Prius C :: Brake Pedal Stuck / Not Going To The Bottom When Pressed
Today I faced another problem i just try to start my car but, due the dead 12v battery it didn't start so i pressed the BRAKE PEDAL until it reach the bottom, again i tried to press but its not going to the bottom why was that, is it due to dead battery? And last time i called an automobile expertise to jump start my car. They check the voltage with a digital multi-meter and he said me if you jump start even you will get this problem again until u replace the new battery. but i said him it doesn't matter do a jump start and finally it was ok . Now again I faced the same problem and this time i am going to change the battery.
View 1 RepliesChrysler - Newyorker :: 1993 - Mechanical Whirring Noise When Brake Pedal Pressed?
I am looking to purchase a 1993 Chrysler New Yorker and when I test drove it I noticed that every time the brake pedal was pushed a mechanical whirring noise was audible. This happened every time the brake was pushed whether the car was moving or not. The car brakes seemed to work fine and there were no other noises associated with normal brake problems. The noise seemed to come from inside the car. What that might be? Also, any other reasons to not buy a 93 New Yorker with about 115,000 miles on it for cheap?
View 1 RepliesFord - Escape :: Grinding Noise While Backing Out Of Driveway (downhill) And Pressed Brake Pedal
I have a 2008 Ford Escape, and today I noticed that while backing out of my driveway (downhill) as I pressed the brake pedal it made this grinding noise, but when I got out of the car I looked through the tires and the rotors and pads were fine. I did not get a chance to check the inner side of the rotor or pad yet. What else could this noise be if it's not the brakes? It only makes this noise when I press the brake pedal which is why I thought it was the brakes.
View 3 RepliesPrius (2010-12) :: 2015 - Solid Brief Single Click When Brake Pedal Pressed / Released
We have a new 2015 Prius with 6k on it and we are noticing one solid brief single click when the brake pedal is pressed and/or released. It doesn't happen every time (just some of the time) but it is only noticeable at slow speeds.
View 19 RepliesHonda - Accord :: 1999 - Engine Dies When Pedal Pressed Down / Revs And Then Quits When Pedal Is Pressed Slowly
Ok, did an intake manifold cleaning on my 99 Accord the other day, and now I have problems...
Long story short, some time ago my car started to have a very rough idle. Took me awhile to find the problem. Turned out the air hose, between the filter and throttle body, had developed a big hole on the underside. So I replaced it and while I was at it used some throttle body cleaner, spraying into the intake manifold chamber. Lot of junk blew out the tailpipe. The car ran much better, but the idle could still be a little rough. I ran it that way for awhile, and finally the other day decided there was probably still some junk in there and it was time to really clean it out. So I took ff the throttle body and intake manifold housing. There was a lot of junk in there! The small intake on the passenger side was completely clogged shut. (I understand this isn't surprising on these cars.) I used a bunch of rags and 2 cans of Valvoline throttle body cleaner and a lot of elbow grease and cleaned it out. I was thinking to myself that whatever I didn't get with the rags flushed through OK, but I didn't want to take the whole intake manifold out.
So I put it all back together. (I took a video before I started, so I'm pretty sure it's all back together right.) But now I have problems. The car starts. It idles fine mostly, but can be a bit rough. But the trouble starts when I put the pedal down. If I do it in Park, well, if I push it quick the engine just dies. If I push it slow, the engine revs then quits, revs and quits, over and over. Similar if it's in gear. If I push it hard, the engine stalls. If I push it gentle, it revs up, but chugs along a bit.
I've run some seafoam through it, thinking it was clogged up with all that junk, and sure enough, lots of smoke comes out, but nothing is improving so far. What have I done wrong?
Cherokee :: Passenger Side Brake Light Won't Engage When Brake Pedal Pressed
I own a 04 Grand Cherokee and have recently had problems with my passenger side brake light. Now the light itself does work under normal running light conditions, but when I go to press the brake pedal it doesn't engage the bright brake light. Drivers side works fine and so do all my other lights, I replaced the bulb to no avail, and am now currently looking into replacing the bulb socket.
View 1 RepliesFord - Explorer :: Brake Pedal Vibrates When Pressed Down
When I press the pedal down the pedal vibrates and make an odd sound like errrrrrrrrrrrr best way I can explain it...
View 5 RepliesLexus LS 2007+ :: Starting Engine Without Brake Pedal Having To Be Pressed
Requiring that the brake pedal be depressed in order to start the engine can be a nuisance, say if the driver is out of the vehicle and the passenger wants to start the engine to run the A/C, etc.
There is a workaround though. Press the engine start switch once to go into ACC mode, then press and hold it for 15 seconds and the engine will start without the brake pedal having to be pressed.
Passat (B6) :: Brake Pedal Vibrates When Fully Pressed In Drive
When brake pedal is fully pressed and my car is in drive the pedal vibrates. The only thing I thought of is that my intake is touching something, but I don't see anything.
View 8 RepliesSubaru - Legacy :: 1996 Sometimes Will Not Start Unless Brake Pedal Is Pressed
Sometimes my 96 Subaru Legacy will not turnover unless the brake pedal is pressed. Other times starts without my foot on the pedal. It seems to need the brake pedal addition more often if it has sat a couple hours or more without being started.
