Audi - A4 - Transmissions :: 2006 - Engine Hangs Around 1700 RPM When Trying To Maintain A Stable Speed
Recently bought an Audi A4 Quattro from a dealer with 112,876 miles on it.. The car runs absolutely beautiful, it up-shifts and downshifts without any noticeable issue, it changes gears without any issue, however... When I am trying to maintain a stable speed of around 35 - 40mph and my engine hangs around 1700RPM it'll bounce up and down slightly..
The revs will hop between 1700RPM up to around 1750RPM and then back down, and then up again.. It's hardly noticeable and the only time it causes any issue/delay is when it hops above 2000RPM and then back down... Is the torque converter the issue or what else could be the cause? Timing belt has been done, spark plugs have been checked, oil has been changed.
Accent LC (2000-05) :: Speed Sensor Location?
trying to find the speed sensor on a 03 accent manual so I can fit cruise control
View 1 RepliesAccent LC (2000-05) :: Buzzing When In Drive While Decelerating After Getting To Speed
A few months ago my automatic 2000 hyundai accent GL was having problems reversing. Some times it would, sometimes it would move a few feet then fall out of gear and stop, sometimes it would not move at all.
The reversing problem fixed itself about a month ago.
Recently i started having problems accelerating, it was noticeably slower to get to speed and had problems upshifting.
Today, it started to make a buzzing when in Drive, while decelerating after getting to speed. This buzz is nonexistent in neutral, 2nd, or low gear.
Here is a video of the sound it is making, with captions to explain what i am doing... 2000 accent transmission problem - YouTube
Accent LC (2000-05) :: P0501 Speed Sensor Code Lit Up
The MIL light up and I got the P0501 Code. (Speed Sensor. I use a Scangauge II and the Speed is 0 KM/H at any speed. (was working before). But the in dash Speedometer work no problem. I look on the HMAservice web page and did not found where is located the Speed Sensor.
View 9 RepliesAccent LC (2000-05) :: Jumpy Gas Pedal In First Gear When Going At Very Low Speed
I have a '05 Accent GLS Hatchback. 5-speed, manual transmission with about 82 thousand miles on it. I bought the vehicle used about 2 years ago. Ever since I've had it, its been a little jumpy in first gear when going at very low speed. Especially during traffic jams, barely pressing on the gas will cause it to jump a little bit until you put the pedal down further. Lately its starting to do something similar when it 4th gear. When you push your foot on the pedal it jumps a little and does the same thing when you take the foot off the pedal. What may be the cause? O2 or TPS sensor maybe? It did give me a flashing check engine light for about 10 seconds this morning but it hasn't done that since.
View 5 RepliesAccent LC (2000-05) :: Jerking /die Speed When Engine Gets Warms Or With AC On
My hyundai accent 2005, have problem of jerks /die speed after engine get warm, also increase if AC on, when I starts car in morning it works great and no problem but after 3 or 5 km as engine get hotter speed kills,but it happens more or worst in evening at 4 when returning from office and temp is 45+ in riyadh, saudiarabia.
I change air filter, fuel filter, spark plugs, spark cables, also use fuel injector cleaner but still problem remains, I want to tell you its start when I changed engine valve cover gasket due to oil leak, as I changed this problem suddenly appeared, I went to other mechanic but he told me the problem not in valve cover gasket,it is somewhere else he clean my throttle body ,and its works for 2 day only that i felt the problem solved but after two days problem appeared again,there is no engine light power on for any electronic malfunctioning.
Accent LC (2000-05) :: Stalls At Low Speed / No Coughing Or Sputtering
3 times now in the last week, my 2000 accent has stalled. each time it was at a low idle, slow moving speed. I was rolling up to a red light twice, and gliding into a parking spot the other. There was no coughing or sputtering. It just stopped. Each time, after about 20minutes or so, the car fires right up. it happened twice today after about 4 miles of driving. If the car sits for a day without running (on an off day from work) its a bit hard to start sometimes, but not consistently. Does this sound like a Crankshaft position sensor? or possible a fuel filter?
View 5 RepliesAccent LC (2000-05) :: 5 Speed Slams In Reverse With A Bang
I have a 2001 accent 1.6 5 speed manual. When I put it into reverse it dont fully engage until I give it some gas and then it slams into reverse with a bang. I am not really sure but I think it only does this with the car is cold I may be wrong though it started this a few weeks ago.
View 3 RepliesAccent LC (2000-05) :: Clicking Sound Proportional To Speed
Have replaced BOTH half axles. Clicking sound present when driving - does NOT change when turning right or left. Seems slightly affected by acceleration/deceleration - makes clicking slightly louder/quieter. Clicking is DIRECTLY proportional to speed - slows down until car stops. Transmission works fine, fluid level is correct. New trans fluid and filter. What the heck could this be? Wheel bearings seem solid - jack up car and try to wiggle wheel - solid as a rock both right and left sides. WHAT ELSE COULD THIS BE???
View 4 RepliesAccent LC (2000-05) :: Hyundai Does Not Speed Up When Press The Accelerator
I'm having an issue with my transmission. When driving it shifts just fine, but I have to let it accelerate slowly. If I press to hard on the accelerator pedal the engine ron races. So I ease up and it catches and slowly accelerates. For example going up hill, I press the accelerator and the car doesn't speed up, the engine races, so I have to just let the car slowly increase in speed by lightly pressing the gas pedal, no get up and go! Only occurs in 4th and 5th gears. What could be causing this. I have already flushed the gear oil as I had to replace the output shaft seal as it was leaking.
