Jetta - Volkswagen :: 2006 - CEL Code P0332 / Knock Sensor 2 In Bank 2 Faulty
I have a 2006 VW Jetta with 92K miles and just a couple of days ago my check engine late came on and when i took to an auto store to check the code, it came as P0332, Knock sensor 2 in bank 2 is faulty. Three things have happened all around the same time and I am not sure if they are related and are just coincidence.1.Check engine light came on.2. I have noticed after that, my car RPM has dropped, idles at about 600-700RPM and when trying to accelerate, it tops at 3000 RPM and feels like the motor cuts off at that point and I have to step off the gas and the car runs ok again, but cant go over 3000.
Had trouble getting on the interstate due to this and thought the car was going to stall, but it didn't. just had to back off the gas and let it run, It did go up to the speed that I wanted, but seems like it wont go past the 3000 RPM point.3. My fuel gauge, drops to empty when it reaches the half way mark on the meter. It stays at the correct level when I start and keep the car in idle, but when I start moving, it drops to empty. When I fill up the tank, it goes all the way to F, and after the car goes the usually of about 190-210 miles, when It reaches the half full level, the meter drops to zero, so have been using my trip odometer to drive after that.
Accent RB (2012+) :: Knock Sensor Location
I cannot find the location of the knock sensor in my 2012 Accent. I just replaced the radiator and had everything off up front unobstructed and couldn't find it. Looked in back, sides, but am completely stumped. I have found information on earlier models but not 2012+.
View 37 RepliesHyundai - Accent :: Check Engine Light Came On - Knock Sensor Code
I have a 2012 hyundai accent. The check engine light came on. The code read knock sensor. Before I could get it into a shop, it went off. It didn't come back for 11 months. When it did come back, the same code was read. Again, it went off the following day before it could be looked at and hasn't been seen since. The shop says that even though there is a history code, it would be hard to diagnose since it isn't an active code. I noticed absolutely no difference in performance when the code was active. Both times it went on, the car was idling for several minutes with the ac on, and it came on as i accelerated onto a highway immediately afterwards. However, it has idled like that many other times without the light coming on as well.
View 11 RepliesAccent LC (2000-05) :: Code P0326 - Can A Knock Sensor Be Influenced By Heavy Bass?
I have upgraded my sound system in my car and sometimes i get a P0326 check engine light.
Now i was wondering if its possible that the Heavy bass ( 25/40 Hz, 1200 Watt RMS and 2500 watt Max) Subwoofers could cause the car to vibrate so much that it sets of the knock sensor?
I have read some things about it but i only found that several "Old" cars with OBDII would have this problem? Is that the same on this hyundai accent?
It only comes once in a while after long cruises and bumping.
Accent LC (2000-05) :: Faulty Engine Coolant Sensor?
I went to emissions test my 2002 Accent, 1.5L 5spd, and failed because of a faulty engine coolant sensor. Problem is, I can't find it anywhere! Worse, I can't find anything online either. I have my second child on the way and need to sell the car and this is the only thing preventing me to sell. Is it worth it to replace myself or to take to a shop and have them do it.
View 6 RepliesSanta FE SM (2001-06) :: P1192 Code - Faulty TPS Sensor
My 2003 Santa Fe 3.5 is in limp mode, you can't change the gears and showing signs of faulty tps sensor, but my mechanic is telling me to change whole electronic throttle system , May be its only the sensor.
View 1 RepliesPrius (Gen 2) :: Faulty Battery Temp Sensor - Code POA9B
My first Prius, an 05 has 249K and performs pretty much flawlessly. My second, an 04 which I purchased in May, has 75K. While driving the 04 yesterday, all the lights came on the dash and really scared me. I immediately pulled off the road and checked belt, fluids and anything else I could. I then called the dealer and they thought since the car was running normal, to bring it in. For a hundred dollars I was told the HV battery, though working and not a problem, would have to be replaced due to a faulty "battery temp sensor" and that this part is not repairable....I need a new battery! Code POA9B ... Tomorrow I am taking the rear panel out and check the HV battery fan, etc. Can I drive the car with these lights on? Everything seems to work but the CC.
View 9 RepliesAccent MC (2006-11) :: Location Of Knock Sensor
I need to change the knock sensor of 2011 Accent, don't know where it is.
View 7 RepliesSanta Fe (CM - 2007-12) :: Code C1209 - Faulty Right Rear Wheel Speed Sensor
My mother in laws 2012 Santa Fe had a number of dash lights on (ABS, hill decent, stability control). I put my scanner on it and came up with fault code C1209 which showed up as a faulty right rear wheel speed sensor. I have replaced this module and then cleared the codes.
However, the dash lights still light up and the vehicle continues to throw the same code. I don't work on Hyundai's very often so I am at a bit of a loss.
Ford Ranger / B-Series :: MIL P1444 Code - Faulty Purge Flow Sensor
So I had a post up saying "is MIL P1444 a urgent fix" and I got "no". On an other website though it said that it was an urgent fix. They said it was "similar to running a bad catalytic converter. You don't want to do it."
