Ford Super Duty (1999-2016) :: 2002 F250 - No Clutch Safety Switch
2002, F250, 5.4L, ZF-6 trans.
Ok...today by accident turned the key with the truck in gear and clutch not depressed...much to my surprise the truck tried to start and lurched forward.
Is this a sign of a failing clutch safety switch or Could it be an ignition switch problem? Anything else that I am not thinking of?
Ford Super Duty (1999-2016) :: Power Door Will Not Lock / Unlock - Clicking VSM / GEM
I've been researching a problem with my power door lock. On my 2002 F-250 Lariat Crew Cab PSD (not the 76' SuperCab)] since Saturday when they began demonstrating the following symptoms:
1) No response to key fob (either lock or unlock)
2) No response to door switches (initially responded to unlock command only)
3) Whenever the key fob or door switch is pushed, a clicking noise from behind the dash occurs for about 15-20 seconds
4) When the key is in the ignition, the clicking from behind the dash is constant
5) Intermitantly, the actuators attempt to lock the doors when I close the door
6) Intermitantly, the locks will respond to some comands
7) Auto down feature on the driver's door window stopped working.
I found the clicking was coming from a unit behind the radio and just above the transmission hump on the firewall.
There are several threads on power door locks and I thought it might work others to have short summary and some links in one post as I just spent the last two days finding and reading these.
The most popular fix involves pulling the actuators apart to remove a thermistor from the motor that is prone to failure. This apparently rejuvinates the actuator motors and the directions for completing this are listed here Power Door Locks FIXED It's a long thread, but there are lots of step-by-step directions including pictures etc.
I tried this on mine, but it didn't work. The clicking from behind the dash is a different problem. At least when I get this fixed I'll have good actuator motors.
The next most popular fix simply involves spraying WD-40 into the door latches (not the hinges, but the latches). This seems to work for many people who have problems with the dome light staying on and other door switch related problems. Check out Door Open Light On Dash What Up? for more info on that.
I tried this too, but, unfortunately, the clicking is more than can be solved with a little WD-40. The Door Open Light On thread had some references to the Vehicle Security Module.
I found a number of threads on clicking from behind the dash and these threads all seem to point to a problem with the General Electrical Module (GEM) or the Vehicle Security Module (VSM). From what I could find, the VSM may have been a new part introduced in 2002 that replaced the GEM (but I'm not sure about this). Here are a couple of the more useful threads I found:
VSM Theory
Dash Open Light On Dash What Up?
Ford Super Duty (1999-2016) :: 2000 - Power Door Locks / Won't Lock Or Unlock
2000 superduty. When you hit the door lock/unlock button, they try but won't move up or down on any of the 4 doors. The switches no longer are illuminated either. Where or have a wiring schematic for the drivers door with power windows/locks? I have done some testing for power, which seems to me there isn't enough voltage going to the actuators, but I can't seem to find power anywhere. The power mirrors don't work either. All fuses are good.
View 8 RepliesCorolla / Matrix 2009-13 :: Safety Feature - Disabling Auto Unlock?
Is there a way to disable to auto lock on these cars? When I put my car in park it unlocks it for me. Locking it is kinda cool, but not unlocking it. I had a situation a few days ago where I was sitting in a parking lot waiting for my girlfriend to get out of the store when a guy opened my door and tried to get in. He realized that he opened the wrong car door. I really do not want this type of situation to happen again due to the fact that I carry every single day. So, is there a way to disable the auto-lock "safety feature".
View 3 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Factory Key Fob To Lock And Unlock The Doors While Running?
Ok, it's cold out... is there a way that I can use my factory key fob to lock and unlock the doors with the truck running? 2000 F350.
View 10 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Door Locks Unlock And Lock Constantly
2000 f350 7.3 Door locks unlock and lock constantly. Wait to start light and 4x4 lights don't come on. Gauges stopped working and clicking behind dash.
