Ford F-150 - 1997-2003 :: 1998 - Column Shifter Loose And Sloppy?
98 f150 4x4 5.4... So i purchased this truck about 3 months ago and now I am having problems putting it in Park. The column shifter is very loose and sloppy. Is there any way to rebuild this?
View 3 RepliesFord F-150 - 1997-2003 :: 2002 - Unable To Put The Shifter Into Gear
It started with not being able to pull the shifter into gear...when started and no wipers, interior light, found a blown fuse, repaced it, all ok, blew fuse again, bigger fuse. It still works, now I have no high beams and cruise. 170,00kms....
View 1 RepliesFord F-150 - 1997-2003 :: Overdrive Light Comes On When Put Shifter In Gear
I got a 1999 f150 if you put shifter in gear the overdrive light comes on. When you put it back in park the light goes out.
View 1 RepliesSubaru - Forester :: 2002 - Gear Shifter Is Very Loose
I've a 2002 Subaru Forester, manual transmission. The gear shifter is very loose. While in any gear, the shifter can move to anywhere. For example, when in second gear making a left turn, the gear shifter will flop to the right side near where third or fourth gear are. This doesn't change the gear of operation that the car is in. It just makes it a bit of a challenge to find where the gears are. Sometimes it is a challenge to find reverse.
We've had the shifter bushings replaced and that tightened things somewhat. But it is still very loose.
Mechanics have said that there is nothing wrong with the motion or the way the linkage operates the transmission. So the problem seems to be in the gear shifter.
Is this common on this car?Is it a sign of a bigger problem?What can be done about it?
Oldsmobile - Cutlass Supreme :: 1997 - Gear Shifter Removal?
I spilled coke into the gear shifter. This is causing my car to no longer move from reverse to park, vice versa. I have already removed the center console and can see the shifter, but I have absolutely no clue as to how to remove it from the vehicle and disassemble it so that I can wash it. Any directions for how to do this? Or better yet, a link to some sort of repair manual I can use?
View 1 RepliesFord F-150 - 1997-2003 :: 1999 - Shifter Indicator Is Off
My shifter indicator is off one on my 99. How do I get at it or what do I take off to adjust or fix it....
View 7 RepliesFord F-150 - 1997-2003 :: Shifter Not Going Into Park - Linkage Sloppy
Having trouble with shifter not going into park. The linkage is sloppy. Is there a bushing kit or something to tighten up the linkage?
View 3 RepliesFord F-150 - 1997-2003 :: 2000 4X4 - Floor Shifter Will Not Move?
Drove to work in 6" of snow in 4H with no issues. Shifted back into 2H for drive home as roads were clear with no issues. Went to shift into 4H moments ago and floor shifter will not move!
View 1 RepliesFord Aerostar :: 1995 - Sloppy And Loose Shifter?
My mom's 95 shifter is slowly getting worse. Right now it's at the point where we have to hunt for gears just to put it into park or reverse or d/od. It's not stiff like the rest of ours, hers is all sloppy and loose. She says it's been doing this for a while, but i think it got worse when i pulled her cluster out to change the light bulbs. I say this because i couldn't get the needle cable un done, so i just let the cluster rest on it while i was changing the bulbs, which put a little bit of tension on it.
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F350 - Gear Shifter Very Tight And Hard To Pull Down
I'm looking at purchasing a 2003 F-350 from a Ford Dealer, Drove the Vehicle last night and the Gear shiftier was very tight and hard to pull down. Is this a real concern? The Sales guys said its better to be stiff rather than sloppy. But they will say anything, right. The vehicle is a deal and so I'm looking to find out why.
View 1 RepliesFord Ranger / B-Series :: 1985 - Shifter Really Loose / Stuck In Reverse
1985 ranger 2.3L TK5 tranny. Shifter was really loose and the tranny finally got stuck in reverse. I have opened up the bottom cover, but am not sure where to move the shift forks to get it back to neutral. I bought a new shifter, but I need to get the tranny back to neutral before I can install it.
View 2 RepliesAccent LC (2000-05) :: 2003 - Shifter Moves Around In Gear
So long story short I picked up a 2003 Hyundai accent 5 speed 80xxx miles for $1,000 almost two years ago, vehicle has been running great but the shifter always felt loose and it feels really weird going into second (kinda like the shifter really falls far into gear) I was online searching and found other different type of Hyundai vehicles with the same issue and they replace the shifter bushings oem or after market and fixes the issue. I called hyundai and gave them my vin and they told me for my vehicle they don't sell the bushings , i would need to buy a whole new cable.
My questions is am I looking at the correct place to replace my shifter bushing on the trans or is there something else I should be looking at? Shifter has been getting to the point where it hurts my wrist to shift, I've already replaced the trans fluid and its not hard to go into gear, just feels loose and if I try and go fast and shift fast the car will probably grind second due to the shift lever.
