Ford 7.3L Power Stroke (1999-2003) :: 2002 F550 Taking 4 Seconds Of Cranking To Start Consistently Hot Or Cold
I have now replaced hpop, injectors, cups, gpr, batteries, uvch on both sides, icp and ipr on my 2002 F550 and it still has a long crank to start.
It has been driven about 1,000 miles since then and no change. I have no codes except buzz test produced a high to low 1272 1274 1276 1278 one time. Cannot get that to happen again.
It is taking 4 seconds of cranking to start consistently hot or cold. It always starts but cranks for what seems like too long compared to my other 7.3s. I have included a screenshot of the data and am curious on what everyone's thoughts are as I am out of things to look at!
Chrysler - Sebring :: 2002 - Engine Is Blown?
I have a 2002 Chrysler Sebring that broke down. Unfortunately it ran out of oil, and I was told that the car has 2 sensors that detected the lack of oil and shut down the engine. A local auto repair shop replaced the sensors. I paid the bill and began to drive the car home but I only got 20 miles away when the engine blew. My question is, if the the shop told me the car was fixed and then the engine blew, aren't they somehow liable for this?
View 19 RepliesChrysler - Sebring :: 2002 - Check Engine Light Came Driving Down The Highway At About 70 MPH
I drive a 2002 Chrysler Sebring convertible with about 130,000 miles on it.
I was driving down the highway in early November when the check engine light came on my car. I took it to Aamco who did some diagnosis and replaced a solenoid assembly in the transmission. The light went off and I was on my way. I never got the exact code.
About a month after that, the light came on again. This time, I got a low end code reader and scanned it myself. I got a "P0700" code, which I've read is a generic code that the transmission system sends to the computer or something. So I used my reader to erase it. However, the light came on 2 days later while I was driving down the highway at about 70 MPH.
So I went to an auto parts store to get a more detailed scan with a better tool. This one came up "P0740 Torque Converter Clutch Solenoid Circuit".
This feels weird, because the solenoid assembly was just replaced a month ago (and is still under warranty).
The car seems to drive okay. I don't notice any actual problems in shifting. The tachometer seemed to get up to about 3000 RPM on the highway. But I've seen practically new cars do that. The last time I had serious transmission problem it would rev up to about 5000 or 6000 RPM on the highway and still only getting up to about 40 MPH. That was 3 years ago and at the time I had a fairly expensive transmission repair (which included a new torque converter).
But like I said, the car seems to be driving okay. I don't drive much. Maybe 100 miles a week? And even that is mostly optional in town driving. I'm not looking to keep this car for more than another 20,000 to 25,000 miles though for the time being I cannot afford a new one.
What are the possible causes here? What are the consequences of ignoring this? Like I said, it's still driving fine and as the old saying goes "if it's not broke, don't fix it".
Sebring - Chrysler :: 2002 - Engine Shut Off While Driving / Apparent Grinding Noise
I have a 2002 Chrysler Sebring with 116,000 miles and over the past month the engine has shutoff as I am driving and once I park turn the key off and turn on it has started to run again. This has happened about four times and each time it has been difficult starting it after the car has stalled. The most recent time this happened when I went to restart the car, a grinding noise became apparent. The last few times that I have started the car the grinding noise would be heard only to ultimately fade away in about 15 seconds. The check engine light came on and went to get the code and it came back suggesting a problem with the camshaft position sensor, but I don't fee the noise is related to that.
View 1 RepliesSebring - Chrysler :: Won't Start - Headlights / Power Windows And Doors Work But No Noise From Engine
My 2002 Sebring won't start. Here's what happens:
Turn the key in the ignition. Engine makes no noise at all. It's sorta like when the battery died 2 months ago, except this time the power windows and doors work, the headlights and interior lights work, though oddly, the radio doesn't. The radio, FYI, is not the one that came with the car. I bought it back in 2010 after the cassette deck on the original broke and I needed something with an Auxilary connector to connect my Ipod to. I had it professionally installed.