View 1 RepliesFord Super Duty (1999-2016) :: F250 - Hubs Won't Unlock / How To Get Them Functional
I just got a 99 F250 PSD, it had not been in 4wd in a while, now the hubs won't unlock.
My 01 F250 seemed to have strictly manual hubs. Turn right to lock, left to unlock. They may have been aftermarket, but on by the PO. Do I need to put some new Warns on the 99? Or can I lube then up and get them functional.
Ford Super Duty (1999-2016) :: F250 V10 Won't Lock At The Hub In 4x4
What a 1999 f250 super duty triton v10 would have for a front axle and why mine won't lock in 4x4 at the front drivers side hub it have warn hubs and will lock in on passenger side but on divers with ether just grind or not go in at all...
View 10 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Unlock On Passenger Side Does Not Work
I recently purchased a 2003 F-250. The door locks don't work properly, the passenger side will lock the entire truck all 4 door locks actually lock. The unlock on the passenger side does not work and neither does the entire switch in the driver side. I attempted to switch the actual switches from the driver to passenger side thinking that it could be a switch that is broken.
After doing that still only the passenger side would lock and the rest of lock unlock buttons did nothing. I have checked all the fuses in my truck and actually took the door panels off today thinking I might find an obvious problem. I know the actuators are a common problem but because all the locks lock in the vehicle I was thinking it might be something else.
Ford Super Duty (1999-2016) :: 2004 F250 4WD Will Not Lock In For Some Reason
I have an 04 f250 the 4wd won't lock in for some reason. The truck has manual locking hubs (turn them to the right to lock in 4wd or turn them to the left to unlock them) and I get the light on the dash just fine but the truck doesn't actually lock in.
When i I put it in 4 low it feels like it's in but it's not. I also noticed that when I put it in park while it's in 4 low it makes a crazy sound like it would when you put a car in park while you're still moving and the park pin makes that clicking noise.
Anywhere in particular I should start to look? Nothing up in the front end looks abnormal or out of place.
I've had the truck 10 years. Never had any 4wd related issues. I did however replace the transmission in December (and I did successfully use the 4wd after the transmission was installed).
Ford Super Duty (1999-2016) :: 2005 F250 - Transmission Will Not Go Into Lock Up
I am again trying to fix my truck. 2005 F-250 6.0 4wd, automatic. Truck now has 89K on it. Truck does not seam to go into lockup mode while driving down the road. it started just after I spun my wheels in a snow storm. No symptom's previous to this. No codes in dash no lights and also no codes when I checked it with an obd code reader.
View 4 RepliesFord Super Duty (1999-2016) :: 2010 F250 Front Hubs Don't Lock
I have a 2010 F250 with 154000km (96000 miles) that we bought last week. When I was looking it over during the purchase I noticed the front axle didn't lockup in "auto", in manual lock it seemed fine so I figured vacuum leak or something like that. Yesterday morning I was in the yard and got a little hung up in snow drifts so just got out, locked the hubs and switched to 4x4 and I think the front end didn't engage at all.
So later on I had it in the shop installing the two way radio and decided to check the front end out a little more thoroughly. Vacuum lines seem fine, hubs turn fine but I notice the axle shafts both move up and down almost a quarter inch, that seems excessively loose to me. I've been doing some research on the internet and it appears the front hubs are serviced as a unit, also some information seems to point to needle bearings within the actual locking hub mechanism itself?
So the questions:
1. Does that front axle shaft seem excessive? What are the specs?
2. Can I replace bearings and seals only or do these units come only as assemblies? Inner hub, outer hub units? Wheel bearings seem fine.
3. With that much play is there a chance the outer axle shafts are worn also?
Ford Super Duty (1999-2016) :: 2005 F250 - Tailgate Lock Cylinder
I just bought a 'new to me' 2005 F250, Crew Cab with a v10. The Carfax showed up clean but after doing some detailing on it, I realized it had been resprayed and there was a little wrinkle in the bumper. I tried using the ignition key to lock the tailgate but it didn't work, so I'm assuming its been replaced. Need to confirm that the ignition key should be the key that works the tailgate lock or is the tailgate a different key that they guy never gave me?
