Camry :: 2011 - Shift Lever Harder To Move Than Normal And Would Not Go Into Drive
I had something unusual happen recently... I backed out the driveway and went to put the car in drive and found the shift lever harder to move than normal and it wouldn't go into drive. It would go into park and reverse easily enough. After some manipulation it went into drive and ran with no problems to my destination. At first, I thought something fell down into the mechanism and was causing it to bind. AND of course, when I showed it to a pal, I could not recreate the issue. The next morning it worked fine, but it happened again later in the day, but it took much longer to get it into drive.
On the way home, the check engine and traction control lights both came on. I dropped it off at my mechanics and he diagnosed error code C1201 P0705 and claims that the remote starter (shop installed after market) is interfering with the transmission control module. I contacted the installer of the starter and he says it is not possible, but I know something is wrong... Now, I can't get it to act up and the idiot lights are gone. I need to rely on my vehicle and can't afford to be stranded somewhere. I feel it would be pointless to take the car to the installer, since the warning lights are gone and there are no shifting issues now.
Lincoln - Towncar :: Intermittent Air Conditioner Outage
I was minding my own business, when my air conditioner started blowing hot air. I took the car to my mechanic, and it was working fine. So--sometimes it works, and sometimes it doesn't. Why?
View 1 RepliesLincoln - Towncar :: 1992 - Transmission Slippage / No Enough Power Develop To Move Forward
I got in to the 92 Lincoln, shifted into drive, and noticed transmission slippage. I checked the transmission fluid. The fluid did not smell burned but was under the add a pint line. I added fluid to the full line. The car is worse. As you shift into drive, then you have to race the engine to get the car to move forward. The car will go up the block but not with any speed. It seems as if it is not developing enough power to get the car to move forward. If I throw the car in reverse, it drives normal. Is it time to sell the car to the demolition derby?
View 10 RepliesLincoln - Towncar :: 2007 - Intermittent Scraping Sound In The Middle Of The Dash
There is an intermittent scraping sound in the middle of the dash on a 2007 Lincoln town car. It is a low mileage car, about 40000 miles. It comes and goes. It doesn't seem to make any difference which position the ac controls are in. but climate control has to be on.. There is also a sound when you turn ignition off, sounds like water moving. I am thinking it might be something with a blend door actuator.
View 3 RepliesLincoln - Towncar :: No Longer Shift Back Into Park
This just happened today. The car will no longer shift pack into park, all the way up the car is still in reverse. All other gears are working fine. What could be wrong with it?
View 5 RepliesLincoln - Towncar :: Vibration In Front End During Hard Braking
My 79 Lincoln Town Car vibrates in the front end during hard braking and braking from more than 30-35mph. There is no vibration in the rear, during turning or felt in the wheel. Is this wheel bearings, rotors, steering linkage, tire belts slipping or suspension? She has four wheel disc with early version of anti lock on rear. Brake fluid level is good with no leakage. Tires are near new but sat for long time parked in garage.
View 1 RepliesLincoln - Towncar :: Slippery Transmission When It Comes To A Very Little Hill Not Taking The Gear
Recently did Transmission rebuild soon after noticed that it's slippery. When I start the car in the morning it's not rolling as it should. I let it worm little like 3minutes then start driving but still it's slippery when it comes to a very little hill not taking the gear. After driving on the straight road for 4-5 blocks then its fine no problem at all. Only when car gets cold this issue happen.
View 3 RepliesFord F-150 - 1997-2003 :: 2001 - Replacing Gear Shift Lever?
I just bought a f150 2001 5.4L crew cab. It has the O/D switch in the gear shift lever and the black plastic handle is broke. I found a complete replacement lever on ebay but cannot find any tutorials on how to replace this.
View 8 RepliesLincoln - Towncar :: 2001 - Arbitrarily Surging / Making A Sort Of Grinding Sound
When I am driving, regardless of the speed at which I am traveling or the weather conditions, etc. The car arbitrarily surges, making a sort of grinding sound. I have to quickly tap the accelerator to stop it...a real problem if traveling in rush hour traffic, for example, so as not to run into the car in front of me. I have mentioned this to the folks who service my car but, naturally, it never does it in the shop.
View 1 RepliesLS / MKZ :: 2002 Lincoln V8 Doesn't Move When Put Into Reverse Or Drive
My 2002 lincoln ls v8 140k miles doesn't move when put into reverse or drive 5 or even d4,3,2,1 , it just starts to roll back/forward when taken out of park. It has the gear selector with d5, d4,3,2,1 not the select shift. I was told needs new transmission, but before it stopped moving completely it was still driveable second slipped at lower speeds(mostly when looking for parking or in traffic).
