Ford Super Duty (1999-2016) :: Add Antenna Via Roof - Now 3rd Brake Light Not Working?
Today I started to install my satellite radio in the 250. I ran the antenna through the roof where the 3rd brake light is. The lights were not working so I thought I'd just replace them while it was off the truck. To my surprise the bulbs the guy had installed must have been too big because the wires, sockets and the housing were melted and not really usable. With that said. I can't seem to find a web site that would have an aftermarket setup that would fit the roof of a F250.
View 8 RepliesFord Super Duty (1999-2016) :: Install And Mount A Light Bar Without Drilling Into The Front Bumper Or Grill?
Any good way to install and mount a light bar without drilling into the front bumper or grill? I have a 32" LED bar I want to mount between the top of the bumper and bottom of the grill, but the mounts aren't ideal for where I want to put the light.
View 9 RepliesFord Super Duty (1999-2016) :: How To Mount Flag Pole To Bed Of Truck
I was trying to figure out how to mount a flag pole to the bed of my truck. I used to use a 5gal bucket with a pvc pipe in it and poured concrete in the bucket and put it in my bed. I have seen others use their stake pockets but don't know how they kept it from falling out.
View 12 RepliesFord Super Duty (1999-2016) :: Firestone Airbags Kit 2535 Mount?
I have a sensor module mounted on the frame right where I need to put the upper bracket for the air bag on the passenger side rear . called e-trailer and they had no clue . special kit for 2011-2013 4x4 diesel 2535. What to do????
View 7 RepliesFord Super Duty (1999-2016) :: Roof Channel Sealant Cracking?
I was checking out a rust spot in the roof and upon closer inspection also saw that the sealant in the channels is cracked on the edges. Can't tell if there is rust in there too or just dirt.
View 14 RepliesFord Super Duty (1999-2016) :: Mounting Side Mount Tool Box Without Drilling?
Mounting a side mount tool box without drilling into the bed floor for the support legs? There are "J" hooks for the rails but there are legs that are supposed to be drilled into the floor.
View 2 RepliesFord Super Duty (1999-2016) :: 2008 - Front Body Mount Removal?
i have a 2008 f250 4x4 i need to replace the drive side front lower body bushing and i can not get the pressed on bushing to come out what is the easiest way to get this to come apart i tried using a 4 ft pry bar and i could not get it to pop free.
View 11 RepliesFord Super Duty (1999-2016) :: Plow Mount Brush Guard Install
So I've had this WAAG brush guard laying around for a few years and figured it was time to do something with it. Of course it was bought with no mounting brackets. I had found a lower gear from a Fisher MM1 plow. Tossed the in the truck and started from there.
Broke out the cherry picker and started lining stuff up. Drilled some holes and bolted it up. It's all bolted up but I still need to take a piece of 2x3 angle and weld it to the lower plow mounts to tie the bottoms together and create a step.
Ford Super Duty (1999-2016) :: 2014 - Front Body Mount Bushing Replacement
The driver side front body mount bushing on my 2014 is gone which has the grill sitting on the bumper. I started to replace it, but the bolt is sized to the nut. ran off about 1/2 inch and that is it, it will not tighten or loosen anymore.
I cut the head off the bolt, but can not get the body high enough to remove the old bushing so i can cut the nut off flush with the rad support. Now I am trying to get the air filter box out so i can cut the top of the "nut cage" off to remove the bolt and nut out the top. but i can not figure out how it is held in.
I have the intake disconnected and the filter hat off, overflow tank hose disconnected, and two bolts holding the whole thing to the fender out, but it will still not budge. What am I missing here?
Ford Super Duty (1999-2016) :: 2015 F350 - Flush Mount LED Driving Lights
I have a 2015 F350 and with the long dark hours of driving, I want to put some auxillary lights on the front of my truck. I have a ranch style bumper on the front and I am thinking about installing a pair of flush mount LED driving lights. I was wondering, how well they work? I am personally thinking about the rigid flushmount hybrid driving/flood lights with the focused beam.
View 6 RepliesFord Super Duty (1999-2016) :: Body Mount Bushings Shredded On Driver Side?
Need recommendation for replacement body mount bushing. Surprised to see the drivers side shredded. Poly replacement?
