Santa FE SM (2001-06) :: Gear Shifter Very Hard To Move And Doesn't Really Go In Park?
This morning as I get in to drive my kid to school (2005 2.7 2 wd auto) as I go to put it in reverse I noticeably have to pull it with some force. I have never had to "force it" before, it had always switched gears with ease. This time it felt very stiff but had no issues going into gear. After I dropped my son off at school I went through the gears up and down and it felt very stiff (at this point i have no issues with starting it or P).
At lunch I go out to get something to eat and when I go to start it up it won't start. I try and try and nothing. All the lights came on, it's not a battery issue at all (brand new). But after 10 tries it starts, so I'm pretty happy. Then I go to put it in gear (reverse) I can not press in the button on the side of the gear shift. It will not go in. I press with all my might and it wont budge. But again, after about 10 good tries at it goes in and I can then select my gear but still feels very stiff.
After stopping again I didn't shut off the engine and dicked around with the shifter basically figured out that my car is not recognizing Park. On the instrument panel each gear lights up but not P. It gets very stiff when trying to put it in P but it doesn't actually go into P. If I put it in P (or really the further up it will go) and shut off the car, it won't start again. I can start it up in N and only N.
Elantra XD (2001-06) :: 2005 - Shifter Is Stiff When Shifting Different Gears
The gear shifter in my auto trans 05 Elantra is really stiff when shifting different gears. I was running fine as I went to work and back today with no problems. After I got back from work, the car was off for 30-40 mins. Then I went back and started the car and the gear shifter was stiff but still shiftable. I checked under the car to and fluid leaks but didn't see anything. What may be the issue here?
View 3 RepliesElantra MD (2010-15) :: Click Sound In Shifter When Come To A Stop?
I know its a normal function of the car, but has noticed when you come to a stop at a light or what not, you hear a click, like a servo or something in or near the shifter (automatic). Not worried, just would like to know what it is that clicks and why?
View 8 RepliesElantra GD (2013+) :: Not Shifting Out Of Park
My 2013 Elantra won't shift out of park. I know that I should check fuses, but what fuses might be associated with this. (The brake lights are not affected).
View 2 RepliesFord Ranger / B-Series :: 2001 - Copper Cable Doesn't Move When The Shifter Does
After taking apart my instrument panel to change the bulbs, I went to reconnect everything, but now the gear shift indicator isn't working. I can change gears fine, and everything else on the instrument panel works just fine.
The copper cable that connects to the shifter doesn't move when the shifter does. Is there a way to fix this problem, or do I need to find a replacement cable?
Ford Escape / Hybrid :: 2001 - Cannot Move Shifter Out Of Park / Safety Interlock
While traveling I made a fuel stop. Restarted engine fine, stepped on brake, but could not move the shifter out of Park. Towed to Ford dealer, after extensive trouble shooting replaced shifter cable and transmission position sensor. A week later same problem but glad I learned about the interlock override lever on the steering column so can continue to drive. It locks up several time a day. Here's what I know and observe.
. brake light switch appears to be normal
. engine starts normally
. brake lights operate normally
. fuse on interlock function is ok
. when the lockup happens the shift indicator is missing the box over the P
. this may not relate but backup/reverse lights operate very weird - in reverse they only light when the engine in rev'd and go out when the gas pedal is released
There appears to be a gremlin in this Escape that eludes Ford and me. I read some reference to a computer control involved in the interlock function. I'm at a loss.
Elantra MD (2010-15) :: Cannot Shift From Park To Drive / Electric Windows Doesn't Work
I own a Elantra 2011 and I have a major problem. I cannot shift from PARK to DRIVE and my electric windows doesn't work either ! Everything else working fine and the car start normally !! The dealer cannot find the trouble and the car just have 19802 KM on it!!
View 3 RepliesElantra MD (2010-15) :: One Clink / Ping Sound When Shifting From Park To Reverse?
It only really happens when the car has not been warmed up, like first thing in the morning. Aside from the noise, the car shifts and drives normally. Noise just developed, 28k on the car, it is a 2012 elantra. As I shift from P to R while backing out of my garage there is a metallic clink/ping as the transmission engages.
It is not a CLUNK sounds, it is deff more on the side of a metallic clink...
