Ford Excursion :: Adding OEM 2001 To 2004 Fog Lights On 2000 Model?
Looking for a guide to adding OEM 2001 to 2004 fog lights and light switch in a 2000 model?
View 4 RepliesFord Excursion :: 4x4 Selector Switch On Dash Lights Up Properly But Auto Hubs Don't Actually Engage
My Excursion is having an issue with the 4x4 system. The. 4x4 selector switch on dash lights up properly for 4x4, but the auto hubs don't actually engage. The hubs will lock only if I manually lock the hubs. I can hear relay click, so I don't think its electrical. The hubs had new o rings installed when I did front ball joints a few thousand miles ago, and the 4x4 worked fine up until today.
View 5 RepliesFord Excursion :: Adding Hydroboost Set Up?
I am thinking of doing a hydroboost setup on my ex??
View 2 RepliesFord Excursion :: Adding A Leaf On Each Spring?
The local shop here suggested getting a set of F350 springs and they would take them apart and a leaf to the front and rear springs.
View 2 RepliesFord Excursion :: 2000 - Adding 3rd Seat To The Front?
I have the 2000 Ex. Tan leather seats. Two seats in the front. I need to add a third. I used to have a F150, that had a flip up/down center console. It was a seat when flipped up (the console became the seat back). What are my options with the Ex?
View 10 RepliesFord Excursion :: Adding Turn Signal Mirrors?
My driver mirror has small clip failed, only way is a new mirror. I found a pair of mirrors with heat like mine BUT they have the turn signal.
View 9 RepliesFord Excursion :: Wiring Diagram Of Adding Relay?
Working on the dang ram 3500... I am needing to add a relay, however, i need to strap the coil of it with a diode to protect the frigging cluster (the new dodges aren't very mod friendly!). My question is, should I add a second diode before the relay to protect the cluster against back emf, or will the one strapped across the relay coil be enough?
Since I am sure you're curious now, the cargo light (light that lights up the bed) gets its power from the gauge cluster of all places. I need to add a relay to the cargo light circuit to drive some other lights, and I am worried the back emf from the relay coil will fry the cluster circuitry.
Ford Excursion :: Adding Speakers In The Barn Doors?
I am interested in putting speakers in the barn doors of the Ex.
View 14 RepliesFord Excursion :: 2000 - Adding Bluetooth To Stock Radio?
Is there any way to add Bluetooth to the stock 2000 Ex Radio?
View 1 RepliesFord Excursion :: 2006 - Adding Remote Start System?
I have a 2006 F250 and it has the stock keyless entry. I would like to have remote start system as well. I know I can buy an aftermarket system, but I'd prefer to no cut any wires. Is it possible to add on the OEM remote start system that may have been used on a superduty or excision of this vintage? and if so, is it a plug in type installation? or do you still have to cut and splice the stock wiring harness.
View 12 RepliesFord Excursion :: Adding Sliders To The Middle Row Captain Chairs?
My third row gets used once in a blue moon. Usually the first two rows are enough. I have captains chairs but when I put the drivers seat all the way back it doesn't leave the middle row passenger much foot space, especially for how large the truck is. I've thought about buying a set of eBay sliders and putting them between the second row seat frame and the floor. That way I could keep all the factory features like the flip and fold, but still slide them rearward a few inches. I'm not sure I'll ever get around to it but I have had it on my mind a while.
View 12 RepliesFord Excursion :: Adding Kenwood DNN770HD In Dash Unit?
After doing some extensive searching it appears Kenwood is well liked as far as their in dash GPS/touch screen units. I know there is one model above this one that is more expensive and one or two under it without the WiFi features etc. that are less expensive.
Getting ready to pull the trigger on a unit..... Kenwood - DNN770HD
Ford Wiring/Electrical :: Reverse Lights Wiring - Adding 2 LED Spot Lights
What I am trying to do it put in 2 led spot light for added backing up light. What i want to do is have them turn on when put into reverse but also have a switch i can use to turn them on when not in reverse. Just need to know what relay I need and if it even can be done.
I was also thinking of just taping into the wiring harness and adding a wire that goes to the spot lights and another wire that goes to a switch that I could turn on and supply power to the light when not in reverse (I know it will light the revers light also) but is it ok to do that?
Ford F-150 (2004-2008) :: 2006 - Adding Reverse Lights To 7 Pin Connector
For our new pontoon with surge brakes I need to add reverse lights to the wiring harness to deactivate the surge brakes while backing up. What is the proper way of doing this? BTW this is on an 06 F150 XLT with factory 7 pin harness.
View 4 RepliesFord Super Duty (1999-2016) :: Adding Fog Lights To 2012 F250 XLT?
I read in a thread about how fog lights need the auto light sensor or something in the kit to be installed and flashed.
My truck is a 2012 f250 XLT that I bought left over from a podunk town IN illinois. It does not have fog lights but it Does have automatic head lamps. So Im very confused on what kit to order to add fog lights to my truck.
Ford Super Duty (1999-2016) :: 2008 F350 - Adding OEM Fog Lights?
Have an 08 f350 xl and was looking to put oem foglights into the bumper where mine has the block out 's, guess what I am asking is if the wiring is already there as it was on a different vehicle I owned ,basically it was a plug and play ,have only had the truck for a week and with the hours I'm working I really haven't had a chance to crawl under and look for the wiring.
View 3 RepliesFord Super Duty (1999-2016) :: 2004 - Adding Stock Driving / Fog Lights To XLT?
I have a 2004 F250 and would like to have more light in front of me. I looked under the front to where the stock fog light would get mounted but I don't see any wire harness in that area. What is involved if I pick up a pair of replacement fog lights like the offer at LMC Truck. Would i need buy a harness? And what about a switch?
View 11 RepliesFord Super Duty (1999-2016) :: Adding LED Lights To Dome Light Wiring
I would like to add an LED light to each running board and tie it in with the dome light wiring so that when the door(s) are opened it will come on with the dome light and light up the factory running board. Any info on where a good place to splice into the wiring, and will the wiring be able to handle a couple extra lights?
The truck is a 2012 F-350 XL, SD Dually....
Ford Super Duty (1999-2016) :: Adding Running Lights To Step Bars?
I am a trucker at heart and I like to add running lights to my running board / step bars. As far as installation of the lights, done it several times, no problem there. However in the past, I have just ran a wire back to the trailer plug and used a scotch lock / snap connector to feed the running board lights.
If I do the same on a 2012, will that cause havick with the computer? Most likely I will be running 7 lights, all 3/4" diameter LED style. If this isn't' the best solution, then where to get power for marker lights.