Accord :: 2005 V6 - High Pressure Power Steering Hose Removal / Replacement
How to remove the "high pressure" power steering hose. I have drained the fluid, disconnected from the pump, and also from the rack. Removed the center clamp, and got it all "loose". However, I cannot seem to figure out how to "fish" the hose out. There is a long piece of metal tubing that connects into the rack, and it seems to be resting above some cross member that is not removable. Went to the library, and searched the AllData Online manuals. On the "How to replace the High Pressure Hose" page, it only showed a diagram of the power steering system, with no written description on how to remove the hose. I am not on a lift, but jacked up and supported and on my back under the car with the right wheel removed. I am stumped, and the new hose is due to arrive soon.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: High Pressure Power Steering Hose
My high pressure power steering hose just blew at the "B" nut at the pump. Meaning, the fitting is still in the pump but the line is out. Do I need to replace the whole line or is there a retainer I can swap out?
View 14 RepliesFord - Explorersporttrac :: Power Steering High Pressure Hose Failure Leak
Just had dealer repair shop complete power steering fluid flush in Jan 2013. Vehicle now has lost all power steering fluid (April 2013) and dealer repair shop has told me it is due to high pressure hose failure - need to replace & then verify pump condition (dealer repair shop not sure if pump bad until hose replaced to test) for repair bill.. I was told this was not related to repair shop power steering flush because this hose not removed for flush or part of that procedure (at which time a transmission flush & spark plugs replaced (minor tune-up) . Just wondering if any pro mechanic can respond with advice about the relative close time frame these two events & if there may be a probable related reason?
View 4 RepliesFord F-150 (2004-2008) :: Shutter In Power Steering - High Pressure Hose Is Leaking From Rust
I have a 2004 with the 4.6l. The high pressure hose is leaking from rust. From other posts I have read, it looks like I should rent a puller and remove the pulley first, and then I'll have access to where the hose connects to the pump.
Question: The leak occurred while driving home from vacation today. Went we stopped for gas, we noticed a shutter in the steering. I added about a 1/2 quart to the reservoir - there was still some fluid but foamy. I made it home, and I when I checked again the reservoir was empty.
Should I go ahead and replace the pump while I am at it? I wondering it if could have gotten damaged from low fluid. The truck has 190k so it's not like the pump owes me anything. Will it make any of the repair easier to toss out the pump too?
Grand Prix :: 99 GTP / Power Steering Pressure Hose?
Just replaced power steering pressure hose while engine out as PM. New hose wasn't correct shape so I bent the tubing to fit. I later realized that I bought a hose for power steering without variable assist and the hose for variable assist looks correct.
Is there any harm in leaving the "w/o variable assist" hose in now?
Camry :: 09 - Power Steering Fluid Low Pressure Hose?
The Power Steering Reservoir has a small leak that makes the area under it looks oily and messy, so i followed a member's DIY PS flush, I used Walmart Supertech ATF Dexll/lll fluid but now I am thinking about using Mobil1 Synthetic ATF once I get the reservoir out.
The new red color shoes the leak is coming from the edge of the connection between the top and bottom plastic parts of the reservoir.
so my questions are:
1- How do i remove/pry or pop the reservoir out of its bracket?
2- Can i use JB Weld epoxy to glue/reinforce them parts together or just pick a used one from junkyard?
and last question: What size ID/OD is the PS fluid low pressure hose?
Honda - Accord :: Low Pressure Hose For Power Steering Leaking
I have a 1989 Honda Accord DX with less than 120k miles. I have two problems.
1) the low pressure hose for the power steering has worn out and is leaking by the fittings (badly) and I can't find the parts to fix it. The high pressure hose was also leaking but we found and replaced that part, and
2) I accidentally topped off the power steering reservoir with brake fluid (this was after I already knew the leaks existed).
Jeep - Grandcherokee :: Power Steering Pressure Hose Blown
So, I have a 1995 Jeep Grand Cherokee (Orvis edition) with about 270,000 miles. It still runs great and has been really useful in the snow this winter. A couple days ago the power steering pressure hose blew. My mechanic wants to replace it, but I can get a replacement hose locally. Is there any reason I shouldn't just do this myself. Do I need to worry about the fluid sprayed around the engine? The serpentine belt is only a few months old and squeaked only a little on the three mile drive to get it home.
