Azera TG (2006-11) :: Rough Idle - No Response When Depressed Gas Pedal
My car was parked for 5 days. When I next started it there was no response when I depressed the gas pedal--car remained in a rough idle. Had to restart the car three times before it worked but check engine light has not gone off.
View 3 RepliesMazda - B2200 :: Screechy Noise Only When In Gear But Gas Pedal Not Depressed
B2200 mazda: I've recently got a screechy noise only when in gear but gas pedal NOT depressed. Could this be an indication of a bad U joint noise? Or? The noise seems to be coming from the rear chassis of car. Noise seems worse if going in reverse. Possibly coincidentally I started noticing the noise after a shock absorber worked its way loose, causing lots of racket. (The mechanic who'd installed it has since tightened it.) Would all that rumbling from the loose shock have caused something to break or work loose? Or is it just age of vehicle (22 yrs) By the way, the noise is very similar to a wire scratching metal. I also have had the classic thunk noise of a u joint, for a longer period of time-- never looked into though.
View 1 RepliesMazda - Protege :: Very Rough Start / Idles Fine And Stalls As Soon As Touch The Pedal
1995 Mazda Protege1.5 LAuto153K miles.
My car was running fine, then one day it started sputtering while driving, mostly when I accelerated. It stalled and I could not get it started. This happened on a day when it was raining hard, but not sure that had anything to do with it. A few days later when I went to pick the car up it started right up, it had stopped raining and been dry for 2 days prior. But about a mile into the drive back home it stalled and I could not get it started.
Here is what I have tested so far.
- Put in new fuel filter.
- Tested the fuel pressure and pressure regulator
- Tested the injectors with a noid light.
- Tested that the spark plugs were producing a spark.
After I pulled the plugs and cleaned and dried them (they were wet with gas) the car started, but I think not because of anything really related to the plugs. What I've noticed is that when cranking the engine if I give it gas it will not start but if I keep off the throttle it will reluctantly start. But once it starts the idle is smooth and as it should be. Then if I give it any gas it immediately stalls. It seems to me given these symptoms that it is getting enough air to idle but not enough air to match the increased gas.
The only CEL code that I'm getting (which I had before this issue occurred) is the "closed throttle position switch" (I forget the number). If it was an MAF, or IAC, or EGR issue would I not get a code? What this could be and how to test it. Again my guess is its an air intake issue but not sure where.
Mazda - Protege :: 2001 - Stuck Gas Pedal / Making Noise When Pushed Harder
Lately, when first starting my car and after it’s been sitting for a while the gas pedal seems to be stuck.
When I push on it slightly it doesn’t move; but if I push a little harder it will make a noise and become free and movable. No further problems until it sits for a while or the next morning. Then the same stuck pedal. Exert a little pressure and it frees up.
I tried squirting WD40 on the linkage but it does no good. What could cause it to bind up? 2001 Mazda Protege LX 2.0 ....
Mazda :: 1996 Protege - Lower Climate Control Hard To Move
128,000 + miles... The lower climate control is physically hard to move like something is blocking it. However, the intensity control moves just fine. Both do their job of controlling the temperature/intensity, etc. Why might the lower control be hard to move? Can I fix it myself?
View 3 RepliesMazda - Protege :: 1996 - Flushing Brake Fluid
Car has 125,000 miles. Not sure if the brake fluid has ever been flushed, despite brake jobs in the past 5 years. I do not have the manual so not sure if it even addresses frequency of flushing the brake lines. None of the invoices mention it. Last checkup in Aprl recommends flushing brakes.
Lots of posts on Cartalk about flushing in general, but not anything for my Mazda 1996 Protege.
Mazda - Protege :: Revving Irregularly High While Traveling On Freeway Around 60 Miles An Hour
On my way home today my Automatic 2003 Mazda Protege started revving irregularly high for just a second while traveling on the freeway around 60 miles an hour. It would fluctuate between 2.5 and 3 RPMs and then jump to 4 then drop again seeming to loose torque. It seemed to become more frequent as i continued home. Happening every two to three minutes or so not necessarily when traveling up hills. Should i be worried about driving my car?
