Ford Excursion :: Auto Lock Hub Not Working
Well just replaced most everything in the front axle. Hubs, vacuum seal, dust seal, inner seals and calipers. I also cleaned the autolock hubs. Fist time I used them they worked. I tried again today and no 4wd. I checked the vacuum lines and they are all intact. Not sure what to do next.
View 14 RepliesFord Super Duty (1999-2016) :: Disable The Auto-dim Feature?
When I turn on the headlights of my 2004 sd diesel dually the console readout dims to the point I can't read it. I know about the intensity wheel but it does not have enough to overcome the auto-dim feature. Can the auto-dim be disabled, ripped out, sent to Iran, threatened with a .45? Anything to get rid of it.
View 3 RepliesCamry :: 2008 Hybrid - Auto Headlight Function Enable / Disable?
I have a 2008 Camry hybrid. It comes with the auto Headlight function where the car will automatic turn the headlight on/off at night and day time. But, but for some reason it doesn't work when I first got the car (pre-owned). I check all the wires/fuse, everything is good, but it just not working. The headlight and on/off switch itself works good. I just wonder if it has an option you can disable/enable it in the console or something else that I should look for?
View 7 RepliesCorolla / Matrix 2009-13 :: Manual Transmission - How To Enable Auto Door Locks
How to disable the auto door locks but I have the opposite problem. Mine were not enabled and I would like them to be. Looking for instructions for enabling the auto door locks? 2010 s, no smart key, manual transmission.
View 14 RepliesLexus GX 2010+ :: Auto Relock Feature Settings?
In vehicle settings, there is auto relock feature, i set it up to 60 seconds, the guy who did a walk through with us said, if we leave the car unlocked for 60 seconds it will automatically relock itself. Left the car in the garage for about 5 minutes and still didnt unlock. Is auto relock supposed to relock the car when we walk away?
View 9 RepliesTiguan :: 2015 - How To Turn Off Auto Locking Feature
I've just acquired a 2015 Tiguan TSI.
I'd like to turn the auto locking 'feature' off. By this I mean the doors locking at 7MPH.
I'm a long-time VAG-COM user, and have performed this operation on a couple of previous vehicles, but the Central Locking controller isn't accessible on this car.
VCDS reports 'no response from controller' after three attempts.
Passat (B5) :: Rear View Mirror Lost Auto Dim Feature
'01 B5 V6 GLX wagon... Inside rear view mirror with auto-dim feature suddenly lost it's auto-dimming ness. Instead, the fluid that does the dimming kinda pools around in a random bubble-cloud within the glass and in various places within the mirror. It's distracting as heck.
View 6 RepliesCorolla / Matrix 2009-13 :: Safety Feature - Disabling Auto Unlock?
Is there a way to disable to auto lock on these cars? When I put my car in park it unlocks it for me. Locking it is kinda cool, but not unlocking it. I had a situation a few days ago where I was sitting in a parking lot waiting for my girlfriend to get out of the store when a guy opened my door and tried to get in. He realized that he opened the wrong car door. I really do not want this type of situation to happen again due to the fact that I carry every single day. So, is there a way to disable the auto-lock "safety feature".
View 3 RepliesLexus ES 2007-12 :: 2011 - Turn Off The Auto Tilt Steering Feature?
I had this on my lS430 a ways back and had to take it to the dealer to disable. No mention of this my owners manual that I can find.
View 2 RepliesLexus RC 2015+ :: RC350 Window Tint - Disable Auto Roll Down Feature
Have problems getting window tinted? Just got my RC 350 and i took it to one of the most referred places in town for tints. (small town)
Anyways, they are having trouble with the drivers side window bc that little autoroll down feature when you open the door keeps on messing up the bottom edge of the tint. I've already taken it back to the shop for them to fix it and now I have to take it back on Monday to get it fixed again.
Any way to disable this auto roll down feature on the rc 350?
Ford Super Duty (1999-2016) :: F250 - Safety Feature Lock / Unlock Only At Start Up And Cutoff
Just started a job with a company that has F250 super duty service vehicles and I am puzzled. All the answers I find don't seem to apply to this vehicle. With a full front seat and the big center console it kinda sucks to have to reach over or walk around to manual lock passenger door 10 times a day. I do NOT have power door lock buttons, number pad on handle, or any type of keyless remote. It seems I only have the safety feature lock/unlock at start up and cutoff. So is there anyway to make it not unlock passenger door when I turn ignition off? I even tried pulling fuse 17 that is marked as lock motors thinking that was related with no success. The dash display doesn't have the option to disable as listed in the manual as one of the 4 ways to turn it off. And for reference it does not behave the way the manual says about autolocking at 12mph. Its instant lock on key turn on and instant unlock both doors on key off.
View 9 RepliesPhaeton :: Can't Use The Keyless Feature To Lock / Unlock - Immobilizer?
On Friday, all of a sudden I found that I could not use the keyless feature to lock/unlock my car anymore, and when I tried to start the car with the push button, it showed "key not found" "immobilizer activated". By that time, i still could use the remote key to lock and unlock the car, and start up the car with the key blade. After I drove and parked the car, I went to get a new battery for my key because I thought my battery was giving me the trouble. Then I went back to the car, I was still able to lock and unlock the car with the remote buttons, but I cannot start up the car, even with the key blade. So I disconnected both battery, waited and reconnected them, the car is able to start with the key blade, but can no longer lock and unlock with the remote buttons. So I can only lock the car manually now.
