Lincoln - Towncar :: 2001 - Intermittent Vibration When Move The Gear Shift Lever To D For Drive
I have a 2001 Lincoln Town Car that has an intermittent vibration that can be felt when seating in the car and you move the gear shift lever to D for drive. The car has 141,000 miles. It is an automatic transmission. The vibration cannot be felt when touching the steering wheel. What could be causing the vibration?
View 3 RepliesElantra MD (2010-15) :: Shift Lever Unable To Move From P And D Position
I have 2013 elentra just about a year old, (Took delivery june/2012). Recently some thing happen on the Shift lever, can't shift to "R" for back in parking, Shift to "N" is OK.
Some time it can't shift out from PARK to "R" or "N" or "D" ... Under any of this situation,car engine would not start.
Sound like the SHIFT LOCK did not release properly, or the Brake paddle position switch input did not send to Computer for engine Start.
Camry :: 2011 LE Won't Start - Cannot Turn The Key Or Even Move The Gear Shift Into Neutral
This morning my 2011 Camry LE won't start. Based on looking at car manual I think the 'Engine Immobilizer System' is still engaged and perhaps not recognizing my key, neither of them since I tried the spare as well. The instrument panel stays black and I can not turn the key or even move the gear shift into Neutral.
Any way to fix this without calling for a tow? So.... found out the problem! The steering wheel was angled slightly. With key in the ignition we jerked the steering wheel slightly and it released the ignition and was able to start.
Ford 6.7L Power Stroke Diesel :: Manual Downshifting In Drive D By Tapping On Shift Lever
I just noticed I could manually down shift transmission in D drive by tapping - on shift lever. I thought this was only possible in M manual mode.
View 3 RepliesSonata I45 (YF - 2011+) :: Seat Heater Won't Turn Off After Shift Lever Recall
Had the shift lever recall (clip) performed. Now the driver's seat heater won't turn off. I call the dealer back and they said that nothing they performed would have caused the issue. However, I don't trust the stealership.
View 4 RepliesSonata I45 (YF - 2011+) :: Braking Noise When Coming To A Stop Near Gear Shift Lever
I have a 2011 Sonata with 4,000 miles. Recently, I have noticed that when coming to a stop, I hear a light thump noise in the center console area near the gear shift lever. If I put my hand on the gear shifter, I can feel it move ever so slightly at the time of the noise. The noise is very repeatable. If I take my foot off the brake and start rolling and then I reapply the brake (either softly or hard) it will make the thump noise. It is not very loud and can be drowned out with loud music, but if listening to news, it is very noticeable and annoying in city traffic, where stops are very frequent. I put the car up on ramps and looked underneath and did not see anything noticeable. It will probably require the center console between the seats to be removed.
View 14 RepliesCamry :: How To Pop Out Flip Lid Between Shift Lever And Armrest
2010 Camry Automatic. The little flip lid between the shift lever and the armrest. My granddaughter accidentally got permanent magic marker on the lid. I tried to clean it to no avail. At a quick glance, I cannot see how it would pop out but then I may not be looking at it correctly or with the right frame of mind.
View 2 RepliesToyota - Camry :: Sticky Shift Lever On Hot Days
My 2000 Camry --4 cyc has a problem with the shift lever on hot days. It is hard to move from P to R to N to D and the other way back to P. There has never been any liquid spill on it. In cold days, the lever shifts fine.
View 2 RepliesNissan - Altima :: 1997 - Shift Car Into Drive And Engine Just Revs But Won't Move?
I have a 1997 Nissan Altima that I just barely got and it has started to show signs of trouble.
Sometimes when I put the vehicle into drive and step on the gas the car will not move and instead the engine will rev.I'll put the car back into park and then into drive and it'll work fine.
I checked the ATF, which was incredibly low and refilled it. The engine oil was also very low, which was refilled. The problem still persists. So I decided to add a bottle of Fuel Injector Cleaner to the gas tank.
I took the car for a short drive and nothing happened aside from the fact that the Check Engine light now comes on and off. The car also idles between 1000-1500 rpms.
