Ford - Explorer :: Brake Pedal Vibrates When Pressed Down
When I press the pedal down the pedal vibrates and make an odd sound like errrrrrrrrrrrr best way I can explain it...
View 5 RepliesGolf VI R :: Clutch Pedal Vibrates When Accelerator Pressed
If I'm at part throttle and i press the clutch pedal in about 2-3 inches, leaving the clutch still fully engaged, i can feel a really rough vibration in the clutch pedal. it stops vibrating as soon as i let off the gas. and i'm only giving it a little bit of gas, mind you.
If I'm at idle, and i have the clutch depressed all the way and rev the engine, I can feel vibration in the clutch pedal. My 6-speed MK4 did not do this, not in the slightest. Is this normal for MK6 or do I have a problem?
Honda - Accord :: 1999 - Engine Dies When Pedal Pressed Down / Revs And Then Quits When Pedal Is Pressed Slowly
Ok, did an intake manifold cleaning on my 99 Accord the other day, and now I have problems...
Long story short, some time ago my car started to have a very rough idle. Took me awhile to find the problem. Turned out the air hose, between the filter and throttle body, had developed a big hole on the underside. So I replaced it and while I was at it used some throttle body cleaner, spraying into the intake manifold chamber. Lot of junk blew out the tailpipe. The car ran much better, but the idle could still be a little rough. I ran it that way for awhile, and finally the other day decided there was probably still some junk in there and it was time to really clean it out. So I took ff the throttle body and intake manifold housing. There was a lot of junk in there! The small intake on the passenger side was completely clogged shut. (I understand this isn't surprising on these cars.) I used a bunch of rags and 2 cans of Valvoline throttle body cleaner and a lot of elbow grease and cleaned it out. I was thinking to myself that whatever I didn't get with the rags flushed through OK, but I didn't want to take the whole intake manifold out.
So I put it all back together. (I took a video before I started, so I'm pretty sure it's all back together right.) But now I have problems. The car starts. It idles fine mostly, but can be a bit rough. But the trouble starts when I put the pedal down. If I do it in Park, well, if I push it quick the engine just dies. If I push it slow, the engine revs then quits, revs and quits, over and over. Similar if it's in gear. If I push it hard, the engine stalls. If I push it gentle, it revs up, but chugs along a bit.
I've run some seafoam through it, thinking it was clogged up with all that junk, and sure enough, lots of smoke comes out, but nothing is improving so far. What have I done wrong?
Cherokee :: Passenger Side Brake Light Won't Engage When Brake Pedal Pressed
I own a 04 Grand Cherokee and have recently had problems with my passenger side brake light. Now the light itself does work under normal running light conditions, but when I go to press the brake pedal it doesn't engage the bright brake light. Drivers side works fine and so do all my other lights, I replaced the bulb to no avail, and am now currently looking into replacing the bulb socket.
View 1 RepliesPrius (Gen 3) :: Chirping Noise When Brake Pedal Pressed
I was wondering if this problem is the "Barking" noise that keeps coming up the search or is it another problem. I will include a link to the video down below.
To start off, the Prius is 2010 Prius II and has 120k miles on it. Great Car. Only other problem was AC compressor dying at 90k.
The chirping noise happens when the brake pedal is pressed and does not go away until the release the pedal. It makes the noise regardless of whether the car is on or off.
It makes the noise when the car is stopped and or when the mechanical brake engage at between 0 and 6 mph.
Noise does not occur when the brake switch is removed. Not valid solution since the brake lights will stay on. It does not affect the performance of braking.
Here is the link to the video .... .... ....
Prius C :: Brake Pedal Stuck / Not Going To The Bottom When Pressed
Today I faced another problem i just try to start my car but, due the dead 12v battery it didn't start so i pressed the BRAKE PEDAL until it reach the bottom, again i tried to press but its not going to the bottom why was that, is it due to dead battery? And last time i called an automobile expertise to jump start my car. They check the voltage with a digital multi-meter and he said me if you jump start even you will get this problem again until u replace the new battery. but i said him it doesn't matter do a jump start and finally it was ok . Now again I faced the same problem and this time i am going to change the battery.
View 1 RepliesDodge - Durango :: 2004 - Brake Pedal Vibrates When Applied
I'm the only owner. Since new the rear brakes have never generated even a fraction of the dust of the front brakes. I have replaced the front and rear pads but never had the rotors turned. The rotors aren't perfectly smooth but they don't have any deep ruts.
Anyway, my brake pedal vibrates when I apply the brakes. And the rear brakes squeak randomly when braking even though there are new pads. I always felt they squeaked because there is not much braking power in the rear.
My Durango stops okay. I'm worried about catastrophic failure because of the vibrating.
Lexus LS 2007+ :: Starting Engine Without Brake Pedal Having To Be Pressed
Requiring that the brake pedal be depressed in order to start the engine can be a nuisance, say if the driver is out of the vehicle and the passenger wants to start the engine to run the A/C, etc.
There is a workaround though. Press the engine start switch once to go into ACC mode, then press and hold it for 15 seconds and the engine will start without the brake pedal having to be pressed.
Subaru - Legacy :: 1996 Sometimes Will Not Start Unless Brake Pedal Is Pressed
Sometimes my 96 Subaru Legacy will not turnover unless the brake pedal is pressed. Other times starts without my foot on the pedal. It seems to need the brake pedal addition more often if it has sat a couple hours or more without being started.
