Santa FE SM (2001-06) :: 2004 - Auto Trans Stuck In 3rd Gear And Does Not Want To Shift
I have a 2004 Hyundai Santa Fe, has 99,000 miles 3.5L. After changing the alternator (alternator did die and drained my battery, the shop recharged the battery) now it seems be stuck in 3rd gear and does not wont to shift (it is a automatic). Fluids are good, transmission was flushed between 50-60,000 miles.
View 3 RepliesSanta FE SM (2001-06) :: 2002 V6 Very Hard To Shift From 2nd To 3rd Gear
I have a 2002 Santa Fe V6 2.7 liter, FWD, 215,000+ miles. When it shifts from 2nd to 3rd the whole vehicle jerks. It does not do this on the other gears. I took it by a transmission place for a free scan and they said the transmission is fine.
View 19 RepliesElantra XD (2001-06) :: 2005 Doesn't Go Forward At All If Shift Into Reverse And Then Go Back Into Drive
I recently bought my '05 Elantra from a small dealership and I'm starting to see a problem with it. If I shift into reverse and then go back into drive, the car doesn't go forward at all. I have to mess with the gear shift a bit to get the car moving. I'm pretty sure it's a bad linkage. The dealership I bought it from said it desperately needed motor mounts when they got it so they replaced 2 of them. I'm sure the problems are related. I can't find any information on replacing it myself though.
View 1 RepliesSanta FE SM (2001-06) :: Auto Transmission Will Not Move In Reverse Or Drive
I just did a motor swap on a 2003 with 3.5 auto tranny and awd. engine runs great and every thing is running fine. Only problem is that the trans will not create any power. With no drive shafts on it still wont move the splines. With that said the trans was driving/running great b4 the swap.
View 2 RepliesPassat (B5) :: 2002 - Transmission Does Not Shift Into First Gear While In Drive
While in drive, transmission does not shift into the first gear (once in motion transmission shifts between 2-5 without any issues), but all 1-5 gears available while in Tiptronic mode. The check engine light is not on. Is it a transmission problem or a control/wiring issue?
View 3 RepliesSanta FE SM (2001-06) :: Gear Shifter Very Hard To Move And Doesn't Really Go In Park?
This morning as I get in to drive my kid to school (2005 2.7 2 wd auto) as I go to put it in reverse I noticeably have to pull it with some force. I have never had to "force it" before, it had always switched gears with ease. This time it felt very stiff but had no issues going into gear. After I dropped my son off at school I went through the gears up and down and it felt very stiff (at this point i have no issues with starting it or P).
At lunch I go out to get something to eat and when I go to start it up it won't start. I try and try and nothing. All the lights came on, it's not a battery issue at all (brand new). But after 10 tries it starts, so I'm pretty happy. Then I go to put it in gear (reverse) I can not press in the button on the side of the gear shift. It will not go in. I press with all my might and it wont budge. But again, after about 10 good tries at it goes in and I can then select my gear but still feels very stiff.
After stopping again I didn't shut off the engine and dicked around with the shifter basically figured out that my car is not recognizing Park. On the instrument panel each gear lights up but not P. It gets very stiff when trying to put it in P but it doesn't actually go into P. If I put it in P (or really the further up it will go) and shut off the car, it won't start again. I can start it up in N and only N.
Santa FE SM (2001-06) :: Clunking Sound When Shift Into Drive Or Reverse - Bad Motor Mounts?
I have a 2002 santa fe 2.7. I just had the transmission rebuilt and since then have noticed a clunking sound when I shift into drive or reverse. It seems to be the lower motor mount is making noise from the motor moving the mount. I look at the mount and it appears to look good, but was wondering how I can really tell if a motor mount needs replacing or not.
View 3 RepliesSanta FE SM (2001-06) :: Drive Stays In 1st Gear
2003 Santa Fe, 2.7L V6
When placed into Drive, the transaxle (and indicator lights) behave as though the gear selector was in the manual gate and at 1st gear. It seems that no matter what I do (wiggle the selector, disconnect the battery, etc) will bring it out of 1st gear while in D. This issue first occurred about a month ago and it somehow corrected itself. I had hoped that it was a fluke, but it is happening again. Initially, I suspected that it might be a switch or something within the gear selector lever housing in the console, but I've done a bit of searching the webs and it looks like it may be more of a sensor(s) issue.
Santa FE SM (2001-06) :: Hard Shift From 3rd To 2nd Gear
My Santa Fe 2001 model V6 4X4 Automatic shift gears down hard from 3rd in to 2nd. I checked transmission oil and its light brown. Should I drain and refill or not worth it.
View 7 RepliesLincoln - Towncar :: 2001 - Intermittent Vibration When Move The Gear Shift Lever To D For Drive
I have a 2001 Lincoln Town Car that has an intermittent vibration that can be felt when seating in the car and you move the gear shift lever to D for drive. The car has 141,000 miles. It is an automatic transmission. The vibration cannot be felt when touching the steering wheel. What could be causing the vibration?
View 3 RepliesSanta FE SM (2001-06) :: 2005 - Gear Shift Knob Replacement?
How do I take off the gear shift knob? I want to replace it with an aftermarket one.
