Accent LC (2000-05) :: Rough Idle While Drive Or Reverse
I have a 2000 Accent with about 150,000 miles on it. Recently I have noticed that when my car is sitting in an intersection, the car appears to idle roughly. I would't exactly say that the car is idling rough, cause it stays at a consistent RPM while in drive or park, but the engine gets louder and the steering wheel starts to vibrating. When I slightly step on the gas, the vibration goes away. Also, when I put my car in park or neutral, the car quiets down and the vibrating stops.
I was wondering if it could be the throttle position sensor, or maybe a broken motor mount, but I haven't had a chance to look into it it. I did replace the purge control valve last week, which slightly improved the vibrations.
Accent LC (2000-05) :: 2004 - No Reverse / Shifts Hard Into Drive
2004 accent had a drink spill on lower console, and think this is why it quit shifting? Disassembled, cleaned switches, unhooked battery, and car still has no reverse, shifts HARD into drive, will not move further.
View 5 RepliesGolf IV / Jetta IV :: Post Oil Change - Car Will Not Move In Drive Or Reverse
I just changed my oil in my mk4 jetta 1.8L and after draining the oil, changing filer, and adding new oil, the car will not move in drive or reverse. Once I give it gas it will move but that's at the higher rpms. I am almost positive I didn't remove the transmission oil but I am just not sure.
View 12 RepliesFord F-150 (2004-2008) :: Engine Revs Up Then Engages And Slam Into Drive While Decelerating?
My truck is a 2004 (new body style) 4.6L XL Supercab 4x4, trans code A, which I believe is the 4R75W transmission. I bought the truck used last year with 110k miles on it and it still only has 115k now. I think the problem with the trans was there when I bought it (it's highly intermittent) which may be the reason why the PO traded it in, because the truck is in excellent shape and has clearly been well cared for in all other regards.
The problem only occurs after having let up off the accelerator pedal for a while and coasting, then getting back on the gas without coming to a complete stop, like one might do coasting downhill or coming up to a light that turns green before you come to a stop. When that happens it feels like the transmission has shifted into neutral and the engine revs up freely for a second or two and then suddenly engages and clunks / slams into drive. This doesn't happen every time that I attempt to reproduce it, and it went for the entire summer without doing it once. But, now that winter is coming on in New England I find that it is doing it again once in a while. The problem seems to happen whether overdrive is engaged or not.
I've checked fluid level and condition and both are fine. Nice bright red color and no burnt smell. The transmission works well in all other ways except for this one issue. With the exception of this problem it seems to be engaging, driving and shifting perfectly, with no slipping, even when giving it a good romp, with or without 4x4 engaged, or even carrying a heavy load, causes no problems.
To me, this seems like a control problem of some kind, doesn't it? If it was mechanical or hydraulic I wouldn't expect it to only occur after coasting for a while.
Accent LC (2000-05) :: Bad Noises After Oil Change
I did an oil change recently, as I have done many times in the past, but this is the first time different noise like this could be heard.
I had synthetic in there before (mobil 1 + mobil 1 filter) because it was on sale for a ridiculous price, and I figured I would try it out. I now have Shell oil in the engine and it is the same weight (10w-30) as always. It is dino oil, supposedly with synth blend or something, and I also installed another synth filter.
I now have some minor valvetrain noise, a little louder than normal, and a tick that is loud - which is the part that really worries me.
Should I go back to synthetic, or should I look at the top end? I opened the valve cover, but nothing looks wrong at a quick glance.
Nissan - Altima :: Clunk Sound When Coming To A Stop And While Changing From Park To Drive / Reverse
I have a 13 Altima and have been hearing a clunk/pop sound when coming to a stop and sometimes when changing from park to drive and park to reverse. It seems to also be there when accelerating too and the car is also seem to be vibrating when moving at lower speeds. Today i noticed something else. I parked the car and took the key out. I went to the side of the car and slowly rocked it back and forth and started to hear this clunk sound. I have uploaded it to youtube and can be found here [URL].... . After hearing the sound, I decided to take the driver wheel off and noticed it makes the same sound when i move the tires. It seems to be coming from the CV joint, where it connects to the transmission. why would a car make that clunk sound with the car/key off and swayed back and fourth? does this seem like a CV joint issue or something related to the transmission.
View 3 RepliesAccent LC (2000-05) :: Transmission Oil / Filter Change?
My 2005 Accent will be due for a transmission oil change soon. (105,000.00mi). I have never done a transmission oil change before and I was wondering if it is necessary to change the filter as well. The maintenance manual says change the oil it does not mention the filter. I'm not crazy about removing the oil pan unless it is recommended.
View 5 RepliesAccent LC (2000-05) :: AC Not Working After Timing Belt Change
I just changed the timing belt and everything runs great. I pushed the AC button and no light came on. I checked all the fuses and they are good I took the H and L caps of and tapped the pin and there was air blasting out. Don't know what it could be? All I did was loosen the compressor and remove the belt and put it back on.