Later, I scanned the car, found there are 2 faults. One is an old fault, which is "the antenna in rear bumper has no signal intermittently", and the new fault is "luggage compartment start/access authorization antenna upper limit exceeded", and gave me a time that this occurred, which is exactly when I first found the keyless entry didn't work on Friday.
Passat (B5) :: Remote Unlock Feature - Driver Side Lock Makes Noise But Other Three Doors Remain Locked
I have a 2001 passat that i have had for about 2 months. recently, about 2 weeks ago, i started having problems with the remote unlock feature. it will unlock the driver side door fine, but when i press the unlock button twice, the driver side lock makes a noise but the other three doors remain locked. when i press the unlock toggle on the driver side controls with the window controls, all the doors unlock fine. i have two remotes, one is pretty new and i just got it programmed (within a month) and neither one will unlock all the doors.all the other functions of the remote work fine.
View 4 RepliesFord Excursion :: Rear Hatch With Fresh Lock Motor Won't Lock
About a year ago I put in a new lock motor and it worked fine for a while but has stopped working. Is it the lock motor or something else? It unlocks but won't lock. There is not latch indicator on the upper hatch so it stayed unlocked without me knowing it.
View 12 RepliesFord 6.0L Power Stroke Diesel :: 2006 - ESOF Hubs Won't Lock In Auto
New to the 4x4 6.0 just bought an 06' King Ranch 130K miles. My other truck is a 95' 7.3 non 4x4 now for sale. So the new to me 06' will not lock the hubs in Auto mode but will in Manual. I have good vacuum down to each wheel hub which is where my question is.
The vac port at either wheel I get 20-30hg however I believe this is only because something is plugged. If I pump up my vac tester to ~25hg right at the wheel port the needle doesn't move, holds vacuum, but does not Auto lock the hub. So I pulled out the Manual/Auto hub by removing the 3 torque screws thinking my vacuum should then go to 0 but it doesn't it stays right at ~25hg.
Before I bought the truck there was some work done to the front end. New ball-joints, Rt tie-rod and perhaps a few other things I haven't ID yet. Could my problem above be an axle seal or something else perhaps installed incorrectly causing the small vac hole going down inside the hub to be covered up or maybe plugged somehow? I believe to replace the ball joints the axle, hub and other parts have to be removed, correct?
Ford Super Duty (1999-2016) :: 2001 F250 4x4 - Auto Lock Hubs Are Not Working
2001 F-250 7.3. The auto lock hubs are not working on the truck lock hubs in and all works fine. First thought is the vacuum system has a leak or something of the sort. Had truck at the shop they are telling me the GEM module controls the vacuum to engage the auto hubs and the signal is not coming from the GEM and it need to be replaced. It was the GEM causing the problem.
View 6 RepliesFord Excursion :: Auto Hubs Won't Disengage?
After a lot of reading and troubleshooting, I have come to know that it takes vacuum to engage and vacuum to disengage the automatic locking hubs on the Ford F series and Excursion. Most indications is that ~ 15" hg is required to engage and approximately half that much to disengage them. The mechanism that either engages or disengages them acts similarly to a ball point pen. The full amount of vacuum causes the mechanism to travel to it's limit, where the hub is engaged, whereas half the amount of vacuum applied only causes the mechanism to travel to its midpoint, which is where is should be for disengagement.
In my case, I have tested for vacuum leaks, none are present. I have installed new Ford OEM hub assemblies, a new locking hub solenoid and have tested the function of my vacuum pump. It draws about 13.5" hg of vacuum on the system. I do not have any issues with HVAC controls in the cabin of the truck. When installing the new hubs, I ensured that they are unlocked, the inner spline assy spins freely and once installed, the wheel shaft spins freely by hand. When I shift to 4WD on the dash, the hubs engage and all is well.
Problem I am having is when I shift back to 2WD, the hubs remain locked. I can tell as the wheel shafts are not able to be spun freely by hand. I have tried backing the vehicle, etc. No luck. Furthermore, when monitoring vacuum while engaging and disengaging 4WD, I can see that the full vacuum (~13,5") is applied when engaging. What concerns me is that only 3.5 - 4.0" hg is applied when disengaging. This is certainly not enough to operate the mechanism to the point of disengaging the hubs.
I have considered replacing the vacuum pump as I am only getting 13.5" hg of vacuum, however, when I research the replacement part, many have indicated that a new one only draws about that much, so I do not see the value in replacement.
Have any of you dealt with the same or similar problem and if so, what was your resolution?
Ford Excursion :: Adding Auto And Fog Lights?
Was about to buy a headlight switch with the Foglights option...realized I miss the auto lamps.
Is there a write-up on how to add these? Looked in the tech folder and didn't see one
What parts are needed?
Ford Excursion :: Auto Locking Hubs Won't Engage?
And the vacuum pump was replaced.
View 7 Replies