View 1 RepliesSanta FE SM (2001-06) :: 2004 - Grabby / Sudden Shift From 2nd To 3rd Gear
Last week my wife's 2004 Santa Fe with 68k went into limp mode, when I ran the code reader it came up with throttle position sensor and pedal position sensor. After fixing both the car runs great except for a Grabby or sudden shift from 2nd to 3rd. It shifts at about the right rpm but very hard. I am wondering if there is trans codes that need to be reset that my code reader is not able to do.
View 3 RepliesSanta FE SM (2001-06) :: Lost Ability To Shift Gear - Stuck In 2nd
My 2001 Santa Fe 2,4l - Have suddenly lost the abillity to shift gear. Its stuck in 2 and the shift stick is very loose in the "front to back and back to front" motion.. in other words there are resistance sideways.
I suspect it to be a broken shift cable. So my question is : changing shift cable on a santa fe easy? Is the best approach to start from inside the vehicle or from transmission side?
Santa FE SM (2001-06) :: 2002 - Hard To Shift From Parking To D
I Have a Hyundai Santa Fe 2002 4X4 automatic for a long Time. Recently, I've had a serious problem, just before couple of month's ago, when I start the car ,and I want to switch from parking to D. The D is Not working at all. Just like if I am on Neutral. The Reverse is Fine though, I stay on the D For a while and step on the throttle pedal and keep trying, suddenly i hear a clicking sound and the car shake a bit and the gear works! I had this every morning, so I got it checked and I've changed the whole gear. The car worked Fine. About a week ago, I've had the same whole problem again! But, in addition, when The gear Works,it jumps to 3rd, I try to Downshift to 2nd or upshift to 4th, it just stay on the 2nd and stay there for a while, then I hear the same old clicking sound with the shake, and its back on 1st. I've Changed the gear Before, will not do again, what else?!
View 2 RepliesSanta FE SM (2001-06) :: 2002 - Slight Hesitation After About 15 - 20 Minutes Of Drive
I have an '02 Santa Fe GLS V6 2WD. I am having a strange problem and do not know what it could be. When car is cold, it starts up and runs with no problems. After about 15-20 mins, there is a slight hesitation or studder. RPM's drop slightly and shutters. When i accel, engine studders, then runs fine. This only happens when at idle in drive. At highway speeds there is no problem. What can this be?
View 7 RepliesSanta FE SM (2001-06) :: 2002 - Loud Noise From Engine When In Drive
2002 hyundai santa fe GL2 4 Cyl Automatic ... I noticed that there is a super heavy motorcycle-ish loud noise from my engine when I put it in drive. When it's idle or in reverse or neutral the problem does not occur. but then when I switch it to drive, uber loud noise...which gets louder when I step on the gas.
What has been done so far - replaced spark plugs, ignition coils and plug wires so far...also changed the oil, no fix.
No check engine light at all.....however the battery did die due to someone leaving a light on for days So I am unable to get any code readings.
Santa FE SM (2001-06) :: 2002 - Code P0715 / Car Won't Shift Properly
My brother and father just finished with all of the small issues after throwing in both a "new" engine into the vehicle and a transmission..both have around 80K miles (chassis has around 180K). There were some issues with codes after both were installed, but then everything was diagnosed and fixed, vehicles codes were gone and vehicle was able to be registered, afterall.
Anyways, now the car threw a P0715 code and has issues with shifting. It appears that the Santa Fe is stuck in a single gear (appears to be a higher gear). The car won't shift properly, especially noticed at higher speeds in a main road. Using tiptronic does not seem to make a difference. After the car sits and is taken around the neighborhood, it seems to drive fine, until it is taken out into a main road...I'm guessing once it heats up?
So, what should be looked into? A sensor? Is it maybe because this "new" used trans was swapped in and all of the trans fluid was replaced with new fluid? What could the issue be? I guesss the car's been a headache but they're trying to get it finished to avoid any further codes/issues.
02' Santa Fe 2.7 FWD
Elantra MD (2010-15) :: When Accelerate While In Drive From A Stop Car Doesn't Seem To Shift Up
I started to realize something very weird in my car. While in drive from a stop I would accelerate and the car doesn't seem to shift up when its suppose too. I know that my car shifts around 2.1k RPM smoothly into second gear but now it would go all the way up to 3K RPM and slams into second gear which is really weird. Sometimes it does this problem and sometimes it doesn't. I would say 70% it would slam into gear. Not only does it slam but it would seem like this car does not want to shift at the proper rpm even when i foot is on the gas pedal very lightly.
Once I got home I tried some stop and goes and see if the problem persist. It still did. Then I tried doing shiftronic and from first gear once the line touches 2k RPM i shift up and yet it would still lag and the needle would go up to 3K RPM once again. This seems like a very bad problem especially MPG wise. I am still under warranty, I think because I've only swap the air filter with a drop in K&N and just plasti dipped my wheels and such.
Prius (Gen 3) :: 2011 Ready Indicator Doesn't Come On / Car Took Long To Shift Into Drive
About once a week our 2011 Prius will start, but the "Ready" indicator does not come on and the car cannot be shifted into drive. Once this happens it takes several attempts, turning the car on/off, until it finally comes on "Ready." I cannot create the problem, but it may stem from pushing the start button before the brake is fully depressed.
Last night it took more than 5 minutes to get it going. I "reset" the car by exiting, locking, and re entering the car. Then it worked, that procedure caused it to work.