Corolla / Matrix 2009-13 :: 2011 - Way To Install Lowering Springs?
This is my 2011 Corolla S with Subaru Brz wheels. I got the entire set on October. It just took from a brand new Brz with Michelin Primacy HP tires. It looks on my corolla. Now I want put the Ei Bach Springs on my car, where is the good place to go?
View 2 RepliesCorolla / Matrix 2009-13 :: 2012 - Lowering The Vehicle
I was looking to lower my 2012 Corolla after seeing torres 16 running 18x10 all around on his car. I fell in love with his Corolla and have been craving to do something similar. Now here's the flip side. I am absolutely clueless about the in-and-outs of stance work or being "slammed". I was thinking running 18x10 all around is a bit too much and was looking to run 18x9.5 Grids - if I could find them new. I'd like to sit "flush." What offset would be recommended? From what I saw on wheeldude, they only come in +20 or +38. Would this be possible on BC coilovers? I'd like to achieve a look similar to Jzen 16 or torres 16. Would I be better off running an air suspension setup? The downfall is they get ridiculously costly.
View 14 RepliesCorolla / Matrix 2009-13 :: 2012 S / Footwell LED Installation?
I have a 2012 Corolla S and I'm trying to install footwell LED lights that are wired to the dome light, which wires do I need to tap in order to make this happen and how do I tap them correctly/safely?
View 2 RepliesGolf VI R :: Lowering Springs Installation Without Removing Axles?
Looking to get a set of VWracing springs but wondering if there is a way to pull the front struts without having to pull the axles out?
View 24 RepliesCorolla / Matrix 2009-13 :: How To Make Car Driving Smoother Without Lowering It
I've read countless threads on coilovers and springs, and I see that a majority of them are addressing ride height.
I currently have the stock springs on my 2010 corolla LE and I would like to make it drive more like a Lexus. I am aware that it is not a Lexus and will never be one unless I trade it in for one.
But I'm hoping I can do something about my perceived rough ride. I've compared it to a 2006 Camry, and even the Camry rides smoother.
I have my eyes on a set of BC coilovers. Will I be able to achieve a smoother (softer) ride than stock...
Corolla / Matrix 2009-13 :: What Tires / Wheels Will Fit With Eibach Springs
my car is basically bone stock (2010 Corolla S). I'm looking at getting Eibach lowering springs fairly soon, and later on new tires/wheels. My question is what are the biggest wheels and tires I can get after I install these springs? Will 17" rims fit? Or does it depend on the tire as well?
[URL]
Corolla / Matrix 2009-13 :: AMP Installation To Factory Radio?
How to install an amp to the factory radio?
View 14 RepliesCorolla / Matrix 2009-13 :: Viper Installation Process?
I really want to put Viper into my car, the remote start and security system. I was thinking about putting in the 5901 or 5704 in, is there a difference?
Should I get the extra accessories like the audio sensor and tilt sensor? And I'll probably need a transponder bypass module with it too?
Corolla / Matrix 2009-13 :: Remote Engine Start Installation?
Installing a remote engine start on corolla? 2013 Corolla with G key specifically.
View 13 RepliesCorolla / Matrix 2009-13 :: Acceleration Not Much Responsive After BC Coilover Installation
I just got my bc extreme drop kit installed, after taking out struts i imagined my corolla would be lighter and faster cuz the struts weigh way more than the coilovers, but when i drove it for first time after install, i noticed the acceleration is weaker and not as responsive, why this is? is it supposed to be like that, whats happening?
View 5 RepliesCamry 2012+ :: Squeak In Front After Installing Lowering Springs?
I put HR lowering springs and I'm getting a bad squeak when the car goes over a speed bump . It's coming from the rubber on the end of the front springs ? Do they make a poly urethane upper mount?
View 4 RepliesCorolla / Matrix 2009-13 :: 2010 Cruise Control Installation Different Than 2007 Vehicle?
