Aurora :: 95 - Slams Into Gear Hard Enough When Put Into Reverse
I just bought this problem child and I am having som trouble finding out why when you put it into Reverse it slams into gear hard enough that the nose dives down. I cant figure out why. Then RPMS are always low like 800 and it acts like its at 2500. It slamms that hard.
The 2nd issue is when I push the brakes there is a vaccum sound from under the dash and the brake pedal gets hard and the car does not stop well. I assume it is the brake booster but I have not tore the dash appart yet.. The RPMS dont drop out when the vaccum leak starts and thats what confuses me.
Ford 6.7L Power Stroke Diesel :: 6r140 - Transmission Slams Hard Into Reverse / Shifting From 1 To 3 Is Awful
I'm having problems with my 6r140 in my 2011, the truck is an early build around 8/2010 I believe.
After cold soak when shifting into reverse after allowing engine to warm a bit the transmission almost always slams hard into reverse.
After that shifting from 1-3 is awful, the transmission will try to go into 3rd but downshift to 1st then fail to go back into 3rd multiple times. This situation is extremely dangerous when trying to pull into traffic.
Oh and once the transmission gets into 3rd it will skip 4th and go right into 5th. There is only 94k miles on this transmission/truck.
I just bought this truck about a month ago, does this sound like an issue with the solenoids in the valve body?
I'm very mechanically inclined and can swap them if need be but now we're talking few hundred in solenoids and then getting the trucks pcm flashed right?
Also fluid has been changed and I used mercon lv.
Santa Fe (CM - 2007-12) :: Stops With A Bang In Reverse
This is the 4th time this has happened.While in reverse it will suddenly lock up as if I hit a large object,and the anti skid light will come on and also the all wheel drive light will come on.I will then shut off the engine and start the vehicle were the lights on dash will reset and go off.
View 7 RepliesFord F-150 - 1997-2003 :: 2000 5.4L 4x4 - OD Hard Shift / Slams Into Gear When Give It Little Gas
I have a 2000 F150 5.4l 4x4. When I am going over 50 on the highway and I am in OD, if I let off the gas a couple of seconds later it feels as though the brakes come on because the truck slow down so drastically and when I give it a little gas it slams into gear. It feels as like there is a "gap" where nothing is engaged before it slams back in. This is a rebuilt tranny with less than 7K miles on it. I took it back once and they said it was the motor mounts. I had those replaced and still the same problem. I replaced the spark plugs 6K miles ago and the COPs 3K ago. There is 170K on the truck. I only drive about 8K miles a year.
View 2 RepliesAccent LC (2000-05) :: Car Doesn't Want To Go In Reverse And 5th Gear
Just bought a 01 Accent hatch the other day. It's a 5 speed 4cyl. First gear through 4th have no problems. If I try to shift into 5th gear or reverse, the car doesn't want to go into them. The dealer I got the car from said that the problem is with a pin or something. I have never bought a Hyundai before this, I've had old 70s american cars. I was thinking it could be a shifter linkage but I figured I would ask you knowledgeable people about it first before I go and break something trying to fix something simple (hopefully simple.
View 8 RepliesAccent LC (2000-05) :: Rough Idle While Drive Or Reverse
I have a 2000 Accent with about 150,000 miles on it. Recently I have noticed that when my car is sitting in an intersection, the car appears to idle roughly. I would't exactly say that the car is idling rough, cause it stays at a consistent RPM while in drive or park, but the engine gets louder and the steering wheel starts to vibrating. When I slightly step on the gas, the vibration goes away. Also, when I put my car in park or neutral, the car quiets down and the vibrating stops.
I was wondering if it could be the throttle position sensor, or maybe a broken motor mount, but I haven't had a chance to look into it it. I did replace the purge control valve last week, which slightly improved the vibrations.
Accent LC (2000-05) :: Scrapping Noise Quiet Down When In Reverse
What this sound is? I thought it was the brake pads so I tried to change them and broke the bolt on the caliper (both sides). Long story short, the car now has new pads, rotors AND calipers. But i hear this scraping sound. Follow the link to a youtube video. It speeds and slows with the car and doesn't change when i apply the brakes but seems to quiet down when I'm in reverse. Wheel bearings seem unlikely since the sound doesn't change when I turn the wheel to either side.
Video: [URL] ....
Accent LC (2000-05) :: 2001 GL Transmission - Reverse Gear Went Out
I have a 2001 Hyundai Accent GL the reverse gear went out but all the forward gears work. Ive been told that I need a new transmission. I found a great deal on a transmission from a 2007 Hyundai Accent. Will this transmission work in my car?