View 5 RepliesSonata NF (2006-10) :: Brake Pedal Produces A Click When Pressed
My Sonata 2008 2.4 produces a single click as I press brake pedal, somewhere half way through. You can hear it and feel it with your foot. I think it clicks somewhere inside the hydraulic system of the brake.
View 13 RepliesAccent MC (2006-11) :: Brake Lights Does Not Work When Pedal Pressed
Noticed when I press brake pedal brake lights does not work even the center one. Checked all fused in the car and the small ones under the hood. All fine. I have a long trip tomorrow. Where else i can look. Everything seems working. Reverse light is fine. Is that related to latest brake light switch recall? Cant think of anything else.
View 4 RepliesElantra MD (2010-15) :: Driver Side Brake Light Does Not Come On When Pedal Pressed?
I have 2013 Elantra ( 20,000 miles) and when I put the brake lights on without the headlights on everything works ok but when the headlights are on the driver's side brake light does not come on when the brake pedal is pressed. I thought it was a bulb problem so I replaced it but I am still having the same issue. What is going on? I know it is still under warranty but I figured I could handle a burnt bulb issue but that was not it. I noticed that the drivers side bulb is not as bright either when brake is pressed without headlights
View 11 RepliesLexus GX 2010+ :: Brake Pedal Have A Slight Modulation Or Vibration While Pressed
To all 2014 and 2015 GX 460 owners, does brake pedal have a slight modulation or vibration while press it. Feels like ABS but not as strong pumping action.
When I step on the brakes the first time feels normal and then I let go of the brakes, then I press it the second time that is when I feel a slight modulation or vibration of the brake pedal.
Jeep - Grandcherokee :: Brake Pedal Spongy And Almost Reaching The Floor When Pressed
After my local brake shop changed the front rotors and brake pads on my 99 grand cherokee the brake pedal is spongy and long, almost reaching the floor. They don't know why. Apparently they had a problem with fitting the new pads. I took it to the jeep dealer and they told me the master brake cylinder was leaking and needed to be replaced. many hundreds of dollars later the brakes are still spongy and long and does not correct with repeated pumping. The dealer was also stumped and I complained that nothing changed with the new master cylinder. what might be the problem?
View 4 RepliesLexus ES 2007-12 :: 2010 ES350 Won't Start - Brake Pedal Couldn't Be Pressed Down
My wife called and said her ES350 couldn't start. I told her to wait 5 minutes and tried again. It still wouldn't start.
So I went there and tried to start the car. My first try did not work either. I noticed that the brake pedal couldn't be pressed down. It was quite stiff. So I pressed hard on the brake pedal and tried again. This time it started. It has been working fine since then.
Toyota - Camry :: 1999 - Brake Light Comes On Sporadically / Pedal Needs To Be Pressed Down Farther
I have a 99 Toyota Camry and recently the breaklight has been coming on and off sporadically. I assumed I had done some damage to my E-break, as the other week I tried to back out with it on (cut me some slack, I just moved to PA after having only really driven in FL lol). I wasn't worried about it since I didn't notice any issues with my breaks, however the last few days I randomly have to press the pedal down almost to the floor to come to a full stop. There doesn't seem to be any consistency to this, sometimes it happens when the light is on but usually not. It does it both when I am stopped (causing me to move forward slightly till I depress it farther), sometimes when I am stopping normally, both when I'm going straight and right after turning, ect.
I checked my break fluid level and it is at the minimum line so I doubt that is the issue. I did some research and saw many saying that it was likely just air in the lines and that the system needed to be bled. But some also mentioned replacing the master cylinder so I wanted to see what response I might get on here (I don't know very much about cars myself).
Ford - Ranger :: 2000 - Speedometer Quit / Jump When Brake Pedal Pressed?
I have a 2000 Ford Ranger, 5spd with 3.0 v6. The speedometer will jump around or quit about half the time whenever you push the brake pedal or use the turn signals. I've cleaned all the grounds I can find including taking the battery cables off the clamps and cleaning them, and I had to clean all the fuses (inside box and outside box) because most of them were corroded. It still does it. Occasionally, I'll hear a buzzing/crackling noise like electricity arcing when I use the brakes or the turn signals which sounds like it's coming from the left side of the dashboard.
I took off panels and the fuse box, but I don't see any sign of arcing. Also, the noise only occurs when the truck is actually moving, never when it's sitting still. Also, the engine has a slight flutter at an idle. I hooked up a computer, and the O2 sensors were erratically jumping between rich and lean, so I replaced all of them. It says Insufficient EGR flow detected, so I did put a new EGR valve on and cleared the codes, but it still reads the same. And lastly, the computer refuses to finish either of its diagnostic tests. I've tried the Koeo and the koer tests, and neither will complete.
Yaris/Scion & Vitz :: 2000 Echo Squealing While Driving Or In 2nd Gear And When Brake Pedal Pressed
The front end of my Toyota Echo has been squealing but only when it's either in drive or in 2nd gear and only when the brake pedal is pressed, once I release the brake pedal it only squeals for a few seconds then once the car moves faster than 5 miles an hour it goes away.. I completely replaced the suspension late last year. I just replaced the belt a few minutes ago and it still does this. I noticed that when the car is off and in park, when I shake the car forward and backward I hear a slight squeal coming from the front. I think it might be the engine mounts and or the transmission mount. What could it be?
View 12 Replies