P1444:
Possible causes
- Faulty Purge Flow Sensor
- Purge Flow Sensor harness is open or shorted
- Purge Flow Sensor circuit poor electrical connection
So I located the purge flow sensor and look at the tube that connects to that,the canp solenoid, and the carbon canister. Nothing looks bad, but I did notice that the tube that connects to the carbon canister to the solenoid is not connected. The part that connects to the carbon canister dry rotted off. So I turned on my car to see if anything was coming out of that tube or air and there was nothing (not sure if that's good or bad). Also a week ago when I filled up my gas tank (before the check engine light was on) a lot of fumes were coming out of the tank while pumping.
The scanner i use also lists the secondary air system, the EVAP system, Heated catalyst, and the AC refrigenant has red X's, but they weren't continuous.
Accent MC (2006-11) :: 2009 - Location Of Knock Sensor
I'm looking for the location of the knock sensor I can't find it?
View 4 RepliesYaris/Scion & Vitz :: 2001 Echo Faulty ECT Sensor - Error Code P0125
I'm getting error P0125 on my 2001 Echo, which points to possibly a faulty ECT sensor.
Where is this sensor located? Seems like under the air box? Is replacing this part as annoying as it looks? And, are there any other possible causes for code P0125?
In case it's related, I will mention that code P0171 (mixture too lean, I believe) is present as well, and the car does hesitate upon initial acceleration when standing still. Once it's moving, it works fine.
Maybe it's time to start thinking about replacing this car... it has 216,000 miles...
Santa FE SM (2001-06) :: Code P0325 Knock Sensor
What is the possible, or most likely, cause of a Knock Sensor No 1 Circuit Malfunction reading??
View 1 RepliesPassat (B5) :: 2002 / 1.8T - Knock Sensor Code 16711 (P0327)
So a letter history about the car and this car is a friends car. They owned the car and drove without changing the timing belt when the car hit 109k. So the timing belt snapped and they went out and bought a timing belt and also the timing belt kit with the pulleys and all. They installed it.. didnt turn over or what so ever.
They towed the car to us which we own an auto repair shop. We knew the valves was bent and so we tore off the heads send them off to have them put new valves and etc etc.. We put the car back together for them and now the car runs fine. They pick it up and about a few days later they brought it back due to a check engine. It threw the code:
16711 - Knock sensor 1-G61 Signal too low. (p0327)
now we replaced both knock sensors and when they came and got the car... the check engine light came back one showing the same code. We cleared it out and the next day it came back on showing the same code Again! So now we don't have a clue why that code keeps coming up because we replaced both sensors with a new one. Any clue why the code keeps popping back up?
Passat (B6) :: Knock Sensor Code After Valve Carbon Scrubbing Service
I have a '07 Passat Wagon 2.0T with 80K miles. I just had the carbon scrubbed off the valves (looked like black popcorn stuck in there!) and now I'm getting a "P0327 Knock Sensor 1" light. The motor seems to run just fine (actually much better now without the carbon build-up). I'll clear the code but it will show up again the next day.
What could cause the code? Could it be related to the recent scrubbing (fully removed and replaced the valve cover in the process), perhaps a chunk of carbon floating around in the tubes somewhere? I want to go back to the guys that performed the service but I want to have a good idea of what could be the problem and the fix before I get there.
Avalon 2005-12 :: Check Engine Light On And Code Is P0327 (Knock Sensor)
So, I have my check engine light and the code is p0327 (knock sensor). Clear cose but it returns. Going on for 3 days now. I was suspicious that something else is going on. I also remembered I've been using a little more antifreeze in the reservoir. So, today I needed to watch the coolant. I ran the car for an hr and I found a lot. Red coolant on my belt, the back passenger side of my engine and it was caked on with coolant. I think the water pump is going up.
I was concerned that coolant was also leaking from the intake manifold but it's only the right side, so I'm pretty sure the coolant is being slung around from the belt. I rinsed the engine down and the knock sensor code went away. Temporarily, until more coolant got back there. Do you think I will need to replace the knock sensor along with the water pump or should the sensor work ok after some intense cleaning after the water pump replacement?
Lexus GS 2006-11 :: Check Engine / VSC Lights On - P0333 Knock Sensor Code
I just purchased a 2006 GS300 AWD w/115k. Started car on lunch hour to find check engine / check VSC lights on. Ran codes to find P0333 Knock Sensor code. Vehicle seem to run perfectly fine, but now that the light is on, it is definity spark knocking under acceleration. This is my first Lexus / Toyota product, so I am unfamiliar with the common problems or fixes. Are knock sensor replacements common?
View 6 RepliesGolf IV / Jetta IV :: Slight Vibration - Knock Sensor 2 (G66) Signal Too Low (code P0332)
I got my car in November and I just did a scan and got this code. I don't have a CEL on. I do feel a slight vibration from time to time. It's very light.
Should I clear all DTCs and then run a scan a couple of days later to see what codes I truly have? Or should I address this code?
If yes, what should I do about this code? Do I need to buy a new knock sensor or should I check the wiring first with a voltmeter?
Ford Super Duty (1999-2016) :: Code Showing For Knock Sensor?
Code was showing for the knock and climbed under the truck and checked to see if it was plugged in grabbed the wire and to my surprise the wire kept coming and so did a piece of the knock sensor, is this going to affect my truck badly?? worst case?? 97 f250 4.6 standard
View 4 Replies