Ford F-150 - 1997-2003 :: 1998 - Column Shifter Loose And Sloppy?
98 f150 4x4 5.4... So i purchased this truck about 3 months ago and now I am having problems putting it in Park. The column shifter is very loose and sloppy. Is there any way to rebuild this?
View 3 RepliesFord Excursion :: Shifter Linkage Is Very Stiff And Not Accurate
My daily driver is a Ford pickup. But we recently acquired a 2003 Excursion.
-5.4L V8
-3.73 rear end
-2WD
It is an Eddie Bauer, and despite its age and 150k miles, it is in really nice shape. It runs and shifts very smoothly. So far, we've replaced the rear glass hydraulics, put 4 new tires and a wheel alignment on it, replaced one brake line from the front to the rear, replaced a cracked rim and one missing wheel hub cap. The driver's seat base cushion leather is ripped, but I procured a replacement leather seat cushion cover which is brand new and a perfect match to the original two-tone leather.
Otherwise, the radio works fine, A/C front and rear is ice cold. The shifter linkage is very stiff and not accurate. I'm guessing the switch selector on the outside of the transmission is failing?
The driver's side power window does not work, and the reverse sensing system has only worked once. The switch always says "off" and if you push it, it won't stay in the "on" setting.
But anyway, here it is .....
Ford Aerostar :: 1995 - Sloppy And Loose Shifter?
My mom's 95 shifter is slowly getting worse. Right now it's at the point where we have to hunt for gears just to put it into park or reverse or d/od. It's not stiff like the rest of ours, hers is all sloppy and loose. She says it's been doing this for a while, but i think it got worse when i pulled her cluster out to change the light bulbs. I say this because i couldn't get the needle cable un done, so i just let the cluster rest on it while i was changing the bulbs, which put a little bit of tension on it.
View 14 RepliesFord Excursion :: 2002 - Sloppy Shifter Lever
I've been experiencing the ever so popular sloppy shifter lever in my 02 excursion. So naturally I started prowling around the site looking for answers to my issues. I have ensured both of the torx bolts are present and tight at the end of the shift tube on the bracket that connects to the shifter cable and have replaced the shift tube (It was worn out) and it worked great but has not completely fixed the issue so today I crawled underneath the truck to try and adjust the shift cable and have found that the detent in the shift linkage from the gear position sensor that runs to the shift mechanism (not sure what it's called) that is inside the transmission is really nonexistent, it is effortless to move it from P to R but from R to N is good and stiff like it should be but from N to D and D to 2 is effortless. I have zero experience with what creates the detent inside of the transmission and looking for a link or pictures or write up something that I can look over and attempt to educate myself on before I dive in to this blind....
View 14 RepliesFord F-150 - 1997-2003 :: Sloppy Front Wheel Bearings
In 30 years of wrenching on cars, I've never encountered this problem. Replaced the pads and left rotor. Rotor is typical Chinese rotor. While there, replaced the wheel bearings. Also knocked out the races (with a brass drift) and replaced the races with the ones that came with the new wheel bearings. The bearings are NAPA bearings. Packed the wheel bearings just like always.
Applied some grease just like always on the spindle. Put it all back together. Tightened the wheel bearing nut while rotating the rotor in the opposite direction. Went to maybe 10 ft lbs. Backed the nut off, set it firm finger tight. Installed the cotter pin. Got a whole bunch of sloppiness in the wheel bearings. I can feel a LOT of it when rotating from the 6 o clock and 12 o clock position. What did I miss? NEVER had this happen before. 2002 f 150 2wd
Ford Aerostar :: 1986 - Shifter Is Sloppy / Often Hard To Find 4th When Downshifting From 5th
I have an '86 Aerostar with the 2.3 four and 5-speed stick. The shifter is sloppy, and it's often hard to find 4th when downshifting from 5th, and sometimes, it shifts hard through all the gears. Other times, it works fine. The manual says that this shifter was used from 86 to 89 only. Did they use the same one on Rangers? Can I buy a rebuild kit? Or, is this a sign of some other problem such as the clutch slave cylinder?
View 1 RepliesGolf IV / Jetta IV :: Quick Shifter Linkage Adjustment (O2M Transmission)
So I just got 42dd shifter bushings and im having some issues!
Installation was no problem but once you complete the install you are supposed to re-adjust the linkage. First you have to lock the shifter in place, both in the cabin and in the engine bay (as shown in this Diesel Geek video: [URL] .... )
The only trouble I'm having is that i cannot locate the locking pin as shown in this integrated engineering picture: [URL] .....
Ford F-150 - 1997-2003 :: Odometer Quits Sometimes / Transmission Skids Loudly / Gear Shift Lever Sloppy
The Speed Needle works fine. But...the Odometer part quit some time ago. I can't tell what my fuel Mileage is now. How to troubleshoot this problem?
Things that might affect this problem; Transmission skids loudly when going in and out of 4-OD. It could be the Torque converter clutch?
The Gear shift lever is sloppy. Doesn't fill me with Confidence.
Brake fluid warning light is on most of the time. Fluid level is up hi though. Driver door mirror control switch don't work in one direction Who on this Forum has a Switch for me?
Ford Super Duty (1999-2016) :: V10 Won't Go Into Park - Shift Linkage?