I installed an aftermarket cruise (Rostra) in my manual 2007 Corolla. Other than cutting the hole for the stalk the only real difficulty was getting my fat hands up under the dash to install the clutch disconnect switch. It certainly didn't involve any wire cutting or messing around with the ECM.
It's a long story, but through a sequence of events I have to opportunity to buy a 2010 base Corolla 5 speed at a pretty good deal. It also doesn't have a cruise control. I went tot eh Rostra website just to make sure cruise units are available and I looked at the installation instructions. Unless I read the wrong sheet, their instructions make it seem like installing cruise on a 2010 involves messing with the ECM wiring harness, moving connectors and a bunch of scary stuff like that.
It seems strange to me that the older car would be "plug and play" but a newer one would need changes to the main wiring harnesses. I'm not talking about a steering wheel mounted system where the clock spring has to be replaced, just a basic cruise.
Corolla / Matrix 2009-13 :: After Installation Of Snow Tire Pressure Warning Light Won't Come On?
Had snow tires on separate rims without pressure sensors installed today. Service rep said that the tire pressure warning light will come on and stay on. However I rode car home and the warning light did not stay on after the initial engine start up. Is this a problem and a concern, or a good thing ?
View 2 RepliesCorolla / Matrix 2009-13 :: Interior LED Light Strip Installation Under Driver And Passenger Side
I am trying to install interior led light strips under my driver and passenger side. I connected to wire to my front fog lights fuse. But when I connect the negative wire to a metal part the light turns on and doesn't turn off unless i take it off. I want to make the lights turn on when i turn on the fog lights. How can I do this / what did i do wrong. I am do this in a 2009 corolla S.
View 2 RepliesFord 6.7L Power Stroke Diesel :: 2012 - Installation Of F550 Coil Springs?
I have a 2012 F350 CCLB with camper package (front coil springs @ 6,000 lbs). I was thinking of installing F550 coils springs, which are rated at 7,000 lbs, to provide greater lift up front.
Before performing this modification, what lift was achieved up front?
My endeavor is not to achieve level, per se, but rather allow for increased tire size, such as 35's and ground clearance.
Corolla / Matrix 2009-13 :: 2012 LE Don't Have Auto On / Off For Headlights
My Mother just purchased a 2012 Corolla LE and this thing doesn't have the auto on/off for the headlights on the switch..
How to install the auto switch from a 2010 or if it will even fit and function?
Corolla / Matrix 2009-13 :: 2012 - Oil Filter Housing Will Not Come Off
I am trying to change the oil on my dad's 2012 corolla LE, and this is the first oil change since it's been out of the 25k mile service plan. I ordered the exact 64mm 14 flute wrench and the filter housing WILL NOT unscrew. I have looked at several videos online and I am sure I'm going the right way. I have tried kicking it, hitting it with a rubber mallet... and nothing! My friend has a breaker bar we are gonna try to use in a little while... Is there any history of dealerships sabotaging this kind of thing so you have to bring it back?
View 3 RepliesCorolla / Matrix 2009-13 :: Engine Knock On Start Up - 2012 LE
I now have 500 Miles on my LE. Driven soft Never over 2,500 rpm except, one time I accelerated to 4,500 RPM in first. Short 5 Mile trips.
Engine knock on start-up (Lasts one second)
sounds like a lifter pumping up.
Only happens occasionally.
Happened last night after driving 40 Miles and parking it for two hours.
Is this normal? I have noticed this since the first 10 Miles on the odometer. Figured it was the 0W-20 Oil.
My friend has a 2003 Echo with 100,000 miles and it does not do this.
Corolla / Matrix 2009-13 :: How To Program 2012 LE Transponder Remote Key
New owner of a used 2012 corolla. I only have one remote key. After digging through google and ebay. I brought a set of new remote keys with the known warning that I have to take it to the dealer for programming.
What tools to get to have this program by myself. It just cost too much over $150 from dealer just to program a key not counting over $250 dollar for the key itself.