Elantra XD (2001-06) :: Shifter Seems To Be Very Slightly Loose
My 2006 Elantra is having a problem I think within the shifting box area. When the cars and park I have a 50-50 chance of the vehicle starting. This does not have anything to do with the break or the switch on the side of the shifter. The transmission while driving is fun and there is no slippage between the gears.
I've opened up the gearbox area and I found we're at the shifter hard into park forwards the car seems to start more consistently. The shifter seems to be very slightly loose. The little orange marks indicating the placement of the shift is not "aligned" with park. It's a bit off. However when I opened the gearbox and I push the cable on the right of the shifter forwards and turn the key, the car consistently starts. Now, I'm wondering if this problem with the cable or maybe a switch in the front? Parts to replace?
Elantra MD (2010-15) :: When Accelerate While In Drive From A Stop Car Doesn't Seem To Shift Up
I started to realize something very weird in my car. While in drive from a stop I would accelerate and the car doesn't seem to shift up when its suppose too. I know that my car shifts around 2.1k RPM smoothly into second gear but now it would go all the way up to 3K RPM and slams into second gear which is really weird. Sometimes it does this problem and sometimes it doesn't. I would say 70% it would slam into gear. Not only does it slam but it would seem like this car does not want to shift at the proper rpm even when i foot is on the gas pedal very lightly.
Once I got home I tried some stop and goes and see if the problem persist. It still did. Then I tried doing shiftronic and from first gear once the line touches 2k RPM i shift up and yet it would still lag and the needle would go up to 3K RPM once again. This seems like a very bad problem especially MPG wise. I am still under warranty, I think because I've only swap the air filter with a drop in K&N and just plasti dipped my wheels and such.
Prius (Gen 1) :: 2001 - Shift Lever In Park Doesn't Lock Transmission
I have just bought a 2001 Prius with 127,550 miles. Hybrid battery has been replaced with a used one and all systems seem to work fine except the shift lever in the "Park" position does not lock the transmission. No big problem as long as the Parking Brake works. Preliminary investigation does not reveal any easy fix.
View 6 RepliesElantra XD (2001-06) :: Manual Transmission Grind When Moving The Shifter From 1 To 2
I recently started having an issue where when I shift from 1 to 2 I'll get a quick grind of the gears. Here are the circumstances:
- the clutch is completely depressed, just the act of moving the shifter from 1 to 2 causes the grind.
- only when the car is moving.
- one time I was driving and coasting for a while just shifting back and forth from 1 to 2 with the clutch fully depressed and it kept happening.
- if I shift really slowly I can usually prevent it from happening, though I don't think it's RPM related.
Elantra GD (2013+) :: Cruise Control Doesn't Work Until Stop Completely
I almost always use my cruise control. When I turn off my car then restart under 2 minutes, the cruise control doesn't work UNTIL I stop completely.
When I turn off my car over 2 minutes then restart, cruise control works fine.
Is something not resetting right or something? It doesn't bother me.. I just have to restart my car after 2 minutes so my cruise control works.
Elantra MD (2010-15) :: Clicking Noise When Shifting And Moving From A Full Stop
I am hearing a clicking sound when shifting and perhaps an unrelated but similar click when I am pressing the gas peddle from a stop. Perhaps a CV joint? I'm taking the car in to the dealer (approximately 79,000 km or 48,000 miles) on the 20th to give the car a once over.
View 6 RepliesHyundai - Elantra :: Creaking Noise Right After A Stop / When Weight Is Shifting Back
My 2003 Hyundai Elantra makes this creaking noise when I come to a stop. It seems to make it when the weight is shifting back from a stop. It's not a brake noise. I've checked my brakes and they're fine. It's not even close to a brake noise. I was thinking it was the shocks or springs since it only does it after I've stopped. It makes this noise also while I am stopped and if I shake the car a little. Not too sure what this noise could be. I'm also hearing a new noise in the front. It a loud squeaking type noise that only happens it seems when I am stopping going down a hill or on hard turns. It gets very loud and I kind of feel a grinding in the pedal when it happens.
View 5 RepliesElantra XD (2001-06) :: 2002 GLS Cranks But Doesn't Start (sometimes)
My 2002 Elantra GLS seems to have some sort of heat related problem.
I live in Arizona, where temperatures routinely reach well over 100. In the morning my car will start fine, after driving it for some time and parking somewhere, if I try and start the car within a couple hours of driving it, it will crank but not start. Lifting the hood to cool it seems to expedite this to get it started.
