Prius (Gen 2) :: 2004 - Clicking Sound When Brake Pedal Depressed
I have another small issue with my 2004 Prius. I just noticed yesterday that the second I very lightly depress the brake pedal, a little clicking sound is made down below. It sounds like it might be coming from the brake pedal itself or somewhere underneath the hood. It's only when I depress the pedal slightly and it makes pretty much the same sound when I release the pedal. I just had a 5000 mile service done to the car and there were no issues then.
View 14 RepliesPrius (2004-09) :: Squeak From Engine Compartment When Pushing Brake Pedal
A few days ago, while on a road trip from CA to CO, I noticed a loud squeak from the engine compartment every time I pushed the brake pedal, no matter how lightly, no matter what speed. It even happened when the car was off. I have almost 60K miles on my '05.
When I arrived in Denver, I dropped the car off at a Toyota dealer for troubleshooting. They isolated the fault to a bad ABS actuator. They had to overnight the part, and spent a day and a half installing it. Sounds like a major project!
Saturn :: 1995 SL Lurch When In 1st Gear, Even Though Clutch Pedal Fully Depressed
When I am stopped (at a red light, for example), the car wants to lurch when in 1st gear, even though I have the clutch pedal fully depressed. I know this is not a problem with the clutch master cylinder leaking by where you lose pressure on the pedal. Car has 245,000 miles and still has original clutch. Car/transmission work fine so long as I put it in neutral when I stop. Doesn't seem to do this w/reverse. Clutch also passes the "stall test" where you let it out in 4th gear with the hand brake on. What's going on here?
View 8 RepliesFord F-150 (2004-2008) :: 2005 XLT - ABS Light Comes On But Brake Pedal Stops Pulsating When Depressed
Ok, I changed my front brake pads and rotors last week and since then everytime I get in the truck and drive for about the first 2 or 3 miles when I push the brake pedal it feels like my ABS sytem is activating. Then it stops and the ABS light comes on but the brake pedal stops pulsating when depressed. Is my ABS going bad or did I possibly do something wrong? I have changed the rotors and pads before without problems....
View 3 RepliesPrius (2004-09) :: ICE Keeps Running Even Though Engine Is Warm And Gas Pedal Not Depressed
I've noticed lately that my Prius (2008) sometimes decides to keep the ICE running even though the engine is warm and the gas pedal is not depressed. I can pulse and glide (with the engine off during glide) the first 5-10 minutes of driving, and then all of a sudden the ICE starts running constantly. I have to press the EV button to be able to glide. Quite annoying... I bought the Prius just to get rid of the ignition jerking.
View 7 RepliesPrius (2004-09) :: Depressed Accelerator Pedal - Clicking Sounds From Engine
Sometime the car is fighting to move forwards when I start to depress accelerator pedal and it sounds like "click click CLICK..." the sound changes from lower to louder depending on how I depress accelerator pedal... (like the car is trying to hard to move)...
View 3 RepliesFord 7.3L Power Stroke (1999-2003) :: Pedal Sink When Brake Depressed After Brake Line Replacement?
03 F250 7.3. I busted a brake line last week somehow, Got it replaced and fixed up, Bled that line and everything was somewhat good.
Now, when i hit the brakes hard, I have pressure. If I let off even a little, My pedal will start to sink till i apply more pressure. I am gonna fully bleed my brakes when I'm home to see if this could solve the problem.
Prius (Gen 3) :: Honking Noise When Pressing / Releasing Brake Pedal And Squeak When Backing Up
I had 2 brake related issues. First was a honking noise when pressing/releasing the brake pedal (covered by T-SB-0363-10, attached below). Second was rear brake squeaks, particularly when backing up (T-SB-0102-11, attached below). I had the squeak issue repaired under a previous TSB a few years ago, but the noise came back after a while, and the updated TSB includes replacing the pads and other parts.
View 8 RepliesPassat (B7) :: Brake Pedal Making Noise When Depressed?
But when I take my foot off the brake pedal , its just seems rather noisy (clunky). As if VW forgot to put some rubber or something to prevent this clunky sound. (it just sounds cheap)
My jetta and tiguan never seemed like this. Have to stick my head under there and see whats up
Passat (B5) :: 2003 - Unable To Get Out Of Park When Brake Pedal Depressed
I have a 2003 Passat GLX 4Motion that was fine Monday...Having heavy rain Monday and with brake pedal depressed unable to get out of park..I have brake lights but when I got into car and started it I have airbag light and esp light on as well as check engine light...Is there a way to by pass the shift lock solenoid so I can move car into my garage...