2000 Hyundai Accent 5 Speed Manual Transmission....
Accent LC (2000-05) :: A/C Not Working - Condenser Fan Won't Go Into High Speed
I have a 2005 accent gls. I use the car for deliveries so a lot of stopping/starting. when the car is hot, the AC compressor will shut off after 5 seconds, and not re-engage until about 20 seconds, then only on for 5, so not keeping cool air. I noticed when I turn the AC on, the condenser fan (i think) kicks into high speed so I assume that's what it should do, but when the issue is happening, it does not go into high speed. the shop I went to wasn't able to determine the problem. they checked pressure and evacuated the system. when it works, it blows cold as it should.
View 3 RepliesAccent LC (2000-05) :: While Driving At Slow Speed RPM Gage Goes Down
2005 hyundai accent, I've noticed something unusual with my trans, whenever I start driving at lower speeds ( which I do all the time to save gas) the transmission shifts into 2nd and 3rd just fine, but in 3rd gear ( at around 2.5 rpm ) the RPM gage goes down a little bit ( about 2.1 rmp), it almost feels like it went into 4th gear and it happens really smooth, it almost feels like its supposed to do that, the car later shifts into 4rd at around 3 rpm, there's no jerking, stalling or sounds at all, this does NOT happen when I take off at a higher speed and acceleration. This transmission has 55.000 miles on it and besides this it works perfectly fine.
View 1 RepliesAccent LC (2000-05) :: 2004 1.6L 5 Speed - Whining And Jingling Noises
I have a 2004 Accent with 150,000km on it. I've done a number of jobs on it, and I find it to be a relatively DIY-friendly vehicle. A little while ago I had an issue where it would die after warming up, sometimes at a stoplight. Otherwise, it would intermittently fail to start after it had been parked for a very short time. This was fairly obviously the crank position sensor, which I replaced. At this time, I haven't had the same issue again.
Since that small repair, however, I have been noticing other issues. From inside the cabin I can hear a distinct whine that climbs 1:1 with the engine RPM, whether or not the clutch is engaged. Once the RPMs hit the power-band(ha-ha), the whine is joined by a metallic jingle. From outside the car, both whine and jingle are audible through the entire RPM range. It sounds to me like a clear case of bearing noise coming from the belt and pulley system.
Since this whine started, the car has been giving lazier starts, requiring slightly longer to fire up. The noise changes significantly when the AC/defrost system are engaged, although I'm not sure if this is because the faulty part is connected to that system, or because the RPMs drop once it's engaged, both, or neither.
I will be doing a timing belt and water pump change before the snow flies, and I would love to find the parts that I need to treat the jingle at the same time as the rest of the belt system replacements.
Accent LC (2000-05) :: Steering Wheel Shakes Quite A Bit When Speed Is Over 50MPH
My old car has this problem when it's on highway the steering wheel shakes quite a bit. Is it a wheel alignment problem or wheel balancing problem? Since I've just fixed the transmission I am driving this car more often(to save gas) and this problem is really annoying.
View 4 RepliesAccent LC (2000-05) :: Thud Noise When Going Over 15mph And Gets Faster With Speed
My i40 (18 months old and already on it's 5th problem) has just developed an enormous noise (thud thud thud) when going over 15mph and gets faster with speed. If I go into neutral and turn the engine off at speed it is still there. The crazy thing is as soon as I veer or turn right it stops but when I turn left it does not stop. It's really lot and I can feel it through my feet and on the steering wheel. I am taking it into Hyundai (again) but I'd like to understand possible issues before I go in.
View 5 RepliesAccent LC (2000-05) :: Idle Speed Lost And Engine Stops
Sometimes I loose the idle speed and the engine stops when I stop the car but it could be started again with full throttle it doesn't happen always it happens from time to time > I changed the MAP, IS actuator and TPS .The fuel pump and filter is new .In rare cases engine stops during driving. How about flash programming the ECU
View 1 RepliesAccent LC (2000-05) :: Slight Clunking Sound From Under Chassis / Speed Correlated
I've noticed for quite a while there's a slight clunking sound coming from the front chassis. It's more noticeable when the car's moving slowly, and when the car's driving faster the clunking sound becomes a vibration. I think it clunk maybe once when the wheel is turning a full circle. Does this indicates a CV joint problem? Both sides of of the front wheels have ruptured CV boots(for a long time). I'm just too lazy to get it replaced. Is it easy to replace the boots and ball bearings inside it, or just to replace the whole axle? The axles are not very expensive any way. Is it possible to find out which side need to be replaced immediately?
View 5 RepliesAccent LC (2000-05) :: 2002 - Brake Chattering Will Rise Or Fall With The Speed
When I depress my brakes the right rear chatters, almost as if metal is on metal. Depending upon my speed when I brake the chattering will rise or fall with the speed I'm braking. Sound familiar?
View 9 RepliesAccent LC (2000-05) :: Thumping Kind Of Sound That Is Constant With Vehicle Speed
For about the last month or so my car has been making a strange thumping kind of sound that is constant with vehicle speed. slow or fast. changed the rotors, pads, hardware, shoes and machined drums. also has a slight pulsation when coming to a stop. Thought it was the tires but they look good. can not find anything wrong.
View 10 Replies