Ford 7.3L Power Stroke (1999-2003) :: High Pressure Power Steering Hose
My high pressure power steering hose just blew at the "B" nut at the pump. Meaning, the fitting is still in the pump but the line is out. Do I need to replace the whole line or is there a retainer I can swap out?
View 14 RepliesAccord :: 2005 V6 - High Pressure Power Steering Hose Removal / Replacement
How to remove the "high pressure" power steering hose. I have drained the fluid, disconnected from the pump, and also from the rack. Removed the center clamp, and got it all "loose". However, I cannot seem to figure out how to "fish" the hose out. There is a long piece of metal tubing that connects into the rack, and it seems to be resting above some cross member that is not removable. Went to the library, and searched the AllData Online manuals. On the "How to replace the High Pressure Hose" page, it only showed a diagram of the power steering system, with no written description on how to remove the hose. I am not on a lift, but jacked up and supported and on my back under the car with the right wheel removed. I am stumped, and the new hose is due to arrive soon.
View 2 RepliesFord - Explorersporttrac :: Power Steering High Pressure Hose Failure Leak
Just had dealer repair shop complete power steering fluid flush in Jan 2013. Vehicle now has lost all power steering fluid (April 2013) and dealer repair shop has told me it is due to high pressure hose failure - need to replace & then verify pump condition (dealer repair shop not sure if pump bad until hose replaced to test) for repair bill.. I was told this was not related to repair shop power steering flush because this hose not removed for flush or part of that procedure (at which time a transmission flush & spark plugs replaced (minor tune-up) . Just wondering if any pro mechanic can respond with advice about the relative close time frame these two events & if there may be a probable related reason?
View 4 RepliesCamry :: 09 - Power Steering Fluid Low Pressure Hose?
The Power Steering Reservoir has a small leak that makes the area under it looks oily and messy, so i followed a member's DIY PS flush, I used Walmart Supertech ATF Dexll/lll fluid but now I am thinking about using Mobil1 Synthetic ATF once I get the reservoir out.
The new red color shoes the leak is coming from the edge of the connection between the top and bottom plastic parts of the reservoir.
so my questions are:
1- How do i remove/pry or pop the reservoir out of its bracket?
2- Can i use JB Weld epoxy to glue/reinforce them parts together or just pick a used one from junkyard?
and last question: What size ID/OD is the PS fluid low pressure hose?
Ford F-150 (2004-2008) :: Shutter In Power Steering - High Pressure Hose Is Leaking From Rust
I have a 2004 with the 4.6l. The high pressure hose is leaking from rust. From other posts I have read, it looks like I should rent a puller and remove the pulley first, and then I'll have access to where the hose connects to the pump.
Question: The leak occurred while driving home from vacation today. Went we stopped for gas, we noticed a shutter in the steering. I added about a 1/2 quart to the reservoir - there was still some fluid but foamy. I made it home, and I when I checked again the reservoir was empty.
Should I go ahead and replace the pump while I am at it? I wondering it if could have gotten damaged from low fluid. The truck has 190k so it's not like the pump owes me anything. Will it make any of the repair easier to toss out the pump too?
Corolla :: Power Steering Pressure Hose Replaced - Slight Squeaking Noise When Turn The Wheel
I just recently had a new pressure hose (had a leak) replaced on the power steering pump but there is a slight squeaking noise when I turn the wheel. the mechanic says it'll go away after a week or so because of the new fluid that was put in? Is this correct?
View 4 RepliesHonda - Accord :: 1993 - Replacing High Pressure Steering Line?
So, I just found out that the noise my car has been making is related to the power steering. The mechanic said I need to replace the pump, two belts and the high pressure line. The car is a 1993 Honda Accord LX. I can't afford to have the mechanic fix it, so I'm going to have to do it myself. My questions are:1) how long should it take me? I'm not experienced at all. I was thinking of just doing the high pressure line as a 'warm up' to start. Is half a day wishful thinking? Any tips?
2) The mechanic said the hose is leaking all over the belts. He said it was "squirting and pouring out". I tried to duplicate the squirting by turning the wheel all the way and revving the engine. What I saw was a very small leak at the joint. So small it wasn't falling, but I'm sure it would if I waited long enough. The belts appeared dry to me, but I'm not really sure what they are supposed to look like. The mechanic said that they are getting soaked in fluid and that I might throw a belt. Anyway, so my question is how can I tell if the belts are "soaked in" steering fluid.
3) I've been told that if the belts are getting steering fluid on them they might be responsible for the loud squealing noise when turning. If I clean the belts with degreaser, and the noise stops, does this mean that replacing the leaking hose would be sufficient?
I'm making a long road trip in about a week (ca to wa). I'd prefer to deal with the replacement when I get to wa, but I also don't want to make things worse.
Camry :: 2009 SE Power Steering - Sometimes Hard To Turn Back
I started noticing my wifes 2009 SE was hard to turn sometime back. I finally checked under the hood and saw this. I'm not sure which hose is which but could the clamps be causing the leak? I've got ATF Dexrom III and a turkey baster with plans to try and flush it (the long way) this weekend.