99 v10 auto 4x4. Won't go into park completely. Have to start in neutral. was fine yesterday, now it doesn't work. if it wasn't snowing like crazy id just crawl around and find out. do our trucks have a linkage? or shift cable? I imagine I am just out of adjustment somewhere. any advice what to look for or where to start when the snow finally stops??
View 3 RepliesGolf IV / Jetta IV :: 02 - Clutch Went Out / Shifter Knob Is Super Sloppy
I have my GTi, a week ago I broke an axle. I was then convinced by friends the clutch went out. So I said screw it and bought a Southbend Stage 2 Daily. When I get it I go to install it, then find out I have a Broken half shaft. So after taking the tranny out to install the clutch anyways and everything goes alright for the most part. (250k miles so that's why I never returned new clutch)
SO I get everything together. Tires spins. Car goes all is good.
Clutch is super spongy as I need to bleed it. But my problem is the shifter knob is super sloppy. Feels like is a whole section lower. It's hard to engage second as I have to double tap it in with a good throw. Everything is right on the shift tower. And seems like it clicks right into all the gears. But the physical knob feels super sloppy and out of place. First, third and 5th are all super far up and seems like it double clicks after putting it into gear. Like if there was a gear above. Kinda weird to explain. I've done the home alignment on the tower and nob, but only have a bolt that was 4.71 mm. So the cables should be really close to being aligned right. But I can't grab second at high Rpms.
I also need to do my drain and fill. So would it be a drain and fill and clutch bleeding will fix my sloppy shifter? Before I did everything it was tight. Felt right.
Ford F-150 - 1997-2003 :: Shifter Very Loose In Gear?
Okay, so I am not really sure where to post this. I have one of the weird 1999 F-250s that aren't a SD. The shifter is pretty loose, about 4-5 inches of play while in gear. Shifting isn't a problem, just the play in the shifter that I worry about. I have been trying to find rebuild kits, but can only find stuff for Rangers/Mazdas.
View 7 RepliesFord F-150 - 1997-2003 :: 1999 - Shifter Indicator Is Off
My shifter indicator is off one on my 99. How do I get at it or what do I take off to adjust or fix it....
View 7 RepliesFord F-150 - 1997-2003 :: 2002 - Unable To Put The Shifter Into Gear
It started with not being able to pull the shifter into gear...when started and no wipers, interior light, found a blown fuse, repaced it, all ok, blew fuse again, bigger fuse. It still works, now I have no high beams and cruise. 170,00kms....
View 1 RepliesFord F-150 - 1997-2003 :: 2000 4X4 - Floor Shifter Will Not Move?
Drove to work in 6" of snow in 4H with no issues. Shifted back into 2H for drive home as roads were clear with no issues. Went to shift into 4H moments ago and floor shifter will not move!
View 1 RepliesFord F-150 - 1997-2003 :: Overdrive Light Comes On When Put Shifter In Gear
I got a 1999 f150 if you put shifter in gear the overdrive light comes on. When you put it back in park the light goes out.
View 1 RepliesFord F-150 - 1997-2003 :: P/S Whine And Motor Won't Stay Running - OD Light On Column Shifter Flashes
2000 XLT ext cab 4.6 4x4 auto .. Having a couple of problems in below freezing weather when temps are below 30 deg F.
1. I have the usual P/S whine, but when starting up a cold engine, the whine is extremely loud and the motor won't stay running. It starts and immediately dies. I have to give it a little gas to keep it running. It only takes a few seconds until the whine dies down, then it idles fine. Should I just replace the P/S pump or is there something else I need to look at?
2. Again, with a cold engine, when I start driving, the OD light on the column shifter flashes. It flashed for quite a while. The tranny worked fine, though. No problems shifting. I was told that I have to have the dealer read the code and it can only be done when its flashing. Is this true? I'd rather not spend the $$ if its something I can take care of myself. I did change the tranny filter and that worked some. Now the light flashes for about 2-3 minutes then it goes away.
Like I said, these problems are only on days when its below freezing and once the truck is warm, everything works fine.
Ford F-150 - 1997-2003 :: F250 Won't Go Into Park?
I have a 1997 f250, light duty. I have noticed that the shift has been sloppy and now it will not go all the way into park, so if the truck is on a incline it will roll and you can feel it trying to catch. The will also not start at times unless I hold the shifter up or put it into neutral. Is this at the shifter or in the transmission?
View 3 RepliesFord F-150 - 1997-2003 :: Running Hot When Sitting Still In Park
I have a 1998 ford f150 with a 4.6 v8 it has about 170,000 miles on it. The truck seems to run hot when sitting still in park. I have replaced the radiator, the thermostat. I am lost at what could be causing this issue. when I am going the truck will cool down however if you ever let it get hot it takes longer to cool it down as opposed to getting in it and just going and not sitting before going.
View 11 RepliesFord F-150 - 1997-2003 :: Starter Engages With Key On In Park
1998 f250 4.6 4x4. In park the starter engages with key on . Ounce running the starter is still engaged in park and neutral. No engagement in the drive gears. Changed the ignition switch and neutral safety switch on the trans. When key is off instrument cluster is still on.
View 3 Replies