Accent LC (2000-05) :: 2003 - Squealing Noise In Reverse
I have a 2003 Accent with 30,000 miles on it... It is making a variety of noises right now but the latest and loudest is that when I am backing out of parking spot or something like that it makes an awful squealing noise... What that might be?
View 2 RepliesAccent RB (2012+) :: Quiet Knock / Ping Sound When Accelerating Or Going Uphill On Low RPM
I am hearing a quiet knock from my 2013 accent, especially when accelerating or going uphill on low RPM. I am getting about 34 MPG after burning a tank of regular gas (87 octane rating) on my commute which is about 2/3rds 50-70mph freeway and 1/3rd stop and go traffic. I usually get more MPG than what the EPA rating is, so that number seems a little bit low to me, but I just got the car used, so I don't know what's "Normal" for it. Idle is pretty quiet though.
I would give a video where you can hear it, but honestly it is pretty hard to hear from inside the car. I generally have to be near a wall with the windows down or something to be able to hear it clearly.
2012 Accent 1.6L GDI Engine Rattle/Knock/Buzz
Also, there are no lights showing on the dashboard besides the ECO light since I have been running the car in that mode. Is it possible that there could be codes that might give more information even though nothing is showing on the dashboard?
Accent LC (2000-05) :: Car Doesn't Want To Go In Reverse And 5th Gear
Just bought a 01 Accent hatch the other day. It's a 5 speed 4cyl. First gear through 4th have no problems. If I try to shift into 5th gear or reverse, the car doesn't want to go into them. The dealer I got the car from said that the problem is with a pin or something. I have never bought a Hyundai before this, I've had old 70s american cars. I was thinking it could be a shifter linkage but I figured I would ask you knowledgeable people about it first before I go and break something trying to fix something simple (hopefully simple.
View 8 RepliesAccent LC (2000-05) :: Rough Idle While Drive Or Reverse
I have a 2000 Accent with about 150,000 miles on it. Recently I have noticed that when my car is sitting in an intersection, the car appears to idle roughly. I would't exactly say that the car is idling rough, cause it stays at a consistent RPM while in drive or park, but the engine gets louder and the steering wheel starts to vibrating. When I slightly step on the gas, the vibration goes away. Also, when I put my car in park or neutral, the car quiets down and the vibrating stops.
I was wondering if it could be the throttle position sensor, or maybe a broken motor mount, but I haven't had a chance to look into it it. I did replace the purge control valve last week, which slightly improved the vibrations.
Accent LC (2000-05) :: 2001 GL Transmission - Reverse Gear Went Out
I have a 2001 Hyundai Accent GL the reverse gear went out but all the forward gears work. Ive been told that I need a new transmission. I found a great deal on a transmission from a 2007 Hyundai Accent. Will this transmission work in my car?
View 1 RepliesAccent LC (2000-05) :: 5 Speed Slams In Reverse With A Bang
I have a 2001 accent 1.6 5 speed manual. When I put it into reverse it dont fully engage until I give it some gas and then it slams into reverse with a bang. I am not really sure but I think it only does this with the car is cold I may be wrong though it started this a few weeks ago.
View 3 RepliesAccent LC (2000-05) :: 2004 - Lost Reverse And All Gears Aside From First
I have the opportunity of getting i believe a 2004 accent gt for next to nothing. It recently lost reverse and all gears aside from first. The codes it is triggering are p0734 p0732 and p0733. Prior to throwing the codes it moved back but wouldn't budge forward. With codes no reverse or any gear higher than first. Car has 160k miles I am pretty mechanical. Should I run from this "cheap" "gas saver" or pick it up? With all 3 codes could it be just that sensor?
View 6 RepliesAccent LC (2000-05) :: No Reverse - P0732 And P0734 Codes Thrown
I have an 02 accent with 1.6 that has no reverse and throws P0732 and P0734. How to repair?
View 5 RepliesAccent LC (2000-05) :: Auto Trans Went Out / No Reverse And The Only Forward Gear Is First
I've got a 2003 Accent and my automatic transmission went out, no reverse and the only forward gear is 1st. Was thinking of pulling it and swapping it for a used, but I have been reading on here the many, many automatic transmission problems of the accent and my next thought was to just rebuild it myself. But now I'm thinking more along the of a swap from auto to manual, as I don't want to have to rebuild a transmission that is only going to have to be rebuilt again anyway. As far as stuff like the clutch pedal, linkages, gear shifter, I can get those pretty easily. Does the Accent have a hydraulic clutch?
View 2 RepliesAccent LC (2000-05) :: 2004 - No Reverse / Shifts Hard Into Drive
2004 accent had a drink spill on lower console, and think this is why it quit shifting? Disassembled, cleaned switches, unhooked battery, and car still has no reverse, shifts HARD into drive, will not move further.