View 8 RepliesCamry :: 2007 - Power Steering Hard To Turn After Replacing High Pressure Hose
I have an 07 Camry with a hard to turn steering wheel. I had to replace the high pressure hose from the rack due to a leak. After that I basically bled the system as one would do under normal circumstances. With the cars front wheels off the ground I turned the wheel hard left and right. The wheel did give a bit but not to the point of perfection. After many turns I put the vehicle on the ground and repeated the process. The fluid no longer leaked but the stiffness was still there.
The hose was replaced at 110,000 miles. It's currently at 112,000 miles
Golf IV / Jetta IV :: Small Leak Coming From The Lower End Of Power Steering Pressure Hose
I have a really small leak coming from the lower end of my power steering hose, it's super small, I was wondering if I could fix this by wiping it down really well and dry, and then layering it with plasti-dip. I think the leak is small/slow enough for me to get in a few good layers. Would this be an okay fix, or would the plasti-dip separate fast?
View 2 RepliesCorolla :: Power Steering Pressure Hose Replaced - Slight Squeaking Noise When Turn The Wheel
I just recently had a new pressure hose (had a leak) replaced on the power steering pump but there is a slight squeaking noise when I turn the wheel. the mechanic says it'll go away after a week or so because of the new fluid that was put in? Is this correct?
View 4 RepliesFord - Windstar :: Shaking And Engine Light After Replacement Of Pressure Hose?
we just replaced a pressure hose that broke and now the engine light blinks 30 times and then goes off and then blinks again plus the engine seems to be shaking allot.
View 1 RepliesPassat (B5) :: Power Steering High Pressure Line Replacement?
How do you get the line back on to the rack? There is absolutely no room and I have experimented with a variety of tools with no luck. What's the trick?
View 1 RepliesFord Transmission :: 1991 F150 - Clutch Won't Disengage After Replacement
I have a 1991 Ford F150 I bought. Told the transmission was shot, long story short, found out it was just a bad clutch. Pulled the transmission, replaced the clutch, pressure plate, and throw out bearing. Put everything back together, now i cant get the clutch to fully disengage. Had good pressure prior to replacement of the clutch, still has some pressure. just doesn't have enough to disengage the clutch. pulled the inspection cover, and verified the slave is moving. What is causing this issue?
View 14 RepliesFord Transmission :: 1995 F150 - Rear Axle Seal Replacement
How do you replace the rear axle seal in a 1995 F150?
View 14 RepliesFord Transmission :: 1995 F150 - Clutch Pedal Losing Pressure?
I have a 1995 F150 with the 4.9L and it has 73000 miles on it. One morning recently (it was about 35 degrees outside) I went to start my truck to let it warm up. When I let off of the clutch it stayed on the floor. I shut it off and drove my car to work instead. I asked around at work and one guy mentioned that it was probably my clutch master cylinder...so that day we replaced it, and bled it until it felt like knew. Since then, we have had to bleed it three more times, because the pedal keeps losing its pressure making it harder to shift. I have inspected around the clutch line and the bellhousing for signs of needing to replace my slave cylinder, but everything looks fine.
View 8 RepliesFord 6.0L Power Stroke Diesel :: EGR Cooler Hose Replacement
My orange one leaks, bought a blue one. How the heck to I install it? I have decent tools.
I reviewed the threads on coolant flush and fill, and bought a coolant filter kit, I will be doing that at the same time.
Santa FE SM (2001-06) :: No Pressure In Radiator Hose
I've noticed that my radiator hose doesn't have any pressure anymore, even after a long drive you can squeeze it nearly together, it is still hot like normal and the heater puts out hot air, the temperature gauge sits between half way between 1/4 and 1/2, would this be the radiator it's self, the thermostat or the water pump that may need replacing, there is no leaks that I can find or see...
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: Lower Radiator Hose Replacement
I'm going to be replacing my lower radiator hose so figured might as well switch over to the extended life stuff going to probably go with the Delo ELC.. Supposedly it's good for 750k.
View 14 Replies