View 8 RepliesMazda - Protege :: Bucking / Hard To Shift Into Gear / Chugging / Slight Odor Of Oil And Very Slow Moving
1996 Mazda Protege, 133224 miles, mostly city driving, automatic transmission
This weekend the car started bucking, problems shifting into gear, chugging, slight odor of oil, very slow moving. This morning (in my pf's) I ran the Scan OBDII and there were no error messages. I checked fluids and they were fine.
Possible problems? I am at a decision point, get rid of the car (needs tires, front brakes and it burns a bit of oil each month (1-2 cups) or fix it.
Ford 7.3L Power Stroke (1999-2003) :: Pedal Sink When Brake Depressed After Brake Line Replacement?
03 F250 7.3. I busted a brake line last week somehow, Got it replaced and fixed up, Bled that line and everything was somewhat good.
Now, when i hit the brakes hard, I have pressure. If I let off even a little, My pedal will start to sink till i apply more pressure. I am gonna fully bleed my brakes when I'm home to see if this could solve the problem.
Mazda - Protege :: 1996 - Rough Idle When Step On Brake At A Red Light
I have a 96 Mazda Protege DX. 1.5L engine, now with 161,000 miles. 5 speed manual transmission. I had it for 7 years. Originally bought it for $1900 with 121,000 miles.
This has been a problem for about 5 years. When I am at a red light or idling and I step on the brake, my idle gets rough and my engine feels like it is about to turn off. The idle does not bounce up and down. It just goes down to 400-500rpm from the normal 800-950rpm range.
Again, this only happens when I step on the brake while the car is not moving. It does not seem to happen when I coast in neutral and hit the brake to slow down. I raised the idle a bit, but it still does it. I could not find any vacuum leak around the brake booster and I know the brake booster works because I pumped my brakes while the car was off, and when I turn the car on, the brakes soften up.
Also, my brakes feel weak. I usually hit the brakes nearly to the floor board to stop the car. New pads, rotors are good. Brake fluid is at right level. Mechanics say nothing is wrong with my brakes.
Secondly, my belts screech at every start up. Lasts anywhere from 3-20 seconds. This has been happening for the entire 7 years I have owned the car. Mechanics replaced the serpentine belts twice in that time. Replaced a pulley and A/C compressor. I tried using WD40 but it doesn't effect it. Mechanics tell me that the belt tension is correct and they do not know why it still screeches.
Mazda :: Ignition Switch Unresponsive / Shifter Shifts Gear Without Brake Being Depressed
I have a 1998 Mazda Protege LX Automatic, and my ignition switch is completely unresponsive: when on accessory or run position nothing comes on.
I am also noticing that I can switch gears even with the key out and brake pedal not depressed.
I tried to check the function of the ignition switch, and found the following:1) It has one white wire with 3.5v2) When the switch is in Acc position, a black wire with white stripe also has 3.5V on it now3) WHen the switch is in On position, all the wires going into the Switch have 3.5V on them...
Passat (B7) :: Brake Pedal Making Noise When Depressed?
But when I take my foot off the brake pedal , its just seems rather noisy (clunky). As if VW forgot to put some rubber or something to prevent this clunky sound. (it just sounds cheap)
My jetta and tiguan never seemed like this. Have to stick my head under there and see whats up
Prius (Gen 2) :: 2004 - Clicking Sound When Brake Pedal Depressed
I have another small issue with my 2004 Prius. I just noticed yesterday that the second I very lightly depress the brake pedal, a little clicking sound is made down below. It sounds like it might be coming from the brake pedal itself or somewhere underneath the hood. It's only when I depress the pedal slightly and it makes pretty much the same sound when I release the pedal. I just had a 5000 mile service done to the car and there were no issues then.
View 14 RepliesPassat (B5) :: 2003 - Unable To Get Out Of Park When Brake Pedal Depressed
I have a 2003 Passat GLX 4Motion that was fine Monday...Having heavy rain Monday and with brake pedal depressed unable to get out of park..I have brake lights but when I got into car and started it I have airbag light and esp light on as well as check engine light...Is there a way to by pass the shift lock solenoid so I can move car into my garage...
