Santa FE SM (2001-06) :: Shifter Pops Out Of 5th Gear
The shifter will not usually stay in 5th gear for very long. The clutch and flywheel were replaced a few weeks ago just before i purchased the car but this problem has only cropped up in the last week. Could it be shifter linkage adjustment?
View 3 RepliesGolf IV R32 :: Shifter Moving Slightly Side-to-side While In Gear - Shifter Cables Need Adjustment?
I recently changed the bushings and installed SS kit. I don't know if this was the case before, but now while in any gear, i can still move it approx half inch to the right and half inch to the left.
I checked everything and all screws are tight. Could it be that the shifter cables need adjustment?
Santa FE SM (2001-06) :: Gear Shifter Very Hard To Move And Doesn't Really Go In Park?
This morning as I get in to drive my kid to school (2005 2.7 2 wd auto) as I go to put it in reverse I noticeably have to pull it with some force. I have never had to "force it" before, it had always switched gears with ease. This time it felt very stiff but had no issues going into gear. After I dropped my son off at school I went through the gears up and down and it felt very stiff (at this point i have no issues with starting it or P).
At lunch I go out to get something to eat and when I go to start it up it won't start. I try and try and nothing. All the lights came on, it's not a battery issue at all (brand new). But after 10 tries it starts, so I'm pretty happy. Then I go to put it in gear (reverse) I can not press in the button on the side of the gear shift. It will not go in. I press with all my might and it wont budge. But again, after about 10 good tries at it goes in and I can then select my gear but still feels very stiff.
After stopping again I didn't shut off the engine and dicked around with the shifter basically figured out that my car is not recognizing Park. On the instrument panel each gear lights up but not P. It gets very stiff when trying to put it in P but it doesn't actually go into P. If I put it in P (or really the further up it will go) and shut off the car, it won't start again. I can start it up in N and only N.
Elantra XD (2001-06) :: Manual Transmission Grind When Moving The Shifter From 1 To 2
I recently started having an issue where when I shift from 1 to 2 I'll get a quick grind of the gears. Here are the circumstances:
- the clutch is completely depressed, just the act of moving the shifter from 1 to 2 causes the grind.
- only when the car is moving.
- one time I was driving and coasting for a while just shifting back and forth from 1 to 2 with the clutch fully depressed and it kept happening.
- if I shift really slowly I can usually prevent it from happening, though I don't think it's RPM related.
Ford - Focus :: 2005 - Park Brake Not Moving Easily
I drove my 2005 Ford Focus 200 miles and parked it at the Kansas City airport for the weekend. When I got back after my weekend vacation, the car started but wouldn't move in reverse gear. I was able to disengage the parking brake. However I could feel that the park brake was not moving easily. I then forced the car in reverse a few feet even though there were some groans and noises coming from the back. I then put it on drive and drove forward to the kerb. I then tried reverse again and voila everything had come unstuck. It moved freely. I was able to drive back the 200 miles without problem. I checked the transmission fluid and it was good. Is this just a case of stuck brake or is it the beginning of major transmission problems? Fyi, I have an automatic transmission and there are only about 70000 miles on the car.
View 4 RepliesPrius (2010-12) :: Engine Running Too Frequently And Longer Won't Quit Easily?
I used to get great MPG's in the beginning (>57 MPG in summer) that deteriorated as the engine started to run longer and more frequently after what I suspected to be a faint bump against a garage wall in the front. This was several months ago. I have since been averaging about 47 MPG overall (averaging winter, summer out). I forgot about the bump incident until last week when the engine suddenly started running shorter and less frequently. This lasted for a week or so, with no significant changes in the weather/temperature. And then inexplicably, it has started to run longer and more frequently again. By "more frequently", I mean when I bring ICE on, it doesn't easily quit, regardless of my prodding it to quit by going into regen momentarily. Also, the initial warmup is longer.
View 4 RepliesSanta Fe (CM - 2007-12) :: Gear Shifter Very Difficult To Move When Put Car In Reverse
Here is what I have:
2009 Santa Fe 3.3L AWD
70k KMs / 43k Miles
Temp has been very cold, -20C / -4 F
Car starts up without any problems. Try to put car in Reverse and the shifter is very hard to move, if it moves at all. When I am able to get it into Reverse, I then try to put it in Drive and it does not "engage" the "D" and the car behaves like its in Neutral. Moving the shifter back to Park, Neutral, Drive is very difficult and sometimes it will not go into Park. The dash lights do not illuminate the selected P, R, N, D.
However, once the car is warmed up (no longer on C on the temperature gauge) I can with a little effort move the shifter freely (but more effort than it should take) and the car behaves normally. Gear shifts are smooth and in general it is operating normally.
The dash lights do illuminate the selected P, R, N, D. I've checked the Trans fluid level and it appears to be normal and was planning to change it this w-e but I'm no longer sure it will work. Even if it has never been changed.
