Ford Excursion :: 2005 V10 - Loose Connector While Looking Under The Hood
I recently bought a beautiful 2005 6.8L V10 Excursion with ~90k miles. While looking under the hood, I noticed a loose cable. See attached pictures. Where it may have come off?
View 2 RepliesFord Wiring/Electrical :: 2011 F250 - Reverse Light Wire Under The Hood?
I would like to hook up some auxiliary reverse lights, I want to use a relay. And activate the relay when I put my truck in reverse. I would like the relay to be in my custom relay/fuse box under my hood near my battery. I'm looking for a wire I can tap into, to use to active the relay as close to the battery as possible. Or at least a wire on the outside of the cab near the engine compartment. Maybe there's one coming from the tranny? I have a 2011 f250 super duty. XL, I think, its a very base model truck no power windows or locks, only fm/am radio, no NAV system, no remote unlock, no nothing, 2 wheel drive.
View 9 RepliesGolf/GTI VI :: Hood Won't Open / Release Inside The Car Is Loose
I picked up a new CSG GTI, 6speed with Xenon and Bluetooth on Thursday. Yesterday evening when I got home from work I opened the hood to make sure everything was cool I guess. Then this morning I was going to open it again, and the release inside the car is loose, like it's hardly attached to anything.
MKVI? I know it's probably a cable issue, but it sucks to have to drive back 50 miles to the dealer, 2 days after buying it, because the hood won't open.
Pic: ........
Ford Wiring/Electrical :: 1980 F250 - Small Click Under The Hood On Driver Side
1980 F-250, 351M. Battery tests OK - 500 cold cranking amps. New starter, new starter solenoid. When I turn the key to ignition, small click under the hood on driver's side. Turn to start, the starter solenoid clicks once, but no turnover. After that, all electrical is dead - no lights, no horn, no radio, no clicks. Turn the key to accessory, gauges work, but no radio, etc. Turn the key to ignition, nothing. Tried jumping from another car, and the cables melted.
View 7 RepliesGolf IV R32 :: Front Suspension Becoming Loose At Mounting Points Under Hood
So I have had my coilovers in for a little less than 2 months now and i have been noticing that my front suspension is becoming loose at the mounting points under hood and needs to be re-tightened periodically. I will say that unfortunately i have to drive in and out of some steep inclines and funny angles where it puts the car into tripod mode regularly. I'm not rubbing anywhere (fenders or bumpers) upon entry or exit but I am very low and really getting every bit of movement out of each corner, lots of creaking and popping (all from front, rears are fine) until tightened then its quiet again, but it all comes back after 3 or 4 days. I haven't tried driving for a week without hitting the steep inclines so I'm not sure if this is even the reason. But its the only thing that i can think of.
View 10 RepliesSonata NF (2006-10) :: Hood Won't Close / Loose Release Handle
I've been driving a 2009 Hyundai Sonata for about 9 months now and it recently (2 weeks ish) started to not shut its hood. I haven't gotten it officially checked out yet as I'm low in funds and don't want to shell out money where I don't have to. I know it's dangerous to drive around with my car hood open (like an inch which is noticeable). I would shut it before I start driving and when I reach my destination it would be up again. Someone (a random guy who pulled up next to me at a red light and told me he could give me a quote for my hood... and the dent on the side of my passenger door) told me it may be due to a loose hood release handle on the driver side. There was no give when I tried the handle (is this called the latch?) and when this someone tried to loosen the rust on the hood lock itself (is this the latch idk these car terms), it still wouldn't close. It would click but pop right up. It keeps clicking when I close it but doesn't fully close because I could lift it up about an inch and it'd stay that way. He said it may be due to a cable issue with the release handle.
View 2 RepliesSaturn - Sl :: Oil Cap Constantly Vibrates Loose / Smoke Coming Out Of Hood
I've tried replacing it, and while it fits in there nice and snug, within 10-20 minutes it vibrates itself loose again and I have smoke coming out from the hood from the oil spilling out onto the engine. Is there some easily-removable caulk I can fasten the oil cap in with? (so that when I need to fill it with oil I can still get to it, natch).
View 3 RepliesFord Excursion :: Loose Steering - How To Tighten This Up
Seems mostly for DIY'rs. Would like to start taking care of this steering issue. Steering wheel turns about an inch in both directions before wheels start to turn . How do we tighten this up?
View 14 RepliesFord Excursion :: Steering Loose After New Tires And Alignment
My Excursion only has 74000 miles and I just replaced the original shocks with Monroe Reflex and combined with my Goodyear Silent Armor tires was running beautifully. Then after a "deal" from Ford, I replaced the Goodyears with LTX-MS2's and had the alignment checked since my Goodyears did have a little cupping after 45000 miles. They also checked all the front end components and said that everything was in good shape! Upon driving it home, the Excursion steering was extremely loose and I was ready to return the tires and get new Silent Armors, but I figured that there probably was something screwy with the alignment that they just did. So I brought it back, test drove it with the tech at 75 mph and he decided he needed to recheck the alignment. After the realignment, it drove beautifully, but after reading the posts on various forums regarding the proper toe-in on the front, I am questioning whether the alignment is set properly?
