Ford Super Duty (1999-2016) :: Firestone Airbags Kit 2535 Mount?
I have a sensor module mounted on the frame right where I need to put the upper bracket for the air bag on the passenger side rear . called e-trailer and they had no clue . special kit for 2011-2013 4x4 diesel 2535. What to do????
View 7 RepliesFord Super Duty (1999-2016) :: Airbags Deployed On 2011 F350
I bought a 2011 F350 that was in a collision. I have done collision repair before but I have not had to deal with air bags... Both driver wheel and passenger bags deployed. I see some for sale on EBAY for around 300 used....do I just by them and install them? Is there a reset or something else I have to do? I see some sell them with the controller as well...do I need that?
View 14 RepliesFord Super Duty (1999-2016) :: 2012 F250 - Replacing Shocks And Airbags?
I have a 2012 F250 King Ranch with the FX4 package. I have a goose neck ball and have recently bought a 37' fifth wheel. The rear of my truck sits a touch lower than the front and anytime I'm hooked to a trailer it looks to be squatted way down. It actually is dropping maybe 3". I am looking to replace the shocks which are Rancho's as I have 55k miles on. I'm wondering about shock types, air bags, springs??? Just don't know what my best option is.
View 9 RepliesFord Super Duty (1999-2016) :: 1991 F250 - Heavy Camper Back Spring Flattened Out - Put Airbags?
I have a 1991 f250 that used to have a camper on it, I recently got this truck and when I put an older heavy camper on it the back springs flattened out and the front raised about an inch or two.
My question is...I am going to put air bags on this truck to alleviate this problem, should I replace the springs as well or will the air bags be sufficient to handle a camper?
Ford Super Duty (1999-2016) :: Block Heater Installation?
When I bought my truck it didn't have the block heater installed, asked the dealership to put it on with the deal, but they didn't have one there. How hard it is to install one? Also what brand should I go with? (On my '16)
View 5 RepliesFord Super Duty (1999-2016) :: Brake Control Installation?
I need to install a brake controller on my truck for an upcoming move from Ca to Tulsa. I have located the light blue wire for the trailer brakes behind the rear bumper but have not been able to locate the same wire under the dash.
View 4 RepliesFord Super Duty (1999-2016) :: 2001 - Exhaust System Installation?
I'm looking to install an aftermarket exhaust system (cat-back system) on my '01 F-250/6.8L/V10. I'm looking for recommendations....Ideally, I'd love to find a system where I don't have to remove the spare tire, and still have a dual exhaust where the tailpipes exit on the side (aft of the rear tires).
View 3 RepliesFord Super Duty (1999-2016) :: 2001 - Installation Of Warn Hubs?
I have a 01 f250 v10 4x4 ... My stock hubs squeak non stop when they are engaged. I want to get a set of warns.
I am going down to napa tomorrow, looking for a detailed link, or instructions of how to install these things? i have searched but just keep coming up with people raving about how great warn hubs are!
Do I need any special tools, do I need to grease the new ones before installing?
Ford Super Duty (1999-2016) :: 2005 - Back Up Camera Installation?
I've been wanting to install a back up camera on my truck for quite some time now. A month ago I backed into a steel pole in a parking garage and trashed my bumper, making me realize I need a backup camera I ordered a cheap ebay camera and 30 feet of extra power and video cable for the install.
Down the road I'll order something better but for now I'm working with a cheapo 15 dollar camera I know where I'm mounting the camera and where/how I'm running the cables, I'm just not sure how to get my head unit to switch automatically when I engage the truck in reverse. I have a pioneer double din touch screen radio as seen here on crutch field.
[URL]...
Ford Super Duty (1999-2016) :: 2001 - Installation Of Heated Towing Mirrors?
How hard is it to install heated towing mirrors on an 01 f-250 7.3L?
View 3 RepliesFord Super Duty (1999-2016) :: 2002 - Gauge Cluster Installation Without Reprogramming?
can i install a gauge cluster from a junk yard truck without reprogramming it? im not concerned with the odometer reading just need gauges. truck is a 2002 f250 sd 2wd auto gas.
