Camry 2012+ :: Squeak In Front After Installing Lowering Springs?
I put HR lowering springs and I'm getting a bad squeak when the car goes over a speed bump . It's coming from the rubber on the end of the front springs ? Do they make a poly urethane upper mount?
View 4 RepliesPrius (Gen 3) :: Get New Shocks And Coilovers When Installing Lowering Springs?
Is it necessary to get new shocks/coilovers when installing lowering springs? (and other concerns)
View 12 RepliesGolf/GTI VI :: Clunking Noise After Installing Lowering Springs
So I installed the DG springs today, and it should've been a simple install. Well once all was said and done I took it for a test drive. Every time I go over a bump I hear a loud clunking noise, like somethings loose. What it could be? I'm pretty sure I tightened everything.
View 10 RepliesCamry :: Rear Suspension Clunk Noise After Lowering Springs Installed
After having lowering springs installed, I've been noticing a clunk noise in the rear suspension when driving over dips in the road (eg. getting out of the parking lot onto the main road). It feels like having your wheels lifted in mid-air and being dropped onto the road.
View 14 RepliesCamry :: 2003 - Low Front After Installing Gabriel Ready Struts
I just finished replacing front and rear struts on my 2003 Camry SE. I decided to use Gabriel Ready Struts because I needed Boots, and Mounts. My Car has 150,000 miles, I noticed some mild nose diving during hard braking, and I wanted to improve this.
The Ready Struts did improve the nose diving, but I think the car had a better ride with original struts with 150,000.
The Car is lower in the front with the new struts, and higher in the back. Its obvious when you look at the car. I have a regular parking place at work, and the first day I parked I scraped the curb. I have parked there every day since the car was new without problems.
I am considering returning the struts, and buying KYB and using my original struts. I was concerned about using my springs with 150,000.
Golf VI R :: Lowering Springs Installation Without Removing Axles?
Looking to get a set of VWracing springs but wondering if there is a way to pull the front struts without having to pull the axles out?
View 24 RepliesGolf IV / Jetta IV :: R32 Struts / Springs Onto 2.8L VR6
I was wondering if the stock front R32 struts and springs will bolt on without any issues onto a 2.8L GTI.
View 2 RepliesCorolla / Matrix 2009-13 :: 2012 - TRD Lowering Springs Installation
I have a 2012 corolla le and I'm looking into getting TRD lowering springs as I don't want to go too low and they work with the stock strut, however; I read that they work best with the XRS' shock and strut (might be just the strut but I'm not sure), my question is what are the XRS' struts called and where would I find them, also from what year would the XRS' struts fit on my le?
View 3 RepliesCorolla / Matrix 2009-13 :: 2011 - Way To Install Lowering Springs?
This is my 2011 Corolla S with Subaru Brz wheels. I got the entire set on October. It just took from a brand new Brz with Michelin Primacy HP tires. It looks on my corolla. Now I want put the Ei Bach Springs on my car, where is the good place to go?
View 2 RepliesPrius (2010-12) :: Changing Out Struts / Shocks And Springs
What additional parts should I be replacing when I do this? Spring seats, bump stops, etc?
View 12 RepliesLexus IS 2014+ :: Will Putting New Lowering Springs Damage Original Shock In The Long Run?
I want to lower the car with RSR DOWN SPRINGS but I have some people telling me that I will destroy my shocks in time and other people saying its fine.
View 14 RepliesAvalon 2005-12 :: Struts And Springs Could Be Replaced From Previous Models?
Can the struts and springs from the 2006-2008 Avalon with the TOURING suspension be put on the 2010-2012. Went to the local Toyota dealer. They had the struts for a 2007 Touring model. We compared them to some from a 2011 , and they looked physically the same.
View 1 RepliesGolf VI R :: Installing VWR Springs - Rear Suspension Unknown Part
I am installing VWR Springs to replace worn stock components on my mk6 R. It appears that the previous owner slammed the car, and removed the "nipple" that holds the rear spring in place from the top. Both upper and lower spring isolators were present.
I am trying to find a name or part number for this unknown "nipple". I tried some combinations, such as "rear spring cap" and "rear spring centering guide". It looks like it would screw into the body, right above the springs themselves.
Passat (B6) :: Installing Springs - Can't Get The Front Strut Tower Out Of The Lower Clamp
We have spread it as much as we can and it's come up about 2 inches - then stops,
View 8 RepliesCamry 2012+ :: XV50 SE 7th Gen Weak HID Output?
Recently installed 35w Canbus Slim Ballast 6000k HIDs into my 2014.5 Camry SE projector headlights (black bezel). For some reason it seems like the Halogens lit up better. I get very poor lighting, and when I drive on the highway at night it barely lights up the signs. I don't know if I need to adjust the angle of the projector because the beams seem kind of low or if I need to upgrade the ballast to a 55w. Also not sure if the housing or the stock wiring can handle the 55w without causing damage.
View 14 RepliesCamry :: AC Is Weak And Compressor Clutch On All The Time
My a/c is weak and the compressor clutch is on all the time. What causes that?
View 14 RepliesCamry 2012+ :: Low Beam Is Too Weak With Original Lights
my low beam is to weak with original lights,led kit for beam projector is good?
View 3 RepliesCamry :: 2006 - Blows Weak And Cooler Air While Driving - Engine Noise
I just bought a 2006 camry a few days ago and am noticing a little problem with the heat. It warms up fine when idling but blows weak and cooler when driving....there is also a slight engine noise. Not sure if related, I am by far not a mechanic. I did try to research this issue but am coming up with more of the opposite (no or weak heat idling/great heat while driving). We are replacing thermostat tomorrow. As far as other maintenance goes it seems that the previous owner just did oil changes and nothing else in the last 3 years (35k since then). Trying to do all the little things now but would like to resolve this issue while I have it in the shop.
View 2 RepliesCamry 2012+ :: Lowering The Car To Eliminate Wheel Gap
I am planning to lower my car a little to eliminate the wheel gap. I've been doing research and I heard lowering springs is better than coilover, and more affordable too.What's the best way to lower my car?
View 2 Replies