View 5 RepliesPontiac :: Quiet Whoop Noise Every Time Turn Steering Wheel Either Way
All of a sudden I am hearing a quiet whoop, whoop, whoop everytime I turn my steering wheel either way. Could that be the bushings wearing out? If so, what must I do?
View 3 RepliesAccent LC (2000-05) :: 2004 - Clutch Lost All Resistance / Hard To Get Into Reverse
I'm not very mechanical when it comes to cars. I have never had any clutch issue with my car. I arrived to work yesterday fine. When I started to leave it was incredibly hard to get into reverse and I had to force shifting after I left and the clutch had also lost all resistance and I could easily push it all the way to the ground. What could be a cause of the clutch always working perfect including the last time you drove it, and then 8 hours later you start up and it has done a 180. The fluid level is fine. I would presume if my clutch had went I have have slowly noticed it going.
View 1 RepliesAccent LC (2000-05) :: Overheating Constantly - Car Won't Go In Reverse And Has Hard Time Shifting Sometimes
I have a 2003 Accent and it has been over heating constantly for about 5 months. After it started, we replaced the main radiator hose, thermostat, radiator cap AND a head and head gasket. It worked for about 2 weeks and then over heated again. It seems like there is too much pressure somewhere because the lid for my reservoir shoots off and all the coolant comes out. I'm just not sure where to look for a clog since it is coming out of the reservoir. It also recently started having transmission problems(?) or that is what I think it is... It won't go in reverse and has a hard time shifting sometimes. I'm not sure if it could be related or if it is the tranny also.
View 4 RepliesAccent LC (2000-05) :: Slam And Stop Briefly When Put In Reverse Then Change Into Drive
'05 Accent, 19k miles. Car has been great, except suddenly I'm getting a weird shifting issue when I first start the vehicle. After I put the car in reverse, then change into drive, the car SLAMS and stops briefly, as if I've hit something. This has started to happen a lot lately.
View 1 RepliesAccent LC (2000-05) :: Light Clunk When Shifting Into Reverse - AT Fluid Has Burnt Smell And Color
I bought a 2005 Accent with 150k one year ago and 3 months ago got AT fluid and filter changed. Color was very dark my mechanic friend said.
I checked the fluid and after just 3 months light driving, noticed it smelled burnt and so just changed it again yesterday and it was very dark.
Another piece of info is that previously when got the fluid changed 3 months ago the level registered way above high when car was off but then then normal when running in N. Same thing is happening now. My knowledgeable mechanic friend just told me to keep my eye on it.
There are no shifting issues, except for just light clunk when shifting into Reverse, but other than that it's great.
I just want to know what problems might be going on to burn the fluid so fast and have strange level readings when car is off but okay when on. I read some stuff about solenoids but because shifting is great should I even consider that?
Golf VI R :: Rubbing / Scrapping And Rattling Noise When Off Accelerator?
Last night pulling into a parking lot, I caught something on the lip of the entrance and there was a loud clunk. Naturally I looked for a different exit from the parking lot, but there wasn't one and on the way out I hit it again. Since then, I've had a loud scraping/rubbing/rattling noise whenever I'm off the accelerator. I haven't been able to get under the car to check things out, but my suspicion is that the resonator is rubbing on the driveshaft, and when I push the gas, the resonator moves down out of the way.
View 1 RepliesYaris/Scion & Vitz :: Scrapping Noise When Wheel Turned To Right
When I turn my wheel to the right, there is a scraping noise. Like, metal on metal. The more I turn, the more intense the sound. Does not affect driving performance, but it does sound problematic. As I turn the wheel, it starts making a scrape-scrape-scrape noise. It sounds like it could be a shield or wheel bearing, but I'm really not sure.
View 1 RepliesHonda - Accord :: Metal Scrapping Noise When Turn Left
My car makes a noise like metal scraping metal when I turn left. The sound comes and goes, and is loudest when I make a left turn from a standstill. I have had my car looked at twice in the past 3 months. The first place told me a need a new rack and pinion, and the second said my tires being low was the only issue. My car will go weeks sometimes without making the noise, and then suddenly start again.
View 3 RepliesGolf V R32 :: Slight Scrapping Noise Every Time Drive Off At Low Speeds
I've been hearing a slight scrapping noise almost every time I drive off at low speeds. It definitely is a metal to metal sound but only is heard once or twice and then its gone. The dealership have checked suspension, wheel bearings, etc. and they say everything looks good and is tight. I dont think its anything steering cuz it happens when driving straight and nothing else feels out of the norm. I just had my 30k service done and I also had them do an alignment (found my front toe and rear camber needed adjustment) and the noise is still there.
View 1 Replies