive first. And still no reverse right away. She is able to get to school with second gear and pop into drive when she gets up to 40-45mph. If she has to backup from start, first she has to put it into second and then back to reverse. Something in overdrive doesn't seem to be doing its job right.
View 3 RepliesFord - Explorer :: 1998 - Truck Hiccuping And Stuttering
My 98 explorer is hiccuping when i am stopped for more than a few seconds and when I press the gas to get going it stutters. It only does this if I am stopped at a light or stop sign for a few minutes. Once I get going again it runs fine. The check engine light is not on and I have replaced the o2 sensors and spark plugs. I am at a loss on what to do next.
View 6 RepliesFord - Explorer :: 1998 - Backfiring / Smells Like Sulfur
My ford just suddenly started backfiring and started smelling like this sulfer kind of smell and knew I needed a new exhaust so I got a new tailpipe and muffler and problem still persisted so then I replaced the driver side catalytic converter because I had noticed after driving it that it was smoking after driving it. So now I've replaced that and i still got the smell and it just rides rougher and the check engine light is blinking after driving a couple minutes....
View 9 RepliesFord - Explorer :: 1998 - ABS Light In - Worn Pads?
I'm thinking about buying a 98 Explorer that has an ABS light on. I haven't looked at it yet. In the ad, the seller claims it's due to worn brake pads in the rear. If that's true, then it's not a big deal. Can the ABS light be set by worn pads? Most of my cars are too old to detect this, but even if they did, I wouldn't know because I never let my pads get that low.
View 7 RepliesFord - Explorer :: 1998 - Transmission Seal Coming Off
Have 1998 Explorer with 5R55E tranny and the automatic transmission extension housing seal keeps coming off, allowing a fluid leak. I just replaced it and it's doing it again. When I put it in there, it seemed tight, but... How to keep this thing in there?
View 3 RepliesFord - Explorer :: 1998 - Seat Lumbar Not Working?
My explorer 98 seat lumbar does not work. When i push the switch i only hear a motor noise and nothing happens. How to fix that?
View 6 RepliesFord - Explorer :: 1998 - Getting No Fuel - Fuse Not Blowing?
my wifes explorer is getting no fuel. (there is a valve I depressed similaR to a tire valve, I pressed it once some fuel dribbled out, and thats it, turned the key several times and not a drop off fuel. I went as far as checking the fuse, the fuse is not blown. what are my next steps of trouble shooting.
View 8 RepliesFord - Explorer :: 1998 XLT - Dome Light Won't Turn Off
Has happened twice now but last night I had to disconnect the battery. A few years ago the driver's door switch was replaced for the same reason. I would do it again but I can't find anything that looks like a switch. Where that thing is? It is a '98 Explorer XLT.
View 4 Replies