View 5 RepliesSonata NF (2006-10) :: Brake Pedal Produces A Click When Pressed
My Sonata 2008 2.4 produces a single click as I press brake pedal, somewhere half way through. You can hear it and feel it with your foot. I think it clicks somewhere inside the hydraulic system of the brake.
View 13 RepliesAccent MC (2006-11) :: Brake Lights Does Not Work When Pedal Pressed
Noticed when I press brake pedal brake lights does not work even the center one. Checked all fused in the car and the small ones under the hood. All fine. I have a long trip tomorrow. Where else i can look. Everything seems working. Reverse light is fine. Is that related to latest brake light switch recall? Cant think of anything else.
View 4 RepliesPrius (2004-09) :: Squeak Occurs When Car Is Stationary With Brake Pedal Fully Depressed
I have recently purchased a 2007 Gen 2 Prius and sometimes it emits a very annoying squeak. It occurs when the car is stationary, with the brake pedal fully depressed. When inside the vehicle it seems to be coming from behind the glove box. When on the outside and facing the car it seems to be coming from below / behind the electric motor. I have made a recording of it with the noise in question being audible for a couple of seconds at 0:13, and then again at 0:22 until the end. It could be nothing I guess, but this is my first hybrid and I am not too sure what is perfectly normal and what is not.
View 14 RepliesLexus GS 2006-11 :: GS300 AWD Vibrates A Little Bit When Hold On To Brake And Gear In Drive
I have 06 gs300, it vibrates a little bit when i hold on to brake and gear in drive, I did take it to dealership and they want $1300 for this job to be done. Replacement of Motor Mount on 2006 GS300 AWD
View 13 RepliesLexus GS 2013+ :: Car Stalls While Stopped In Drive, When Brake Pressed Firmly
'15 Gs350 FSport. 4K miles. I have been able to replicate this issue, and won't have time to bring it into shop until next week.
I am at a stop light after driving for a bit. Car in drive obviously, foot on brake. If I press the brake very firmly, almost to where it hits the floor board, the slip indicator light comes on and flashes, and call stalls (or goes into idle). I am forced to shift car into park, and then shift back into drive. Or I have to turn car off, and back on again.
What was going on - I was reaching over to the passenger seat while at a stopped light and pressed down the brake pretty hard by accident. But I am now able to replicate it.
Elantra MD (2010-15) :: Driver Side Brake Light Does Not Come On When Pedal Pressed?
I have 2013 Elantra ( 20,000 miles) and when I put the brake lights on without the headlights on everything works ok but when the headlights are on the driver's side brake light does not come on when the brake pedal is pressed. I thought it was a bulb problem so I replaced it but I am still having the same issue. What is going on? I know it is still under warranty but I figured I could handle a burnt bulb issue but that was not it. I noticed that the drivers side bulb is not as bright either when brake is pressed without headlights
View 11 RepliesLexus GX 2010+ :: Brake Pedal Have A Slight Modulation Or Vibration While Pressed
To all 2014 and 2015 GX 460 owners, does brake pedal have a slight modulation or vibration while press it. Feels like ABS but not as strong pumping action.
When I step on the brakes the first time feels normal and then I let go of the brakes, then I press it the second time that is when I feel a slight modulation or vibration of the brake pedal.
Jeep - Grandcherokee :: Brake Pedal Spongy And Almost Reaching The Floor When Pressed
After my local brake shop changed the front rotors and brake pads on my 99 grand cherokee the brake pedal is spongy and long, almost reaching the floor. They don't know why. Apparently they had a problem with fitting the new pads. I took it to the jeep dealer and they told me the master brake cylinder was leaking and needed to be replaced. many hundreds of dollars later the brakes are still spongy and long and does not correct with repeated pumping. The dealer was also stumped and I complained that nothing changed with the new master cylinder. what might be the problem?
View 4 RepliesLexus ES 2007-12 :: 2010 ES350 Won't Start - Brake Pedal Couldn't Be Pressed Down
My wife called and said her ES350 couldn't start. I told her to wait 5 minutes and tried again. It still wouldn't start.
So I went there and tried to start the car. My first try did not work either. I noticed that the brake pedal couldn't be pressed down. It was quite stiff. So I pressed hard on the brake pedal and tried again. This time it started. It has been working fine since then.
Toyota - Camry :: 1999 - Brake Light Comes On Sporadically / Pedal Needs To Be Pressed Down Farther
I have a 99 Toyota Camry and recently the breaklight has been coming on and off sporadically. I assumed I had done some damage to my E-break, as the other week I tried to back out with it on (cut me some slack, I just moved to PA after having only really driven in FL lol). I wasn't worried about it since I didn't notice any issues with my breaks, however the last few days I randomly have to press the pedal down almost to the floor to come to a full stop. There doesn't seem to be any consistency to this, sometimes it happens when the light is on but usually not. It does it both when I am stopped (causing me to move forward slightly till I depress it farther), sometimes when I am stopping normally, both when I'm going straight and right after turning, ect.
I checked my break fluid level and it is at the minimum line so I doubt that is the issue. I did some research and saw many saying that it was likely just air in the lines and that the system needed to be bled. But some also mentioned replacing the master cylinder so I wanted to see what response I might get on here (I don't know very much about cars myself).