I had a mechanic friend of mine hook up his OBD computer at his shop, nothing out of the ordinary. He suspected either a crankshaft or camshaft position sensor. No check engine light, nothing out of the ordinary on his computer check. I removed spark plug wires for cylinders 1 and 4 and I have spark while cranking when it fails to start. My mechanic friend said the spark would rule out a faulty crankshaft position sensor. I have also tried spraying starting fluid into the intake manifold, and it has no effect. The battery has been replaced within the last two months, connectors are new as well.
Elantra XD (2001-06) :: Idles Erratic While In Park
I have an 01 elantra that idles erratic while in park. Also when i remove plug wires from the number one and three cylinders it will smooth out which doesn't seem to make sense to me because they are being fired from different coils, but if i pull two or four it continues to rev. Could this be a timing issue, I have been told that it could be the IAC as well as the cruise control module, what was it?
View 1 RepliesElantra XD (2001-06) :: Erratic Shifting At Around 40 Mph
I have a 2001 Elantra GLS. The tranny shifts smooth. At around 40mph, it wants to shift into what I guess is overdrive. At that speed it is like it can't figure out where it wants to be and will down and upshift. Aside from that the tranny has no other problems.
View 5 RepliesElantra XD (2001-06) :: 2002 - Shudders And Doesn't Accelerate Well When Going Uphill
I've been having problems with my '02 Elantra. It shudders and doesn't accelerate well (or at all) going up hill, or attempting to accelerate quickly (like passing a car on the interstate). If I try to push it through these situations it will run worse, engine light flashes, and sometimes will stall. In the past, when it stalled, it would start up again in about 30mins or so.
Codes it has thrown were P0304, P0303, and P0420.
When I took it to mechanic, he really couldn't figure it out. He ended up testing and replacing fuel pump motor in November. Got it back and within a few days it was throwing same codes and having same symptoms.
Everything else from this point as been DIY. I bought a manual, researched these forums, learned as I went, and did the following myself:
I changed the spark plugs and wires. Still ran as described above but at this point when the engine light comes on, I am only down to the P0304 code right now.
Thought perhaps it was a vacuum leak. I have very few tools, and Autozone said I could use seafoam as a means to tell if I had a leak if smoke came out of vacuum lines as I put it in. I tried this, none came out of vacuum lines that I could tell. I drove it after seafoam, some white smoke came out tail pipe from solution but dissipated after driving a little while, and then I had the shuddering issues and loss of power while driving the interstate. It literally would act like I wasn't pressing the gas peddle, then suddenly surge as if it realized I was... engine continued to run until I pulled over and then it stalled. Normally it would start right back up after 30mins or so. But this time it didn't, I had to tow it home.
With a crap load of starter fluid and jamming the gas pedal, I finally got it to start. It ran horribly at idle, had a weird knock. So I didn't drive it and did the following instead.
I replaced the coil pack.
Replaced crank position sensor.
I confirmed that I have spark on all 4 cylinders.
There are no obvious oil leaks (nothing on garage floor and I don't see any obvious signs of wet oil on engine or smoke when it runs)
Temperature is fine, coolant level is normal & hasn't needed refill or topping off.
I pulled the fuel pump again, noticed that the fuel sock had holes and was full of muddy/pasty type crap. Gas was dark, cloudy in spots, and appeared to separate in some areas.
Replaced fuel sock.
Syphoned gas.
Thoroughly cleaned out gas tank.
Put premium gas in.
Manually cleaned fuel injectors.
Reassembled and it started right up, runs strong, no more weird knock, but the other symptoms start to reappear... the shuddering, loss of power, and stalling. Its intermittent... sometimes when I jam on the gas peddle, sometimes when I'm cruising at low speeds. I can force it to stall by jamming on the gas peddle to the floor, acts like it's choking, engine light flashes, lose power, then it stalls. Pretty much every time I push it like that.
I can continue to limp it to Autozone for codes, but the engine light currently isn't on.... and it usually takes it a hard drive pushing it through the symptoms for the light to appear, and it's always been the P0304 code at this point.
Is there anything else I can do from home with no special testing equipment?
Is there a part or sensor that would cause these symptoms and NOT throw a code other than the misfire?