View 5 RepliesFord Super Duty (1999-2016) :: 2015 F250 XL - Back Up Camera Installation
First tech post for my new truck. I just bought a hold-over but new 2015 F250 XL Supercab 2wd and love the simplicity of no unwanted options. That said, there are two features I am adding. The first is perfectly straightforward, cruise control (swap button cluster and have the function turned on by the dealer). The second is a tiny bit more involved, back-up camera, in mirror display with bluetooth hands-free (I like the simple AM/FM radio because I can work it all with gloves on).
So I basically need three things from the truck and my research has been inconclusive on a couple of things because most of the threads are for 2014 or earlier. I think I can pull switched 12V and ground (pin 1 and 4) plus reverse lights (center, or pin 7) all from the the trailer wiring harness. It appears these are not affected by the canbus load restrictions of other places to tap reverse signal (remember, XL so likely nothing in the overhead console for the auto-dimming rear view mirror). Are there any challenges with this when I do hook up my enclosed trailer or when it is not hooked up regarding the trailer brake controller/anti-sway?
I already found a good youtube video for how to route the wires so I think this is my primary challenge at this point.
Ford Super Duty (1999-2016) :: 2015 F250 - Installation Of Upfitter Switches
I just got a 15 f250 with the console and nav system but it didn't come with the upfitter switches.
I picked these up and got a copy of the .pdf for the installation, but I'm finding it hard to follow for where the relay and box should install. I ran the wire up to the upfitter switch location and can even find a nice spot to connect the grounding wire.
I can't for the life of me figure out where the box installs and where the wiring harness taps into the main harness. Need a photo of where your box is installed and where it taps into the main harness?
Ford Super Duty (1999-2016) :: Installation Of New Outer Dust Seal - Use 3 Jaw Pulled?
Earlier this week I pulled out my right axle shaft and found the outer portion of the Spicer two piece seal attached to the axle, the part number on the seal is 52148. The axle tube is dry, no signs of the seal leaking. I need to remove that seal from the shaft to install a new outer dust seal. Can that seal be removed with a 3 jaw pulled then get reinstalled, or can I get a new 53148 and install that portion with out removing the carrier. I am not set up where I sit right now to pull both axles.
View 2 RepliesFord Super Duty (1999-2016) :: 2007 F250 - Drive Shaft Installation
My elderly neighbor has asked me to re-attach his drive shaft on his F250.
Said his wife was driving and it broke the u joint or something, and he has gotten it repaired and wondered if I could put it back on. Has been sitting for a bit from what he said.
Just need to know, how I should clean up and or grease? the end with the boot on it. before I put it together. The boot looks to be zap strapped, is that standard?
Ford Super Duty (1999-2016) :: After Installation Of Remote Access - Got Code 00011000?
I've had the Ford Remote Access installed on my pickup for over a year now and it's worked great up until about a week ago when I changed cell phone providers from AT&T to Verizon. Now when trying to use the app I get the error code 00011000. I up-dated the app to reflect the new carrier but it still doesn't work. And yes, my subscription to the service is current. What I need to do to get this working again, with winter just around the corner I'd sure like to have this functional again. I figured I'd give the forum a shot before I resort going to the dealer.
View 5 RepliesFord Super Duty (1999-2016) :: 2012 F350 - Tailgate Step Installation?
We just purchased a new 2012 F 350. Love it, however when shoping forgot about getting one with a step. Have found step and handle available (OEM) but need to know how hard/easy to install it on our current tailgate. I gather from another post the handle part is easy but what about the step itself?
View 2 RepliesFord Super Duty (1999-2016) :: 2011 - Upfitter Switches And Fog Lights Installation
How hard is it to install the upfitter switches and the fog lights? Is it all plug and play?
View 4 RepliesFord Super Duty (1999-2016) :: F350 - CC Pop N Lock Installation - Wiring Harness?
Installing a Pop N Lock on a 2016? What were the wire colors you tapped into?
View 3 Replies