Camry 2012+ :: Harder Acceleration With Harder Push On Brake
I normally drive my 2010 Prius. But I have been driving my wife's 2012 Camry XLE the last couple of days. (My Prius was clean and hers was not.
Well twice in the last two days I started her car and put it in drive to find it was accelerating uncontrollably! The harder I pushed on the brake the harder it accelerated.
After taking my foot off of the brake I discovered that my size 13 EEE shoe was on both the brake AND the accelerator.
Now knowing this, the same thing happened the second day! Luckily They both happened in parking lots and NO damage was incurred!
This has never happened in my 10 Prius or my 08 Prius. maybe the pedals are not as close or the Prius's low end power was not noticeable.
It would be ironic if all the BS over the floor mats came down to big feet or improperly placed pedals. My feet have been the same size for 50 years and many cars and NEVER had this occur before.
Prius (Gen 1) :: 2002 Brake Pedal Little Harder To Push - Lubricating Lever?
Recently the brake pedal on my 2002 Prius has been a little harder to push for the first mm of travel it almost "sticks" requiring slightly more effort once it moves past that point it is normal no fading or extra effort required this problem has now progressed to the point where the pedal is kind of crunchy for the first 5mm of travel and occasionally will not return right away causing the brakes to drag a little but again pressure required to stop is exactly the same no fading etc
I am thinking since I live on 2 miles of dusty washboard dirt road and some grit has worked its way into the bushing .
Sonata I45 (YF - 2011+) :: Gear Shift Won't Move Out Of Park
My mom has a 2016 Sonata that recently has started experiencing some issues with the gear shift. A few weeks back my stepdad was not able to get the gear shift to move out of park. Finally, my step brother did get it to go into drive, but then could not get back into park (he could only get into neutral), so my mom took it to have it looked at. While at the dealer someone there was able to get the gear shift to work and we thought everything was okay. That was until today when my stepdad could not get it out of park again. I noticed today that button on the shift knob was fully depressed while in park. I did attempt to use the shift lock release per the instructions in the manual with no luck.
My mom is going to call Hyundai in the morning to see what they can do for her, as the car is parked at minimart right now.
Toyota - Camry :: 2000 Won't Start When Warm / Gear Shift Lever Is Not Finding Park Or Neutral
My Daughter owns a 2000 Camry. It has a very annoying habit of not starting when it is warm (think driving to the gas station, turning the car off to fill it and then it doesn't start again). We have tried new solenoids, a new starter and several other tweaks but nothing seems to fix the problem. Recently she discovered if she jiggles the gear shift lever (it's an automatic) it will start. So, obviously she gear shift lever is not finding Park or Neutral so that it can be in position to start. She has experimented with this concept and it appears to be the only thing that consistently solves the starting issue. What would we have to fix in the gear shift lever, or elsewhere, to fix this problem?
View 5 RepliesCamry :: 2002 - Grinding Noise And It Won't Move In Reverse Or Drive
I replaced the front hubs and bearings on my brothers 2002 Camry today. He drove less than a block and developed awful grinding noise and it won't move in reverse or drive. It rolls when I put it in park. I had to pull it back into my shop. Is it possible the inner CV came loose and i didn't realize it? It all seemed to go back together fine. The new CV axle nuts were quite tight and slow to put on with my impact gun.
What else could possible go kaput when I re & re hub/bearings? And what a long ugly job to replace those bearings. Don't even think about doing this without a good hydraulic press. Up to the point of getting knuckle off, it was easy job.
Camry :: 2003 - Trans Won't Shift Into 4th Gear In Normal Conditions - DTC P0766
On a '03 Solara, I've got this code. It designates Shift Solenoid Performance (stuck off) for the S4 valve. It makes sense because the trans won't shift into 4th gear in normal conditions.
But I was wondering what the likelihood of the transmission speed sensor set this code by giving a faulty reading that was too slow. The car seems like it is going somewhat faster than the speedometer is reading. RPMs are over 3000 at 50 mph. Seems like I'm doing 60-65. I wonder if the ECM is not commanding the 3-4 shift because it 'thinks' the car has not reached the required speed?
