Accent LC (2000-05) :: Engine Turns Over Once Then Clicks Loudly A Few Times - Coil Pack Faulty
I have a 2001 Accent GL DOHC 1.5L (which I believe is the same as your LC model).
One night it started running poorly - missing, bad acceleration - like it was only running on 3 out of 4 cylinders. It was missing whilst idling and would backfire and struggle to accelerate. I took it to a mechanic and they said I needed a new coil pack. So I bought a coil pack from a 2nd hand wreckers that looked pretty good, the car idled better but accelerated worse, like it was only running on 2 cylinders .
So I swapped it back to the old coil pack - and now it wont even start. The engine turns over once then clicks loudly a few times - I think the clicking is from the distributor.
Accent RB (2012+) :: Code PO326 - Faulty Knock Sensor
2012 Hyundai Accent. I am getting a po326 code. Wondering if it may be a faulty knock sensor. And po463 fuel level sensor code when I fill up with gas.
View 2 RepliesFord 7.3L Power Stroke (1999-2003) :: Faulty Coolant Temp Sensor Effects?
Plugged in my ScanGaugeII on a whim, it's usually on my 6.5 Suburban daily drivers, but was curious to monitor a few things on the 7.3
Noticed this right away, coolant temp reading a solid -40*F and never budging.
Ford - Mountaineer :: 2000 - Faulty DPFE Sensor - How To Replace
I have a 2000 Mountaineer AWD 5.0 with a faulty DPFE sensor. (as diagnosed by dealership) I'm relatively handy with tools and I was wondering if this is an easy fix.
View 13 RepliesAccent LC (2000-05) :: 2001 - Changed MAF Sensor Now Engine Stutters
I have a 01 Hyundai Accent, 1.5L, stick shift. My CEL came on and I had it read. Mechanic told me it was P1128 (Fuel Lean) or something like that. Looked it up on line and everything said to check for air leaks and then look at the MAF Sensor. I checked and saw no leaks. Took out MAF Sensor and cleaned it with MAF Cleaner. Disco'd battery to reset computer. CEL went out for maybe 30 minutes and then back on. Didn't do anything with it for about 4 months, now car stutters sometimes.
So, I finally broke down and bought MAF Sensor and replaced myself. Disco'd battery to reset computer. Started up and engine was not smooth at first(30 seconds) then smoothed up. But CEL still on. Drove home (25 minutes) and checked again this morning. CEL is off! Only problem is that the car stutters a little at acceleration. Smooth when at cruising RPM and speed. Just stutters a little at start of acceleration and when switching gears until at cruising speed. Is this going to go away? Is the computer just getting set up after changing MAF Sensor?
Toyota - Corolla :: 2004 - Check Engine Light On / Oxygen Sensor Faulty
I have a 2004 Corolla with a Check Engine light on. The Toyota dealer diagnosed this as: "Oxygen Sensor Bank 1 Sensor 1 - slow to respond".
The diagnostic code is PO133. Elsewhere, I find that this code indicates:
The oxygen sensor is faulty.
The wiring to the sensor is broken / frayed.
There is an exhaust leak
Haven't noticed exhaust leakage, and I doubt the wiring is faulty.
1) Where is sensor 1?
2) Do I really need a new sensor, or can I clean the old one?
Toyota - T100 :: Check Engine Light On Due To Faulty Emission Evap Control Pressure Sensor
Engine runs perfectly but "check engine" light" stays on due to faulty Emission Evap control pressure sensor (P/N; 89460-0w020). Problem is Toyota no longer makes this part and there is no after market for it. It appears I may have to "junk" a perfectly good truck.
View 9 RepliesFord Super Duty (1999-2016) :: 2008 F250 V10 - Bank 2 Sensor 2 Oxygen Sensor Is Faulty
My Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 RepliesAccent MC (2006-11) :: 2008 - Coolant Temp Sensor Location?
Where the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?