View 5 RepliesGrand Prix :: 99 GTP / Power Steering Pressure Hose?
Just replaced power steering pressure hose while engine out as PM. New hose wasn't correct shape so I bent the tubing to fit. I later realized that I bought a hose for power steering without variable assist and the hose for variable assist looks correct.
Is there any harm in leaving the "w/o variable assist" hose in now?
Lexus LS 2007+ :: 2009 460 SWB AWD - Power Steering Hard To Turn For A Second Or So?
In the last two days I've noticed that my steering wheel would suddenly have intermittent episodes of being hard to turn for a second or so. It has gotten progressively worse over the last 24 hours or so where when trying to make a right turn the steering wheel feels noticeably "heavy" during the turn. And in some cases after I make a turn onto a side street I let go of the steering wheel for it to straighten itself out so I can continue straight down the street I just turned on but the steering wheel doesn't straighten itself out quickly enough like it used to and I have to physically turn it back myself otherwise I'd start making a u-turn motion and careen into a parked car. Weird.
I can only conclude that there's something wrong with my power steering rack.
FYI, I have a 2009 460 SWB AWD with about 78k miles on it.
Honda - Accord :: Low Pressure Hose For Power Steering Leaking
I have a 1989 Honda Accord DX with less than 120k miles. I have two problems.
1) the low pressure hose for the power steering has worn out and is leaking by the fittings (badly) and I can't find the parts to fix it. The high pressure hose was also leaking but we found and replaced that part, and
2) I accidentally topped off the power steering reservoir with brake fluid (this was after I already knew the leaks existed).
Jeep - Grandcherokee :: Power Steering Pressure Hose Blown
So, I have a 1995 Jeep Grand Cherokee (Orvis edition) with about 270,000 miles. It still runs great and has been really useful in the snow this winter. A couple days ago the power steering pressure hose blew. My mechanic wants to replace it, but I can get a replacement hose locally. Is there any reason I shouldn't just do this myself. Do I need to worry about the fluid sprayed around the engine? The serpentine belt is only a few months old and squeaked only a little on the three mile drive to get it home.
View 8 RepliesCamry 2012+ :: Power Steering Got Stiffer Suddenly - Hard To Turn The Wheel
My car's about 1.5 years old and 10k miles. About a week ago I started noticing that the power steering got a fair amount heavier/stiffer: it's suddenly a bit harder to turn the wheel. It came out of nowhere and I can't identify a cause, and the local dealership couldn't find anything wrong with the car. (2012 SE I4)
Since it's electric power steering I'm not sure what could have gone wrong here... and while it doesn't make the car un-driveable, it is rather annoying. The tire pressure is still around 37 PSI (according to the sensors) and they're Michelin.
Golf IV / Jetta IV :: Small Leak Coming From The Lower End Of Power Steering Pressure Hose
I have a really small leak coming from the lower end of my power steering hose, it's super small, I was wondering if I could fix this by wiping it down really well and dry, and then layering it with plasti-dip. I think the leak is small/slow enough for me to get in a few good layers. Would this be an okay fix, or would the plasti-dip separate fast?
View 2 RepliesFord Transmission :: 2001 F150 - Location Of Replacement Pressure Hose For Power Steering
2001 F150 Supercrew 5.4L ... Dealership unable to locate replacement pressure hose for power steering . I've returned 3 wrong parts. The hose in pic goes all the way up to the reservoir.
View 13 RepliesFord Escape / Hybrid :: Replacing Power Steering Pump Pressure Line
I need to replace my pressure line on my 02 Escape 3.0L. Looking for a DIY for doing this same job?
View 1 RepliesCamry :: Leakage Developed In Power Steering Hose
OK, I have developed a leak in the power steering hose that connects to the fluid reservoir (the smaller diameter hose). The dealer only sells this as an assembly (all the way to the pump, and very expensive). The hose is molded. Need to replace just this first hose section? AutoZone and several others I checked don't seem to have this (at least on line).
View 11 RepliesCamry :: Leakage In Rubber Hose Attached To Power Steering Reservoir?
So the big rubber hose attached to my power steering reservoir is leaking and my mechanic told me to replace it. I went to a couple of different Autozone stores and they both couldn't identify the correct dimensions of it. They told me to take it out and then bring it to them. This is very hard for me since this is my only car and how to pull the bottom bit of the hose out from whatever it's attached to.
I've measured the length to be about 2.4 feet but I'm not sure on how thick it is. I've taken a pic of the hose here:
Camry :: 2006 4 Cylinder / Identifying Power Steering Hose Part Number?
I have a 2006 Camry 4 cylinder. The bigger rubber hose coming out from the power steering fluid reservoir has been leaking for quite some time now. I've tried putting a second clamp on it which has worked but hasn't stopped the leak completely. As far as I understand, the big hose has a certain bend to it so I can't just get any rubber hose from an auto parts store and chug it in.
It is leaking all over the nearby surface:
I need to identify the part number for that power steering rubber hose so that I can replace it once and for all. Once the power steering fluid leaks out, my steering starts groaning whenever I turn it.