Accent LC (2000-05) :: 2004 - Clutch Lost All Resistance / Hard To Get Into Reverse
I'm not very mechanical when it comes to cars. I have never had any clutch issue with my car. I arrived to work yesterday fine. When I started to leave it was incredibly hard to get into reverse and I had to force shifting after I left and the clutch had also lost all resistance and I could easily push it all the way to the ground. What could be a cause of the clutch always working perfect including the last time you drove it, and then 8 hours later you start up and it has done a 180. The fluid level is fine. I would presume if my clutch had went I have have slowly noticed it going.
View 1 RepliesAccent LC (2000-05) :: Trans Shifts Hard Into Second And Won't Go Into Overdrive When First Started
I have the p0734 and p0732 codes. Thing is it shifts hard into second and wont go into overdrive when first started. After about ten minutes of drive time you shut it off and turn it back on and the thing shifts perfectly. No hard shifts and overdrive works then check engine light turns off. The pulse generators have been replaced when i purchased car. It is an 02 accent with 90,000 miles.
View 3 RepliesAccent LC (2000-05) :: Rough Idle While Drive Or Reverse
I have a 2000 Accent with about 150,000 miles on it. Recently I have noticed that when my car is sitting in an intersection, the car appears to idle roughly. I would't exactly say that the car is idling rough, cause it stays at a consistent RPM while in drive or park, but the engine gets louder and the steering wheel starts to vibrating. When I slightly step on the gas, the vibration goes away. Also, when I put my car in park or neutral, the car quiets down and the vibrating stops.
I was wondering if it could be the throttle position sensor, or maybe a broken motor mount, but I haven't had a chance to look into it it. I did replace the purge control valve last week, which slightly improved the vibrations.
Ford Excursion :: 2000 V10 Shutting Off When Go From Drive To Reverse Or Brake Hard
My V10 Excursion is giving me a little bit of a hard time. Once warm, it shuts off when I go from drive to reverse and when I have to brake hard. I cleaned the mass air flow sensor and replaced the idle air valve behind the throttle body. Not sure what else I can do.
View 14 RepliesAccent LC (2000-05) :: Slam And Stop Briefly When Put In Reverse Then Change Into Drive
'05 Accent, 19k miles. Car has been great, except suddenly I'm getting a weird shifting issue when I first start the vehicle. After I put the car in reverse, then change into drive, the car SLAMS and stops briefly, as if I've hit something. This has started to happen a lot lately.
View 1 RepliesAccent LC (2000-05) :: 2001 GL Transmission Shifting Hard Into Drive
I have a 2001 hyundai accent GL the transmission has started shifting hard when it shifts into drive. It shifts fine and smooth from first to second but when it shifts into drive it hits drive hard and sometimes it acts like it doesn't want to shift and if you let up on the gas it will go ahead and shift, but when it shifts to overdrive it seems fine but hits hard when it down shifts back to drive. Also I have noticed a couple times when it goes to shift into drive the engine seems like it revs up some but when you let off the gas it goes ahead and shifts.
View 3 RepliesAccent LC (2000-05) :: Overheating Constantly - Car Won't Go In Reverse And Has Hard Time Shifting Sometimes
I have a 2003 Accent and it has been over heating constantly for about 5 months. After it started, we replaced the main radiator hose, thermostat, radiator cap AND a head and head gasket. It worked for about 2 weeks and then over heated again. It seems like there is too much pressure somewhere because the lid for my reservoir shoots off and all the coolant comes out. I'm just not sure where to look for a clog since it is coming out of the reservoir. It also recently started having transmission problems(?) or that is what I think it is... It won't go in reverse and has a hard time shifting sometimes. I'm not sure if it could be related or if it is the tranny also.
View 4 RepliesSanta FE SM (2001-06) :: 2004 - Hard Thump When Shifting From Reverse Into Drive
Recently my 2004 Santa Fe 2.7 AWD (~86k miles) has started to give a sort of hard thump when shifting from reverse into drive. It's fine going into any other gears and it shifts up and down normally. If I shift from reverse to neutral and then to drive it's fine.
I changed the transmission fluid when we first got the car at 40K miles with Hyundai Liquid Unobtanium SPiii fluid and again at 80k miles with Valvoline's SPiii offering. I just checked the transmission fluid level and it's within the normal range.
I can't tell if this is just drive-line slop or something else inside the tranny.
Ford F-150 (2004-2008) :: 2005 - Hard Time Moving From Park To Drive And Reverse
I have a 2005 Ford F-150 with a 4.6L and auto tranny non 4 wheel drive. I have a hard time moving from park to drive and reverse. Is there a switch that lets you put it in gear once the brake pedal is depressed? Could that have gone bad?
View 5 RepliesPassat (B5) :: 2001 - Shifts Into Reverse With A Hard Clunk
So a friend of mine has a 01 Passat 1.8 T (Automatic). He is having some reverse issues. It shifts into reverse with a hard clunk then the second you touch the gas it clunks into neutral. The odd part is if you put it in reverse and stay off the gas it will idle back in reverse... But the second you touch the gas nothing. I'm finding it hard to believe the transmission is gone because every other gear is beyond smooth (I mean like brand new car smooth).