Or possibly the button on the shifter is simply malfunctioning. The indicator light on the dash comes on if the button is pushed, and goes out when you push it again. I'm not familiar with what the normal RPM would be at highway cruising. It's a 4 cyl with 169,400 miles. Would torque converter clutch be more likely to fail than the shift solenoids on these cars?
Chrysler - 300m :: 2000 - Press Harder Than Normal While Stopping At Light?
My 2000 300M has 135k miles on her. With the a/c on when I come up to a traffic light and stop, it feels like i have to press harder then normal to keep the car stopped at the light. the other night at a light I put the car in nuetrel and the engine rpm went from 700 rpm to 1500 and up to 2000 rpm. There is no check engine light at this time. the car does not to this when the a/c is off. I have not scanned the car yet.
View 7 RepliesBuick - Regal :: Brakes Sticking And Engine Sounds Like It Is Working Harder To Get The Car To Move
I have a 1999 Buick Regal GS and it feels like I'm continuously riding the brakes at random times and engine sounds like its working harder than usual to get the car to move. I thought I had this problem solved by replacing the master cylinder but I seems to be happening again. The reason I replaced the master cylinder was because I came out one morning about 2 months ago and started down my driveway to get the mail (I live on a steep hill) and I thought I had a broken line or something because I had almost no pedal and it was sinking to the floor. What confused me the brakes seemed good the day before when I drove about 40 miles round trip to town and then parked it overnight. (except for the brakes sticking feeling) I had the car put on a rack and found nothing more than a slow leak at the proportioning valve but I noticed on the way to the shop the car was no longer hard to move and was smoother rolling than it had been in a long long time.
The brake fluid was a little low but when I filled it to the max level the pedal still felt soft and would sink unit I had the master cylinder replaced, With the sinking pedal and all I was thinking its probably a bad/sticking master cylinder that maybe could have been applying slight pressure to all the brakes at once and now it was released. I purchased a reman master cylinder from advance and had it put on and it seemed to work great and my car was still rolling freely. The proportional valve is still leaking (small drip when pressed) but I didn't think it could cause all these problems. I usually have to pump the brake before I leave of a morning or my pedal will be soft and sink but not all the time.
Recently I noticed my car is starting to feel like it is sticking again and my last mpg estimate was 17mpg, I might be a little hard on the throttle at times but not all the time. The rims feel equally warm after driving but not real hot. I have replaced a lot of parts over the last 2 years so most of the braking parts are near new. All the brake lines have been replaced along with the hydraulic hoses. Front calipers are new Rear caliper I rebuilt myself Master cylinder was replaced over a month ago. Could it be the abs unit or the brake booster? A week ago the car rolled freely but the pedal was starting to feel hard like the symptoms of a bad brake booster.
Dodge - Neon :: 2000 - Knocking Sound When Get On Gas A Bit Harder Than Normal From A Dead Stop
I have a 2000 neon, a knocking sound has started only when I get on the gas a bit harder than normal from a dead stop. It seems to last only a few seconds knock knock really fast and then its gone, does not sound like engine knock (rocker knock or persistent knock) more like a mechanical noise. Where to start ? Front breaks were done 4months ago, new rotors / pads / and 1 caliper ...
Seems it to be worse now....now starting to lean towards broken motor mount ... how to check or where to find them. Also now starting to hear while braking.
Tiguan :: Won't Start - Move Lever To P/N Message
Can't start my Tiguan this morning. Getting the message "Move lever to P/N". The lever IS in park - moving to neutral doesn't work either.
Last night the girlfriend turned off the car while it was still in gear (she's used to manual). I've done that before though and never had any issues. You can't actually remove the key until it's in park anyway.
However now the computer seems to be stuck on the idea that the vehicle is still in gear. Not sure what to do. Guess I'm going to just keep trying it through out the day and hope it ends up correcting itself. I'll just work from home today/tomorrow. But I'm eventually going to have to get it towed to the VW dealership.