I cleaned connections as was suggested and had a tough time as Bentley Manual states to remove console one must put lever into 3 which as lever is stuck in PARK was impossible...I tried pulling out the shift knob button as described and when I still couldn't get any response found that when I pushed the button back in that I was finally able to get shift lever to respond and finally come out of park...
I now get code for no TCM Signal P1626 No Powertrain Data Bus Signal Missing Message from TCM which now triggers ABS , Airbag ,ESP , and Check Engine light all with the cause no TCM Signal .... Now wondering if any easy way to test for data bus signal ?
Ford Excursion :: 2005 - No Brake Lights When Pedal Depressed
I have a 2005 Excursion 4x4 Limited 6.0 diesel. I had someone pull alongside me today and tell me my brake lights were out. Sure enough. I double checked and nothing at both lower lights and also nothing at the third brake.
So... here's the short version of the things I've checked so far:
1. no brake lights when pedal depressed.
2. running lights work fine
3. turn signals work fine
4. hazards work fine
5. brake lights DO illuminate when I press the brake button on my trailer brake controller
6. checked power to the green with red tracer wire going to the brake light switch on the pedal. 12 v present continuously
7. checked power to light green wire. 12 v present when pedal is depressed. 0 v when pedal is released.
8. checked power to tail lights (wish I had tried the trailer brake controller sooner, this step would have been unnecessary). voltage present (I think 10-12 v) when the running lights were turned on. 0 v when brake pedal depressed. I suspect now that I would have 12 v when squeezing my trailer brake controller button.
I was pretty convinced it was the brake switch at the pedal. But since I'm seeing the voltage pass through the light green wire when depressed.... I know the wiring to the lights are good because they work when pressing the trailer brake controller button.
So... Do I need to dig into the multifunction switch that I've been reading about? Does the power go from the pedal switch to the multifunction, then to the trailer brake controller? I'm really hoping that I don't have to dig into the column to check that multifunction switch!
Santa FE SM (2001-06) :: Brake Pedal Is Very Soft And Goes To The Floor Before Braking Occurs
Here's the short of it. 3rd time in a year the brakes on my 2005 SF (177K miles, 2.7L) have gone out.
The brake pedal is very soft and goes to the floor before braking occurs. Typical signs of a bad master cylinder.
The first time was a year ago. I bought a re-manufactured master cylinder, change it and bled the brakes. Worked like a champ and lasted 10 months.
To months ago same exact symptoms. I assume it was a bad re-man part. It's under warranty, not big deal. I do warranty exchange, bleed system, brakes return. All is good.
Less then 3 weeks later, brakes gone, same symptoms! This time I spend the difference and get a brand new OEM cylinder with reservoir. Replace, bleed, problem fixed. Brakes go out in less than a week.
I'm not leaking anywhere. Reservoir is to corect level. ABS light is NOT on. No chattering in brakes. Braking is smooth both when power brakes work and when not. No visible damage to calipers. I'm 99% sure there is no air in the system, but I'm going to try bleeding again. I have not put it up on a lift to yet to check all the lines.
Lexus GX 2010+ :: Brake Pedal Vibration And Noise When Depressed At Low Speeds
We purchased the vehicle (2013 GX460) in September 2012, and had the car for 6 weeks before my wife was hit by an oncoming car who missed a stop sign. 8 weeks later and 23k of repairable damage to driver fender, front bumper, grille, hood, frame, and all components within those major areas, we received our vehicle.
The vehicle is wonderful and a joy to drive. When the brake pedal is depressed at low speeds (i.e., maneuvering in parking lot, entering driveway), there is a slight vibration to the pedal (similar to the vibration from a cell phone) and a noise that suggests an electric motor is working. The vibration is not like ABS; ABS is a profound vibration. The vibration we experience is very slight. The vibration is not apparent at highway speeds.
I do not recall either the vibration or the noise prior to the accident, and I suspect that this is a result from the accident or from the repairs. I have already brought the GX back to the dealer for this problem and they were quick to dismiss it, but I am really concerned that this is a real problem, and I want the dealer to re-assess.
