Ford 7.3L Power Stroke (1999-2003) :: High Pressure Power Steering Line Blown?
I just replaced my 3rd HP power steering line last night( 3rd in 300K, always blows the same point....fitting comes apart where it attaches to the pump.
I'll start, mine have gone about 100K plus or minus 10K, almost thinking about making it a 100K maintenance item.
Accent LC (2000-05) :: 2003 - All Metal High Pressure Power Steering Line Has A Leak
I have an 03 Accent. The all metal high pressure power steering line had a leak. So I bought a new one for around 70 dollars from Hyundai. This part has a curved shape and fits around the radiator. The old one was difficult to get off, but the new one is proving impossible to get on. I cant get it into place.
View 2 RepliesFord Ranger / B-Series :: Power Steering Leak / Sensor On High Pressure Line?
I think I've tracked my power steering leak to some type of sensor on the pressure line, close to where it connects to the steering box:
I assume this is a pressure sensor? I got no CEL or anything like that when the fluid had leaked down to the level that the pump started whining pretty badly though. As far as I can tell by looking at pictures, the parts store replacement pressure lines do not have this sensor, or any provision to connect a sensor to it: Advance Auto Parts: Power Steering Pressure Hose by Powercraft - Part 71878
I may just put a replacement line on there and leave the sensor plug hanging and see what happens...
Accord :: 2005 V6 - High Pressure Power Steering Hose Removal / Replacement
How to remove the "high pressure" power steering hose. I have drained the fluid, disconnected from the pump, and also from the rack. Removed the center clamp, and got it all "loose". However, I cannot seem to figure out how to "fish" the hose out. There is a long piece of metal tubing that connects into the rack, and it seems to be resting above some cross member that is not removable. Went to the library, and searched the AllData Online manuals. On the "How to replace the High Pressure Hose" page, it only showed a diagram of the power steering system, with no written description on how to remove the hose. I am not on a lift, but jacked up and supported and on my back under the car with the right wheel removed. I am stumped, and the new hose is due to arrive soon.
View 2 RepliesHonda - Accord :: 1993 - Replacing High Pressure Steering Line?
So, I just found out that the noise my car has been making is related to the power steering. The mechanic said I need to replace the pump, two belts and the high pressure line. The car is a 1993 Honda Accord LX. I can't afford to have the mechanic fix it, so I'm going to have to do it myself. My questions are:1) how long should it take me? I'm not experienced at all. I was thinking of just doing the high pressure line as a 'warm up' to start. Is half a day wishful thinking? Any tips?
2) The mechanic said the hose is leaking all over the belts. He said it was "squirting and pouring out". I tried to duplicate the squirting by turning the wheel all the way and revving the engine. What I saw was a very small leak at the joint. So small it wasn't falling, but I'm sure it would if I waited long enough. The belts appeared dry to me, but I'm not really sure what they are supposed to look like. The mechanic said that they are getting soaked in fluid and that I might throw a belt. Anyway, so my question is how can I tell if the belts are "soaked in" steering fluid.
3) I've been told that if the belts are getting steering fluid on them they might be responsible for the loud squealing noise when turning. If I clean the belts with degreaser, and the noise stops, does this mean that replacing the leaking hose would be sufficient?
I'm making a long road trip in about a week (ca to wa). I'd prefer to deal with the replacement when I get to wa, but I also don't want to make things worse.
Santa FE SM (2001-06) :: Fluid Spraying From Some High Pressure Line Under Car By Steering Rack
I own a 03' 2.7 Santa Fe (2wd) and when I got home last night i noticed that she was smoking like crazy (not overheating). Opened the hood looked under the car and noticed some fluid spraying on the the exhaust and leaking down from there which was causing the smoke. I put her on jack stands and noticed what looks like to be some hard (i think pressurized) lines that are attached to a connector of some sort in front of the steering rack. What lines are these? Power steering? oil cooler? Transmission related? The fluid that is leaking looks like transmission fluid cause its reddish brown. Ive worked on a few other cars before but not too familiar with Hyundai. When i get home later I will take a pic of this area and post a picture. And it looks like its spraying from the connecting lines (maybe a crush washer gone bad? ) not sure. I can't seem to find any image of this area online either.
View 2 RepliesSanta FE SM (2001-06) :: Power Steering Return Line Replacement
I have a 2003 Santa Fe that had a corroded leaking power steering return line. I want to replace both the high pressure and the low pressure lines coming from the steering box. The high pressure removed quite easily. I cannot get the low pressure out. Everything is broken free. Is there a trick to this? I want to see how it comes out so I can put the new one in same way.
View 3 RepliesSanta FE SM (2001-06) :: Power Steering Lower Return Line Replacement
Looking for the instructions on how to remove the lower power steering belt and replace it. We recently discovered the leak and I can't find any information on it.