View 4 RepliesFord F-150 - 1997-2003 :: 1998 - Transmission Will Not Go Into Drive / Shifts From Park And Goes Into Reverse
I was driving my 1998 Ford F150 the other day and pulled into a driveway. At that time, the transmission quit pulling like I put it in neutral. It shifts from park and goes into reverse but not drive. It has the 4.6L and is 2 wheel drive.
View 4 RepliesFord F-150 - 1997-2003 :: Transmission Shifts To Reverse And Drive But Park Engaged
I have a 2001 f150 crew cab 4x2 82k miles 4.6 with a 4r70w. Was pulling it over a curb and it popped now it will shift into reverse and load the motor like its pulling against a wall. In drive it will move some but still will lock up and stop moving. I assumed something in the rear had broken from the way it would roll a few feet and lock. Replaced the rear and still have same problem. Is there something I can replace to fix a stuck park or does the transmission need replaced or rebuilt?
View 1 RepliesAccent LC (2000-05) :: 2004 - Lost Reverse And All Gears Aside From First
I have the opportunity of getting i believe a 2004 accent gt for next to nothing. It recently lost reverse and all gears aside from first. The codes it is triggering are p0734 p0732 and p0733. Prior to throwing the codes it moved back but wouldn't budge forward. With codes no reverse or any gear higher than first. Car has 160k miles I am pretty mechanical. Should I run from this "cheap" "gas saver" or pick it up? With all 3 codes could it be just that sensor?
View 6 RepliesChevrolet :: 2000 - Shifts Late And Hard
2000 cavalier z24 2.4 170k automatic....
At first I thought this was a transmission fluid problem but had it checked and it's full. This may be a combo of 2 issues. At first it shifted so hard I couldn't really drive the car. AutoZone computer said the tp sensor needed replaced. I got the tp sensor and the issue did change for the better in that I can drive the car now but there is still a problem.
Its an automatic 2000 cavalier z24 2.4. shifts hard into drive and through the gears, although a bit softer into 3rd and 4th. The weird thing is, and this is how I manage driving it with less issue, is that if I slightly let off the gas real quick and push again when I think it should shift normally, it does. Every time. If I don't let off the gas and push again slightly it will shift late and hard which I imagine isn't good for the trans to deal with.
Not sure if it might be something like a speed sensor or what.
Ford - Ranger :: 2000 - Transmission Shifts Hard From Stop To Go
2000 Ranger autimatic, 2.5 lt 2wd, 155,000 miles. To my knowledge it has never had a tranny flush or the fluid changed. I have noticed last week that when you are taking off from a stop sign it jerks going into gear. This only happens when you are taking off all the other shifts are smooth. The transmission fluid color is redish-brown and doesn't have a burnt odor. I don't know where to start. Do I get a tranny flush, change the fluid or is it something else?
View 5 RepliesLexus GX 2004-09 :: Transmission Shifts Into Drive Twice
Lately, I've been having an issue with my 03 GX. It seems when the engine is cold and I back out of my driveway, when I put the truck into D, I feel the usual bump into drive, then it falls off and then a harder bump before I'm able to roll forward. If I don't pay attention and accelerate at the time the transmission seems to drop out of gear momentarily, the truck slams into gear and feels like I granny dropped it.
The truck is coming up on 120K. I've checked the transmission fluid and it is at the correct level.
Ford Super Duty (1999-2016) :: F350 - Trans Shifts Great Under Light RPMs But 2 - 3 Shifts Very Hard
I have 99 f350 v10 4x4 and trans shifts great under light rpms but 2-3 shifts very hard. At wide open from about 35 mph it will shift down and take off like a bullet but wont shift until I lift my foot and then it bangs hard from 2-3. All other gears are smooth. I did some searching and have found some threads saying it could be an accumulator spring that is broken? Truck has 115,000 miles on it. love the truck but want to fix this before it does some damage.
View 1 RepliesFord 7.3L Power Stroke (1999-2003) :: 2000 E350 - Overdrive Light Is Flashing - Shifts Hard
Here is my issue. I have a 2000 e350 7.3 the overdrive light is flashing, the speedometer and the odometer isnt working it also shifts hard, i changed the vss, the vss plug, range sensor, and alternator. still acting up. also all the fuses are good.
View 8 RepliesSubaru - Impreza :: 2001 - Hard To Get Into Gear And It Would Not Move In Reverse / Neutral Or Drive
I had a problem with the CV Axle and the Wheel Bearings. I replaced them already and I ran into another issue with the Wheel Studs and the Ball Joint, so I ended up replacing them as well. Yesterday I put everything back together after replacing all the parts mentioned before and I made sure everything was bolted down and tightened, and then the tire back on and lowered the jack. I started up my car expecting it to drive just fine and it was harder to get into gear than before and it wouldn't move in reverse, neutral, or drive. I called a Monroe Muffler around here and they told me that the CV Joint is probably not seated all the way inside the Transfer Case.
So later the same day I took everything back apart and made sure that I put the CV Joint back into the Transfer Case and I put the pin back in and made sure that both CV Axles would turn at the same time, which they did. I figured it was good so I put it all back together again and went through the same process as before, making sure everything was tightened down, all the bolts and nuts and pins were where they needed to be. Everything seemed to be good. I put the tire back on again, lowered the jack, started the car and attempted to drive it again. It still won't move. Why this is happening.