Ford 7.3L Power Stroke (1999-2003) :: 2002 F550 Taking 4 Seconds Of Cranking To Start Consistently Hot Or Cold
I have now replaced hpop, injectors, cups, gpr, batteries, uvch on both sides, icp and ipr on my 2002 F550 and it still has a long crank to start.
It has been driven about 1,000 miles since then and no change. I have no codes except buzz test produced a high to low 1272 1274 1276 1278 one time. Cannot get that to happen again.
It is taking 4 seconds of cranking to start consistently hot or cold. It always starts but cranks for what seems like too long compared to my other 7.3s. I have included a screenshot of the data and am curious on what everyone's thoughts are as I am out of things to look at!
Santa Fe (DM - 2013+) :: 2016 - Hard Starting / Taking 3 To 4 Seconds Of Cranking Before It Will Fire
On the wifes Santa Fe 2.4 AWD every few starts it seems to crank over longer than it should. It will usually crank right up like it is supposed to. Every few times it may take 3-4 seconds of cranking before it will fire.
The car runs great, averages over 30mpg per the computer. No codes. I don't have a clue what it could be.
Accent MC (2006-11) :: 2009 - Cranking Slow / Taking Longer To Start
On my 09 accent, it's been cranking slow/taking longer to start. Occasionally it won't even have the guts to spin the starter (clicking solenoid noise).
I checked the battery (<1 year old), and it has a resting voltage of 16.2 (?!) When running, it jumps to 17.4. Is this a bad alternator?
Toyota - Start - Celica :: 1987 GTS 2.0 Has No Spark
1987 Toyota Celica GTS 2.0 manual Transmission The Problem ... The power cable to alternator sparked on the side of the engine when I was connecting it. I did not think the battery cable was connected at the time but it was.. Now I have NO SPARK I have changed all the fuses at the battery could not find any that were blown but still changed them and checked all the fuses under kick panels none were blown. What should I look for now?
View 4 RepliesFord 7.3L Power Stroke (1999-2003) :: 2001 F350 - Hard To Start / Taking Lot Of Cranking
I have a 2001 F-350 7.3L Powerstroke. 48,000 miles. I've been having trouble with cold starts. So far it has always started but is taking a lot of cranking, but it hasn't gotten too cold yet so I'm worried about when it does. I ohmed out the the glow plugs and am getting close to 0 resistance. The GPR has 12.5 volts on the hot side and when the relay is closed 10.5 on the other side. Is that difference in voltage in the GPR enough to screw up the Glow Plugs heating up? If I plug it in at night it starts right up. I'm worried about when I am at work for 16 hours and don't have a place to plug it in this winter. BTW this is my first winter with the truck.
View 14 RepliesPassat (B5) :: 2002 1.8t Taking 15 To 20 Seconds To Start
I've had this passat since it had 103k. Now at 167k. It's ran good. Til now. Lately its been having a problem starting. Goto start it and it takes a good 15-20 secs to start. Eventually starts but had a couple times when it started the engine would act like it was going to die then eventually stay running. I've noticed when the car sits for awhile. About 3-4 hours or more it starts ok. But say I run to the store and let it sit for 20 min to a hour then I have problems starting it. Had a local store test battery, starter, and alternator and everything tested fine except the starter failed on startup but then passed after the car was running for a min. So replaced starter. Still having starting issues. Recently I have changed the spark plugs and valve cover gasket.
View 4 RepliesGolf V R32 :: Start Up Hesitation And Takes A Couple Seconds Of Cranking - Misfire
Summary of Events:
Lower radiator hose decided to disconnect itself.
Stopped and had car towed home.
Connected hose and filled coolant system.
Car is hesitant to start and takes a couple seconds of cranking.
Misfires in cylinder 3, and a few in cylinder 5, no other codes.
New OEM plugs, no change.
Swapped coil packs around, no change.
Idle is rough but at speed, everything is smooth.
Chrysler - Sebring :: 2002 - Engine Start After About 5 - 10 Seconds Of Cranking When Cold
I recently bought an 02 Chrysler sebring (4 cyl) When cold, it takes about 5-10 secs of cranking for engine to start. Is that normal?
View 4 RepliesFord 6.0L Power Stroke Diesel :: No Start - Oil Pressure Registers On Dash After A Few Seconds Of Cranking
Dang, won't start again. My auction truck needed batteries, so I put mine in it and bought new ones for my work truck. Couple of days later, didn't start. Checked SG and I wasn't getting enough RPM. Jumped it and it fired right up. Replaced one of the new batteries and it's started fine the last few times, until just now, in the parking lot of the tire store.
The RPMs were weak - they'd go over 160 but then fall back to the 140s. I walked home and got my auction truck, jumped it, and it still doesn't start. Just spins. RPMs still fall back to the 140s after a few seconds of cranking, but they got as high as 220 so I don't think that is the problem. Fuel pump runs, the upper bowl is full, no bubbles. Oil pressure registers on the dash after a few seconds of cranking.