Ford F-150 - 1997-2003 :: P/S Whine And Motor Won't Stay Running - OD Light On Column Shifter Flashes
2000 XLT ext cab 4.6 4x4 auto .. Having a couple of problems in below freezing weather when temps are below 30 deg F.
1. I have the usual P/S whine, but when starting up a cold engine, the whine is extremely loud and the motor won't stay running. It starts and immediately dies. I have to give it a little gas to keep it running. It only takes a few seconds until the whine dies down, then it idles fine. Should I just replace the P/S pump or is there something else I need to look at?
2. Again, with a cold engine, when I start driving, the OD light on the column shifter flashes. It flashed for quite a while. The tranny worked fine, though. No problems shifting. I was told that I have to have the dealer read the code and it can only be done when its flashing. Is this true? I'd rather not spend the $$ if its something I can take care of myself. I did change the tranny filter and that worked some. Now the light flashes for about 2-3 minutes then it goes away.
Like I said, these problems are only on days when its below freezing and once the truck is warm, everything works fine.
Ford F-150 - 1997-2003 :: Loose Shocks Causing Front Pop When Accelerate?
I have a 2000 f150 xlt 4x4 with a 6" suspension lift. Recently Ive had some front end noise, so after swapping out a lower ball joint and the sway bar links, i still have the pop. It only happens when at a stop or slowly moving and i turn to the right and accelerate. It sounds like its coming from the front drivers side. I have wiggled everything in the front end and everything is very tight. The only loose things i can find are:
1) Bottoms of shocks can be wiggled back and forth, both sides do this.
2) driveshaft leading to the front end has a lot of play, but I don't believe that's relevant since its not used when I am in 2wd.
Ford F-150 - 1997-2003 :: Electrical Plugs To Fuel Injectors Seemed Really Loose
When doing my last spark plug change I noticed that the electrical plugs to the fuel injectors seemed really loose. The plastic tabs on the harness plugs don't even lock onto the injector plug. Its actually amazing that they don't vibrate loose or stay electrically connected. The plugs are not cracked or damaged that I can see. Is this a problem? I feel that I should replace the plugs with something that has more of a positive "grip" to the FI plug....
View 2 RepliesFord F-150 - 1997-2003 :: Rattling In Engine Like Something Came Loose - Transmission Fluid Leak
I have a 97 ford f150 v6 2wheel drive. I was driving to work when l heard rattling in the engine like something came loose when I stopped to check my transmission fluid was pouring out drained out in 2mins tops. What do you think it could be?
View 6 RepliesFord F-150 - 1997-2003 :: Codes P0302 And P0401 / Misfire Due To A Loose Injector Plug
My 97 F150 4.6 4x4 threw a P0302 and P0401 the other day, I traced the miss fire to a loose injector plug. I reset the codes last weekend, I got in the truck and went to the Dump and to town to pick some stuff up. It threw the EGR code again, so this morning I did a little checking on the EGR I cranked the truck and disconnected the FPR vacuum line and hooked it to the EGR valve and the truck died down but didn't completely die.
Now the green line that went to the EGR valve felt like it had a slight bit of pressure coming from it. Is this normal? I did pull the white feed line from the EGR Regulator and it had good vacuum.
The regulator also makes a humming sound when you cut the truck off. Ill be pulling the alternator this weekend due to it going out last night, while I'm in there if Ive got to pull the throttle body id rather do it while I'm elbow deep in it. So does it sound more like a Clogged Throttle body or a Faulty sensor?
Ford Super Duty (1999-2016) :: Auto Shifter Lever Extremely Loose / Will Not Go Into Park At All
1999 F-350 . My shifter lever is extremely loose, it will not go into park at all. I tightened the two torx bolts, adjusted the needle but its still bad. Im thinking the cable is loose, I saw that there is a small rod attached to the end. Is there a way to tighten it or do I need a new cable assy.?
View 5 RepliesFord 7.3L Power Stroke (1999-2003) :: 4r100 Transmission Loose After Warm Up Especially At 4th Shift Overdrive And Passing Gear
I have a 4r100 on in a 99 7.3 4x4. The shifting problem I have appears to be intermittant. it seems loose after warm up especially at the 4th shift overdrive and passing gear. possibly due to low presures ? sometimes (lately more often than not) hunts back and forth between 4th and o.d when passing or hill climbing. Under normal driving it shifts somewhat firm with 4th being an exeption.I have changed my crank position sensor filters and fluids which had turned dark and improved slightly. When I pulled the pan and replaced the filter the pan was spotless. No residue or signs of plates or debris. There is about 100,000 miles on the tranny and 350,000 on the truck. Questions: Is there a tcm for this transmission and if so could it cause these problems? I'm considering a purchase of an unlocked 1705 superchip to change the shifting but unsure if this will work for my issues...
View 14 Replies