Ford Super Duty (1999-2016) :: Installation Of Airbags?
I waned to know if I get a set of airbags for my f350 dully would it de hard to install
View 6 RepliesFord Super Duty (1999-2016) :: Airbags Deployed On 2011 F350
I bought a 2011 F350 that was in a collision. I have done collision repair before but I have not had to deal with air bags... Both driver wheel and passenger bags deployed. I see some for sale on EBAY for around 300 used....do I just by them and install them? Is there a reset or something else I have to do? I see some sell them with the controller as well...do I need that?
View 14 RepliesFord Super Duty (1999-2016) :: 2012 F250 - Replacing Shocks And Airbags?
I have a 2012 F250 King Ranch with the FX4 package. I have a goose neck ball and have recently bought a 37' fifth wheel. The rear of my truck sits a touch lower than the front and anytime I'm hooked to a trailer it looks to be squatted way down. It actually is dropping maybe 3". I am looking to replace the shocks which are Rancho's as I have 55k miles on. I'm wondering about shock types, air bags, springs??? Just don't know what my best option is.
View 9 RepliesFord Super Duty (1999-2016) :: 1991 F250 - Heavy Camper Back Spring Flattened Out - Put Airbags?
I have a 1991 f250 that used to have a camper on it, I recently got this truck and when I put an older heavy camper on it the back springs flattened out and the front raised about an inch or two.
My question is...I am going to put air bags on this truck to alleviate this problem, should I replace the springs as well or will the air bags be sufficient to handle a camper?
Ford Super Duty (1999-2016) :: LED Strobe Light Mount To The Roof
I need to mount a LED strobelight to the roof of a F250 2016. not really liking to drill a hole in the roof of a new truck I thought of running it thru the existing wiring from the brake light above the rear window. Looking for info if there's a hot wire in there that I could get power from & than could just run 1 wire to a switch. How to run the wiring ????
View 4 RepliesFord Super Duty (1999-2016) :: How To Mount Flag Pole To Bed Of Truck
I was trying to figure out how to mount a flag pole to the bed of my truck. I used to use a 5gal bucket with a pvc pipe in it and poured concrete in the bucket and put it in my bed. I have seen others use their stake pockets but don't know how they kept it from falling out.
View 12 RepliesFord Super Duty (1999-2016) :: Mounting Side Mount Tool Box Without Drilling?
Mounting a side mount tool box without drilling into the bed floor for the support legs? There are "J" hooks for the rails but there are legs that are supposed to be drilled into the floor.
View 2 RepliesFord Super Duty (1999-2016) :: 2008 - Front Body Mount Removal?
i have a 2008 f250 4x4 i need to replace the drive side front lower body bushing and i can not get the pressed on bushing to come out what is the easiest way to get this to come apart i tried using a 4 ft pry bar and i could not get it to pop free.
View 11 RepliesFord Super Duty (1999-2016) :: Plow Mount Brush Guard Install
So I've had this WAAG brush guard laying around for a few years and figured it was time to do something with it. Of course it was bought with no mounting brackets. I had found a lower gear from a Fisher MM1 plow. Tossed the in the truck and started from there.
Broke out the cherry picker and started lining stuff up. Drilled some holes and bolted it up. It's all bolted up but I still need to take a piece of 2x3 angle and weld it to the lower plow mounts to tie the bottoms together and create a step.
Ford Super Duty (1999-2016) :: 2014 - Front Body Mount Bushing Replacement
The driver side front body mount bushing on my 2014 is gone which has the grill sitting on the bumper. I started to replace it, but the bolt is sized to the nut. ran off about 1/2 inch and that is it, it will not tighten or loosen anymore.
I cut the head off the bolt, but can not get the body high enough to remove the old bushing so i can cut the nut off flush with the rad support. Now I am trying to get the air filter box out so i can cut the top of the "nut cage" off to remove the bolt and nut out the top. but i can not figure out how it is held in.
I have the intake disconnected and the filter hat off, overflow tank hose disconnected, and two bolts holding the whole thing to the fender out, but it will still not budge. What am I missing here?
