Golf IV / Jetta IV :: 2010 - Key Stuck In Ignition - Shifts Out Of Park Without Pressing Shifter Button?
So I have a 2010 jetta 2.5 and my key is stuck in the ignition has been for a couple weeks also don't know if it's related but when I start the car I can pull the shifter out of park without pressing shifter button just have to press brake and after I shut the car off if I take it out of park and put it in gear it just freely rolls only stops if it's in park. NOT A DSG
View 3 RepliesMazda - B2200 :: Screechy Noise Only When In Gear But Gas Pedal Not Depressed
B2200 mazda: I've recently got a screechy noise only when in gear but gas pedal NOT depressed. Could this be an indication of a bad U joint noise? Or? The noise seems to be coming from the rear chassis of car. Noise seems worse if going in reverse. Possibly coincidentally I started noticing the noise after a shock absorber worked its way loose, causing lots of racket. (The mechanic who'd installed it has since tightened it.) Would all that rumbling from the loose shock have caused something to break or work loose? Or is it just age of vehicle (22 yrs) By the way, the noise is very similar to a wire scratching metal. I also have had the classic thunk noise of a u joint, for a longer period of time-- never looked into though.
View 1 RepliesMazda - Protege :: 1994 - Brake Pedal High And Hard And No Response When Depressed
A couple weeks ago the front brakes were done on the Mazda. Then the wheel bearings needed to be done. I think the shop outsourced what I guess was the packing of the bearings. I paid for the work, and drove away, nearly, but didn't because I had no brakes and there I was pulling out into 5:00 PM traffic. The emergency brake saved me. I walked back into the shop and they discovered the power brake booster had broken. I wonder, because if you drove the Mazda to park it in the shop lot where the customers pick up the vehicles after repairs are made, wouldn't you notice that there is no braking action. The brake pedal was high and hard and there was literally no response when I depressed it.
The shop keeper said, darn I guess I'll have to replace this, meaning pay for it, since it (may have) happened when the bearings were being worked on. My question is, is there any reason why working on bearings might end up breaking the brake booster? Chances are, it was just coincidence, right? or? I don't know. Because the car is old, he had to take several days to find the part. Anyway, he sent me off and told me to drive it carefully. The drive home was absolutely nervewracking and required continual tugging up on the emergency brake stick. I wonder if they despise my car so much now that they are sending me off to drive in it in such an unsafe condition. Anyway, hoping it will be fixed tomorrow. But my question still is ... would working on bearings possibly be cause for breaking the brake booster?
Malibu :: 2005 - Switch On Shifter Will Not Move Transmission Down To 2nd Or 1st Gear
I need removing the console on a 2005 Malibu Max. The switch on the shifter will not move the transmission down to 2nd or 1st gear. There was a post by "shadow5599" on 05-05-2009 stating that this problem was caused by a broken wire in the harness under the console leading to the shifter +/- switch. He said it was easy to fix but the console needed to be removed. Later on the same day he posted that he had just posted the instructions on how to remove it. I'm a first time user on this site and I haven't been able to locate those instructions.
View 1 RepliesCamry 2012+ :: 2013 - Transmission Automatically Shifts To 4th Gear When Switch To Sport Mode
I've always wondered why the transmission automatically shirts to 4th gear when I switch to sport mode! Is this normal??? It's an i4
View 14 RepliesCamry :: 2002 XLE - No ABS And Brake Light When Switch Ignition Key On
Camry 2002 XLE 4Cyl. 2.4 ... When I switch ignition key on, there are no ABS and Brake light come on. Why is that happening? How to fix it? Normally, when we switch ignition key on, what are indicator light on?
View 6 RepliesFord F-150 (2009-2014) :: M Position On Gear Shifter And 5-position Switch
Well I read most of the 2011 manual last night to find out why I have "M" on my gearshift, & found it near the end...so we can manually shift our gears. So I normally drive in D, and I use the tow/haul switch when trailing...so under what circumstances does the normal person need to manually shift through 5 gear positions using M, and the 5-position switch?
View 7 RepliesCorolla / Matrix 2009-13 :: Sunroof Switch Unresponsive?
I'm having some issues with my sunroof on my 2010 Corolla: the switch seems to be unresponsive, but if I push the button several times, the sunroof will open up (this happens with both the slide and the tilt function).
View 2 RepliesTouareg :: 2004 - Foot Brake Depressed Brake Light Stays On?
I have a 2004 Treg with 28k miles. This car has the air suspension and the dashboard with the LCD display.
When the foot pedal break is released, the break light remains on and the center display sounds off the alarm that the foot break is on as the car begins to roll.
After half dozen additional pulls of the break release handle, the issue goes away. This is now happening almost every time the foot break is used.
Ford F-150 - 1997-2003 :: Brake Light Come On When E-Brake Depressed
Is the brake light supposed to come on when the E-brake is depressed? It's not right now, bulb?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Pedal Sink When Brake Depressed After Brake Line Replacement?
03 F250 7.3. I busted a brake line last week somehow, Got it replaced and fixed up, Bled that line and everything was somewhat good.
