Ford 7.3L Power Stroke (1999-2003) :: Key Lock On The Steering Column Broken / Starter Never Engages
My truck was stolen over the weekend. Fortunately, it was recovered but they broke the key lock on the steering column and I'm having a hard time getting it started. I can turn the ignition all the way to the start position with my key or a screwdriver but the starter never engages. I'm sure I'm missing something simple but I can't seem to figure it out. Looking for instructions on how to get this started again?
View 14 RepliesFord F-150 - 1997-2003 :: 2004 - ABS Engages When Coming To Stop
I have a weird problem that just started concurring. When you approach a stop and the vehicle is almost at 1 or 2 MPH, the pedal pulses and I can hear the ABS buzzing. None of the wheels are slipping, and all my tires are of the correct size & pressure. There is no ABS codes at all. There is no ABS light on either. How can I diagnose? 2004 Heritage.....
View 2 RepliesFord F-150 - 1997-2003 :: 1999 - Manual Shift Transfer Case / 4x4 Only Engages In Reverse
just bought the truck first time out hit some snow and it was not engaging low or high range, but I noticed that when I was backing up it was engaged again works in high and low range, i had to reverse about a mile up the road but it worked ? 99 4.2 standard with manual shift transfer case....
View 1 RepliesFord Excursion :: Starter Engages When Headlights Are Turned On And Reverse?
Had the Ex (2000 Limited V10 134K) about a month now, doing some reading in the FTE, saw the thread about wire chaffing in the steering column related to the gear shift selector and overdrive. Well, everything else has been chaffed on this truck so far I figured I better look at that too. They are chaffed right at the bottom of the base of the selector, not much wire to work with, might just replace.
I put everything back together and no issues. The next morning, I drove it and no issues until at work, put it in reverse (to park next to the bosses pretty new red Titan, picked that up from You Might Drive and Ex If) and the starter engaged. Got it parked, starter playing with switches for it to repeat, found that with the keys in my hand and turning on the headlight switch on (park or headlight position) the engine would start turning over, turn the key on and the headlights on and the EX starts, started stayed engaged until headlights are turned back off. Reverse only engaged the starter when the engine was running, when not running neutral safety switch kicked in telling me it works.
Searches had me reading in other in another place that there are wires that go from the headlight switch to the steering column specifically heavier guage blue wire with red or pink stripe "I think".
So last night I took the column covers back off and started chasing wires. As I was moving wires looking for the short I kept turning the light switch on and off as I wanted to know if and when I found the short. Evidently, I found it because the headlight switch and reverse stopped engaging the starter. I never did find the actual short. So the chipmunk has been chased from my wood pile but for how long?
I left everything in the column until the problem went away so to speak. I took the turn signal selector out inspected both connectors and wires and went about 6 inches back into the wiring harness, I found nothing, the turn signal selector had no impact on the started engaging.
Ford F-150 (2004-2008) :: Engine Turns Over And The Starter Engages But It Won't Fire
My 2008 F150 5.4l SCrew wouldn't start this evening. The engine turns over and the starter engages, but it won't fire. Oddly enough the starter stays engaged after I take my hand off the ignition! I have to physically turn the key off for it to quit (didn't want to burn out the starter). The culprit may be the wet weather....it's been a lot milder today and we've had some freezing rain that turned to drizzle. My truck has only done this once before (last year I think). I eventually got it to start tho.
View 13 RepliesFord Super Duty (1999-2016) :: Starter Engages After Truck Is Running
I have a 2004 to 250 super duty 5.4 and automatic trans it has about 233,000 miles on it. Yesterday when I started my truck I could see my reverse lights were stuck on against the garage door in the dark. After I put the truck in drive the lights went out later on I shift at the truck and to park and the starter engaged I put the truck in neutral and it stopped the starter from running after doing that several times the truck now does it even when it's in reverse or neutral. I have to leave it in drive and push the emergency brake on I am in and out of the truck all day long. I did change the shift to blast may I check the screws on the back of the shift to bury thing seems fine.
View 1 RepliesFord Wiring/Electrical :: 2000 F250 V10 Starter Engages When Truck Is Put Into Reverse
2002 Ford F250 V10 Auto... When I put the transmission into reverse, the starter kicks in...
View 8 RepliesFord - Ranger :: 1995 - When Ignition Key Engages Engine Jumps Back / Starter And Flywheel Grinding
In a matter of weeks, my truck destroyed two sets of flywheels and starters. When the ignition key engages, the engine "jumps back?. Apparently, this causes the starter and flywheel teeth to grind. My mechanic cannot determine the cause of the "jump back". He thought that it might be the timing. His examination and testing, however, proved the engine properly timed.
View 6 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Starter Engages When Shift Into Reverse
I have a 02 F250 Super Duty XLT with a triton V8 with a automatic transmission . and when I shift into reverse after driving for a while the starter engages . It does not happen all the time . If i start up the truck and shift through or into reverse it doesn't happen . the only time it happens is when i've been driving for awhile and want to back up or park it will only do it once or twice after each drive so trying to get it to happen while in the shop is almost impossible . could this be caused by the transmission range sensor . I just had the code P0705 (transmission range sensor , A circuit input ) come on but the problem has been happening for a few weeks before that code came up .
