Prius (Gen 3) :: Get New Shocks And Coilovers When Installing Lowering Springs?
Is it necessary to get new shocks/coilovers when installing lowering springs? (and other concerns)
View 12 RepliesGolf VI R :: Lowering Springs Installation Without Removing Axles?
Looking to get a set of VWracing springs but wondering if there is a way to pull the front struts without having to pull the axles out?
View 24 RepliesGolf/GTI VI :: Clunking Noise After Installing Lowering Springs
So I installed the DG springs today, and it should've been a simple install. Well once all was said and done I took it for a test drive. Every time I go over a bump I hear a loud clunking noise, like somethings loose. What it could be? I'm pretty sure I tightened everything.
View 10 RepliesCamry :: Weak Struts After Installing Lowering Springs
Few weeks ago, I got the Tein spring installed on my camry. Drop 1.5/1.6 front/rear.
Problem is now I sometimes hear this clunking sound from the rear. It doesn't happen very frequently, just every once in a while when i drive through a small&sudden bump.
Only from the rear, nothing from front of the car.
Another thing is that when i reverse & turn (ex. getting out of garage), it makes one or two cracking noise from the front, small clunking sound from the rear.
I'm suspecting the strut may be bad. The mechanic guy said that my rear struts are bad (when he was installing the springs).
Am I in need to get new struts ?
Corolla / Matrix 2009-13 :: 2012 - TRD Lowering Springs Installation
I have a 2012 corolla le and I'm looking into getting TRD lowering springs as I don't want to go too low and they work with the stock strut, however; I read that they work best with the XRS' shock and strut (might be just the strut but I'm not sure), my question is what are the XRS' struts called and where would I find them, also from what year would the XRS' struts fit on my le?
View 3 RepliesCamry 2012+ :: Squeak In Front After Installing Lowering Springs?
I put HR lowering springs and I'm getting a bad squeak when the car goes over a speed bump . It's coming from the rubber on the end of the front springs ? Do they make a poly urethane upper mount?
View 4 RepliesCorolla / Matrix 2009-13 :: 2011 - Way To Install Lowering Springs?
This is my 2011 Corolla S with Subaru Brz wheels. I got the entire set on October. It just took from a brand new Brz with Michelin Primacy HP tires. It looks on my corolla. Now I want put the Ei Bach Springs on my car, where is the good place to go?
View 2 RepliesCamry :: Rear Suspension Clunk Noise After Lowering Springs Installed
After having lowering springs installed, I've been noticing a clunk noise in the rear suspension when driving over dips in the road (eg. getting out of the parking lot onto the main road). It feels like having your wheels lifted in mid-air and being dropped onto the road.
View 14 RepliesLexus IS 2014+ :: Alignment After Lowering?
Problems getting an alignment AFTER lowering. seems no one in my area has the old fashioned machine where it clamps on the wheel edge,they have the ones that clamp on the outside of the tire,which limits the rotation of the wheel if the body is too close. I am on rsr downs with Vossens,which wont work at all, so hoping the stock wheels will.
View 6 RepliesLexus IS 2014+ :: Oil Leakage From Rear Driver Side Shock
I found out the rear driver's side shock was leaking oil after I jacked up the car to take a look at exhaust options for the car. 3 of the 4 shock are clean and show no signs of oil.
Is this a defective shock or a pothole destroyed it?
Passat (B5) :: Kick Starting Damage Anything On The Long Run?
i dont have to much money right now to buy a new starter but possibly in a week or so. Will this damage anything on my car???
View 7 RepliesFord Excursion :: 2000 - Damage From Not Driving For Long Distance?
I have a 2000 X 7.3 diesel with under 100,000 miles. I drive it about 10,000 miles a year, all towing. However it does get used everyday driving a student to the bus, a distance of about 10 blocks. There is an engine block heater which I use all winter but the engine never warms up on the ten block run. I do service the engine twice a year, every six months. What damage am I doing and what can I do to prevent any damage?
View 14 RepliesFord 6.0L Power Stroke Diesel :: EGT Gets High On Long Steep Pulls / Lowering?
What besides a 4" exhaust can I do to lower EGT? When I tow with my tow tune the EGT gets high on long steep pulls. Would like to be able to use it with the tune because there is more power and it pulls nicer, but I want to lower my EGT. I have a 4" flo pro system coming. What else can I do? Would a new intercooler make much of a difference? Already have an S&B cold intake and Banks Hi Ram.
View 14 RepliesLexus IS 2014+ :: Floor Jacks Not Long Enough?
how to find a floor jack that is low enough and has a long enough chassis to get to the central jacking points of the IS? I have 2 different models and there is no way they are long enough to reach the identified jack points but still allow for handle movement. Need to change my winter wheels and don't want to use the floor jack on the pinch weld jacking positions. Also don't really want to use the onboard jack....
View 6 RepliesFord F-150 (2009-2014) :: 2011 - Addition Of Original Keypad?
My XLT doesn't have a door keypad and in the last 2 years I've really missed it. I found one on eBay that is factory part. I know I'll need to purchase a new handle with the holes for the keys to come through, but my question is will my truck be pure wired with the necessary plug to install this or is it going to be a hassle? The description says it will work on any trick with keyless entry. I assume this means the key fob keyless entry but before I ordered it I wanted to check on here first.
View 14 RepliesFord F-150 (2009-2014) :: Lowering New Truck
I want to lower my 2014 FX2 supercrew 2/4. Can't seem to find any drop spindles for it. What are you using to drop your trucks. I don't want to change the driving or handling of the truck any more than necessary.
View 14 RepliesLexus RX 2004-09 :: RX330 Original Key Not Working - How To Reset
How to reset/re-program my original key. It all started when the plastic casing of the key broke off and tried to use the original spare key wallet type with transponder and key dont go all the way in the ignition and key get stuck in one position but manage to get it out. Tried to put the broken one with the transponder close to it and will not start. Luckily i still have another original key that works. I have change the battery of the broken one and fabricated new housing made of brass and have tried the remote and it doesnt work too.
View 12 RepliesLexus GS 2006-11 :: Original Brakes And Rotors Squeak
When I 1st brought the car the original brakes and rotors squeak, I really didn't mind bcuz I had plans on changing them, now I installed the aftermarket slot/drilled rotors with new ceramic brake pads, and I still get squeaking from the front brakes, weather it's wet or dry, cold or warm they squeak, what I can do to stop this?
View 5 RepliesLexus GS 2006-11 :: Mirrors Don't Tilt Back To The Original Position
My 07 GS350 after coming out of Reverse the mirrors don't tilt back to the original position and sometimes it don't tilt down far when put in reverse.
View 12 Replies