Passat (B6) :: 2009 - Squeaking / Creaking Suspension Noises Seeming To Originate From Shock / Strut Tower Areas
Any noted 2.0T, B6 experience/solutions for squeaking/creaking suspension noises seeming to originate from shock/strut tower areas? I purchased new in 2009, 37K mi ago. VW dealer service persons think they hear it sometimes. Been chasing this problem for a year or more, mostly notable in cold weather. Condition evident driving on uneven pavement, dips in the road etc. Passengers ask "what is that squeaking".
View 7 RepliesPrius (Gen 3) :: Removing Tanabe (strut Tower) Brace To Change Fuses?
I have given this scenario a careful study and developed a few tools and techniques for access to the fuse box cover on a Gen III Prius with a Tanabe strut tower brace installed.
1. The left hand bracket can be removed and reinstalled without removing the wipers, wiper motor and the two splash pans.
2. A 14mm offset custom made long box wrench or "ring spanner," a long flat blade screw driver and an extension magnet is needed to remover and install the bracket nuts.
There is enough space, using a long offset box wrench to loosen and tighten the 14mm flange nuts holding the bracket.
Camry 2012+ :: Squeak In Front After Installing Lowering Springs?
I put HR lowering springs and I'm getting a bad squeak when the car goes over a speed bump . It's coming from the rubber on the end of the front springs ? Do they make a poly urethane upper mount?
View 4 RepliesCamry :: Spring Clunking Noise Coming Out Of Driver Side Strut Tower
So I installed my H&R lowering springs about 2 months ago and I am very happy about the stance, ride, and handling up until about 2 weeks ago. The car always had a bit of a spring clunk coming out of the driver's side strut tower, but it has become more apparent and pronounced over the last few days. I already tightened the strut nut and shock tower bolts, what else is there to check out?
View 14 RepliesCorolla / Matrix 2009-13 :: Less Body Roll When Taking Corners After Installing TRD Front Strut
Ok so i just installed the trd front strut as my first"upgrade" on my 2009 corolla LE 2 days ago. Immediately i noticed when taking corners there was muchhh much less body roll which i love and i can take corners at a faster speed. BUT i have noticed at highway speeds it feels like the car is "swaying" left and right even if the car is moving in a straight line.Mainly the back of the car feels like its moving back and forth especially when its uneven roads while the front remains "even" Its quite unsettling as it feels like the back of the car will fishtail and lose control at any second.And yesterday it seems even at low speeds around 20 mph it feels like slight swaying. My question is, is this normal simply because everything else suspension wise is stock while the front has a strut bar? Maybe something else is wrong? Maybe its my imagination and its just the uneven roads?
View 14 RepliesFord F-150 (2009-2014) :: Adding Steel Plate To Strut And Rear Springs?
After installing the autospring 2" Leveling kit and the rear add a leaf 1.5" I was wondering if its at all possible to add a slight steel plate between the spacers and rear leaf to get just a little more lift.
I have access to our shop where I can get the steel and get it cut and drilled accurately, just wondering if this will cause any issues be adding additional plate?
Like for the front add it between the spacer and strut and in the back, when when I was adding the new leaf it had some shims I guess in between the leafs, so just curious if I could add the plate under the leafs?
Prius (Gen 3) :: Get New Shocks And Coilovers When Installing Lowering Springs?
Is it necessary to get new shocks/coilovers when installing lowering springs? (and other concerns)
View 12 RepliesGolf/GTI VI :: Clunking Noise After Installing Lowering Springs
So I installed the DG springs today, and it should've been a simple install. Well once all was said and done I took it for a test drive. Every time I go over a bump I hear a loud clunking noise, like somethings loose. What it could be? I'm pretty sure I tightened everything.
View 10 RepliesCamry :: Weak Struts After Installing Lowering Springs
Few weeks ago, I got the Tein spring installed on my camry. Drop 1.5/1.6 front/rear.
Problem is now I sometimes hear this clunking sound from the rear. It doesn't happen very frequently, just every once in a while when i drive through a small&sudden bump.
Only from the rear, nothing from front of the car.
Another thing is that when i reverse & turn (ex. getting out of garage), it makes one or two cracking noise from the front, small clunking sound from the rear.
I'm suspecting the strut may be bad. The mechanic guy said that my rear struts are bad (when he was installing the springs).
Am I in need to get new struts ?
Golf IV R32 :: Passenger Strut Won't Come Out When Installing Coilover
The strut is lose, I can spin it hardly but I can't get the rotor to go down far enough, already disassembled the control arm but it didn't do much considering I couldn't move it forward or backward so the rotor still sits on a corner or the arm. I did the drivers side already.