View 1 RepliesAccent LC (2000-05) :: 2003 - Squealing Noise In Reverse
I have a 2003 Accent with 30,000 miles on it... It is making a variety of noises right now but the latest and loudest is that when I am backing out of parking spot or something like that it makes an awful squealing noise... What that might be?
View 2 RepliesAccent LC (2000-05) :: 2004 - Lost Reverse And All Gears Aside From First
I have the opportunity of getting i believe a 2004 accent gt for next to nothing. It recently lost reverse and all gears aside from first. The codes it is triggering are p0734 p0732 and p0733. Prior to throwing the codes it moved back but wouldn't budge forward. With codes no reverse or any gear higher than first. Car has 160k miles I am pretty mechanical. Should I run from this "cheap" "gas saver" or pick it up? With all 3 codes could it be just that sensor?
View 6 RepliesSanta Fe (CM - 2007-12) :: Hard Bang When Shifting Under Low Speed?
I need to know if this is considered "normal" behavior of the transmission. This cold morning while driving in traffic the car just jerked really hard while shifting from 3rd to 2nd and as described in other threads its like someone rear ended the car.
It has only 2650 km, it's a 2012 2.4 6sp automatic 4wd Santa Fe, should I waste my time going to the dealer? It only happened once, no engine light no nothing. Could it be just a "glitch" in the ECM? I read some other threads before posting, but they were a bit older. Has experienced such a shifting bang under low speed with so little mileage?
Accent LC (2000-05) :: Whistle When Speed Is Stable (between 90 And 120 KM/H)
When I'm on highway (between 90 and 120 KM/H) I heard a whistle when speed is stable. it happen frequently in the last week. I notice it happen approximately at 95 and 110 KM/H. When I remove my feet from accelerator, I don't hear the noise anymore.
(Accent 2002 hatchback).....
Accent LC (2000-05) :: Speed Sensor Location?
trying to find the speed sensor on a 03 accent manual so I can fit cruise control
View 1 RepliesAccent LC (2000-05) :: No Reverse - P0732 And P0734 Codes Thrown
I have an 02 accent with 1.6 that has no reverse and throws P0732 and P0734. How to repair?
View 5 RepliesAccent LC (2000-05) :: Auto Trans Went Out / No Reverse And The Only Forward Gear Is First
I've got a 2003 Accent and my automatic transmission went out, no reverse and the only forward gear is 1st. Was thinking of pulling it and swapping it for a used, but I have been reading on here the many, many automatic transmission problems of the accent and my next thought was to just rebuild it myself. But now I'm thinking more along the of a swap from auto to manual, as I don't want to have to rebuild a transmission that is only going to have to be rebuilt again anyway. As far as stuff like the clutch pedal, linkages, gear shifter, I can get those pretty easily. Does the Accent have a hydraulic clutch?
View 2 RepliesAccent LC (2000-05) :: 2004 - No Reverse / Shifts Hard Into Drive
2004 accent had a drink spill on lower console, and think this is why it quit shifting? Disassembled, cleaned switches, unhooked battery, and car still has no reverse, shifts HARD into drive, will not move further.
View 5 RepliesAccent LC (2000-05) :: 2004 - Clutch Lost All Resistance / Hard To Get Into Reverse
I'm not very mechanical when it comes to cars. I have never had any clutch issue with my car. I arrived to work yesterday fine. When I started to leave it was incredibly hard to get into reverse and I had to force shifting after I left and the clutch had also lost all resistance and I could easily push it all the way to the ground. What could be a cause of the clutch always working perfect including the last time you drove it, and then 8 hours later you start up and it has done a 180. The fluid level is fine. I would presume if my clutch had went I have have slowly noticed it going.
View 1 RepliesAccent LC (2000-05) :: Overheating Constantly - Car Won't Go In Reverse And Has Hard Time Shifting Sometimes
I have a 2003 Accent and it has been over heating constantly for about 5 months. After it started, we replaced the main radiator hose, thermostat, radiator cap AND a head and head gasket. It worked for about 2 weeks and then over heated again. It seems like there is too much pressure somewhere because the lid for my reservoir shoots off and all the coolant comes out. I'm just not sure where to look for a clog since it is coming out of the reservoir. It also recently started having transmission problems(?) or that is what I think it is... It won't go in reverse and has a hard time shifting sometimes. I'm not sure if it could be related or if it is the tranny also.
View 4 RepliesAccent LC (2000-05) :: Slam And Stop Briefly When Put In Reverse Then Change Into Drive
'05 Accent, 19k miles. Car has been great, except suddenly I'm getting a weird shifting issue when I first start the vehicle. After I put the car in reverse, then change into drive, the car SLAMS and stops briefly, as if I've hit something. This has started to happen a lot lately.
View 1 Replies