So the car doesn't start. The engine doesn't make any noise. The headlights do come on. The dashboard lights that normally come on when you try to start it up (the check engine light, the airbag light etc., also do not come on at any point. I don't recall any particular clicking sounds when I turn the ignition. I do remember hearing these clicking noises (sort of a quick one time click for each key turn) when the car wouldn't start due to battery/alternator issues two months ago.
So I did a bit of research, and I think it's either the starter solenoid or the ignition switch. Am I far off base?
Accent LC (2000-05) :: Starting After 5 To 6 Seconds Of Cranking When Engine Is Cold
I have a 2000 Accent with 90k miles. The last week or two, it takes about 5- 6 seconds of cranking to start when the engine is cold. Having had the car since new, I know that it's not normal.
The engine seems to crank strongly, and once started idles and drives well. This occurs once about every 4 starts when engine cold. Warm engine starts normal.
Changed plugs - no difference. Maintenance current per owners manual schedule.
Sebring - Chrysler :: Heater Blowing Cold Air
Got a bit of a problem with my car. Earlier this week, I got in and noticed there was heavy condensation on the inside of the windshield of my 2002 Chrysler Sebring convertible. The windows had been rolled up and the top up of course. I see this kind of condensation happen on the outside a lot in the mornings. You know, dew settling and all that. If I wait around until later in the day, it evaporates on its own.
Anyway, this time it was on the INSIDE. I wiped it clean easily enough and was on my way.
Today I noticed that my heater wasn't working. The temperature gauge goes up to about 1/3 of the way, so I know the car is warming up. I'm not sure if it normally goes up that high; I don't usually pay much attention to the temperature gauge.
Sebring - Chrysler :: Burning Smell Coming From Vents When Heater Is On Hot Or Cold
I have an extreme burning smell coming from my heater whenever it is on, curious I put the fan on cold and it still has the burning smell. I pulled over and got out of the car he popped the hood and I don't smell anything underneath the hood. I've been leaving it off because I don't want anything blowup on me... It is a 98 chrysler sebring convertible, and the low and medium don't work on it, it only turns on on high....
View 9 RepliesSebring - Chrysler :: 2004 - AC Stop Blowing Cold If Went Over A Big Bump Or Hit A Pothole
I have a 2004 Sebring. The A/C had been working intermittently, now not at all. When it was working, if I went over a big bump or hit a pothole, it would stop blowing cold. Now it will not blow cold through the dash vents, but the defroster still blows cold so I believe there is enough coolant. The mechanic has discouraged me from investigating saying it will be very expensive to take the car apart to diagnose.
View 1 RepliesSebring - Chrysler :: 2002 - Shakes Badly Under Acceleration And Braking - Cause?
So. My car shakes badly when I get above 35 mph and up. It shakes under acceleration and braking above these speeds. Under these speeds its fine. When I am above 35 if I am just coasting its fine it doesn't shake. The shaking feels like I am off the side of the road and driving over rumble strips. What could be the cause of this?
View 19 RepliesSebring - Chrysler :: 2002 - CEL Came On - Camshaft Position Sensor - Hard Starting?
Check engine light came on and off for a couple of months. At first engine would lug at about 35 mph then light would come on, then off, usually by next start. Car stalled once when sitting at light, then light came on. Scanner said it was the Camshaft Position Sensor. Replaced it and now I need to give it gas first thing in the morning and in the evening after it's been sitting a work all day. Why it's doing this?
View 6 RepliesSebring - Chrysler :: 2008 - Won't Start Intermittently
I have a 2008 Sebring convertible that has starting issues. Sometimes when I turn the key to start, it does nothing (no noises, maybe a small click very rarely). If I take the key out and put it back in, it may start. Usually, I have to turn the power on, move the gears, and try again. Sometimes, it will start immediately, or I may have to do this procedure several times. It has been taken into the Chrysler dealer twice. They said it was not the switch or alternator and replaced the battery that wouldn't keep a charge. It was a 5-yr battery with 3 years of use. I was told to drive more! I shouldn't have to charge the battery every day. Several diagnostic tests were performed with no results. It still did this twice after the battery was replaced. Could it be cables?
