Passat (B6) :: 2007 - Error Code Of P0171 System Too Lean
I have an 07 passat with a 2.0 4 cyl turbo and I have an error code of P0171 system too lean (bank1) but engine seems to run just fine, what this code means, am wondering if it is something I can fix or if it needs to go to the shop??
View 2 RepliesSanta Fe (CM - 2007-12) :: Cover For The Shift Lock Release Is Gone
While driving today I noticed that something didn't look right in the gearbox of my santa fe. It turns out that the cover for the shift lock release is gone. I have no clue what happened and for some reason its bugging me so I need to get one.
View 7 RepliesPassat (B6) :: 2007 - At Start Up Got Message Steering Column Lock Malfunction?
I've been having an intermittent problem starting our 2007 Passat 2.0T. Sometimes when I insert the key fob into its slot the car starts then stalls immediately. The steering wheel icon is displayed and the MFD says "Steering column lock malfunction". The car eventually starts after several attempts but I'm wondering what's causing the problem
My wife are both guilty of two things that I've read in the manual and I'm thinking that may have contributed or is causing the problem. We both insert the key and push it in to start the car in one motion. The book says to do it in three motions. We also do not depress the brake pedal when starting the car.
Needless to say we are not going to that anymore. If I may have done damage to the steering column and its associated parts?
Passat (B5) :: Child Safety Lock On Passenger Side Rear Door Won't Release
Since I had my '02 I've had the child safety lock on the passenger side rear door on (active). I went to disable it (you know, stick the ignition key in and turn it 90 degrees to the side without the child's picture) and I'm still unable to open the door from the inside.
Everything else with the door works fine. The power locks work. Even pulling the handle twice pushes the lock button to the up position. And opening the door from the outside works as it's supposed to. The only thing I cannot do is open the door from the inside. Have I missed anything?
Elantra XD (2001-06) :: Power Steering Squeal When Turned The Wheel To Full Lock
I have an 02 Elantra GT. I was dropping off a friend who knows cars and went to turn around, turned the wheel to full lock to make the turn and heard a squeal. I asked my friend what it was and he said it was the P/S and I just needed to add some P/S fluid. I got some fluid and sure enough when I went to fill up the reservoir it was below to MIN line, not too much below but still below it. I filled up the fluid and didn't hear the problem for the rest of the day but this morning I heard the same noise when I was leaving for work. I figured the fluid had to work its way though but am not sure if there is something else I should check or do.
View 3 RepliesSonata NF (2006-10) :: Radio Stays On And Steering Column Does Not Lock After Ignition Turned Off And Key Removed
This started today, when I turn off the ignition and remove the key the radio stays on and the steering column does not lock. The guy at the dealership suggested spraying wd 40 into the ignition. No go.
2008 sonata.
Avalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement
So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?
I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.
Prius (2001-03) :: Error Code 1554 - Power Steering Won't Working
I have just won a Mk 1 Prius on eBay and hope I have made a good choice - not having seen the car! There is an error code: 1554 which apparently is why the power steering isn't working
View 8 RepliesPrius (2004-09) :: P0A08 Error Code - Losing Steering And Brakes While Driving?
Previous thread (with new subject title) on my 06 Prius losing steering and brakes while driving with multiple errors (red triangle, battery, etc.) while braking on steep down hill section of hwy 17 (mountain road). Took car to dealer but dealer could not find the root cause.
View 4 RepliesCamry :: 2007 SE Getting Error Code U0073
My 2007 Camry SE has an intermittent electrical issue. The problem started yesterday, no accidents of any time ever in the car. 195,000 miles on car.
As I was driving along the speedometer, tachometer, temp gauge all started bouncing. Simultaneously the ABS and Emergency brake light came on. The engine did not change, still drove fine. I got the code U0073. I checked a couple obvious fuses like ABS and Alternator as well as cleaning the contacts on the computer at the actuator. I've also checked my battery terminals -- fine.
I am hoping to narrow something down other than just going straight to replacing that ECU by the actuator. That is an expensive part not to be 100% sure of it, but as it stands now I would almost rather it be something "simple" like that because chasing these electrical phantoms is quite aggravating.
Also all the items I have focused are based off the assumption it is something electrical revolving around the ABS unit. Is it possible the instrument cluster is the culprit, wiring in the harness or a simple fuse related to that panel?
Santa Fe (CM - 2007-12) :: Invalid VIN Error Code Shown
Check engine light is on, when I went to get my car inspected it was showing an invalid vin code. How do get this off so I can get my emissions done?