View 2 RepliesMitsubishi - Eclipse :: 2000 - Shakes When Put Into Reverse Or Drive
My 2000 Eclipse has a really bad shaking problem when put into reverse or drive. Also, it bogs down really bad when accelerating when first put into gear. It is the gs model. And I've searched everywhere online for an answer. It shifts fine. The idle drops down to around 500 when put into gear.. Whats the problem..
View 19 RepliesInfiniti - G20 :: 2000 - Dies When Put In Drive / Fine In Reverse?
Very strange problem for me especially since it's not my car, belongs to my sister. Only code that was set last month indicated the MAF so I cleaned it and the car ran fine. Started to hesitate up hills (steep uphill driveway) so I replaced the fuel filter yesterday and my sister said it drove just fine uphill. Now it stalls whenever put into drive, no codes set and none pending. It will idle in reverse but not in drive.
View 1 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Trans Occasionally Slam When Shift From Drive To Reserve
I have a 2008 for 250 6.4 powerstroke. Issue I am having is occasionally when I shift from drive to reserve it will slam when I shift to reverse. It is an intermittent issue. What causes this and what to do?
View 1 RepliesAccent LC (2000-05) :: Engine A Little Louder After Timing Belt Change
My mechanic just did the timing bet, water pump and other belts. Also changed the tensioner.
Car runs fine and everything seems great until I get to a red light. The engine sounds louder then before. Not very loud but its louder and maybe a very slight vibration, not sure yet. No noises while driving, seems like its running the same or better then before. Runs fine though
Honda - Prelude :: 2001 - CEL Went On / When Accelerating From Stop Engine Stutters Briefly
I got the car last fall so I don't know too much of the history. I will list the symptoms the best I can.-goes through about a quart of oil every 300 miles, looks to mostly come out the exhaust-seems to really blow smoke when the vtec activates-as the weather has gotten colder, it has been idling erratically until it warms up.-check engine light went on today-when accelerating from stop engine stutters briefly (this started when light came on)-warm idle speed now seems to be over 1000 rpm....
View 14 RepliesAccent LC (2000-05) :: No Radio / Power Windows / Fans After Battery Change
After changing the battery on the 2005 Accent, problem now is: no power windows, no radio, no air/heating fan, battery light always stays on. Checked all fuses in box besides driver seat an all OK. Rest of electrical seems ok ( int. and ext. lights, lighter, etc...). I would really really like not to have to bring it to the dealer.
View 4 RepliesCivic - Honda :: 2000 - Slipping Into Neutral From Drive Or Reverse Suddenly
it's a 2000 honda civic EX. I pulled into a parking spot and slowed down, then decided to speed back up and when I accelerated it was like the car was in neutral. No gear would drive. Turned off the engine and re started and it shifted and did fine then about a 1/4 mile down the road the same thing happened. It just switched into neutral. The transmission fluid is full and clean and the filter has been changed. There was no warning signs at all.
The only caveat I can think of is last week at 15 mph my front passenger wheel fell off after someone replaced a tire. I traveled less than 10 feet on the wheel. But didn't think the transmission would be low enough to hit the ground.
At first I thought transmission clutch but it would be doing it in one direction? Then I thought maybe a pump? Or could it be a sensor or the torque converter.
Ford Excursion :: 2000 V10 Shutting Off When Go From Drive To Reverse Or Brake Hard
My V10 Excursion is giving me a little bit of a hard time. Once warm, it shuts off when I go from drive to reverse and when I have to brake hard. I cleaned the mass air flow sensor and replaced the idle air valve behind the throttle body. Not sure what else I can do.
View 14 RepliesAccent LC (2000-05) :: Car Doesn't Want To Go In Reverse And 5th Gear
Just bought a 01 Accent hatch the other day. It's a 5 speed 4cyl. First gear through 4th have no problems. If I try to shift into 5th gear or reverse, the car doesn't want to go into them. The dealer I got the car from said that the problem is with a pin or something. I have never bought a Hyundai before this, I've had old 70s american cars. I was thinking it could be a shifter linkage but I figured I would ask you knowledgeable people about it first before I go and break something trying to fix something simple (hopefully simple.
View 8 RepliesAccent LC (2000-05) :: Buzzing When In Drive While Decelerating After Getting To Speed
A few months ago my automatic 2000 hyundai accent GL was having problems reversing. Some times it would, sometimes it would move a few feet then fall out of gear and stop, sometimes it would not move at all.
The reversing problem fixed itself about a month ago.
Recently i started having problems accelerating, it was noticeably slower to get to speed and had problems upshifting.
Today, it started to make a buzzing when in Drive, while decelerating after getting to speed. This buzz is nonexistent in neutral, 2nd, or low gear.
Here is a video of the sound it is making, with captions to explain what i am doing... 2000 accent transmission problem - YouTube
Accent LC (2000-05) :: Scrapping Noise Quiet Down When In Reverse
What this sound is? I thought it was the brake pads so I tried to change them and broke the bolt on the caliper (both sides). Long story short, the car now has new pads, rotors AND calipers. But i hear this scraping sound. Follow the link to a youtube video. It speeds and slows with the car and doesn't change when i apply the brakes but seems to quiet down when I'm in reverse. Wheel bearings seem unlikely since the sound doesn't change when I turn the wheel to either side.
Video: [URL] ....