Ford Super Duty (1999-2016) :: 2015 F350 - Flush Mount LED Driving Lights
I have a 2015 F350 and with the long dark hours of driving, I want to put some auxillary lights on the front of my truck. I have a ranch style bumper on the front and I am thinking about installing a pair of flush mount LED driving lights. I was wondering, how well they work? I am personally thinking about the rigid flushmount hybrid driving/flood lights with the focused beam.
View 6 RepliesFord Super Duty (1999-2016) :: Body Mount Bushings Shredded On Driver Side?
Need recommendation for replacement body mount bushing. Surprised to see the drivers side shredded. Poly replacement?
View 14 RepliesFord Super Duty (1999-2016) :: Install And Mount A Light Bar Without Drilling Into The Front Bumper Or Grill?
Any good way to install and mount a light bar without drilling into the front bumper or grill? I have a 32" LED bar I want to mount between the top of the bumper and bottom of the grill, but the mounts aren't ideal for where I want to put the light.
View 9 RepliesFord Super Duty (1999-2016) :: 2002 - Super Coil Went Out While Driving?
One of the super coils busted while driving my 2002 F250 Super Duty. I drove it for less than 100 ft. before parking it. It made a rapid "check,check,check,check" sound, which I'm assuming was mainly the coil smacking against other parts while loose. It busted near the point where it screws into the motor. I felt like I lost some compression as it drove sluggishly once broken, although I only drove for a very short time. I also thought I may have smelt a slight burning scent, or maybe oil, but didn't smell anything once I got out of my truck. Any problems I should look forward to other than simply replacing this coil?
View 14 RepliesFord Super Duty (1999-2016) :: Super Loud Clunk Noise Come From The Door When Car Turned On
So the other day i opened the door and heard a super loud clunk noise come from the door and when I turned the car on and pulled hte window down it wouldn't go down all the way, only about 75% of the way so I assumed like BMW cars the window motor died but oddly it continued to go up and down just now 100% down.
Then 3 days later when I came to drive the car again the window went down to the 75% mark and now its jammed there with no movement even if I tried to lift the window up myself. Usually a broken motor allows this to happen but since it isn't budging I am wondering if its an electrical issue with the power window button more than the motor?
I say this because when i try to lower the passenger window from the driver side it works than out of no where on the 3rd time it wont move at all than 5 minutes later it will move or if it doesn't move I just go and pull the window down from the passenger side then I come to the driver side and try it and it works again than it'll stop again. So maybe its the power window control buttons on the drivers side that's failing?
Ford Super Duty (1999-2016) :: 2016 - Passenger Seat Rattles / Vibrates Quite Loudly?
I have a 2016 F250 6.2 XLT CC 4X4 that is mostly stock, except I did put on 18x9 wheels and LT275/70/18 Cooper ST MAXX tires. I have noticed recently on hwy driving and even in town driving, that the passenger seat rattles/vibrates quite loudly. Obviously if there is someone setting in the seat, it is just fine.
Is this a common issue? Is there a quick fix (tightening a couple bolts or replacing a couple clips?) Or should I take this back to the dealer for warranty?
Ford Super Duty (1999-2016) :: Heavy Duty Rubber Floor Mats With Transfer Case
New floor mats. My truck is going to be 10yr old and has the original King Ranch floor mats. I want some heavy duty rubber ones that will fit around my manual transfer case lever. I ordered the Weathertech digital fit liners and I am not happy with them so they are headed back tomorrow. They have a heavy duty all weather mat but not sure how it will work with my shift lever on the floor. Husky liners/mats look nice and heavy duty but won't accommodate the floor lever.
View 6 RepliesFord Super Duty (1999-2016) :: Difference Between F250 Custom And Heavy Duty Steering Stabilizer?
Is there a steering stabilizer for a 92 Ford F-250 custom 2wd? and what's the difference between a f250 custom and a f250 heavy duty?
View 2 RepliesFord Super Duty (1999-2016) :: Dash Swap 1999 To 2008 Model?
I'm thinking of doing a dash swap on my 99 super duty to the 2008 super duty dash, steering wheel, etc. I know the od in my truck is mechanical and in the new one its electronical is it possible to swap without having to redue the whole electrical system and computer? Is the steering wheel going to line up and the ducting? How should i approach the wiring?
View 14 Replies