I had made an appointment to bring my car to the shop and the same day is when it stopped moving. All this happen within a week during the week i constantly got an e where d5 was and on last day check engine light came on.
Lincoln - Heating - Fans - Towncar :: 2001 - Heater Quits Working On Colder Days
The heater fan quits working on colder days. It is not the fan motor, as twice after it has quit, several days later the fan began working again. As controls are switched, the indicators light and mode shifting sounds can be heard. It seems to be that the fan quits on the colder days (<38 deg) the will resume working again when the outside temperature exceeds 50 degrees.
View 7 RepliesElantra MD (2010-15) :: Shift Lever Unable To Move From P And D Position
I have 2013 elentra just about a year old, (Took delivery june/2012). Recently some thing happen on the Shift lever, can't shift to "R" for back in parking, Shift to "N" is OK.
Some time it can't shift out from PARK to "R" or "N" or "D" ... Under any of this situation,car engine would not start.
Sound like the SHIFT LOCK did not release properly, or the Brake paddle position switch input did not send to Computer for engine Start.
Monte Carlo :: 2001 SS Hardly Move When Shifted Into Drive Like It Was Starting Out In High Gear
Recently purchased this Monte Carlo SS with a bad engine. Picked up a really good engine and it sounds great. Backed the car out of the garage, and when I shifted into drive, the car would hardly move. It felt like it was starting out in high gear. Had code P1860 (Trans converter clutch) set. Car has 150K on it. Suspected bad trans. Just had the trans rebuilt by AAMCO to the tune of $1100.00. Still have the exact same problem. The car will go in reverse just fine, but it won't hardly move forward. The old engine pushed a lot of antifreeze and oil through the exhaust. When I started the new engine, it smoked like a smoke stack for about 20 minutes, but then quit smoking. What am I missing? The trans is full of oil, and all connections are fine.
The Monte Carlo is a 2000, not a 2001.
Subaru - Impreza :: 2001 - Hard To Get Into Gear And It Would Not Move In Reverse / Neutral Or Drive
I had a problem with the CV Axle and the Wheel Bearings. I replaced them already and I ran into another issue with the Wheel Studs and the Ball Joint, so I ended up replacing them as well. Yesterday I put everything back together after replacing all the parts mentioned before and I made sure everything was bolted down and tightened, and then the tire back on and lowered the jack. I started up my car expecting it to drive just fine and it was harder to get into gear than before and it wouldn't move in reverse, neutral, or drive. I called a Monroe Muffler around here and they told me that the CV Joint is probably not seated all the way inside the Transfer Case.
So later the same day I took everything back apart and made sure that I put the CV Joint back into the Transfer Case and I put the pin back in and made sure that both CV Axles would turn at the same time, which they did. I figured it was good so I put it all back together again and went through the same process as before, making sure everything was tightened down, all the bolts and nuts and pins were where they needed to be. Everything seemed to be good. I put the tire back on again, lowered the jack, started the car and attempted to drive it again. It still won't move. Why this is happening.
GMC - Sierra :: 1999 - Gear Selection Lever Hard To Move
I have a 99' GMC 1500 Sierra SLT w/5.3 Vortec V-8 w/460,000 miles (yup !!) I bought the p/u w/59,000 miles, and the gear-selection lever on the column has always been hard to move when selecting gears. My daughter drives the p/u, and is hard for her to select gears.
View 1 RepliesSanta FE SM (2001-06) :: 2002 Auto - 4wheel Drive Doesn't Shift Into 5th Gear
Have an 02 Auto with the 2.7, 4wheel drive, and it doesn't shift into 5th gear. Can go through the 4 gears with the manual shift, but when just in drive, only shifts up to 4th. At 65mph, RPM's over 2500.
View 3 RepliesFord 6.7L Power Stroke Diesel :: Manual Downshifting In Drive D By Tapping On Shift Lever
I just noticed I could manually down shift transmission in D drive by tapping - on shift lever. I thought this was only possible in M manual mode.
View 3 RepliesLincoln - Towncar :: 2002 - Won't Turn Over
I purchased a new battery yesterday because the old one went dead. The car has been sitting for a month, upon completion of installing the battery, I cranked the car but it wouldn't turn over.
Lincoln LS 2002 V6....
Lincoln - Towncar :: 1997 - Replacing Oil Pan?
Replacing oil pan. It is a 1997 town car with the V8 4.6.The other mechanic told them that the pan is rotting through and it's not just a weeping gasket.
I have not had the chance to get this car to my shop, so I have not gotten a look at it.I'd just like to know what I will get involved with before I see the owners and the car.
how extensive this will be to get the engine up high enough to pull the old pan out.I'm hoping that I can just unbolt the motor mounts and jack the motor up a bit if need be.