View 3 RepliesGolf VI R :: Installing VWR Springs - Rear Suspension Unknown Part
I am installing VWR Springs to replace worn stock components on my mk6 R. It appears that the previous owner slammed the car, and removed the "nipple" that holds the rear spring in place from the top. Both upper and lower spring isolators were present.
I am trying to find a name or part number for this unknown "nipple". I tried some combinations, such as "rear spring cap" and "rear spring centering guide". It looks like it would screw into the body, right above the springs themselves.
Passat (B7) :: Squeaking / Groaning Sound From Front Strut Mount Area
I had my ST coilovers installed a while back. I love the ride, but a really annoying squeaking/groaning sound developed several weeks ago from the front strut mount area. The noise is heard at low speeds as I roll down the road (most likely high speeds, too) and sounds like its coming from both sides of the upper strut mount area. If you lift up/push down on the car, you can also hear the sound.
I purchased a set of 034 Density upper strut mounts from AMI Motorsports in hopes of eliminating the sound, but the sound got worse!! I still do not have a resolution. At this point, I'm thinking about putting the stock strut mounts back in, as the sound wasn't near as bad with the OE mounts in place.
I've lubricated the sway bar bushings and installed shorter end links (thinking the sound may be sway bar related), but the noise is still there. I even disconnected the end links all together - sound is still there. Could this be faulty coilovers? I tried to file a warranty claim through ST - they don't think their strut is faulty, and even if they did, I'm having a hard time with warranty coverage (long story). If it's the struts, then why did the sound get worse when the new 034 Density upper strut mounts were installed? Could it be faulty mounts?
At this point, I think it's either the mount or the strut, as I did not experience any issues prior to the coilovers.
Passat (B5) :: Installing A B5.5 Front End?
Need to know if this is a bolt on affair or what possible fabrication may be needed?
View 3 RepliesFord - Explorer :: 2004 - Lower Strut Bolt Stuck
Was replacing the struts and front ball joints on my wife's '04 Explorer last week. I get to the last one (driver's side front) and the lower strut bolt seems to be frozen to the bushing. I heated it up and beat on it a little bit. Nothing. Just wondering for some other way or am I going to have to cut it out?
View 3 RepliesPassat (B5) :: How To Remove Clamp Around Hose
How to remove clamp around hose? I am in process of changing out reservior tank. Ignore post. I got it, was afraid they were the one-time use only type of clamps. But duh, they are the spring clamps.
View 1 RepliesGTI 337/20th Anniversary :: Coilovers Installation - Lower Strut Mounting Bolt Seized
I am installing my coilovers on my gli and I have everything installed but the passenger side coilover. I cant even remove the old strut because the damn lower strut mounting bolt is seized and I've been trying for hours to remove it at no avail. I have used pb blaster, my heat gun, and my sweat. I dont have impact tools, just my ratchet..
View 15 RepliesGolf IV R32 :: After Installing Low Temp Thermostat Very Lower Coolant Temps?
After buying and installing the low temp thermostat, fan switch and green top sensor, I'm still encountering boiling in the line and a temp of 3/4 of the way when at idle. My coolant mixture is about 70/30 and unfortunately I had to use a temporary fix of the prestone universal coolant mix due to the dealer being closed and I didn't want to add more water
What would be the disadvantages of running straight g12 coolant? My issue is boiling and I figure the more coolant and less water, the less chance of boiling to occur.
Passat (B6) :: Noise At Lower Speeds / Grabbing From Front Wheels
A few weeks ago we notice a noise and grabbing from the front wheels. Noise was at lowers speeds only. Dealer did the following work.
Replace steering lock assembly and program
Replace left and right lower arm bushings
Replace outer cv boot, grease and repack
Extended warranty covered only steering wheel assembly and car rental.
They also said that the tires need it to be replace due to capping. Tires are only 9 months old. Replaced tire under warranty Potenzas G09 and di alignment that was way off. Two months ago was ok and drove less the 1,500 miles...
Sonata NF (2006-10) :: Lower Front Lower Ball Joints Freeze And Creak When Turning
Would bad lower front ball joints freeze and creak when turning. I have noticed that my car(2010GLS) with 108k miles has a creaking sound when turning the wheels left to right. I poked a hole in the rubber boot covering the joint and sprayed WD 40 in there and now it seem to creak even more. Guess I am going to replace the l and r lower ball joints.
View 9 Replies