Golf VI R :: Shifter Squeak When Moving Side To Side
Experiencing stock shifter squeaking when moving side to side?
View 10 RepliesGolf IV R32 :: Shifter Side To Side Movement Sluggish - Cause?
So I have been noticing the spring when the car is neutral is VERY slow to react or the car doesn't center back if you move it side to side. What causes this in terms of which shifter spring/cable controls that? I'm not sure if that piece is in the car under the shifter OR in the engine bay. I'm thinking the springs or plastic over the years is finally shot so shifting has become rather sluggish. Gets worse as the car heats up.
View 3 RepliesSanta FE SM (2001-06) :: Gear Shifter No Longer Moving Easily
When I went to put my car into gear today (automatic gear box, 2004) the gear shifter was very hard to move, as if whatever automated its ease is no longer functioning. And i'm pretty sure the steering and brakes are not performing with their power aided functions either. Is this a set of servos all on one line somewhere? Fried? Just a fuse?
View 6 RepliesFord Excursion :: Reverse Lights And Back Up Alarm Will Not Engage - Gear Shifter Adjustment?
My reverse lights and back up alarm will not engage unless i hold up on the shifter while in reverse the only thing i found was a adjuster for the indicator....
View 14 RepliesGolf IV R32 :: Cable Shifter Adjustment Gone Wrong?
Ok so I was putting a drill bit into the home slot under the shifter boot. I didn't realize it was so deep and the piece dropped all the way down the hole. Is this bad? If so, what can I do to get in there and get it?
View 5 RepliesGolf IV / Jetta IV :: Quick Shifter Linkage Adjustment (O2M Transmission)
So I just got 42dd shifter bushings and im having some issues!
Installation was no problem but once you complete the install you are supposed to re-adjust the linkage. First you have to lock the shifter in place, both in the cabin and in the engine bay (as shown in this Diesel Geek video: [URL] .... )
The only trouble I'm having is that i cannot locate the locking pin as shown in this integrated engineering picture: [URL] .....
Golf IV / Jetta IV :: Shifter Adjustment - Cannot Get Transmission Into Home Mode
When going to adjust my DG shifter since it wouldn't go into first I noticed that my L-shaped lever (02J-301-358C) on the tranny was more out then usually and could be pulled straight out with no resistance. I am guessing the piece at the end is also broken and will need to be pulled out, but how will I put the transmission into home mode after?
View 8 RepliesGolf IV R32 :: Could Not Get The Shifter To Get Over To 1st Or 2nd Gear
So i was driving home from work yesterday and out of no where i couldnt get the shifter to get over to 1st or 2nd gear. i had to wiggle it around and push down on the shift knob and it eventually went over. Happened a few more times yesterday and like twice on my way to work today. It feels kind of sticky or something, not really moving as freely as it used to. What could be causing this?
View 6 RepliesGolf IV / Jetta IV :: Shifter Would Not Go Into Any Gear
The issue with the car is that the tranny won't go into any gear. With clutch in or out. I had very little play left or right or up and down. Not sure what could be wrong. The car has 120k miles and no mods.
View 2 RepliesGolf IV / Jetta IV :: Wobbling Of Shifter While In Gear
I have the 20th anniversary GTI with the 6-speed manual at 90k miles
I have the Dieselgeek Short shifter installed so for the most part my shifter is nice and tight/precise. However, I have some play in the shifter while it is in gear and I understand that this is normal for a car as it ages. But I assumed that the Dieselgeek would've solved all the gear slop in my shifter, and I was wrong.
So is there a part I can replace to tighten it back up?
Golf IV / Jetta IV :: Hard To Get Shifter Into Gear
When the car is in gear it's great! Or at least it seems great. However, trying to place the Shift Lever in the car into the gear "slots?" is troublesome.
It feels as though there is a wall in the way for each gear, and i have to force my way through the wall. It's not absolutely Terrible, for i've been driving like this for months. But i want a smother shift! I want to be able to just slide the Shift Lever into gear without any hangups or major resistance.
Double Clutching seems to work, however it might just be from the small loss of RPMs through the process of double clutching.
Personally I would rather not have to double clutch just to see a slight improvement. I have big feet and they constantly are rubbing on the floor mat as well as the plastic above the pedals, so double clutching always feels like i'm wedging my foot into a hole, then back out and in, before i can go into another gear lol.
The problem is only a real issue when i'm in higher RPMs giving the car more gas. I.E. after a fast launch in first, shifting even around 5500 puts a WALL up on second gear making it impossible for me to get it into second gear, after not getting it into second i usually throw it in third, and essentially lose all the acceleration i had from the first gear launch.
As well is there anyway to make the clutch a little stiffer? She grabs fine, i just like stiffer clutch, it requires less of me trying to wedge my huge foot on the pedal.