I cleaned connections as was suggested and had a tough time as Bentley Manual states to remove console one must put lever into 3 which as lever is stuck in PARK was impossible...I tried pulling out the shift knob button as described and when I still couldn't get any response found that when I pushed the button back in that I was finally able to get shift lever to respond and finally come out of park...
I now get code for no TCM Signal P1626 No Powertrain Data Bus Signal Missing Message from TCM which now triggers ABS , Airbag ,ESP , and Check Engine light all with the cause no TCM Signal .... Now wondering if any easy way to test for data bus signal ?
Ford Excursion :: 2005 - No Brake Lights When Pedal Depressed
I have a 2005 Excursion 4x4 Limited 6.0 diesel. I had someone pull alongside me today and tell me my brake lights were out. Sure enough. I double checked and nothing at both lower lights and also nothing at the third brake.
So... here's the short version of the things I've checked so far:
1. no brake lights when pedal depressed.
2. running lights work fine
3. turn signals work fine
4. hazards work fine
5. brake lights DO illuminate when I press the brake button on my trailer brake controller
6. checked power to the green with red tracer wire going to the brake light switch on the pedal. 12 v present continuously
7. checked power to light green wire. 12 v present when pedal is depressed. 0 v when pedal is released.
8. checked power to tail lights (wish I had tried the trailer brake controller sooner, this step would have been unnecessary). voltage present (I think 10-12 v) when the running lights were turned on. 0 v when brake pedal depressed. I suspect now that I would have 12 v when squeezing my trailer brake controller button.
I was pretty convinced it was the brake switch at the pedal. But since I'm seeing the voltage pass through the light green wire when depressed.... I know the wiring to the lights are good because they work when pressing the trailer brake controller button.
So... Do I need to dig into the multifunction switch that I've been reading about? Does the power go from the pedal switch to the multifunction, then to the trailer brake controller? I'm really hoping that I don't have to dig into the column to check that multifunction switch!
Lexus GX 2010+ :: Brake Pedal Vibration And Noise When Depressed At Low Speeds
We purchased the vehicle (2013 GX460) in September 2012, and had the car for 6 weeks before my wife was hit by an oncoming car who missed a stop sign. 8 weeks later and 23k of repairable damage to driver fender, front bumper, grille, hood, frame, and all components within those major areas, we received our vehicle.
The vehicle is wonderful and a joy to drive. When the brake pedal is depressed at low speeds (i.e., maneuvering in parking lot, entering driveway), there is a slight vibration to the pedal (similar to the vibration from a cell phone) and a noise that suggests an electric motor is working. The vibration is not like ABS; ABS is a profound vibration. The vibration we experience is very slight. The vibration is not apparent at highway speeds.
I do not recall either the vibration or the noise prior to the accident, and I suspect that this is a result from the accident or from the repairs. I have already brought the GX back to the dealer for this problem and they were quick to dismiss it, but I am really concerned that this is a real problem, and I want the dealer to re-assess.
Accent MC (2006-11) :: Brake Pedal Making Creaking Noise When Depressed
My brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
Ford Excursion :: Cruise Control Cuts Out When Brake Pedal Is Depressed
Why is there a sensor on the brake master cylinder? Most other cars and trucks I've seen have tied the cruise control into the brake light (and clutch interlock if Manual transmission.) switch so that when the pedal is depressed, the cruise control cuts out.
In the Ex, could I tap the brake pedal enough that the brake lights come on yet I don't trigger the pressure sensor in the master cylinder to cut the cruise control?
Prius (2004-09) :: Squeak Occurs When Car Is Stationary With Brake Pedal Fully Depressed
I have recently purchased a 2007 Gen 2 Prius and sometimes it emits a very annoying squeak. It occurs when the car is stationary, with the brake pedal fully depressed. When inside the vehicle it seems to be coming from behind the glove box. When on the outside and facing the car it seems to be coming from below / behind the electric motor. I have made a recording of it with the noise in question being audible for a couple of seconds at 0:13, and then again at 0:22 until the end. It could be nothing I guess, but this is my first hybrid and I am not too sure what is perfectly normal and what is not.
View 14 Replies