View 6 RepliesGolf V R32 :: Squeaking Noise When Starter Motor Engages
I've had my .:R for a while now, gotten used to its little quirks. But one thing that sparks my interest (not really worrisome though) is I have a squeaking noise when the starter motor engages. It definitely squeaks once per revolution for about 4-5 sqeaks, and it's noticeable in and out of the car. Is it a bearing going bad?
View 5 RepliesFord F-150 - 1997-2003 :: How To Remove Starter
Starter Removal, The top bolt is a bugger.
View 5 RepliesFord F-150 - 1997-2003 :: New Starter Won't Disengage?
The starter on my kid's truck doesn't disengage and continues to turn over after the ignition is off. I have seen a few posts on this but have yet to find a clear troubleshooting path and it seems a lot of money wasted on new starters, solenoids and new ignitions.
View 4 RepliesLexus LS 2007+ :: Starter Engages And Continues Cranking - Intermittent Start
For the past year I have had intermittent start issues with my LS that occur about 15 percent of the time. Ambient or engine temperature do not make a difference. Sometimes the starter engages but then disengages right away. I then need to depress the start button an additional time or two before it actually starts. At other times the starter engages and continues cranking while the engine sounds like it is trying to start (like it is just barely keeping ahead of the starter speed). That carries on for several seconds and then it starts. Nothing shows on diagnostics and the dealer says I am going to have to wait until there is a complete "no start" before they can trouble shoot. There was a similar issue with earlier 460 models but the Lexus service tech said that problem does not apply to the 2011's. It seems there is a lack of fuel delivery but from what point? And why only intermittent and momentary?
View 6 RepliesFord F-150 - 1997-2003 :: 1999 - No Power Going To Starter
I have a '99 F-150 SC, 4x4, 4.6L, with 48,000 miles. I drove approximately 15 miles, then parked for 20 minutes. When I returned, the truck wouldn't do anything when the key was switched to start. It's as though there was no power going to the starter. Could it be a problem with the immobizer system, or just a freak incident with how I handled the key? The truck ended up starting after another 15 minutes and has consistantly started for the remainder of the day.
View 4 RepliesFord F-150 - 1997-2003 :: 1999 - New Starter Won't Disengage
Starter problem with my 1999 Ford 5.4 f150. Last few days I’ve had to cross the solenoid terminals in order to start up. After replacing the solenoid the starter would not disengage. Put the old solenoid back on, crossed term and the starter did the same thing. Bought new starter (what a job finding the upper bolt) replaced old one, and I’m still hearing the starter running along with the motor. What else?
View 11 RepliesFord F-150 - 1997-2003 :: No Start Just A Click From Starter
I got a 1997 f150 4x4 4.6L had to replace fuel rail after a couple holes were rubbed in it and caused a fire, but now after two weeks of it sitting at the dealer, I wasn't gonna pay for a fuel rail to be put on so i had it towed home and I did it, however now when I go to start it, it just clicks. So I have the battery tested and its bad so it was still warrantied so it now has a new battery and i also replaced the starter solenoid while i was at it. But still just a click when i try to start it. I had the starter out and bench tested it and it went but went slow and looked very old and tired, I am thinking i need a starter now because its a click from the starter, like its trying to go but isn't strong enough.
View 3 RepliesToyota - 4runner :: Starter Eventually Engages And Cranks 2 Or 3 Times But Engine Does Not Turn Over
During the cold snap over the last few months, my 1997 Toyota 4Runner has been having starting problems with the following symptoms in this order:
I turn the key and nothing happens.
I keep turning the key from off to start, and the starter eventually engages and cranks 2 or 3 times, but the engine does not turn over.
I keep trying and the starter engages and keeps cranking even after I turn the key off.
I panic, and turn the key on and off until the starter stops cranking.
I try a few more times and the starter cranks and the engine catches, but lugs until I pump a little gas.
Really weird thing. Occasionally, after the above sequence, the emergency brake light stays on even though the brake handle has been disengaged, and it feels like I have no power, then the light goes out and the car runs just fine.
The problem in intermittent. Cold seems to cause it although it doesn't cause it every time. Rain may be a factor as well. Sometimes, I only have to turn the key a few times, and then the starter will engage. I changed the battery after the trouble began, and it cranks well if and when the starter engages.
Up until this I have not had a day's trouble with this vehicle other than a little belt squeaking.
Ford F-150 - 1997-2003 :: New Starter Won't Turn / Motor Is Seized?
I have 98 f150 with 4.6 starter went so I put a new one on wich was a hassle and it tries to turn but just wont as if the motor is seized. I had been hear a loud howling sound from what I think is the ac unit and the ac line burst after trying to start. Would a bearing or something with the AC be enough to stop the engine from turning over? Or could it maybe be a wire connection problem? To me it sounds like a starter trying to start a seized motor but I cant see that my motor would be out it only has 190 000km and the oil looks good. but we couldn't turn the motor over with a ratchet? The truck had been getting gutless. I am stuck...
View 4 RepliesFord F-150 - 1997-2003 :: Grinding And Starter Won't Engage The Flywheel
I just bought a 2000 f150 4x4 ex cab with the 5.4. Once in a while when starting, there is a grinding and the starter won't engage the flywheel. The truck has only had 17000 miles put on it in the past 4 years, and has sat quite a bit. Could the starter gear be gummed up and not engaging all the way, or should the starter be replaced? Or could poor contact on the cables cause this? Or is this a flywheel issue?
View 14 Replies