After the 1st alignment (in degrees):
LF Camber .3; Caster 3.0; Toe .01
RF Camber -.2; Caster 3.2; Toe -.03
Total Toe -.03; Steer Ahead .02
LR Camber .1; Toe .12
RR Camber -.03; Toe .16
Total Toe .27; Thrust Angle -.02
After the Realignment (in degrees):
LF Camber .3; Caster 3.0; Toe -.03
RF Camber -.2; Caster 3.2; Toe -.04
Total Toe -.07; Steer Ahead 0.00
LR Camber .1; Toe .13
RR Camber -.3; Toe .18
Total Toe .31; Thrust Angle -.03
Ford Excursion :: 2005 - Steering Loose - Not Stable
New to owning a 2005 Excursion Limited 4WD 6.0 Diesel 140k miles.
When I bought the Excursion I had to drive it about 200 miles back home and it was all over the place. The steering seems real loose and when I hit bumps or a large gust of wind comes along the Excursion is all over the road.
I took it to Ford to get an alignment the next day and they said I need new outer tie rods ends, upper & lower ball joints, front shocks, steering stabilizer, locking hubs.
After that I took it to my mechanic who said I did not really need all that stuff done but if I did it I should be set with the Excursion for a long time. I opted to do all of these suggestions because I will be doing a lot of traveling with my family and wanted the peace of mind that all is well. For shocks I put new front and rear bilstein shocks (nothing fancy, I think they were about $80 each, sales rep said they would provide a firmer ride for towing).
After that I took it to another Tire shop for an alignment, they complimented all the work done and said I just need to get used to the steering after coming from a 2014 Jeep Grand Cherokee. I took there word for it and headed on a 2k road trip.
I love the Excursion but once again it was all over the place. It seems worse around 65-70 mph, and I found going around 75-85 it would be a little bit easier of a drive until a Semi Truck would go by or I would get stuck in a lot of traffic or hit a lot of bumps.
At first I had a very firm grip on the wheel but quickly learned that a loose grip at around 4 & 8 o'clock on the wheel was best. I talked to a number of other Excursion owners who said there was very smooth and straight.
The way it drives right now does not seem safe.
Ford Excursion :: Loose Wire To Steering Wheel Controls
So I have a loose wire to my steering wheel controls. They don't light up anymore and when I smack the back of the wheel, they will light momentarily. Also, 2 of the radio buttons work intermittently. How do I access them?
View 8 RepliesFord Excursion :: Hood Release Cable Replacement?
So in order to get my hood to open, I have to pull the hood release lever in the cab, go pull up on the hood itself, then pull the release lever again, and pull on the hood to get it to finally pop. Is this a cable perhaps going bad? Or another issue I need to fix?
View 14 RepliesFord Excursion :: Big Click And Truck Went All Dead - Loose Battery Connection
My husband was kindly pulling the Ex into the garage for me. I drove it around town today. He came in and He said he pulled it in and turned it off. Then went back to turn it on to pull it in a little farther. When he tried to restart it there was a big "CLICK" and it went all dead. He said the theft light briefly flashed after everything else went dead. Also, aux power such as cig lighters still work. Could it be a fuse?
View 14 RepliesFord Excursion :: 2005 - Passenger Outer Tie Rod Is Shot / Loose And Won't Tighten
Had the Ex inspected and the passenger outer tie rod is shot. It's loose and won't tighten. I was told I needed an outer tie rod. I feel like this is something I can do, but my question is what else should I replace? While I'm in there I might as well replace whatever may also be worn (or wearing). So what all do I need to replace?
2005 6.0 4x4 Excursion
Ford Excursion :: 4 Random Dead Ended Wires Under Hood?
What do these 4 random dead ended wires under the hood go to.
View 3 RepliesFord Excursion :: Screech / Squeal Coming From Under The Hood While Driving
On the way home tonight, the Ex started to make what I can best describe as a screech/squeal. It sounds a little bit like a pulley spinning against a stuck belt or a motor that ran out of grease. I heard it 4 times and it lasted about a second or 2 each time. It seems to be coming from under the hood. The only common variable between all of the occurrences is a speed between 5 - 20 mph.
Belt has been replaced recently, when I looked under the hood all pulleys were spinning normally. The only thing I can think of is maybe it's the re-manufactured power steering pump that I put in after the redhead box install or the a/c compressor. When the compressor is running it makes a ticking noise. Maybe it's finally done and the screech is it starting to spin up when it engages the pulley?
Ford Excursion :: Removing Wires From Under Hood Fuse / Relay Box
Well, it's starting to look like I may have to build my underhood harness from bits of multiple harnesses. I found a 2000 Excursion harness, but the engine plugs and wires were hacked off during engine removal.
After in-depth study of wire diagrams, it looks like I can just get a pickup harness and combine it with the aforementioned damaged Excursion harness to get what I need- and do it for about 50 bucks.
I also notice that there are a few Ebay sellers who just sell the fuse/relay box with the wiring harness hacked off of it. So my question is- how do you remove the wires (including the terminal ends) from the fuse/relay box? I've fiddled around with my burned up parts and can't seem to figure it out.
Ford Excursion :: Stripping Emissions And Other Pointless Bits From Under The Hood
Trying to work under the hood and notice that in the acre or so I have to work in, there are tons of canisters and hoses and lines. What all can be removed and what can be relocated?
View 10 RepliesFord Excursion :: 2002 - High Pitched Squeal Under The Hood
My 2002 PSD X with 258K miles has a high pitched squeal in the engine compartment. I only had a minute to look at it as my wife was leaving with it. But, I was able to stick my head under the hood and it seems like it is coming from the front of the engine. Trying to pinpoint where the squeal is coming from with all of the other engine noises is tough. I suspect one of the bearings up there like idler pulley, tensioner pulley, alternator, AC compressor, water pump. The alternator has about 70K miles. The other items I don't know.
View 5 Replies