Also note that I have recently changed a wheel/hub bearing due to a noise that sounds a lot like loud tires on a highway. The bearing change did not eliminate the noise and I assumed that I've changed the wrong one. The noise does not appear to be coming from the Trans, but I cant be 100% sure. The noise is speed related and occurs only after about 20KM/h 16MPH. Unsure if they are related..
Santa Fe (CM - 2007-12) :: Shifter / Gear Select Hard To Move
Got in to go to work this am, and the gear shifter was difficult to move. What to check?
I drove 70 miles to work and didn't seem like any issues with the transmission shifting.
Got in to go to lunch and it seems even more difficult to move...
Shifting back and forth in the selector seems to loosen things up a little.
A friend move the selector while I looked at the linkage and the bracket that support the cable is flexing while shifting between gears....More likely a transmission issue or something with the linkage?
Santa FE SM (2001-06) :: AC System No Longer Holds A Charge
This is for my 2005 SF with the 2.7L.
My AC system no longer holds a charge and I'm looking to replace the parts myself and have a professional service it after I finish.
I'm looking for recommendations for reliable brand of compressor. Also, other parts I should be looking at replacing to get another 9 years out of it.
Santa FE SM (2001-06) :: Key Ignition Cylinder Light No Longer Works
2003 Santa afe 2.7 litre: So for some reason the key ignition cylinder light no longer works, but no issues with the ignition at all. What powers the light, is there a specific part of the cylinder I need to check or replace or do I have to replace the whole cylinder. Would a another cylinder I pick up from the junk yard work?
View 11 RepliesSanta FE SM (2001-06) :: Jiggle The Shifter To Get Engine To Crank - Neutral Safety Switch?
I have a '05 santa fe, auto, 2.7L, 4WD...sometimes I have to jiggle the shifter to get the engine to crank...would this be the neutral safety switch? or is there something in the shifter housing that could be causing this?
Maybe a minor adjustment... Just a slight movement of the shifter and it fires right up... If it is the neutral safety switch..where is it located? on the trans?
Elantra XD (2001-06) :: 2002 - Improper Shifting / Trans Moving To 3rd Gear
After car warms and while driving trans moves to 3rd gear and stays ??
View 2 RepliesSanta FE SM (2001-06) :: Error Code U0D00 - Engine Will Rev Really High When Moving After Stop
I got an Error Code of U0D00. What this is or means. The scan tool says to refer to your manual but I don't have one.
What the vehicle is doing is that it will work fine for a while then when you stop (in park) the engine will rev really high and back down all by it self for example. It will go up to 3.5 and back to 1 rpm repeated. Then when you start moving the car it will continue to idle higher like you are pressing the gas. During all of this the check engine light will appear?
Ford - Explorer :: 2001 - Gear Indicator Selector Moving Freely Between All The Gears
I have a 2001 Sport Trac. I was hooking up my boat, and went to put it into "R" and heard something that sounded like plastic break. Then, the gear selector seemed to move freely between all the gears. I know it is a pretty vague question, but what part do I ask for to repair it. Or more importantly, HOW do I repair it?
View 1 RepliesPhaeton :: 2004 V8 Shifter Not Moving Into Tiptronic Mode
I have a 2004 Phaeton V8 with about 68K miles. The transmission works great in both Drive and Sport mode but the shifter doesn't want to move to the right to engage Tiptronic mode most of the time. I can get it into Tiptronic about 20% of the times I try. Isthis indicative of any bigger problem?
View 5 RepliesLexus RX 2004-09 :: Shifter Is No Longer Going Into Drive - Trans Won't Shift To 5th
'04 RX330 AWD 116k...Recently noticed the shifter is no longer going into drive. When placed in the "D" position (on the right hand side of the "4-D" slot), the dash indicator reads "4". I have verified the trans is only shifting as far as 4th (70mph=3000rpm w/stock tires). ECT/Snow is not turned on.
To clarify, the problem is not physical/mechanical as far as the shifter itself...the shifter will drop to the correct "D" position, but the car says, thinks, and acts like its in "4".
Golf/GTI VI :: DSG Shifter Makes A Squeak Noise And No Longer A Smooth Movement
2013 MKVI golf TDI with DSG. I use the manual mode a lot and now the shifter makes a squeak noise and is no longer a smooth movement. Ive attached a video link below of the noise.
I've tried spraying silicone lube down into the shifter and it hasn't made any difference. How I can maybe take the shifter apart and grease it?
[URL] ....
Porsche :: 1967 Won't Start Easily - No Power Once Put In Gear
I have a 1967 Porsche 912. Today it was being a bit difficult getting fired up. Third time was the charm, but once in gear it had no power at all. The tachometer was around 3.5k in first before it even found the 10mph neighborhood ad took its sweet time to get there when shifting into second the car died. I turned her right around an put her to bed. I am thinking carburetor...
View 11 RepliesSanta Fe (DM - 2013+) :: Fuel Door / Lid Won't Open Easily - Get Stuck
This really ticked me off big time today, whatever I do the gas cap won't open when I tried to at the gas station. Before I noticed that I would have to try this a couple of times before it will open, but today, it just won't open at all.
View 10 Replies