Ford Excursion :: Loose Steering - How To Tighten This Up
Seems mostly for DIY'rs. Would like to start taking care of this steering issue. Steering wheel turns about an inch in both directions before wheels start to turn . How do we tighten this up?
View 14 RepliesElantra XD (2001-06) :: Passenger Front Door Window Outer Weather Strip Is Loose At One End
2001 GLS... Noticed the passenger front door window outer weather strip is loose at one end. Looks like a "tab" on the strip fits into a slot on the door panel. Since the tab is smaller that the slot, is there some kind of clip or something that holds the weatherstrip tab securely in the slot?
View 2 RepliesFord Excursion :: Passenger Side U-Joint Is Shot And Axle Wiggles Around In The Dust Seal
Picture if you will...Removed tire, caliper and rotor. Removed hub, and knuckle containing the stub shaft/spindle with it's yoke for the U joint. You are now looking at the end of the axle tube, with the axle shaft in it, one end connected to the differential carrier, the other end has the yoke for the U joint on it. Just inboard of the yoke, is a seal. Apparently it's called a "dust seal" is there a bearing behind this, or is the first bearing all the way in at the differential? When I was doing my brakes, I noticed the passenger side u-joint is shot, and the axle wiggles around in the dust seal. Figured I'd replace the seal while I was doing the U joint. Also, how do I get the axle shaft out? Just pull, or do I have to remove a C clip from the inboard end? What is the right National part number for the seal? I have a 6/2000 Excursion.
View 2 RepliesFord F-150 (2004-2008) :: Loose Side Mirror - How To Tighten Up
How to tighten the drivers side mirror? It's rattling around and driving me nuts. It's loose at the pivot point not the door mount. It's the power/folding version. I looked at it but can't figure out how to tighten it. There is a little plastic access panel on the bottom below the pivot but there doesn't appear to be a nut or anything to tighten in there? Maybe I missed it?
View 3 RepliesFord Excursion :: 2005 - Steering Loose - Not Stable
New to owning a 2005 Excursion Limited 4WD 6.0 Diesel 140k miles.
When I bought the Excursion I had to drive it about 200 miles back home and it was all over the place. The steering seems real loose and when I hit bumps or a large gust of wind comes along the Excursion is all over the road.
I took it to Ford to get an alignment the next day and they said I need new outer tie rods ends, upper & lower ball joints, front shocks, steering stabilizer, locking hubs.
After that I took it to my mechanic who said I did not really need all that stuff done but if I did it I should be set with the Excursion for a long time. I opted to do all of these suggestions because I will be doing a lot of traveling with my family and wanted the peace of mind that all is well. For shocks I put new front and rear bilstein shocks (nothing fancy, I think they were about $80 each, sales rep said they would provide a firmer ride for towing).
After that I took it to another Tire shop for an alignment, they complimented all the work done and said I just need to get used to the steering after coming from a 2014 Jeep Grand Cherokee. I took there word for it and headed on a 2k road trip.
I love the Excursion but once again it was all over the place. It seems worse around 65-70 mph, and I found going around 75-85 it would be a little bit easier of a drive until a Semi Truck would go by or I would get stuck in a lot of traffic or hit a lot of bumps.
At first I had a very firm grip on the wheel but quickly learned that a loose grip at around 4 & 8 o'clock on the wheel was best. I talked to a number of other Excursion owners who said there was very smooth and straight.
The way it drives right now does not seem safe.
Ford Excursion :: 2005 V10 - Loose Connector While Looking Under The Hood
I recently bought a beautiful 2005 6.8L V10 Excursion with ~90k miles. While looking under the hood, I noticed a loose cable. See attached pictures. Where it may have come off?
View 2 RepliesLexus ES 2007-12 :: Rear View Mirror Loose - How To Tighten
I'm not talking about the attachment of mirror to glass, I mean the mirror arm/neck/pole/thing to its base.
It seems like there's a loose Torx screw (is it? I can't see it clearly).
What tool I need? It's out of warranty....
Chevrolet - Express3500 :: Constant Pitch Noise - How To Tighten A Loose Serpentine Belt
Actually above + an interesting mystery.. Late last spring I began hearing a noise of constant pitch (sounding like someone sanding wood) when the engine was cold---Louder when it was colder/cooler. As the engine warmed up the noise went away. Throughout the summer,No Noise. n. Late summer broken water pump replaced along with hoses/belts. No noise until, temps in AM in the 40's.
Now that same damn noise is back.Only LOUDER! Same pattern>>as engine warms noise softens and goes away. My ear suggests noise is coming from the tensioner pulley (But, I've been fooled before)As to the question above, Do I tighten the belt on 'This vehicle' using the tensioner pulley or do I have to use the "Pry the Alternator forward" method.? One last thing, while the noise is occurring it does get louder with acceleration but is soon blocked out by normal engine noise.
Ford Excursion :: Rear Window Hatch Shocks Are Shot?