2007 Santa Fe SE
Passat (B5) :: CEL And Error Code P1476
I have this error code on my VW 1999 passat 1.8T automatic car. How to resolve it. My friend reset it and CEL went off for few days and now it came back again. How to resolve it??
View 2 RepliesPassat (B5) :: Getting Error Code 0012?
It happened to passat. Once I hit about 75mph on highway I get a stop engine (oil presser low light). It flashes than goes off once I lower my speed. I checked all fluids are normal. It throws a 12 code an says oil passage blocked, cam positioning sensor, skipped timing chain. These are what the code says could be wrong with it. The car runs fine with no hesitation at idle or normal city driving. I have already flushed the oil with cleaner, and still getting the light.
View 5 RepliesPrius (Gen 2) :: 2007 - Error Code P0ac0, P0afa Diagnosed
Car was perfectly fine. Parked it in a parking spot, turned it off for a minute, started it back up, and BAM, Master Indicator Light is illuminated(not blinking), along with check engine light. (yellow, not blinking)
Code reader gives me these two codes: P0ac0 and P0afa
Santa Fe (CM - 2007-12) :: Misfires Along With Error Code P0341 / P2189
I have a 2008 model 2.7 v6 with 80000 Km, and I would like to share my experience with several issues:
- Random misfire: brought the car to Hyundai, very bad response. I bought online the wiring of the spark plugs (according to them that was the reason of the misfire) and they installed it, did not improve. The car was still showing error code after clearing, and the fuel consumption at an average of 23L/100km.
- I then decided to change all the 6 spark plugs, no difference. The workshop told me the coils were in perfect condition. Still having a message like this: "ignition error on 2 or more spark plugs".
- I did a complete cleaning with contact spray of the MAF sensor.
- I bought online a couple of ignition coils, being original Hyundai ones, and changed them. When installing them i realized the existing ones were not original Hyundai and had a small marking, making me think they were recycled or chinese stuff.
- Having done that, the OBDII shown two more error codes: P341: error on camshaft position sensor, P2189: fuel idle (too much air, maybe caused by the first one). Changed both camshaft position sensors and then big change in the behaviour, more response, throttle, better gear switching.
- I so concluded that the 4 remaining coils have to be changed and ordered another time 4 of them online. OBDII showing now only one error code: random misfire. The engine going much better than all i got before.
- I have decided to take advantage of this order and also ordered a new TPS (seeing here that it was a common problem) and a Crankshaft position sensor (in order to prevent any other issue).
- I also changed previously 2 downstream o2 sensors that were giving an error related to emission. Emission here are not strictly controled so it is not a big issue.
My question is, what in all that sensors can more likely make my car burn 23L/100km??? Asian cities are quite similar to american cities, lots of highways. This consumption compared to what you describe is way over the normal one isn't it? I was assuming the ignition problem was the responsible, am i right?
Santa Fe (CM - 2007-12) :: Error Code P0057 - O2 Sensor Replacement
I need to replace O2 Sensor which is Bank 2 Sensor 2 which needs to be replaced.
Where is this located on a 2009 Hyundai Santa Fe 3.3L
Santa Fe (CM - 2007-12) :: Error Code C1627 - ESP Light Is On And 4WD Blinking
I have an issue in my car (Santa fe 2011) and it occurred since it was new (ODO 3000 KM , ESP light is on and the 4WD Blinking) . the agency could not resolve the issue. and my car up to now been in and out from the workshop for more than 6 times . and more the error code ( C1627 ) that appears in the GDS(Global Diagnostic System) does not exist in the system (troubleshoot manual) .
View 5 RepliesLexus ES 2007-12 :: Got Error Code C1201 / P0057 / P0161
So I just bought a used 2007 ES 350. One week into ownership the check engine light, vehicle stability light (car with swerving tire tracks) and check vsc lights all come on.
I got the codes read and they are C1201 P0057 and P0161.
The last two I believe are oxygen sensors and the first is a vague engine control problem?
The lights come on for a few days, then go away for a few days.
The non-Lexus dealer who sold me the car sent me to a mechanic who says the lights will likely go away all together if we just replace the correct O2 sensors.
The car also vibrates when moderately applying the brakes at speeds higher than 60 mph- is that normal?
Passat (B5) :: OBD-II P1818 Error Code - Faulty TCM?
I was able to borrow an OBD-II scanner to read the error code(P1818) currently displayed. I was wondering if the P1818 Error Code is related to a faulty Transmission Control Module (TCM).
View 1 Replies