Elantra XD (2001-06) :: Manual Transmission - Thump When Shifting
I've been hearing a quiet 'thump' when shifting. In particular, when first letting up the clutch starting out in 1 but also when shifting between gears when the clutch is fully down such as from 2->3.
I thought perhaps a fluid change was in order since I'm at 110,000 miles. It didn't make any difference. (I used Mobil 1 GL5 which according to independent tests is safe on yellow metals.)
So then I wondered if it's the engine mounts, but I'm not sure what it sounds like when they need to be replaced or if simply shifting between gears while driving as described above would cause a worn one to 'thump'.
Elantra XD (2001-06) :: Manual Transmission Always Pops Out Of 2nd Gear To Neutral
I have a 2005 Elantra GT hatchback that I love with a 5 speed transmission. Lately every time I'm in 2nd gear, the transmission will pop out of 2nd into neutral. This only happens in 2nd gear. I heard it could be the shift collar (i.e. teeth?) that aren't grabbing in that gear.
View 5 RepliesVolvo :: 1988 / Manual Transmission Stuck In 4th - Shifter Freely Moves
last night I was on my way to work and had the car in forth traveling about forty-five. A light ahead of me turned red and I held the clutch in until I had stopped. I shifted into what I thought was first. I discovered that regardless of the shifter position, the transmission left it in forth gear. Barely got it moving from a stop and brought it back home.
Looking under the car, I don't know exactly what the linkage mechanism looks like. I'm not sure how to tell if it has been disconnected or misaligned. I don't know if the problem is in the transmission itself either. The shifter moves to other positions freely, but in actuality it stays locked in forth gear.
Ford 6.0L Power Stroke Diesel :: Location Of Manual 4wd Shifter Mounts To Transmission?
I cannot locate a picture of where the manual 4wd shifter mounts up to the transmission.
I am finishing up 4wd'ing my F550, but am not exactly sure how the shifter bolts up. Can someone take their boot and bezel off and take a couple photos of how the shifter mounts to the 5R100W by any chanc?
Santa FE SM (2001-06) :: Gear Shifter No Longer Moving Easily
When I went to put my car into gear today (automatic gear box, 2004) the gear shifter was very hard to move, as if whatever automated its ease is no longer functioning. And i'm pretty sure the steering and brakes are not performing with their power aided functions either. Is this a set of servos all on one line somewhere? Fried? Just a fuse?
View 6 RepliesElantra MD (2010-15) :: 2011 - Transmission Started To Grind When Shifting
I purchased my car almost two years ago. I drive a lot for work, and my car now has 74000 kilometers on it.
So far its gone thru 3 CV Axle Joints on the drivers side, a radio unit, clutch bearing, fork, and fulcrum, and now there's something wore out in the rear suspension (squeaking and snapping).
The transmission in mine has also started to grind when shifting like the syncros are wearing out. Motor knocks when it's cold, sounds like the top end goes dry of oil when sitting overnight and takes awhile to get any.
Elantra MD (2010-15) :: Manual Transmission And Stalling
When first drove the new Elantra, I stalled it more than should. At first I figured I was just new to the feel of the clutch, and not in tune with the hints of RPM given by the motor's sound, etc.
A couple of times after stalling, I pulled the shifter to a middle neutral, and then back in 1st, and now it really felt like it was in 1st. Eventually, I developed a quirky habit of shifting out of 1st to neutral and back to 1st every time I stopped. My kids commented on it and they don't even drive.
A couple of times I've cautiously done this test, and it proved my suspicion. Suppose you are coasting at a speed of around 40 mph or 60 kph, and intend to come to a stop ahead. I typically push the clutch in and coast, then brake. Somewhere along the coast to stop, I will also put the gear into 1st. I've discovered that if the gear shift is put into 1st while the coast speed is sufficiently high, the actual gear selected is 3rd. Then, when you start to pull away from the stop, the engine stalls.
If anyone tries to reproduce this shift into 3rd when 1st was intended while still coasting, be careful and let out the clutch slowly at the early part of the release so you will get a hint from the engine RPMs what gear it is heading toward. I don't want to be responsible for wear and tear on your transmission/engine or accidents. I've only attempted this test on a road with no traffic, myself.
Although what I am claiming sounds wacky, I think it is possible, given that transmissions over the years have been moving towards electronic rather than physical linkage.
Golf IV R32 :: Shifter Moving Slightly Side-to-side While In Gear - Shifter Cables Need Adjustment?
I recently changed the bushings and installed SS kit. I don't know if this was the case before, but now while in any gear, i can still move it approx half inch to the right and half inch to the left.
I checked everything and all screws are tight. Could it be that the shifter cables need adjustment?
Elantra MD (2010-15) :: Manual Transmission - Cruise Inoperative In 6th Gear
I've been working on a cruise control issue on & off for about a year now. Vehicle is a 2011 UD Elantra with a 6 speed manual trans. Problem is cruise won't set in 6th gear. Works perfectly in 2nd through 5th gears.
Cruise power light stays on but won't set. Upshift indicator working correctly. I've had Hyundai field service engineers look at it 3 times with no luck. Vehicle has no fault codes at all. All switch & sensor inputs are correct. The only vehicle I had with a man. trans. to compare to was a 2013 MD. Cruise worked fine in 6th on that vehicle. The last word we got from Hyundai (supposedly from Korea), was that this is normal and cruise on that model is not supported in 6th gear. I find this hard to believe but I wouldn't doubt this is a programming issue. 6th gear should be the most used gear for cruise operation.