Accent MC (2006-11) :: Brake Pedal Making Creaking Noise When Depressed
My brake pedal is making a creaking noise when depressed and can also be heard when letting off the pedal. The noise is not coming from the brakes themselves (front/back are like new) but the pedal area or somewhere behind it. This noise doesn't start until I've driven the car for a little while. The brakes work fine for the most part but sometimes feel a bit spongy if making a sudden or hard stop. The fluid levels are fine.
I'm taking it in on Friday and hoping that the brakes just need to be bled a little or maybe the pedal just needs lube, but I'm worried it might be the booster or master cylinder---if it is one of these?
Ford Excursion :: Cruise Control Cuts Out When Brake Pedal Is Depressed
Why is there a sensor on the brake master cylinder? Most other cars and trucks I've seen have tied the cruise control into the brake light (and clutch interlock if Manual transmission.) switch so that when the pedal is depressed, the cruise control cuts out.
In the Ex, could I tap the brake pedal enough that the brake lights come on yet I don't trigger the pressure sensor in the master cylinder to cut the cruise control?
Mazda - Protege :: 1994 - Brake Pedal High And Hard And No Response When Depressed
A couple weeks ago the front brakes were done on the Mazda. Then the wheel bearings needed to be done. I think the shop outsourced what I guess was the packing of the bearings. I paid for the work, and drove away, nearly, but didn't because I had no brakes and there I was pulling out into 5:00 PM traffic. The emergency brake saved me. I walked back into the shop and they discovered the power brake booster had broken. I wonder, because if you drove the Mazda to park it in the shop lot where the customers pick up the vehicles after repairs are made, wouldn't you notice that there is no braking action. The brake pedal was high and hard and there was literally no response when I depressed it.
The shop keeper said, darn I guess I'll have to replace this, meaning pay for it, since it (may have) happened when the bearings were being worked on. My question is, is there any reason why working on bearings might end up breaking the brake booster? Chances are, it was just coincidence, right? or? I don't know. Because the car is old, he had to take several days to find the part. Anyway, he sent me off and told me to drive it carefully. The drive home was absolutely nervewracking and required continual tugging up on the emergency brake stick. I wonder if they despise my car so much now that they are sending me off to drive in it in such an unsafe condition. Anyway, hoping it will be fixed tomorrow. But my question still is ... would working on bearings possibly be cause for breaking the brake booster?
Passat (B6) :: Brake Pedal Vibrates When Fully Pressed In Drive
When brake pedal is fully pressed and my car is in drive the pedal vibrates. The only thing I thought of is that my intake is touching something, but I don't see anything.
View 8 RepliesNissan :: Keyless Entry Vehicle With Remote Starter - Engine Shuts Off When Brake Pedal Depressed
Nissan Rogue SV 2011 is keyless entry vehicle. When using remote starter, the engine shuts off when brake pedal depressed and the car is restarted to drive away. does this 'turning off/turning on' the engine damage any of the systems of this vehicle. it just doesn't seem a good idea to have the engine turned off and then immediately turned on.
View 5 RepliesFord Brakes/Suspension :: Hissing Sound Each Time As Depressed Brake Pedal Sank To The Floor
Brake pedal to the floor... And a lot of fluid on the ground.
I was coming home (empty fortunately) last evening when I noticed the brake pedal give an initial resistance, then slowly sank all the way to the floorboard when slowing down to turn onto my street. When I got to the house, I noticed a hissing sound each time as the depressed brake pedal sank to the floor. When I got out, there was a lot of brake fluid on the ground on the left rear side. It appears to be between the fuel tank and frame rail. From the side it is the section between the fuel filler to just ahead of the left rear wheel. The tank and frame rail is drenched and dripping DOT 3.
I am lucky to not have been pulling my 5th wheel when this happened! However, I have a camping trip coming up in a few weeks, but now my TV is broken. What has happened, and an estimate for repairs? Where is the best place to have it fixed, dealer or specialty shop? I just bought this vehicle in January and it has 102,500 miles, and came complete with full and meticulous repair records. The P.O. was incredible at upkeep, so this is something curious and flukey to me. But do I need to worry about the other side now, too?