View 14 RepliesFord Super Duty (1999-2016) :: How To Get Inner Liner For Front Roof Console - Radio Wiring Same In Vehicle Side
1) How to get the inner liner for the front roof console (cubby and sunglass holder only no comp) out? I am planning on adding a couple of switches up there and need to clearance it in a couple of spots.
2) Is the wiring on the stock radio the same colors as the wiring harness on the vehicle side? Looking at changing out for a touchscreen (for rear cameras and bluetooth for my phone) and the one I am looking at needs to be wired in, and was looking at just cutting the plug off the radio and wiring to that instead of cutting into the harness on the truck side.
Ford Super Duty (1999-2016) :: 2000 F250 - ABS Light Is On / Blinking Overdrive Light Comes On At Around 25 MPH
The problems that I am having at the moment are that the abs light is on from the speedometer, odometer, also the blinking overdrive light that comes on at around 25 mph. After some research I had purchased a ford factory sensor for the rear dif. I then replaced the old sensor with the factory one. Started the truck and not a single thing had changed, both the meters were not working as well as the od light was still flashing.
View 4 RepliesFord Super Duty (1999-2016) :: 2002 - ABS Light On - Speedometer Bouncing - O/D Light Flashing?
this morning my 02 decided to turn the ABS light on, and start bouncing the speedometer. plus, the OD light is flashing when stopped with foot on the brakes, but the trans is shifting fine.
nothing changed on the truck except almost 3 inches of rain fell last night.
will AE tell me if the VSS is going bad?
Ford Super Duty (1999-2016) :: After WTS Light Goes Out SES Light Comes On?
This is 6.0 VT365 in an F650...truck runs just fine however the SES light stays on. I have noticed that with the truck running the SES light does not come on until the Wait to Start light goes out
I have read the codes using Snap on Scanner and have code 252 which is apparently configuration module (volts below norm or shorted)...but I am told 252 is an un document code...which is not very useful.
I have been working through the various connectors and checking the harness, but not yet finding the issue, as to the the SES light only coming on after the WTS goes out with the engine already running.
Ford Super Duty (1999-2016) :: 2001 F250 - ABS Light Is On And Overdrive Light On Shifter Is Flashing
I recentlyHad to replace the right front wheel bearing and after the install the speedometer and turn signals don't work, the ABS light is on and the overdrive light on the shifter is flashing. I've replaced the VSS on the rear diff, pulled and cleaned Speed sensors on front hub?
View 2 RepliesFord Super Duty (1999-2016) :: 2010 F250 XL - OEM Fog Light Install / Switch Didn't Light Up
I have a 2010 f250 XL v10 6 speed 4wd. I was looking into adding factory fog lights to it. I have the factory plug by the headlight. I've read that some XL trucks just need the fog lights, wiring harness for the lights and the headlight switch with the fog light option.
So today my buddy (has an 09 f250 xlt with factory fog lights) and I decided to try his headlight switch in my truck to see if it would send power to the plug by the headlight. Plugged it in, turned the fog lights on and had no power. Actually the little fog light light on the switch didn't light up that I noticed either. So we compared wiring harnesses going to the headlight switch. Both trucks have 9 wires. #21 fuse in the kick panel is intact and good.
What else my truck would need in order to use the factory fog light parts? I know I could run new wiring and use an aftermarket switch but I'd rather it be factory.
Ford Super Duty (1999-2016) :: Dome Light Not Working When Open The Door And Ajar Light Is On
My Dome lights don't work when you open the door. I can manually turn them on though. Also door ajar light is on. Are these issues caused by the door latch switch? Also have no fog lights I replaced the switch and bulbs. I have a 2003 F250.....
View 2 RepliesFord Super Duty (1999-2016) :: 3rd Brake Light And Pedal Adjustment Switch Does Not Work - ABS Light On
Was checking fuses for why my 3rd brake light and pedal adjustment switch does not work. Was also looking for a fuse to tie into so that a light in the cab floorboard will stay on when the headlights or marker lights are on... After trying several spots to no avail (finally putting it into the bright headlight fuse). I got the light to work.... But now my ABS light stays on!!! Also 3rd brake still not working...
View 1 Replies