Accent MC (2006-11) :: 2008 GS - Misfire On 3 Cylinders / Rough Idle And Poor Acceleration

After scouring through hundreds of threads on this forum (which is Awesome, BTW), it seems as if this misfire / rough idle thing is fairly common (which is scary!!). CEL is on steady. Had the codes pulled; P0301, P0302, P0303. At the recommendation of the mechanic, I had the plugs replaced...no improvement. He then replaced the ignition coils...no improvement. Just finished replacing the MAP sensor. This actually had a VERY temporary positive effect. However, after about 5 miles of driving, the misfiring returned. Took the car to the Hyundai dealership, and they acted as if they didn't want to fool with it. They referred me to a couple of local repair shops...????

View 8 Replies

Accent MC (2006-11) :: Location Of Knock Sensor

I need to change the knock sensor of 2011 Accent, don't know where it is.

View 7 Replies

Accent MC (2006-11) :: Mass Flow Air Sensor Location

2009 accent, cant find its location. Picture would be nice...

View 4 Replies

Accent MC (2006-11) :: 2009 - Location Of Knock Sensor

I'm looking for the location of the knock sensor I can't find it?

View 4 Replies

Accent MC (2006-11) :: 2008 - Coolant Temp Sensor Location?

Where the ECT sensor is located? I would really like to have a diagram of the engine. Where I can find an engine diagram for a 2008 accent gls?

View 3 Replies

Accent LC (2000-05) :: Knocking Sensor Location?

Where the knocking sensor is located on a 2005 Accent. I am in need of finding it so that i can wire a controller into the signal wire?

View 2 Replies

Accent LC (2000-05) :: Speed Sensor Location?

trying to find the speed sensor on a 03 accent manual so I can fit cruise control

View 1 Replies

Accent RB (2012+) :: Knock Sensor Location

I cannot find the location of the knock sensor in my 2012 Accent. I just replaced the radiator and had everything off up front unobstructed and couldn't find it. Looked in back, sides, but am completely stumped. I have found information on earlier models but not 2012+.

View 37 Replies

Accent LC (2000-05) :: 2001 - MAF Sensor Location?

I'm trying to locate the MAF sensor on my 2001 LC accent. I can see the air cleaner box, the tube which T's off to the surge tank, and then it goes straight into the throttle body. On the hmaservice website, it shows a MAF sensor between the air cleaner box and the surge tank (or "resonator"). I don't have that! There's concertina tube going straight from the throttle body to the air cleaner box (with T off). Am I just missing a part?? There don't *seem* to be any unused harness connectors lying idly around the place!

View 2 Replies

Accent LC (2000-05) :: Transmission Temperature Sensor Location / P0711 Code

Wife's car threw a p0711 code. It says temp sensor failure or whatever. I found the part on rockauto for 22 bucks but that's not the issue. I've tried searching about this and I seem to find some stuff about elantras and sonatas. I can't seem to find anything specific to a accent. I've read that it's inside the transmission which is fine I've changed valves before and such on old rwd transmissions. But some things I find say it's on the bottom and some say the side. Also wiring is mentioned pretty often with service bulletins.

View 28 Replies

Accent MC (2006-11) :: 2009 - Fuel Not Getting To Cylinders

I have a 2009 accent.. fuel pump went so I just replaced it...it pumps fuel but not getting any fuel to the cylinders...had a plug out to test the spark and it has good spark but plugs were dry and very faint fuel smell...also changed the crankshaft position sensor.. what could cause a no fuel issue??car ran fine, shut it off and no start..checked the fuel pump and it wasn't working though it had power to it...why the injectors wouldn't be working??

View 12 Replies

Accent MC (2006-11) :: Low Acceleration And Engine Shaking / Two Cylinders Misfiring

So as I was heading out the other day, the car had low acceleration and engine shaking. The check engine light started flashing.

Checked the codes at the parts store: P0300, P0301, P0303.

I just dropped it off at the auto repair shop.

Could it be a I'm just wondering if I shouldn't have taken it to the dealer as the printout says it could be a CPU issue?

View 5 Replies

Elantra HD (2006-10) :: DTC P1100 / Location Of The MAP Sensor?

Don't know the location of the MAP sensor for a 2008 Elantra 4-dr (HD)? I'm reading a DTC P1100, which indicates a manifold absolute pressure (MAP) sensor malfunction. The Haynes manual refers to this only being necessary for the previous model Elantra.

View 3 Replies

Sonata NF (2006-10) :: 2009 2.4l - Location Of Knock Sensor?

Replacing the knock sensor on a 2009-2010 Sonata with a 2.4l? Where exactly is it located and what has to be removed?

View 2 Replies

Sonata NF (2006-10) :: Camshaft Position Sensor Location On 2007 GLS

I have been getting a P0011 error code. Changed the OCV but the code continues. I'm going to try replacing the CMPS but am not quite sure of the location on the 2007 Sonata GLS. Looking for any pics of the location or a description?

View 1 Replies

Ford Super Duty (1999-2016) :: 2006 - Door Sensor Location?

Where are the door sensors located?

The ones that turn the light and off when you open and close the doors.

It use to be switches on the old trucks and cars.

But on my 2006 F-250 I can find anything that seems to do that function, nor is anything mentioned in the repair manuel.

View 8 Replies

Accent MC (2006-11) :: Cylinder 1 Misfire

What is the easiest fix on this and what is the worse case scenario?

View 6 Replies

Accent MC (2006-11) :: 2007 - Cylinder 1 Misfire

I am currently having an issue with my 07 Accent misfiring on cylinder 1. So far, I have changed the spark plugs, which were due anyway, and checked the coil pack. Every coil on each cylinder reads 0.8 ohms, so I am going on the assumption that they are ok. Didn't see any issue with the connector end inside the boot. However, when I changed the plugs, I discovered that I had oil in the plug tubes on 1 and 4. So I changed the valve cover gasket and tube rings and cleaned all oil residue from the packs. I have also checked the short coil wire harness right on the packs themselves. Have not tried to check further because I don't know which pins that harness goes to on which ECM connector. I still have the misfire, and I'm not sure where to go next. I was thinking compression or fuel injector. I don't have a compression tester, and I assume the only way I can check the injector is to swap it with another cylinder?

View 10 Replies

Accent MC (2006-11) :: Multiple Cylinder Misfire

My car has been really acting up lately (AGAIN) so I took it in to have it looked at and they came back and told me it had multiple cylinder misfire, and they wanted like $1200 to fix it. What in the world does that mean and what is entailed in fixing it? They mentioned doing a full maintenance on it.

View 9 Replies