It's an un-molested MKIV Jetta VR6 with 167k.
Golf IV / Jetta IV :: Shifter Pops Out Of 3rd Gear When Let Off The Gas
My problem is that it pops out of 3rd gear when I let off the gas. I have had this problem before so any tips on setting my shifter linkage?
View 5 RepliesElantra XD (2001-06) :: Shifter Seems To Be Very Slightly Loose
My 2006 Elantra is having a problem I think within the shifting box area. When the cars and park I have a 50-50 chance of the vehicle starting. This does not have anything to do with the break or the switch on the side of the shifter. The transmission while driving is fun and there is no slippage between the gears.
I've opened up the gearbox area and I found we're at the shifter hard into park forwards the car seems to start more consistently. The shifter seems to be very slightly loose. The little orange marks indicating the placement of the shift is not "aligned" with park. It's a bit off. However when I opened the gearbox and I push the cable on the right of the shifter forwards and turn the key, the car consistently starts. Now, I'm wondering if this problem with the cable or maybe a switch in the front? Parts to replace?
Golf IV / Jetta IV :: 03 - Shifter Stopped Engaging 1st Or 2nd Gear
My03 GLI will not engage first or second gear.
This morning, i was having some issues getting the car in reverse, but it eventually engaged and is fine now. I drove to the barbershop, and on the way home, the shifter stopped engaging 1st or 2nd gear. it moves freely into position (TOO FREELY) and all other gears will engage. common sense tells me that the clutch is fine and the problem is with the shifter.
Golf IV / Jetta IV :: Cannot Shift Into Any Gear / Shifter Just Flopping Around
I have a 5 speed 01 wolfsburg. I was about to leave my driveway tonight and went to shift into 1st and the shifter was all loose. I could not shift into any gear, the shifter was just flopping around. Earlier in the day the neutral jiggle was much looser than it usually is, which I thought was peculiar.... So I guess that was it breaking.
Question is: how do I fix it? I looked under the hood and all of the linkage to the transmission looks good, I think it has disconnected/broken under the shift knob... I've looked around online and cant find anything for this year... or replacement parts for that matter.
I guess im going to have to get the car up on jacks and remove the heat shield to get to the bottom side?
Golf/GTI VI :: 2012 - Shifter Squeaking When Changing Gear?
It happens when there's side to side movement or any gear change. I've tried spray/grease nothing seems to be working. I've read on other forums people replace everything under the boot only to have it return in a few months. I would really like to have this this squeaking gone. Cars a 2012 GTI
View 13 RepliesGolf IV / Jetta IV :: Shifter Got Stuck And Won't Budge Out Of 5th Gear?
I'm having an issue with my clutch and I'm really in a hole. Two days ago I was driving my car and everything was fine. Later in the day the shifter got stuck and would not budge out of 5th gear. Eventually it popped out. Driving like normal again and then yesterday I was on my way home from work and all hell broke loose. I was a mile away from my house and the car would not shift into any gear without a fight.
I also at this time lost my clutch pedal. It went really soft but did come back up.. it would not engage however. Limped it the rest of the way home and took a look at it. What I came across was a full brake/clutch reservoir, no leaks around the slave, and I didn't see any leaks around the master. I will say that after the car sat for about 10 mins the pedal felt normal again but quickly went soft after a few pumps.
2.0 AEG 5spd. Trans code DZQ if any of that would be relevant..
Golf IV / Jetta IV :: Car Starts In 4th Gear After Replacing Shifter Solenoids
I have a 2000 Golf GLS which I tried to replace the shifter solenoids on and since I replaced them it shifts very very incorrectly it almost feels as if it starts in 4th gear and works its way to 1st.
View 2 RepliesGolf IV / Jetta IV :: When Shifting Into Third Gear Sometimes Shifter Does Not Move All The Way Forward
I have a 2004 2.0L Jetta with a 5 Speed manual transmission.
When shifting into third gear sometimes I push the shifter forward and it does not want to move all the way forward. It feels like I am pushing the shifter knob against a wall, or more accurately the bottom of the shift that pulls the cables feels like it is hitting a wall. If I pull it back out and press it in hard it will go into place sometimes.
This also solves the problem: While the shifter is mid shift into third, at the wall/ at the point of resistance, I let off the clutch slightly to give the flywheel some friction. This rolls the transmission a bit and allows third gear to slide into place.
I have experience with a MK4 Audi TT 1.8T that cam with a 6-SPD and it at had a 1-2 and 2-3 synchronizer issue (The one where the nipples are worn and it grinds at higher RPMS because they can no longer make a firm handshake). The issue I am experiencing is not that.
Could it be the transmission cables? Could it be some other cogs in the transmission? - If so does this mean I need to buy a used one? My car has 180K miles on it with the original clutch.