View 3 RepliesCelica :: 2000 GT - Coolant Temp Sensor Gone Bad
I have a 2000 Celica GT and I suspect the coolant temp sensor has gone bad....the fans are not turning on and I'm not getting any hot air out of the heater.....where is the coolant temp sensor located on this thing?
View 4 RepliesAccent LC (2000-05) :: Knocking Sensor Location?
Where the knocking sensor is located on a 2005 Accent. I am in need of finding it so that i can wire a controller into the signal wire?
View 2 RepliesAccent LC (2000-05) :: Speed Sensor Location?
trying to find the speed sensor on a 03 accent manual so I can fit cruise control
View 1 RepliesAccent LC (2000-05) :: 2001 - MAF Sensor Location?
I'm trying to locate the MAF sensor on my 2001 LC accent. I can see the air cleaner box, the tube which T's off to the surge tank, and then it goes straight into the throttle body. On the hmaservice website, it shows a MAF sensor between the air cleaner box and the surge tank (or "resonator"). I don't have that! There's concertina tube going straight from the throttle body to the air cleaner box (with T off). Am I just missing a part?? There don't *seem* to be any unused harness connectors lying idly around the place!
View 2 RepliesFord F-150 - 1997-2003 :: 2000 V8 - Location Of Coolant Temp Sensor?
Where exactly is the coolant temp sensor located on a 2000 F-150 4.6 V-8.
View 5 RepliesAccent LC (2000-05) :: P0501 Speed Sensor Code Lit Up
The MIL light up and I got the P0501 Code. (Speed Sensor. I use a Scangauge II and the Speed is 0 KM/H at any speed. (was working before). But the in dash Speedometer work no problem. I look on the HMAservice web page and did not found where is located the Speed Sensor.
View 9 RepliesAccent LC (2000-05) :: Recurring Cam Sensor Input Low Code
About 3 weeks ago, I purchased a 2001 Accent GL 4dr 5spd from a friend of mine. A few days later, the CEL came on. I went to O'Reilly and got the code pulled, it was for a cam sensor input LOW. I replaced the sensor and was on my way.
Yesterday after starting the car for the first time for a few days (I wasn't driving because it needed a clutch), the light came on. Has it gone bad again or is something causing the signal to be low? Maybe a low output on the alternator or low battery? The interior lights dim slightly when the brake pedal is applied while the car is running.
Accent LC (2000-05) :: How To Reset A Throttle Position Sensor
I was reading the car's settings using the Torque app and an OBDII bluetooth dongle and I realize that at WOT the ECU is only seeing 85% from the TPS. O know on some vehicles there is an actual procedure like turn the key forward, hold the gas pedal at WOT, turn the key all the way forward w/o starting while pulling the turn signal stalk down or something crazy like that to force the ECU to re-measure while you keep the gas pedal pinned to the floor. I know on other cars when it doesn't read a full 100% you miss out on a small amount of power and MPG so if it's an easy procedure with these cars I'd like to reset it. I did some searching but mostly came up with info on how to replace it and a few related subjects but noting on this specifically for this car specifically.
View 2 RepliesAccent LC (2000-05) :: Bubbling In Coolant Overflow?
Why my coolant overflow tank would be bubbling away whilst the engine is hot? No signs of overheating, not done a compression test yet though.
When the engine is cold, the level in the coolant reservoir is higher than it should be and the radiator was low.
Accent LC (2000-05) :: Camshaft Position Sensor Code P0342
So my little car.....driving home from jersey (about an hour and a half) and within the last 2 miles I notice the car just shut off. Not any electronics just the motor. Pulled over and tried to start it an it just cranks prolly no fuel or spark. happened to have my obdII scanner with me. It says camshaft position sensor(po342). Only code in there. Sounds simple enough. Got a new one and put it in. Just cranks. Plugs and wires were done about 3 months ago and I drive about 40 miles a day 5 days a week. I did the timing belt last spring so I opened that back up to make sure the timing hadn't jumped for some stupid reason. It's perfect. Noticed now after doing all of that there is some (a little) oil in the throttle body. I know about blow by and don't think I should have that much at 113k but who knows.
View 2 Replies