Hyundai - Elantra :: Manual Transmission - No 1st Or 2nd Gear On Cold Start
My 2005 elantra 5-speed had typical clutch issues. Had a new one put in where i worked which repaired dump trucks and dumpster roll-off trucks. Got in the car and still had similar issues. I say similar because now when i start it cold, i have no 1st or 2nd..start moving in 3rd and drop into 2nd. After about 10 minutes of driving, you can chirp the tires in 1st. Could they have put gear oil that was too heavy and it needs to get warmed up? Does this sound possible? Should I change the gear oil?
View 3 RepliesElantra MD (2010-15) :: Transmission Shifter - Gear Selector Would Get Stuck In Neutral
Just got my 2013 Elantra Limited last weekend. It appears the car is having some issues with the transmission shifter. I am not sure if its tranny related, but I highly suspect it is. Dealer gave me the usual bs not being able to duplicate the symptoms.
1. Intermittently, gear selector would get stuck in neutral, when I try to put the car into P, after a long or a short drive.
2. I would have to wiggle the shifter to get into P, or I would have to shift to D, and then I am able to shift back into P.
Elantra XD (2001-06) :: Shifter Seems To Be Very Slightly Loose
My 2006 Elantra is having a problem I think within the shifting box area. When the cars and park I have a 50-50 chance of the vehicle starting. This does not have anything to do with the break or the switch on the side of the shifter. The transmission while driving is fun and there is no slippage between the gears.
I've opened up the gearbox area and I found we're at the shifter hard into park forwards the car seems to start more consistently. The shifter seems to be very slightly loose. The little orange marks indicating the placement of the shift is not "aligned" with park. It's a bit off. However when I opened the gearbox and I push the cable on the right of the shifter forwards and turn the key, the car consistently starts. Now, I'm wondering if this problem with the cable or maybe a switch in the front? Parts to replace?
Elantra XD (2001-06) :: 2002 - Temperature Gauge Not Moving At All
My car (200,000kms - 5spd). Just noticed today that the gauge is not moving at all. Heat comes out of the dash vents no problem. Could it be the thermostat? Or is it the gauge it's self?
View 2 RepliesElantra XD (2001-06) :: Shifter Doesn't Stop At D When Shifting Out Of Park
I recently purchased a 2005 Elantra Automatic, my question is, when shifting it out of park, the shifter doesn't stop at "D" but at "3" is there an adjustment or is it just a quirk of the car?
View 2 RepliesElantra XD (2001-06) :: 2005 - Shifter Is Stiff When Shifting Different Gears
The gear shifter in my auto trans 05 Elantra is really stiff when shifting different gears. I was running fine as I went to work and back today with no problems. After I got back from work, the car was off for 30-40 mins. Then I went back and started the car and the gear shifter was stiff but still shiftable. I checked under the car to and fluid leaks but didn't see anything. What may be the issue here?
View 3 RepliesElantra MD (2010-15) :: Manual Transmission Loose - Gears Make Noise As Shift From Coast To Drive
Ok so my transmission feels loose, too much play between the coast and drive side of the gears. Makes enough noise now that my wife complained about it so I'm looking into taking it to the dealer. I pretty much expect them to pass this off and do nothing, but its getting worse especially in the last couple of months.
Noticed a lot of play in there gearbox? Can you hear the gears make noise as they shift from coast to drive side?
Elantra XD (2001-06) :: Temperature Gauge Needle Is Moving Up And Then Back Down
The needle is moving up and then back down. This mostly happens while at a stop and simultaneously the ac compressor kicks off.
Recently new radiator and temp gauge, plus coolant flush.
Golf IV / Jetta IV :: 2001 - Shifter Won't Shift The Transmission All The Way?
I have an 01 Jetta, 2.0L, 5 Speed manual transmission.
The issue seems to be that the shifter wont shift the transmission "all the way" into 1st, 3rd, and 5th gear. When I shift into the gears that are forward on the shifter, it will go into gear, but then the shifter (in the car) moves back toward neutral a little. I can drive in 1st no problem, but in 3rd and 5th some weird stuff happens...
While driving, when I shift from second to third I have to keep my hand on the shifter otherwise I get kicked out of gear. Also, when I drive on the highway, I periodically get kicked out of 5th gear if I don't keep my hand on the shifter (usually, when I let off the gas).
Anyway, being that I've fixed many problems on many cars by searching forums and google, I spent the last few days trying to figure out the problem by looking through the forums, but I have yet to find a solution. I tried adjusting the shift linkage using the method described in the dieselgeek video on youtube [URL] ...., but it didn't work. I'm pretty certain it's not the shifter bushings because i have almost no play in the shifter in neutral.
I had someone cycle through the gears while I watched under the hood, and its clear that the cable that controls the forward and back part of the shifting is not pulling back far enough on the counterweight on the transmission. (When shifting into 1st, 3rd, and 5th.) When the shifter puts the tranny into these gears I can still move the counterweight on the tranny further than the shifter will pull in in the same direction.I tried adjusting the linkage to compensate for this, but the cable is as far into the cable end as it will go...
Elantra XD (2001-06) :: 2002 - Improper Shifting / Trans Moving To 3rd Gear
After car warms and while driving trans moves to 3rd gear and stays ??
View 2 Replies