Accent MC (2006-11) :: Location Of Knock Sensor
I need to change the knock sensor of 2011 Accent, don't know where it is.
View 7 RepliesAccent MC (2006-11) :: 2009 - Location Of Knock Sensor
I'm looking for the location of the knock sensor I can't find it?
View 4 RepliesAccent RB (2012+) :: Code PO326 - Faulty Knock Sensor
2012 Hyundai Accent. I am getting a po326 code. Wondering if it may be a faulty knock sensor. And po463 fuel level sensor code when I fill up with gas.
View 2 RepliesAurora :: Location Of Knock Sensor On 1997 Vehicle
Where the knock sensor is located on my 1997 Aurora. what does it do?
View 2 RepliesSonata NF (2006-10) :: 2009 2.4l - Location Of Knock Sensor?
Replacing the knock sensor on a 2009-2010 Sonata with a 2.4l? Where exactly is it located and what has to be removed?
View 2 RepliesHyundai - Accent :: Check Engine Light Came On - Knock Sensor Code
I have a 2012 hyundai accent. The check engine light came on. The code read knock sensor. Before I could get it into a shop, it went off. It didn't come back for 11 months. When it did come back, the same code was read. Again, it went off the following day before it could be looked at and hasn't been seen since. The shop says that even though there is a history code, it would be hard to diagnose since it isn't an active code. I noticed absolutely no difference in performance when the code was active. Both times it went on, the car was idling for several minutes with the ac on, and it came on as i accelerated onto a highway immediately afterwards. However, it has idled like that many other times without the light coming on as well.
View 11 RepliesAccent LC (2000-05) :: Code P0326 - Can A Knock Sensor Be Influenced By Heavy Bass?
I have upgraded my sound system in my car and sometimes i get a P0326 check engine light.
Now i was wondering if its possible that the Heavy bass ( 25/40 Hz, 1200 Watt RMS and 2500 watt Max) Subwoofers could cause the car to vibrate so much that it sets of the knock sensor?
I have read some things about it but i only found that several "Old" cars with OBDII would have this problem? Is that the same on this hyundai accent?
It only comes once in a while after long cruises and bumping.
Accent LC (2000-05) :: Knocking Sensor Location?
Where the knocking sensor is located on a 2005 Accent. I am in need of finding it so that i can wire a controller into the signal wire?
View 2 RepliesAccent LC (2000-05) :: Speed Sensor Location?
trying to find the speed sensor on a 03 accent manual so I can fit cruise control
View 1 RepliesAccent LC (2000-05) :: 2001 - MAF Sensor Location?
I'm trying to locate the MAF sensor on my 2001 LC accent. I can see the air cleaner box, the tube which T's off to the surge tank, and then it goes straight into the throttle body. On the hmaservice website, it shows a MAF sensor between the air cleaner box and the surge tank (or "resonator"). I don't have that! There's concertina tube going straight from the throttle body to the air cleaner box (with T off). Am I just missing a part?? There don't *seem* to be any unused harness connectors lying idly around the place!
View 2 RepliesAccent MC (2006-11) :: Mass Flow Air Sensor Location
2009 accent, cant find its location. Picture would be nice...
View 4 RepliesAccent MC (2006-11) :: Misfire On 2 Cylinders - Location Of MAF Sensor?
I have a 2009 Hyundai accent. 2 cylinders misfire. I changed out the spark plugs after the misfiring began and the 2 cylinders that misfire don't follow any specific ignition coil, it's just 2 random ones.
Looking at the data with a reader points to fuel injector number 1 not working properly. The first few seconds the car is on the check engine light blinks and fuel injector 1 spray duration (fluctuates based on gas applied) changes just like all the others. However, when the check engine light goes solid (then the misfire code is thrown) fuel injector 1's spray duration is stuck (usually around 3.5 ms)
The cable going into the fuel injector powers those little troubleshooting lights like it should until you plug the cable into the fuel injector OR remove and replace the light a few times.
I don't know much about cars but someone told me to try cleaning out the Mass AirFlow sensor as they had the problem above and the MAF sensor was the cause. I can't find anything on where the MAF sensor is located though.
Accent MC (2006-11) :: 2008 - Coolant Temp Sensor Location?
Where the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?
View 3 RepliesAccent RB (2012+) :: 1.6L GDI Engine Rattle / Knock And Buzz Under Load
My 2012 Accent's 1.6L GDI engine has developed an engine rattle when under load and warmed up.
View 38 RepliesAccent LC (2000-05) :: Transmission Temperature Sensor Location / P0711 Code
Wife's car threw a p0711 code. It says temp sensor failure or whatever. I found the part on rockauto for 22 bucks but that's not the issue. I've tried searching about this and I seem to find some stuff about elantras and sonatas. I can't seem to find anything specific to a accent. I've read that it's inside the transmission which is fine I've changed valves before and such on old rwd transmissions. But some things I find say it's on the bottom and some say the side. Also wiring is mentioned pretty often with service bulletins.
View 28 RepliesCamry 2012+ :: Transmission Temp Sensor Location?
Where the transmission temperature sensor is on a 2014 Camry 4 cylinder. I am contemplating unplugging it to improve shift points. I know it may affect gas mileage but the current shift points suck.
View 2 RepliesAccent RB (2012+) :: Quiet Knock / Ping Sound When Accelerating Or Going Uphill On Low RPM
I am hearing a quiet knock from my 2013 accent, especially when accelerating or going uphill on low RPM. I am getting about 34 MPG after burning a tank of regular gas (87 octane rating) on my commute which is about 2/3rds 50-70mph freeway and 1/3rd stop and go traffic. I usually get more MPG than what the EPA rating is, so that number seems a little bit low to me, but I just got the car used, so I don't know what's "Normal" for it. Idle is pretty quiet though.
I would give a video where you can hear it, but honestly it is pretty hard to hear from inside the car. I generally have to be near a wall with the windows down or something to be able to hear it clearly.
2012 Accent 1.6L GDI Engine Rattle/Knock/Buzz
Also, there are no lights showing on the dashboard besides the ECO light since I have been running the car in that mode. Is it possible that there could be codes that might give more information even though nothing is showing on the dashboard?
Ford Super Duty (1999-2016) :: 2012 - Pitch Sensor Location?
Truck is 2012 F250XL single cab 6.2. Where is the pitch sensor on this truck? There are times the hill start assist will keep the brakes applied on level ground, and occasionally I will crest a hill onto a level stretch and the truck doesn't want to upshift. So I am thinking the pitch (incline) sensor needs recalibrated. Where it is?
View 7 RepliesAccent RB (2012+) :: 2013 - Location Of Correct High Beam Wire
I have a 2013 Accent and have installing driving lights. I am looking for the correct high beam wire on the driver's side on the headlight assembly. I will then run this to a relay so that when I turn on my highs, the driving lights will come on. I have tried to locate the correct wire but the one wire that is hot when the highs are on, is still hot when the car is off as well as the lights.
View 6 Replies