View 8 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Door Lock Won't Work With Key
I have an issue in the passenger door lock on my 2000 F250. My key rarely works on the passenger door. If it does work it takes a lot of wiggling and trying.
I have power locks that work normally and the key works great on the driver's door. How it works but I've heard there is an anti-theft feature where if you hit the lock button twice on the fob the door locks no longer work with the key until they are unlocked with the fob again. I figured my lock issue was related to that.
How to work on this system? What might cause this?
Ford Super Duty (1999-2016) :: 2001 F250 4x4 - Auto Lock Hubs Are Not Working
2001 F-250 7.3. The auto lock hubs are not working on the truck lock hubs in and all works fine. First thought is the vacuum system has a leak or something of the sort. Had truck at the shop they are telling me the GEM module controls the vacuum to engage the auto hubs and the signal is not coming from the GEM and it need to be replaced. It was the GEM causing the problem.
View 6 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Ignition Lock Cylinder Removal
I bought my 2000 F-250 CCSB a while ago and it came with 2 keys - one for the ignition, and one for the doors/tailgate - may not seem like a big deal, but it annoys me to no end.
From my understanding, the truck had previously been stolen and had the driver's side lock punched, and then something happened to the ignition lock to where it had to be replaced - hence the different key. I finally got around to replacing all the locks so that I'd only have one key. I started with the doors, then moved to the ignition (which I thought would be the easy part). I've replaced several cylinders before and I know it should be simple, but for the life of me I can't get the cylinder out!
I push the detent, turn the key to run, wiggle and pull.... nothing. I can feel the detent push in, and the cylinder will move a little, but it won't come out. I'm not sure if this is something that just happens sometimes and there's a fix for it, or if I'm in a unique circumstance and my column was somehow damaged during the theft and that's what's causing it.
Ford Super Duty (1999-2016) :: Disable The Auto-dim Feature?
When I turn on the headlights of my 2004 sd diesel dually the console readout dims to the point I can't read it. I know about the intensity wheel but it does not have enough to overcome the auto-dim feature. Can the auto-dim be disabled, ripped out, sent to Iran, threatened with a .45? Anything to get rid of it.
View 3 RepliesFord Super Duty (1999-2016) :: Neutral Safety Switch Removal
How do I remove the neutral safety switch? I bought a replacement and am having trouble removing it.
After shifting into neutral, I disconnected the connector, then unbolted the two screws. Now I can't get the little white ring that connects the lever coming from the transmission to the actual switch. I have tried prying it off with a screwdriver, spraying a little PB Blaster to lubricate it a little. Nothing will get it off it seems.
I'm leaving to go back up to school tomorrow afternoon, and I need to have this fixed before I leave.
Ford Super Duty (1999-2016) :: 2005 F250 Steering Stuck Or Lock Up / Jerk When Releases
Steering problem... 2005 F250; Four Wheel Drive; Automatic; 93,000 miles; gas engine. The basic description that I have been giving people is that the steering will "stick" or "lock up" to the point that I have to use some force to get the steering wheel past the stuck point, when it releases, it's a " jerk, " THEN it sticks the other direction and I have to force the steering wheel back the other way again. So, in other words, when the truck decides to do this, in order to drive a straight line I am literally turning the wheel back and forth, probably only an eighth of a turn each way, but back and forth. If it's bad enough, I have to pull the truck over.
If I pull over, sit and turn the wheel back and forth a few times, loosening it up (when I'm stopped, I can't say that I really feel it stick at all), I can pull back on the road and be fine. A lot of the time, it happens right after I've turned a wide corner (not specifically right or left. It does it both ways), say taking a corner at an intersection as a yield or turning through a wide intersection onto say, an entrance ramp to the highway. I would say in a lot of cases, even when the truck doesn't have "an episode," I can still feel a stiff spot when I'm driving down the road/highway. This is not a vibration-type problem.