Now, when i hit the brakes hard, I have pressure. If I let off even a little, My pedal will start to sink till i apply more pressure. I am gonna fully bleed my brakes when I'm home to see if this could solve the problem.
Accent LC (2000-05) :: Front Fog Lights Not Working / Green Led Not Coming On When Switch Depressed
I own a 2001 Hyundai Accent. For some reason my front fogs lights have stopped working, i am suspecting the switch is dead because the green led does not come on when the switch is depressed, i have checked the fuse and all ok however on the fuse box/relay cover in the engine bay it says that there should be a relay (see attachment) but i don't have a relay there and never have had even when the lights worked, well at least i have never taken it out. Back to the switch, how to remove the switch from the panel so i can test the circuit with one of the other switches.
View 13 RepliesGolf IV R32 :: Shifter Moving Slightly Side-to-side While In Gear - Shifter Cables Need Adjustment?
I recently changed the bushings and installed SS kit. I don't know if this was the case before, but now while in any gear, i can still move it approx half inch to the right and half inch to the left.
I checked everything and all screws are tight. Could it be that the shifter cables need adjustment?
Mazda - 626 :: 1991 - Transmission Hard Shifts From 1st To 2nd - Jerks When Driven For A Bit
A while ago, I acquired a 1991 Mazda 626 automatic (currently 105,000 miles) that now has what appear to be the beginning of transmission issues. It hard shifts from 1st to 2nd - the shift jerks really hard when the car is cold but once I've driven it for 15-20 minutes the hard shift almost disappears completely and stays that way as long as the car is warm - except for stop and go traffic (Seattle traffic) than the hard shift comes back no matter how long I've been driving. The only other shifting issue I notice is on the hills where it seems to shift more frequently than I might expect it too.
Other than what I've described this car is in perfect condition inside and out, as well as engine-wise. My question is on transmissions and whether I should get a rebuilt one. I've taken it to multiple transmission shops and almost all have told me two things 1) I need a new transmission and 2) that the issue is a hard component problem and I could most likely drive this car for months or years without having to replace the transmission - if I want to put up with the rough shifts. They recommended just driving it until the transmission goes out and then replacing it.
Mazda - Mazda6 :: Transmission Shifts Really Hard After Driving For Some Time
I have a 2003 Mazda 6. Almost every day, after starting it and driving maybe .10 of a mile, it seems as my car shifts, it shifts really hard, like a thump. I am thinking of having the Transmission serviced. Is this worth it? About what should the cost be? What do they do, just drain the fluid and add new?
View 2 RepliesFord Ranger / B-Series :: Gear Shifter Does Not Go Into 1st Gear But Changes To Other Ones
I bought a 96 Ford Ranger XLT Supercab 4.0 on the 21st and the gear shifter doesn't go into 1st gear but changes to the other ones(see pic below) and was wondering if it's a easy fix.
Also I have a oil drip(at least it looks like oil to me) and I can't figure out where it's coming from because it's a small drip and the oil dipstick and tranny dipstick both show full and I can't figure out where the drip is coming from and I only noticed a dip on a metallic tank but don't know what that is either but check out the pic below to see the drip I circled.
Ford - Mustang :: 1995 - Electrical And Shifter / Ignition Malfunction
I have a 1995 ford mustang with a 3.8 v6, and have recently discovered an electrical problem. First I thought it was just the headlight switch. We replaced it, but looking at the old one, we found that it had gotten so hot, it melted all the plastic off the wires, and that this caused the switch to burn out. I replaced the old one with a new one but it still gets super hot. I'm afraid to drive my car at night for the reason that my lights might fail me in the dark.
Another problem, I'm unsure if they are associated, but it did appear around the same time I replaced the headlight switch. When my car is running, it is impossible to shift it from the park. The button on the shifter (its an automatic transmission) refuses to give, and the result is that my car can only be shifted into gear by turning the key to turn on the ignition position while pressing in the button on the shifter, and then starting my car and driving off. Another thing that i'm sure is associated with this problem is that the cruise control will not be turned off by the brake. It will disengage the cruise when braking but re-engages after my foot leaves the brake. These last two problems began at the same time.
Passat (B7) :: Brake Pedal Making Noise When Depressed?
But when I take my foot off the brake pedal , its just seems rather noisy (clunky). As if VW forgot to put some rubber or something to prevent this clunky sound. (it just sounds cheap)
My jetta and tiguan never seemed like this. Have to stick my head under there and see whats up
Saturn :: 1995 SL Lurch When In 1st Gear, Even Though Clutch Pedal Fully Depressed
When I am stopped (at a red light, for example), the car wants to lurch when in 1st gear, even though I have the clutch pedal fully depressed. I know this is not a problem with the clutch master cylinder leaking by where you lose pressure on the pedal. Car has 245,000 miles and still has original clutch. Car/transmission work fine so long as I put it in neutral when I stop. Doesn't seem to do this w/reverse. Clutch also passes the "stall test" where you let it out in 4th gear with the hand brake on. What's going on here?
View 8 Replies