View 3 RepliesSebring - Chrysler :: Intermittent No Crank Or Start Condition
2008 Chrysler Sebring V6 hardtop convertible ... Intermittent no crank / no start condition – when turning key to start position, either you get nothing as if there is no battery connected and or a slight click as if the solenoid was trying to engage. The pattern can be nothing, nothing, nothing, click, click, nothing, startup or any combination of clicks or nothing, always resulting with a startup. Sometimes it will only be 3-4 attempts, other times 15-20. This occurs anywhere from every 15-20 starts to driving 2,000 miles from NH to FL without one failure.Completely random occurrence – no pattern can be seen – has been ongoing since September 2015 to now March 2016.
I have tried moving the shift lever and the steering wheel while it occurs, no change.Facts – battery was replaced 2-3 years agoAfter the first occurrence I yanked the battery, cleaned the terminals as well as the terminals under the hood. Over the next couple of months brought it to the dealer who could find no codes and of course it did not fail while they had it so they did nothing. In December I appealed to the service manager to replace the starter as I thought is sounded like a bad spot on the armature. He did so and also had the WIN module replaced. No issues until I was in FL weeks later. Here the dealer has replaced the PTC and TIPM modules and installed a redundant ground wire. The problem is still occurring. I’m down to under 400 miles on my 100k bumper to bumper warranty?
Ford 6.0L Power Stroke Diesel :: New Injectors - Now Truck Takes Almost Two Seconds Of Cranking To Start Engine
I just finished installing a new set of injectors, standpipes and the blue spring kit on our 2005 Excursion 6.0. The truck idles and runs much better but now it takes almost two seconds of cranking to start the engine. Cold and hot are the same and the length of time between shut down and start doesn't seem to matter either.
What to check? I am planning to check the ICP tonight when I get home. Could I have air trapped some where in the system? This is my first powerstroke so I don't know if this is a possibility.
Sebring - Chrysler :: 1989 - Won't Start When Turn The Key / All Dash Lights Come On
My frend has a 89 Sebring that won't start all the dash light come on but turn the key and it doesn't do a thing....
View 8 RepliesSebring - Chrysler :: 2004 - Engine Wants To Stall When Idling
I have 2004 chrysler sebring and lately when I'm at a light/stop sign the rpm gauge fluctuates between 1000 and 500 and wants to stall. I've been told to change the spark plugs and wires, cleaned the throttle body, and put in a new air filter. What else I should do?
View 1 RepliesChrysler - Sebring :: Water Bubbles In The Radiator And Heat Builds Immediately After Start Up
My friend's 04 Sebring (6cyl) is overheating. After start up, almost immediately the water bubbles in the radiator and heat builds. He has replaced the radiator, thermostat, water pump, and even rebuilt the heads - still the overheating issue. What may be the problem and how to correct?
View 2 RepliesChrysler - Sebring :: 2006 2.4L - Engine Keeps Rattling And Making Noise
Engine oil has been changed and spark plugs changed. The engine is still making rattling/clicking noise. I checked with a mechanic and he indicated that engine needs to be repaired. Didn't say exactly what needs to be done and stated it would cost about $2200 for parts and labor. Why the engine keeps rattling and making the noise? Oh, before plugs were changed, the engine was shutting off at times when in idle mode.
View 5 RepliesChrysler - Sebring :: 2005 Engine Cuts Out / Cannot Go Above 2500 RPMs
I have a Chrysler Sebring 2005Engine cuts out at 2500 spurts stutters can't go above 35 mph...But still runs... No cruise available will not come on.. Engine light on... Which I guess from what I read is normal In "limp mode" Got it home.. Shut it off.. Starts back up.. I'm thinking cam/crank shaft sensor? Both of those are new.. And an ECM all from a prior problem.. Or fuel pump.?? Not enough pressure to keep up with demand..
View 4 Replies