The last time, I wiggled some fuses and it started. Not this time. FICM at 48, ICP around 700 while cranking. Volts and IPV are good. FPW is 0, but I think that's right, until it cranks. Same with Sync - at 0 while cranking - does it ever go to 1 without starting?
It acts like it has in the past - cranking just fine but no start. And in the past, when it finally starts, it acts like nothing was ever wrong. I checked my IPR screen about a month ago after replacing it about 6 months ago when it didn't start. What am I missing? I'll go read some threads for clues.
Ford 6.0L Power Stroke Diesel :: New Injectors - Now Truck Takes Almost Two Seconds Of Cranking To Start Engine
I just finished installing a new set of injectors, standpipes and the blue spring kit on our 2005 Excursion 6.0. The truck idles and runs much better but now it takes almost two seconds of cranking to start the engine. Cold and hot are the same and the length of time between shut down and start doesn't seem to matter either.
What to check? I am planning to check the ICP tonight when I get home. Could I have air trapped some where in the system? This is my first powerstroke so I don't know if this is a possibility.
Celica :: 1987 - Oil Pan Replacement?
How do I replace the oil pan in my Celica? I have a crossmember directly below it.
View 2 RepliesCelica :: 1987 Toyota ST Will Not Seem To Turn Over
My 1987 Toyota Celica ST will not seem to turn over. When it has the push button addition that takes the power from the battery straight to the seloniod it works. But when i set the starter back up to the ignition switch and set it up factory style it will not spin over. it sends the 12 volts needed to start it but yet will not turn it over.
View 3 RepliesCelica :: 1987 GT Won't Idle At Lower RPMs
I have a 1987 Convertible Celica GT, with Manual Transmission. The car will not idle at lower RPM. I had someone look at it, and they have it where it will idle at 2000 RPM, but anything lower than that, and the engine will die when not giving it gas.
The engine accelerates great and runs great at any speed, but if you push in the clutch without giving it gas, it will die, unless the idle speed is cranked up like it is now. What this might be?
Celica :: 1990 GTS Violently Shudder Taking Off In First Gear
I have a 90 celica gts. when it drove, it would violently shudder taking off in first gear. the front motor mount was shot so i was hoping that was the problem. well right after i fixed it, the starter went so i had to compression start it, and the shuddering was still there, and i was about to shift to second when it revved up popped outta gear and didn't go anywhere. it wouldn't go into any gear.
I can go through all the gears without the clutch in. the guy i got the car from said the clutch was new. now i'm not sure if hes just lying or if the guy who put it in didn't know what he was doing. could this be a bad throughout bearing? or the trans? if its the trans i'm scrapping it, also the shiftier is REALLY loose. and before the clutch went it would make weird whirring noises in 1st.
Ford Ranger / B-Series :: 1987 - Replaced Relay - No Pumps Working While Key Is Turned To Run Or While Cranking
Ranger wont fire! fuel pumps not pumping..... Jumped fuel pump relay and got both pumps working, but while jumping relay and cranking motor, still no fire. Plenty of fuel pressure though. got spark too. Replaced relay and no pumps working while key is turned to run or while cranking. I got to get this sweet puppy back on the tarmac...
View 7 RepliesCelica :: 1987 ST Auto Transmission - No Power To Radiator Fan
1987 Celica ST
3sfe
auto trans
Last week the rad cooling fan stopped working. The fan itself is fine. It spins when connected directly to the batt. Relay tested good, and fuse isn't blown. I unplugged the temp. switch connector, and grounded it to the batt. to test the circuit, and nothing. Switched on the A/C, and both fans spin. So, where else should I look for the problem?
Celica :: 1987 Toyota Brake Pedal Is Going To The Floor When Applied
My 1987 toyota celica brake pedal is going to the floor when I apply the brakes but not all the time,i checked the pads and shoes they are still good i also bled the brakes, I am thinking it is the master cylinder or maybe the master cylinder needs to be bled.
View 1 RepliesToyota - Celica :: 1987 - Suddenly Revved Into Higher RPMs While Slowing Down
I was driving home from campus yesterday, and as I approached about 50mph, the Celica suddenly revved into higher RPMs, all the while slowing down. I pushed the gas pedal, which only worsened the problem. I was able to limp the car home. About an hour later, I tested the car again, and the problem remains: Accelerate to about 35-50, then get high RPMs while the car slows down and jumps forward.
I suspect a transmission problem, accentuated by a loose wheel bearing that I haven't been able to afford to get fixed yet. My Celica is an automatic, with about 213000 miles on it.
Passat (B6) :: Startup Taking About 8 - 10 Seconds When Put In The Key Fob To Ignition
just wondering what are the problems typically associated with a long start up. it took about 8-10 seconds from the time i put in the key fob to ignition. it was especially cold and windy today, so i know the cold had something to do with it.
View 6 Replies