View 1 RepliesFord F-150 - 1997-2003 :: 2000 - Power Steering HP Line Replacement
I am replacing the high pressure power steering line on my 2000 Lightning and have a question about the fitting that goes into the steering gear. The new hose came with a black rubber o-ring that the instructions seem to indicate goes on the end of the steering gear fitting. The problem is that I did not see any o-ring on the original hose end or in the steering gear itself and the hose did not leak there (it was leaking on the pump fitting). Should there be an o-ring at the end of the fitting or does the fitting go on without it and uses a metal to metal seal? If replace this hose, did you use the o-ring or leave it out? Does it go on like this? Or like this?
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2003 - Reconnect High Pressure Oil Line To Rail?
I've found everything there is to know about disconnecting the high pressure oil STC line from the oil rail on the early 6.0's, but I can't find anything about reconnecting them. Do you simply press it back on? Should there be an audible "click"?
View 14 RepliesFord Escape / Hybrid :: Replacing Power Steering Pump Pressure Line
I need to replace my pressure line on my 02 Escape 3.0L. Looking for a DIY for doing this same job?
View 1 RepliesFord 6.0L Power Stroke Diesel :: Hydroboost High-pressure Line Coupling Leak - Replaced ORing?
I've been watching fluid build up on what I think is the hi-pressure line on the hydroboost. It appears to be originating at the coupling in the line because it is dry back at the unit.
Is there an o-ring or nylon washer in this fitting?
Can it be tightened?
Does the o-ring or washer need to be replaced?
Is it a sign of something else, like a build up of pressure in the line that is too high?
I currently have zero problems or noise coming from the steering or brake system.
Passat (B5) :: 2003 - Power Steering Line Has A Visible Leak?
I am a clueless 2003 Volkswagen Passat 1.8L Turbo owner. My power steering line has a visible leak that I can see underneath the front bumper. The leak is now more like a hole and was caused by the line dragging after the car was in the shop. I guess someone bumped it or it got knocked loose, but at this point, I need to just get the line fixed. The leak is on a U shaped part of the line, and I can take a picture of it.
I also understand that the power steering fluid is not the standard type...where do they sell the kind I need?
Ford 7.3L Power Stroke (1999-2003) :: High Pressure Power Steering Hose
My high pressure power steering hose just blew at the "B" nut at the pump. Meaning, the fitting is still in the pump but the line is out. Do I need to replace the whole line or is there a retainer I can swap out?
View 14 RepliesFord Transmission :: 2001 F150 - Location Of Replacement Pressure Hose For Power Steering
2001 F150 Supercrew 5.4L ... Dealership unable to locate replacement pressure hose for power steering . I've returned 3 wrong parts. The hose in pic goes all the way up to the reservoir.
View 13 RepliesNissan - Frontier :: 2004 - AC Went Out / Leak In High Pressure Line
My AC went last fall. I saw signs of a leak in the high pressure line. Took it to the Nissan dealer last week and they diagnosed the same problem. They changed the HP line. Told me it was good, but when they pulled it up, no AC. They took it back in and said the low pressure line was leaking as well so they changed it. Still didn't work, although it was a little cooler but the compressor seemed pretty loud. Told me they thought it might be the thermistor. I bought the sensor and replaced it myself. AC seemed to work, but sure enough, it only blows slightly cool air and the compressor is still making a bit of noise.
View 2 RepliesFord - Explorersporttrac :: Power Steering High Pressure Hose Failure Leak
Just had dealer repair shop complete power steering fluid flush in Jan 2013. Vehicle now has lost all power steering fluid (April 2013) and dealer repair shop has told me it is due to high pressure hose failure - need to replace & then verify pump condition (dealer repair shop not sure if pump bad until hose replaced to test) for repair bill.. I was told this was not related to repair shop power steering flush because this hose not removed for flush or part of that procedure (at which time a transmission flush & spark plugs replaced (minor tune-up) . Just wondering if any pro mechanic can respond with advice about the relative close time frame these two events & if there may be a probable related reason?
View 4 RepliesFord Excursion :: 2003 - Transmission High Pressure Line Leaking
I have a 2003 Ford Excursion with the high pressure line leaking. My guess is that the original line had a rubber hose and was replaced with a 3/8" ID high pressure hose. My problem is that I can not get the 3/8" ID replacement hose over the second larger bulge on the line going to the radiator cooler. What am I doing wrong?
View 3 RepliesCamry :: 2007 - Power Steering Hard To Turn After Replacing High Pressure Hose
I have an 07 Camry with a hard to turn steering wheel. I had to replace the high pressure hose from the rack due to a leak. After that I basically bled the system as one would do under normal circumstances. With the cars front wheels off the ground I turned the wheel hard left and right. The wheel did give a bit but not to the point of perfection. After many turns I put the vehicle on the ground and repeated the process. The fluid no longer leaked but the stiffness was still there.
The hose was replaced at 110,000 miles. It's currently at 112,000 miles