I think my rear window shocks are shot. Last week when the temps hit -15 they completely failed. Are these a rebuild-able shock or do I need to purchase new ones?
Why do I have a bad feeling that this will be an overpriced item????
Ford Excursion :: 2001 - Replacing Outer Axle Stub?
I think I ran a wheel bearing dry on the front end of my 2001 Ford Excursion. Do I need to replace the outer axle stub when I replace the hub/bearing assembly? Where's the least expensive place to buy one?
I think this has the Dana 50.
Ford Excursion :: 2001 - Front Tire Wear On Both Outer Edges
I have am 01 6.8 two wheel Limited. about 150K. My question is about both the front tires having more wear on both the inner and outer edges. The inner is a bit more but not by much.
I have been keeping very close track of my air pressure because I know the usual suspect is low air pressure but I am running 75psi and the max sidewall reads 80psi. I have never had it below 72psi. The truck tracks and steers down the road very nice with no drift or pull to either side. wheel balance is good.
Front end align is good. I have no issues with how she drives down the road. Everything seems to be checking out to be in spec..?
Ford 6.0L Power Stroke Diesel :: Passenger Side Lower-outer Tie Rod Is Clunky
I know jack about tie rods. But what I do know is the passenger lower-outer tie rod is clunky [Right where it connects near the wheel. Jacked up the truck and moved the tire from right to left and the passenger side lower tie rod made a very obvious clunking noise right where it connects with the upper piece.
My question is, can I just replace the passenger lower arm or do I need to replace the upper [not sure what it's called] that it connects into? While under the truck I found it difficult to figure out exactly how they are joined together and taken apart? My drivers side is nice and tight, no clunking.
2005 F-250 CREW CAB 4X4
Ford Super Duty (1999-2016) :: 2003 Excursion - Outer Axle Seal Installment
Do I need a special tool to put the outer axle seal on a 2003 excursion? I could make one if I new how far down it needs to be. I'm replacing the needle bearings in the back of the hubs and it looks like the last seals were not on far enough and the hub tore them up....
View 13 RepliesFord Excursion :: 2005 - Rear Axle Seal Leaking On Passenger Side
2005 4wd excursion. I have a leaking rear seal on passenger side.
I have the hub assembly off. I'm down to the spindle. My old seal came out in pieces. There's either a piece of the old seal or another seal on the back of the spindle.
Are there two seals? This what looks like a seal still on the spindle against the plate on the back...
Ford Excursion :: 2005 - Loud Clunk Or Pop Noise From Under Driver And Passenger Floorboards
I have a '05 4X 6.0 PSD... that has a loud clunk or pop noise from under the drivers and passengers floorboards. I've done A LOT to try and fix this noise... and know, it's definitely due to frame twist. As I can drive straight, on flat ground and it'll never happen. On a dirt road, with stutter bumps... still, nothing. When the road is off-camber, or I have an S-Turn the CLUNK will be there, and sometimes more than once (seemingly if the load change is enough).
If I'm off-road, and the road is off-camber or has my X articulating 1-2' in either direction side to side or diagonally, the CLUNK is so annoying, so bad, I think the X is going to fall apart.
So this past weekend, I had my fiance' roll back and forth (about 20') over a small dirt embankment, while I was on my hands on knees outside next to the running board. And boy... it's a LOUD clunk, and I can feel it on my feet in the X... or if I put my hand on the frame. But, for the life of me... can't find the culprit.
Avalon 2005-12 :: Left Tires (only) Have Exaggerated Outer Edge Wear
2011 Limited. 44867 miles.
Today when I rotated all five Turanza tires (RF > SP, RR > RF, SP > RR, swap L, as per the manual), I noticed the left tires (only) have exaggerated outer edge wear. All three from the right have even wear.
Wifey says it's because I weigh 400 lbs (181kg) and am generally driving alone. When I'm not alone, my passengers are all normal weight. This would be the first time in my life my weight cause uneven wear to tires.
By the way, these tires are LOUD on certain road surfaces.
Avalon 2005-12 :: 2007 LE - Outer Reverse Lights On Both Sides Not Working
I (or rather my dad) have a 2007 avalon limited. I'm trying to install a backup camera for him. I don't know if it's something I did now but I see the outer reverse lights (on the car body, rather than trunk lid) don't come on as they should. Also any tips to install the video interface and/or camera are extremely welcome - it can never be too basic!
View 11 RepliesElantra XD (2001-06) :: 2005 - Driver Side Outer Window Seal Detached
Just had the driver window glass replaced. This is the second repair as the first guy just glued it and I think he partially detached the outer window seal. Is there a way to glue it back or does it need to be replaced? Is that something I could do. Now that I've seen videos, I could have replaced the window glass myself.....
View 5 RepliesFord Excursion :: Loose Wiring Under Hood
What is this supposed to go to? Found it just flopping around under the hood while we were replacing a fuse.
View 7 Replies